城市污水处理脱磷滤料的研究

生物法除磷投资省、成本低,但稳定性较差,当废水中磷酸盐浓度较高时,出水很难达标排放.化学法除磷工艺简单,运行可靠,能达标排放,但运行费用高,产生大量污泥,导致二次污染.文章进行了第三种除磷方法即滤料除磷的研究,并探讨了污水pH及水力停留时间对滤料除磷效果的影响.试验结果表明:煤渣和改性煤渣滤料对城市污水总磷的去除率可以达到54%和71%,但处理后的出水不能达标排放;碳酸钙滤料对城市污水总磷的去除率可以达到83%,能达标排放,但处理效果与城市污水pH值密切相关.城市污水pH值在8～9的范围,出水不能达标排放;pH值在5～8的范围,处理后的出水则可以达标排放,而且污水pH越低,总磷的去除率越高,其最佳水力停留时间为10 min.该方法具有处理效果好、处理成本低、无污染、投资省、占地面积小的特点.     

Secondary materials and international trade: A comment on the domestic market

Concentrating on wastepaper, Grace et al. [J. Environ. Econ. Manag. 5, 172–186 (1978)] have argued that international trade in secondary materials can effectively help to stabilize their prices. In their modeling, however, they erroneously assume that pulp sets the upper bound for the price of wastepaper. This paper presents evidence to the contrary. Pulp contracts are typically long term, so wastepaper is frequently an input of last resort. The wastepaper price can therefore easily exceed the price pulp when output demand is high. A geometric model is presented to formalize this explanation, and it is argued from there that the increased stability offered by trade is more significant than suggested by Grace et al.     

Government green procurement spillovers: Evidence from municipal building policies in California

We study how government green procurement policies influence private-sector demand for similar products. Specifically, we measure the impact of municipal policies requiring governments to construct green buildings on private-sector adoption of the US Green Building Council?s Leadership in Energy and Environmental Design (LEED) standard. Using matching methods, panel data, and instrumental variables, we find that government procurement rules produce spillover effects that stimulate both private-sector adoption of the LEED standard and investments in green building expertise by local suppliers. These findings suggest that government procurement policies can accelerate the diffusion of new environmental standards that require coordinated complementary investments by various types of private adopter.     

Recycling municipal,agricultural and industrial waste into energy,fertilizers, food and construction materials,and economic feasibility: a review

The global amount of solid waste has dramatically increased as a result of rapid population growth, accelerated urbanization, agricultural demand, and industrial development. The world's population is expected to reach 8.5 billion by 2030, while solid waste production will reach 2.59 billion tons. This will deteriorate the already strained environment and climate situation. Consequently, there is an urgent need for methods to recycle solid waste. Here, we review recent technologies to treat solid waste, and we assess the economic feasibility of transforming waste into energy. We focus on municipal, agricultural, and industrial waste. We found that methane captured from landfilled-municipal solid waste in Delhi could supply 8–18 million houses with electricity and generate 7140 gigawatt-hour, with a prospected potential of 31,346 and 77,748 gigawatt-hour by 2030 and 2060, respectively. Valorization of agricultural solid waste and food waste by anaerobic digestion systems could replace 61.46% of natural gas and 38.54% of coal use in the United Kingdom, and could reduce land use of 1.8 million hectares if provided as animal feeds. We also estimated a levelized cost of landfill solid and anaerobic digestion waste-to-energy technologies of $0.04/kilowatt-hour and $0.07/kilowatt-hour, with a payback time of 0.73–1.86 years and 1.17–2.37 years, respectively. Nonetheless, current landfill waste treatment methods are still inefficient, in particular for treating food waste containing over 60% water.

     

Metal removal with two biochars made from municipal organic waste: adsorptive characterization and surface complexation modeling

The adsorptive characteristics of biochar produced from garden green waste (S-char) and a mixture of food waste and garden green waste (FS-char) were investigated. Adsorption of Cu²⁺, Zn²⁺, and Mn²⁺ onto the two biochars reached equilibrium within 48 hours. The metal adsorption was effectively described by the pseudo-second-order kinetic and Freundlich isotherm models which suggest heterogeneous chemisorption. The initial solution pH influenced adsorption of Zn²⁺ and Mn²⁺ but not of Cu²⁺. Simulation via a surface complexation model showed that the fraction of XOCu⁺ adsorbed onto biochar was increased with increasing pH until it reached the adsorption maximum at pH 8.5, while the endpoint for the maximum of XOMn⁺ was higher than pH 12.     

