中国“达标排放”政策的实证分析及理论探讨

以固定点源烟尘排放为例,从排放标准和监测标准两方面讨论了中国现阶段“达标排放”的状况,指出当前的大气污染源达标排放实际上是“初步达标排放”,现在的排放标准和监测规范合适考核污染源的初步达标排放,不适合考核污染源的连续达标排放。排放标准的规定形式、监测规范和适用范围需要改革。现在的排放标准指标需要与监测规范和超标率限值结合起来,以促进污染源的连续达标排放。     

沈阳发展循环经济初探

通过分析循环经济在沈阳发展的意义 ,提出沈阳发展循环经济的初步设想 ,为创建循环经济示范城市提供初始框架。     

Effects of sludge retention time, carbon and initial biomass concentrations on selection process: From activated sludge to polyhydroxyalkanoate accumulating cultures

Four sequence batch reactors (SBRs) fed by fermented sugar cane wastewater were continuously operated under the aerobic dynamic feeding (ADF) mode with different configurations of sludge retention time (SRT), carbon and initial biomass concentrations to enrich polyhydroxyalkanoate (PHA) accumulating mixed microbial cultures (MMCs) from municipal activated sludge. The stability of SBRs was investigated besides the enrichment performance. The microbial community structures of the enriched MMCs were analyzed using terminal restriction fragment length polymorphism (T-RFLP). The optimum operating conditions for the enrichment process were: SRT of 5 days, carbon concentration of 2.52 g COD/L and initial biomass concentration of 3.65 g/L. The best enrichment performance in terms of both operating stability and PHA storage ability of enriched cultures (with the maximum PHA content and PHA storage yield (Y_PHA/S) of 61.26% and 0.68 mg COD/mg COD, respectively) was achieved under this condition. Effects of the SRT, carbon concentration and initial biomass concentration on the PHA accumulating MMCs selection process were discussed respectively. A new model including the segmentation of the enrichment process and the effects of SRT on each phase was proposed.     

炸药及火工品可靠性与安全性评定方法

可靠性的评定结果是否可信,直接关系到炸药及火工品的使用安全性和作用可靠性。但是,现有炸药及火工品可靠性评定方法却存在着达不到置信度要求、评价结果偏于危险的缺点。为此,提出了一种确定炸药及火工品安全度和可靠度的高精度方法,并给出了应用实例。该方法不仅可信程度高,而且适用于小样本情况,尤其是在利用了以往试验数据后,既可提高安全性和可靠性评定的精度,又可大大节省试验的费用及时间     

浮萍生长及其除磷效率的影响因素的研究

磷是藻类增殖的限制因子,是引起水体富营养化的关键营养物质.有效除磷,能在很大程度上减轻水体的富营养化.利用浮萍科植物吸收转化污水中的营养物质引起了越来越多研究者的关注,但对浮萍科植物除磷效果的影响因素的研究相对较少.以少根紫萍(Spirodela oligorrhiza)为供试材料,以完全培养液为处理对象,研究了培养液pH、少根紫萍初始放养密度对其生长及除磷效率的影响.结果表明:少根紫萍能够耐受的最低pH在4左右,在pH＝5～9能正常生长,在pH＝6～8具有较高的TP去除率,最高去除率可达84.1%;少根紫萍的相对增长率随其初始放养密度的增加而降低,但其鲜重增长量、平均增长速率、TP去除率及平均TP去除速率均随着初始放养密度的增加而增加.     

Effect of initial temperature on the explosion pressure of various liquid fuels and their blends

In this work, the effect of initial temperature on the explosion pressure, P_ex, of various liquid fuels (isooctane, toluene and methanol) and their blends (isooctane-toluene and methanol-toluene, with three different fuel-fuel ratios) was investigated by performing experiments in a 20-l sphere at different concentrations of vaporized fuel in air. The initial temperature was varied from 333 K to 413 K.Results show that, as the fuel-air equivalence ratio, Φ, is increased, a transition occurs from a “thermodynamics-driven” explosion regime to a “radiant heat losses-driven” explosion regime. The maximum pressure, P_max, is found in the former regime (Φ < 3), which is characterized by a trend of decreasing P_ex with increasing initial temperature. This trend has been explained by thermodynamics. In the latter regime (Φ > 3), P_ex increases with increasing initial temperature. This trend has been addressed to the decrease in emissivity (and, thus, radiant heat losses) with the increase in temperature.     

