循环经济产业园规划与产业政策和相关规划的协调性分析

循环经济产业园规划与相关规划的协调性分析是论证循环经济产业园规划合理性的关键环节之一。以武汉市千子山循环经济产业园为例,通过对该产业园规划与产业政策和相关规划的协调性分析,论证了千子山循环经济产业园规划的合理性,为国内同类产业园规划提供参考。     

电化学开关表面活性剂对芘的可逆增溶作用

表面活性剂增强修复技术(SER)是目前行之有效的有机污染土壤修复技术,但SER技术存在表面活性剂与污染物分离困难、易导致二次污染、成本高等问题.基于此,提出采用具有电化学开关特性的表面活性剂(N,N-二甲基二茂铁甲基十二烷基溴化铵,Fc12)代替SER技术中的常规表面活性剂,发展基于开关表面活性剂的可逆增强修复技术(RSER).选取芘作为目标物,研究了Fc12在氧化和还原态对芘的增溶作用以及常见环境因素,如pH和温度对Fc12可逆增溶的影响.结果表明,相对于氧化态Fc12,还原态Fc12在其临界胶束浓度(CMC)以上时对芘表现出显著的增溶作用,且增溶能力随表面活性剂浓度增大而增强.温度对Fc12的增溶作用影响显著,例如,还原态Fc12在浓度为3 mmol·L~(-1)、25℃条件下时,芘的表观溶解度为0.779 mg·L~(-1),当温度增加到40℃时,芘的表观溶解度为0.971 mg·L~(-1),其表观溶解度增加了24.6%;但氧化态条件下,芘的表观溶解度仅增加了6.5%;芘的解吸率(芘在还原和氧化态Fc12的表观溶解度差值与还原态Fc12增溶芘的比值)由63.67%增加到71.27%.pH也显著影响Fc12的增溶,当pH值在6—10范围变化时,还原态Fc12的增溶作用呈现先增加后减小的趋势,且在pH 9附近增溶能力最强,而pH 8时芘的解吸果最好.     

二氧化锰基纳米材料对重金属离子的去除及机理研究进展

重金属离子对人类健康和环境安全产生了严重威胁,因此重金属废水高效处理成为了环境领域最具挑战性的热点问题之一.二氧化锰(MnO_2)是一种环境友好型金属氧化物,具有来源广泛、成本低廉、形貌多样、晶型丰富、结构稳定、粒径可控等优异的性质,在重金属离子的去除应用上展现出巨大的潜力.近年来,人们利用MnO_2基纳米材料在重金属离子的有效治理方面开展了大量的研究.本文综述了MnO_2基纳米材料在重金属离子环境修复方面取得的研究进展,包括MnO_2的制备和改性方法,MnO_2基纳米材料在水溶液重金属离子去除中的应用及吸附作用机制,并对研究方向进行了总结和展望,旨在为进一步设计合成对重金属离子的吸附去除具有实际应用价值的MnO_2基纳米材料提供参考.     

混合酸溶-电感耦合等离子体发射光谱法测定粉煤灰样品中的微量元素镓

粉煤灰是我国最大的工业固体废弃物之一,准确测定粉煤灰中镓(Ga)的含量对实现粉煤灰的高附加值利用具有重要的意义.通常采用分光光度法测定粉煤灰样品中的Ga,需使用多种有机试剂,易造成环境污染.本文采用电感耦合等离子体发射光谱法(ICP-OES)测定Ga,不使用有机试剂.通过考察HNO_3、HCl、HF、HNO_3-HCl、HNO_3-HF-HClO_4、HNO_3-HF-HCl-HClO_4的溶样效果,确定使用HNO_3-HF-HClO_4溶解样品.本方法的检出限为0.0042μg·g~(-1),相对标准偏差为1.8%,加标回收率为95.4%—106.0%.方法简便、快速,应用于粉煤灰中Ga的分析,结果与X射线荧光光谱法(XRF)的测定值相符.     

