垃圾焚烧炉飞灰的低温玻璃固化初步研究

在研究我国城市生活垃圾焚烧炉飞灰的毒性特征和高温灼烧特性的基础上，试验了几种常用玻璃熔制助溶剂、烟气净化产物中的成分对飞灰的溶融温度和熔融减量的影响，以实现低温玻璃固化。实验发现受热温度越高、时间越长，飞灰减量越大；B2O3、硼砂、CaF2对飞灰助溶效果明显，而废玻璃、CaO、CaCl2能使悄灰溶融后形成的玻璃态物质地均匀、少孔。按一定比例同时加入硼砂、CaF2、废玻璃、CaO、CaCl2于飞灰中，混合物的熔融温度降到1000℃以下，大大低于飞灰自身的熔融温度（1200℃）。对该熔融物在空气中淬火形成的玻璃态物质按标准方法浸沥，选择测量了浸出液中铅、汞、镉、砷的浓度，初步发现低温玻璃态物质对重金属铅和镉具有较好的固化效果，而对汞有砷的固化效果尚不确定。     

The effect of Na and Ca salts on MSWI bottom ash activation for reuse as a pozzolanic admixture

In this study the possibility of both chemical and combined chemical + thermal activation of municipal solid waste incinerator bottom ash was investigated. A number of chemical activators including Na₂SiO₃·9H₂O, NaOH, Na₂SO₄ and CaCl₂·2H₂O were individually added at varying concentrations to bottom ash/Portland cement mixtures having different bottom ash contents. The effect of the selected compounds was evaluated in terms of macroscopic properties including mechanical strength and composition of cementitious materials/water slurries. The results showed that Na-based activators were not capable of improving the characteristics of the cementitious products if compared to Portland cement under both normal and accelerated curing. Conversely, the use of calcium chloride at 40 °C-curing did promote the pozzolanic properties of bottom ash, leading to UCS values of 45.5 and 60.0 MPa after 10 and 20 days, respectively, as opposed to a value of 43.6 MPa obtained after 28 days for Portland cement under normal curing conditions.     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

垃圾焚烧飞灰有毒重金属固化稳定技术研究综述

采用焚烧法处理生活垃圾正呈快速增长的趋势,焚烧过程产生的飞灰中所含有的大量有毒重金属对自然环境和人类生存都造成极大影响。阐述了目前常用的几种固化稳定垃圾焚烧飞灰有毒重金属的方法,综合分析了其固化特点和优缺点,并初步探索了一种低能耗环境下实现高温熔融处置技术的有效途径,从而为垃圾焚烧飞灰高温固化稳定有毒重金属的实施提供一定的理论基础和技术支持。     

基于污泥掺烧的某生活垃圾焚烧厂烟道气、飞灰及炉渣中的二(口恶)英特征

以我国南方某生活垃圾焚烧厂掺烧10%市政污泥的生活垃圾为研究对象,对前/后口废气、飞灰、炉渣及用于掺烧的污泥中17种二(口恶)英的含量进行了测定,并分析了其指纹分布特征.结合焚烧工况及处理设施,从生成机理角度探讨了二(口恶)英的排放特征、毒性当量浓度主成分特征及主要单体的排放因子线性关系.结果表明：掺烧10%的市政污泥后,废气中二(口恶)英的去除率为99.4%,低于国家排放标准;固体废物中二(口恶)英含量为飞灰 > 炉渣 > 污泥.这说明采用高温焚烧和"活性炭喷射+布袋除尘"装置不会影响掺烧10%污泥的达标排放.指纹分布特征表明,前口废气以1,2,3,4,6,7,8-HpCDF和OCDD为主,后口废气以OCDD和OCDF为主;飞灰、炉渣及污泥中的主要单体为OCDD、1,2,3,4,6,7,8-HpCDD、OCDF、1,2,3,4,6,7,8-HpCDF.主成分分析显示,前口废气和飞灰中的二(口恶)英毒性分布特征相似;炉渣和污泥的毒性分布特征相似;后口废气有自身的特征.这说明在相同工况条件下,经同一设施处理的废物中二(口恶)英排放特征相似.排放因子分析表明,2,3,4,7,8-PeCDF和1,2,3,6,7,8-HxCDF、1,2,3,6,7,8-HxCDD和1,2,3,7,8,9-HxCDD与总毒性排放因子具有较强的线性关系,且呋喃类（PCDFs）强于二(口恶)英类（PCDDs）.     