Photolysis Behavior of Herbicide Propisochlor in Water Media and Preliminary Analysis of Photoproducts Under Different Light Sources

Photolysis behavior of a new herbicide propisochlor in water media as well as the effects of light sources, initial concentration of propisochlor, pH value, dissolved oxygen (DO) level, and salinity on the photolysis process was investigated. It was found that the relationship between initial concentration of propisochlor and its photodegradation rate was negatively correlated. The changes in acidity and alkalinity of the reaction medium influenced the photoreaction rate evidently. In the alkaline solution the degradation was accelerated. In the reaction media with different pH values, the photolysis followed the first-order kinetics. The presence of dissolved oxygen may promote the photolysis and there existed an optimum of dissolved oxygen concentrations. Increasing the DO level can weaken the promotion and even have an adverse effect. It was demonstrated that with dissolved oxygen the photodegradation of propisochlor followed the first-order kinetics equation. The addition of salt ions Ca²⁺ and Mg²⁺ changed the ionic strength and solvent polarity, resulting in the effect on propisochlor photolysis. The photoproducts were detected by both HPLC and GC-MS methods. It was found that photolysis products varied under different light sources. Conclusions may be reached that in the photodegradation of propisochlor, the benzene ring remained intact under irradiation of both solar light and high-pressure mercury lamp, and the amido link was relatively stable, while dechlorination was liable to take place; moreover, α-hydrogen at the substituent of benzene ring was active.     

Forecasting of dissolved oxygen in the Guanting reservoir using an optimized NGBM (1,1) model

An optimized nonlinear grey Bernoulli model was proposed by using a particle swarm optimization algorithm to solve the parameter optimization problem. In addition, each item in the first-order accumulated generating sequence was set in turn as an initial condition to determine which alternative would yield the highest forecasting accuracy. To test the forecasting performance, the optimized models with different initial conditions were then used to simulate dissolved oxygen concentrations in the Guanting reservoir inlet and outlet (China). The empirical results show that the optimized model can remarkably improve forecasting accuracy, and the particle swarm optimization technique is a good tool to solve parameter optimization problems. What's more, the optimized model with an initial condition that performs well in in-sample simulation may not do as well as in out-of-sample forecasting.     

Forecasting of dissolved oxygen in the Guanting reservoir using an optimized NGBM (1,1) model

An optimized nonlinear grey Bernoulli model was proposed by using a particle swarm optimization algorithm to solve the parameter optimization problem. In addition, each item in the first-order accumulated generating sequence was set in turn as an initial condition to determine which alternative would yield the highest forecasting accuracy. To test the forecasting performance, the optimized models with different initial conditions were then used to simulate dissolved oxygen concentrations in the Guanting reservoir inlet and outlet (China). The empirical results show that the optimized model can remarkably improve forecasting accuracy, and the particle swarm optimization technique is a good tool to solve parameter optimization problems. What's more, the optimized model with an initial condition that performs well in in-sample simulation may not do as well as in out-of-sample forecasting.     

On the influence of chemical initial and boundary conditions on annual regional air quality model simulations for North America

The influence of chemical initial conditions and chemical lateral boundary conditions (CLBCs) on long-term regional air quality model simulations was investigated using outputs from an annual simulation of the year 2002 on a North American domain. This simulation was carried out using the AURAMS regional air quality model. It was subdivided into three multi-month segments with two overlap periods (May 15–30 and September 1–30) to allow the segments to be run in parallel. For this approach to work, model predictions had to match very closely by the end of the two-week and four-week overlap periods. The time required for the values of daily domain-average surface PM_2.5 concentration to match for the two simulation segments associated with each of the two overlap periods was four and six days, respectively. For individual locations within the model domain, however, the required spin-up period was as much as nine days, considerably longer than the 2–4-day spin-up period usually assumed in the literature. For ozone, on the other hand, the daily domain-average surface ozone concentration values did not converge for either overlap period. A zero-gradient CLBC had been used for all run segments and species. When a time-invariant CLBC for ozone was used instead, the daily domain-average surface ozone concentration values behaved more realistically and did converge after fewer than three days. A similar improvement was also obtained for individual locations, but with spin-up periods of up to nine days. Model chemical spin-up time thus seems to be dependent on the species considered, the time required for the influence of the inflow boundaries to reach all locations within the domain, and the impact of local emissions sources. These results suggest the use of a spin-up period of longer than one week for a large (continental) domain and long-term simulation of PM_2.5 and O₃ rather than the 2–4 days commonly assumed in the literature.