Key features of new particle formation events at background sites in China and their influence on cloud condensation nuclei

New particle formation (NPF) event at multi rural sites in China Identifying the characteristics of NPF event Comparing NPF event between clean and polluted conditions Quantifying contribution to the cloud condensation nuclei Implication of climate and air quality Long-term continuous measurements of particle number size distributions with mobility diameter sizes ranging from 3 to 800 nm were performed to study new particle formation (NPF) events at Shangdianzi (SDZ), Mt. Tai (TS), and Lin’an (LAN) stations representing the background atmospheric conditions in the North China Plain (NCP), Central East China (CEC), and Yangtze River Delta (YRD) regions, respectively. The mean formation rate of 3-nm particles was 6.3, 3.7, and 5.8 cm⁻³·s⁻¹, and the mean particle growth rate was 3.6, 6.0, and 6.2 nm·h⁻¹ at SDZ, TS, and LAN, respectively. The NPF event characteristics at the three sites indicate that there may be a stronger source of low volatile vapors and higher condensational sink of pre-existing particles in the YRD region. The formation rate of NPF events at these sites, as well as the condensation sink, is approximately 10 times higher than some results reported at rural/urban sites in western countries. However, the growth rates appear to be 1–2 times higher. Approximately 12%–17% of all NPF events with nucleated particles grow to a climate-relevant size (>50 nm). These kinds of NPF events were normally observed with higher growth rate than the other NPF cases. Generally, the cloud condensation nuclei (CCN) number concentration can be enhanced by approximately a factor of 2–6 on these event days. The mean value of the enhancement factor is lowest at LAN (2–3) and highest at SDZ (~4). NPF events have also been found to have greater impact on CCN production in China at the regional scale than in the other background sites worldwide.     

膜生物反应器在污水处理中的应用现状及展望

综述了膜生物反应器（MBR）的研究进展，介绍了其分类及特点、处理机理与MBR运行的影响因素以及膜污染的控制等，并概括了MBR的发展及展望。MBR是近来发展较迅速的一种污水治理设备，具有占地少、能耗低等优点，但也存在一定的缺点，其中膜污染是影响其推广应用的主要因素，目前国内外学者一般都以膜污染作为切入点进行研究，通过改变料液性质、优化操作参数、提高膜清洗效率等方法得以防治膜污染。     

A combined radical and non-radical oxidation processes for efficient degradation of Acid Orange 7 in the homogeneous Cu(II)/PMS system: important role of chloride

Environmental Science and Pollution Research - Trace copper ion (Cu(II)) in water and wastewater can trigger peroxymonosulfate (PMS) activation to oxidize organic compounds, but it only works under...     

硝基苯类废水的预处理技术研究

Fe(OH)2对硝基苯具有强烈的还原作用，短时间内可把硝基苯还原为苯胺。催化铁屑法处理硝基苯类废水，除了包括铁屑法处理废水的各种反应外，还能使硝基苯在其表面直接还原，且反应在弱碱性条件下效果较好。m(Fe)：m(Cu)为10：1，pH为9．5，废水硝基苯进水质量浓度为250mg／L，反应时间为30min，硝基苯的去除率达100％。     

Method of pollution sources assessment in relation to residential site selection

Much investigation supports a high incidence of disease and death rates when people live in ambient polluted air for a long time. Thus, the location of residential sites is important from a public health viewpoint. The method outlined in this paper is useful for determining the location of residential sites based on pollution sources assessment.     

北京市大气中挥发性有机物的组成特征

采用预浓缩—GC-MS方法分析了北京市大气中挥发性有机物(VOCs)的组成,共检测出108种,其主要成分是饱和烷烃(33%)、芳香烃(21%)、烯烃(16%)、卤代烷烃(20%)、卤代烯烃(9%)和卤代芳香烃(1%),总VOCs平均质量浓度为(163 7±39 0)μg m3。更重要的是,在检出物中有54种是有毒有害的物质,主要成分是苯系物和卤代烃,其中苯,甲苯,丙烯,1,3-丁二烯,氯乙烯和1,2-二氯乙烷是含量最高的组分。      

气相色谱法测定二硫化碳和甲硫醚

利用气相色谱(配火焰光度检测器,采用3mxφ2mm玻璃填充柱分离)对CS2和甲硫醚(DMS)两种含硫化合物进行了分离检测。该方法具有较高的灵敏度和良好的线性关系。结果表明:该分析对含硫气体的最小检测浓度在mg/m3级,在柱温为70℃,检测器温度为180℃,气化室温度为150℃,氮气流速为50mL/min时,CS2的回收率为98.66%,变异系数为2.12%;甲硫醚的回收率为98.66%,变异系数为1.56%。     

旋流冲击湿式脱硫除尘器在燃煤锅炉中的应用

本文结合旋流冲击脱硫除尘技术在淄博矿务局的应用，阐述了工作原理，工艺设计，运行结果和技术特点。     

一硫代磷酸酯杀虫剂的酶促降解

从降解菌ＹＦ１１中提取了降解权衡利弊并测定了该降解酶对对硫磷,甲基对硫磷和杀螟松的降解特性。对硫磷和甲基对硫磷酶促降解的最适ｐＨ均为８．０,杀螟松的最适ｐＨ为８．５,最适温度为３２．５℃,该降解酶对对硫磷,甲基对硫磷和杀螟松的米氏常数分别为１８７．２,２０５．５和２１２．４ｍｍｏｌ／ｍｌ。     

悬浮膜(CFM)分离技术在油田废水处理中的应用

应用微电解等技术对油田废水进行预处理,然后用悬浮膜进行分离,使其中的油、微生物和固体物与水相分离,使其达到回注用水要求。重点对CFM分离设备的结构及原理加以介绍,以期推进过滤技术的进步,提高油田废水的处理水平。