山东省农田土壤中拟除虫菊酯类农药污染特征与风险评价

在山东省范围内采集农田表层土壤样品91个,采用气相色谱法分析了7种拟除虫菊酯类农药(SPs)的含量和组成,分析了其分布特征,比较了大田土壤和大棚土壤中该类农药含量的差异,并评价了其生态风险.结果表明,7种拟除虫菊酯类农药总含量(∑_7SPs)范围在0.01—88.51μg·kg~(-1)之间,均值为5.65μg·kg~(-1).与国内其他地区农田土壤相比,山东省农田土壤中拟除虫菊酯含量处于中等偏低水平.山东省各地区的拟除虫菊酯含量存在差异,但组成相近,均是高效氯氟氰菊酯、联苯菊酯和氯氰菊酯的比例较高.部分地区大棚土壤中的含量高于大田土壤.风险评价结果表明,山东省农田土壤个别采样点中甲氰菊酯和高效氯氟氰菊酯具有生态风险,三分之一的采样点存在潜在生态风险,其余采样点不存在生态风险.     

Enhanced triallyl isocyanurate (TAIC) degradation through application of an O3/UV process: Performance optimization and degradation pathways

• UV/O₃ process had higher TAIC mineralization rate than O₃ process. • Four possible degradation pathways were proposed during TAIC degradation. • pH impacted oxidation processes with pH of 9 achieving maximum efficiency. • CO₃^2– negatively impacted TAIC degradation while HCO₃^– not. • Cl^– can be radicals scavenger only at high concentration (over 500 mg/L Cl^–). Triallyl isocyanurate (TAIC, C₁₂H₁₅N₃O₃) has featured in wastewater treatment as a refractory organic compound due to the significant production capability and negative environmental impact. TAIC degradation was enhanced when an ozone(O₃)/ultraviolet(UV) process was applied compared with the application of an independent O₃ process. Although 99% of TAIC could be degraded in 5 min during both processes, the O₃/UV process had a 70%mineralization rate that was much higher than that of the independent O₃ process (9%) in 30 min. Four possible degradation pathways were proposed based on the organic compounds of intermediate products identified during TAIC degradation through the application of independent O₃ and O₃/UV processes. pH impacted both the direct and indirect oxidation processes. Acidic and alkaline conditions preferred direct and indirect reactions respectively, with a pH of 9 achieving maximum Total Organic Carbon (TOC) removal. Both CO₃^2– and HCO₃^– decreased TOC removal, however only CO₃^2– negatively impacted TAIC degradation. Effects of Cl^– as a radical scavenger became more marked only at high concentrations (over 500 mg/L Cl^–). Particulate and suspended matter could hinder the transmission of ultraviolet light and reduce the production of HO· accordingly.     

Degradation of polyacrylamide (PAM) and methane production by mesophilic and thermophilic anaerobic digestion: Effect of temperature and concentration

• PAM degradation in thermophilic AD in comparison with mesophilic AD. • PAM degradation and its impact on thermophilic and mesophilic AD. • Enhanced methane yield in presence of PAM during thermophilic and mesophilic AD. • PAM degradation and microbial community analysis in thermophilic and mesophilic AD. Polyacrylamide (PAM) is generally employed in wastewater treatment processes such as sludge dewatering and therefore exists in the sludge. Furthermore, it degrades slowly and can deteriorate methane yield during anaerobic digestion (AD). The impact or fate of PAM in AD under thermophilic conditions is still unclear. This study mainly focuses on PAM degradation and enhanced methane production from PAM-added sludge during 15 days of thermophilic (55°C) AD compared to mesophilic (35°C) AD. Sludge and PAM dose from 10 to 50 g/kg TSS were used. The results showed that PAM degraded by 76% to 78% with acrylamide (AM) content of 0.2 to 3.3 mg/L in thermophilic AD. However, it degraded only 27% to 30% with AM content of 0.5 to 7.2 mg/L in mesophilic AD. The methane yield was almost 230 to 238.4 mL/g VSS on the 8th day in thermophilic AD but was 115.2 to 128.6 mL/g VSS in mesophilic AD. Mechanism investigation revealed that thermophilic AD with continuous stirring not only enhanced PAM degradation but also boosted the organics release from the sludge with added PAM and gave higher methane yield than mesophilic AD.