生活垃圾焚烧飞灰制陶瓷砖表征

为了探索生活垃圾焚烧飞灰资源化利用途径,在对飞灰化学组成及矿物成分分析的基础上,利用飞灰、黄陶土、耐火砂及长石研制陶瓷砖,最佳配比方案为:飞灰20%,黄陶土60%,长石10%,耐火砂10%,分析了最佳配比制品的吸水率、抗压强度、微观结构及水平振荡浸出毒性。结果表明:飞灰属SiO2-Al2O3-金属氧化物体系,主要矿物成分是钙硅酸盐及铝硅酸盐等,可用于制陶瓷砖;最佳配比制品达MU15强度等级,满足抗风化的要求;随煅烧温度的升高,制品结构不断密实化,960℃烧成的制品显示出完全烧结的特点,960~1 000℃烧成的制品中出现明显的晶化、玻璃化过程。最佳配比制品重金属浸出毒性完全达标,重金属的浸出率与坯体相比大大降低。     

垃圾焚烧飞灰处理处置研究进展

针对作为危险废物的垃圾焚烧飞灰,介绍了近年来国内外对其进行处理处置的研究情况.飞灰的固化/稳定化处理主要从水泥(沥青)固化、熔融固化及化学药剂固化几方面进行论述,飞灰中重金属的提取主要从酸碱浸提、生物浸提、螯合剂浸提及电渗析法提取几方面进行论述.     

Relative importance of polychlorinated naphthalenes compared to dioxins, and polychlorinated biphenyls in human serum from Korea: Contribution to TEQs and potential sources

Polychlorinated dibenzo-p-dioxins (PCDDs), polychlorinated dibenzofurans (PCDFs), and polychlorinated biphenyls (PCBs) in human have been studied extensively; however, polychlorinated naphthalenes (PCNs) have been studied less widely. The mean concentrations of PCNs, PCDDs, PCDFs, and PCBs in 61 healthy human volunteers were 2170 pg/g lipid, 452 pg/g lipid, 116 pg/g lipid, and 120 ng/g lipid respectively, and the mean toxic equivalents (TEQs) contributed by PCNs, PCDDs, PCDFs, and PCBs were 5.88, 5.22, 5.48, and 5.33 pg/g lipid, respectively. PCNs contributed to 26.8% of the total TEQs. 1,2,3,7,8-PeCDD, 2,3,4,7,8-PeCDF, PCB126, and hepta-CN-73 accounted for >62% of the total TEQs in the human serum samples. The overall serum PCN homologue profiles of all subjects were dominated by tetra- and penta-CN homologues, and the most predominant individual congener was hepta-CN-73, which contributed 17.5% of the total serum PCN concentration. Enrichment of hepta-CN-73 in the human serum samples might be due to contributors from combustion sources.     

内配燃料垃圾焚烧飞灰烧结无害化处理实验研究

研究了一种垃圾焚烧飞灰烧结无害化处理的工艺,该工艺是将飞灰与不同比例煤粉混合并添加助熔剂进行造粒烧结。通过对试样进行热流和热重测量,分析了飞灰试样在加热过程中热重变化的规律,并利用XRD、扫描电镜、氮吸附分析仪等仪器分析手段对烧结试样的物相、微观形态和孔隙特性等物理化学性质进行了研究。最后采用电感耦合等离子体发射光谱仪对烧结试样重金属浸出性进行了分析。实验结果为飞灰烧结炉的设计和内配燃料烧结工艺运行参数的制定提供了依据。     

广东某大型城市生活垃圾焚烧厂9种重金属的迁移特征

采集广东某大型城市生活垃圾焚烧厂一期(WI-A)和二期(WI-B)的进厂垃圾、渗滤液、飞灰、底渣和烟气样品,分析了各样品中砷、镉、钴、铬、铜、汞、镍、铅、锌共9种重金属含量,研究重金属的迁移特征。结果显示,9种重金属呈现4类不同的迁移特征,钴、铜、镍、铬主要迁移至底渣中,锌、砷、铅主要迁移至底渣和飞灰中,镉主要迁移至飞灰中,汞主要迁移至飞灰和烟气中。活性炭吸附和布袋除尘器的组合对除汞以外的重金属治理效果明显。WI-A和WI-B垃圾中的汞分别约有28%、37%随烟气排到环境中。