Emerging electrochemical processes for materials recovery from wastewater: Mechanisms and prospects

• Mechanisms for selective recovery of materials in electrochemical processes are discussed. • Wastewaters that contain recoverable materials are reviewed. • Application prospects are discussed from both technical and non-technical aspects. Recovering valuable materials from waste streams is critical to the transition to a circular economy with reduced environmental damages caused by resource extraction activities. Municipal and industrial wastewaters contain a variety of materials, such as nutrients (nitrogen and phosphorus), lithium, and rare earth elements, which can be recovered as value-added products. Owing to their modularity, convenient operation and control, and the non-requirement of chemical dosage, electrochemical technologies offer a great promise for resource recovery in small-scale, decentralized systems. Here, we review three emerging electrochemical technologies for materials recovery applications: electrosorption based on carbonaceous and intercalation electrodes, electrochemical redox processes, and electrochemically induced precipitation. We highlight the mechanisms for achieving selective materials recovery in these processes. We also present an overview of the advantages and limitations of these technologies, as well as the key challenges that need to be overcome for their deployment in real-world systems to achieve cost-effective and sustainable materials recovery.     

Mortality estimates from repeated visual censuses of a parrotfish (Sparisoma viride) population: demographic implications

Repeated visual censuses of different categories (juveniles, females, territorial and group males) of the stoplight parrotfish (Sparisoma viride, a protogynous hermaphrodite) over a 3-year period indicated a relatively stable size and structure of the adult population. This allowed estimates of size-specific mortality, sex change, and territory acquisition probabilities from previously reported growth rates. Comparison of the predicted number of survivors, sex changers, and territory take overs with field observations indicates that our estimates are quite reliable. However, rather large differences in mortality are obtained for the largest three size classes (>25 cm), which may be due to reduced accuracy of length estimates of large fish. A pooled mortality for these classes is therefore suggested as a more realistic estimate. The life-history implications of our findings are investigated by comparing the predicted survival and future reproductive success of fish that change sex at different sizes. Ten percent of the adults reach an age of ca. 17 years, once a length of 20 cm is attained, as predicted from the pooled estimates. Calculations based on these estimates indicate that the predicted reproductive output of a 15-year-old fish (2500 matings) is the same for early (i.e. at 20 cm) and late (>30 cm) sex changers and for an average fish subject to the estimated daily sex change and territory acquisition probabilities. These findings suggest that S. viride individuals are able to flexibly adjust the timing of sex change in an adaptive way to unpredictable local conditions. However, independent mortality estimates are needed to corroborate our present findings. Received: 2 January 1997 / Accepted: 27 January 1997     

Recycling combustibles from aged municipal solid wastes (MSW) to improve fresh MSW incineration in Shanghai: Investigation of necessity and feasibility

Aged municipal solid wastes (MSW) excavated from landfills and dumpsites were characterized to analyze their fraction composition, moisture content, and lower heat value (LHV). The necessity and feasibility of recycling combustibles from aged MSW to improve the incineration of fresh MSW were investigated. The results showed that combustibles in aged MSW were easily separated from other components and than LHV of the separated combustibles are higher than 11000 kJ/kg. The fresh MSW are of high moisture contents with average LHV below 6500 kJ/kg, making their stable combustion difficult to maintain in MSW incinerators. For both fresh MSW and aged MSW, plastics are the main contributor to their LHV. To improve incineration of fresh MSW that are characterized with low LHV, combustibles separated from aged MSW were made into refuse derived fuel (RDF) pellets and were then added to fresh MSW by 2% wt.–5% wt. LHV variation and air supply resistance change of the MSW layer on the incinerator grate caused by the addition of RDF was checked, and no significant changes were found. No obvious difference was observed for the ‘burn-out time’ between RDF pellets and fresh MSW either. RDF made from aged MSW combustibles is found to be a promising auxiliary fuel to improve the incineration of fresh MSW, and aged MSW from old landfill cells and dumpsites can be finally disposed of jointly with fresh MSW by recycling combustible from the former to be coincinerated with the latter in the incineration plants.     

Secondary sex ratios do not support maternal manipulation: extensive data from laboratory colonies of spiny mice (Muridae: Acomys)

Spiny mice of the genus Acomys (Muridae) represent a very suitable mammalian model for studying factors influencing the secondary sex ratio (SSR). The maternal effort in these rodents is extremely biased in favour of the prenatal period and, therefore, maternal manipulation of the SSR is potentially more advantageous. We studied the SSR in four populations/species of spiny mice kept in family groups consisting of two closely related females, one non-relative male and their descendants. The groups were established from founding animals aged about 3 months (maturing age) and were allowed to breed freely for several months. Each litter was sexed after birth, and relevant data were thoroughly recorded. Altogether, data were collected on 1684 litters: 189 of Acomys sp. from Iran, 203 of A. cilicicus, 875 of A. cahirinus, and 417 of A. dimidiatus. We recorded the sex of 4048 newborns of which 1995 were males and 2053 were females. The overall sex ratio was close to 1:1 (49.2%). Generalized linear mixed models and/or generalized linear models were constructed to evaluate the effect of four life history and eight social variables on the sex ratio. No consistent effects of these variables on the sex ratio were found and, interestingly, none of the variables associated with maternal life history had any effect on the sex ratio. Three factors associated with group composition (i.e. the number of immature males, the number of immature females and the number of breeding females) did have significant effects on the sex ratio, but these effects were not consistent across the studied species. In conclusion, our evaluation of this large dataset revealed that the sex ratio in spiny mice is surprisingly stable.     

Ancient settlement dynamics and predictive archaeological models for the Metapontum coastal area in Basilicata,southern Italy: from geomorphological survey to spatial analysis

In the ancient territory of the Greek settlement of Metaponto and its Chora (Ionian sector of Basilicata, southern Italy) geomorphological mapping, GIS-supported statistics, and landform topographic features were investigated and combined to extract settlement rules and site dynamics. Analyses of environmental dynamics as well as of spatial and temporal settlement evolution were carried through an integrated approach that, starting from a detailed geomorphological analysis, tried to extract the spatial relationships between archaeological site locations and landform/landscape features. Spatial analysis was used to investigate the relationships between environmental parameters and archaeological sites. The advantages to develop a predictive model using Archeological Spatial Evaluation (ASE) analysis lay in the possibility to deeply study the relationships between man and the environment. In the present study, the analysis was carried out in a pioneering way in the ~400 km² Metaponto territory in order to robustly validate - in the aftermath data - human and territorial dynamics. A model describing interactions between sites and parameters such as elevation, slope, aspect, landforms, land use, and distances from rivers was constructed. Sensibility maps were produced, which will help archaeologists to know how many and which are the parameters increasing the probability to find new archaeological sites as well as how the main geomorphological features of the study area, contextualized within the most likely paleoclimate scenario, affect ancient site arrangement though time. The preferential occupation of mid-altitude marine terraces, and the consequence spreading of agriculture on these territories, is likely due to the existence of well-developed soil profiles on them. Clearly colonists recognized that on these landform units there were the better conditions for the development of massive agricultural practices: since the SP age (4,1 to 2,0 Kyr B.P.) the settlers expands inland looking for most fertile territories as well as for areas sufficiently protected (being far away from the coast). The increase in farmhouses on the top of marine terraces from the FC up to EC-EE periods and the modifications of settlement distribution (gradual abandonment of alluvial) in the Metaponto area is likely related to the acceleration of alluvial processes. The progressive decrease of human occupation during the Hellenistic up to the Roman Age is clearly consequence of the Roman conquest. However, a role played by the increase in flooding occurrence in the coastal plain/floodplains of the main rivers in triggering the abandonment of these territories and marking the beginning of the decadent phases should not be neglected. Productive areas (locally associated to farmhouses) are preferential set along the fluvial incisions (sometime associated to farmhouses), thus implying that productive area setting is strongly linked to the presence of rivers, and of their lower rank tributaries, both as an intrinsic need of manufacturing and to facilitate the spreading of products. From the Classical to the Hellenistic Age until the Roman Age, Necropolis are spread in the entire area, from marine terraces to alluvial plain. On the other hand, Sacred areas - which appearance is recorded starting from the Colony Foundation Age - exhibits a settlement continuity in the study area starting from this time up to the entire Roman period, and the sacred areas setting is strictly associated to the category of Settlement.     

Statistical tools for analysing the data obtained from repeated dose toxicity studies with rodents: a comparison of the statistical tools used in Japan with that of used in other countries

In the present study, an attempt was made to compare the statistical tools used for analysing the data of repeated dose toxicity studies with rodents conducted in 45 countries, with that of Japan. The study revealed that there was no congruence among the countries in the use of statistical tools for analysing the data obtained from the above studies. For example, to analyse the data obtained from repeated dose toxicity studies with rodents, Scheffé's multiple range and Dunnett type (joint type Dunnett) tests are commonly used in Japan, but in other countries use of these statistical tools is not so common. However, statistical techniques used for testing the above data for homogeneity of variance and inter-group comparisons do not differ much between Japan and other countries. In Japan, the data are generally not tested for normality and the same is true with the most of the countries investigated. In the present investigation, out of 127 studies examined, data of only 6 studies were analysed for both homogeneity of variance and normal distribution. For examining homogeneity of variance, we propose Levene's test, since the commonly used Bartlett's test may show heterogeneity in variance in all the groups, if a slight heterogeneity in variance is seen any one of the groups. We suggest the data may be examined for both homogeneity of variance and normal distribution. For the data of the groups that do not show heterogeneity of variance, to find the significant difference among the groups, we recommend Dunnett's test, and for those show heterogeneity of variance, we recommend Steel's test.