Investigation of carbonyl compound sources at a rural site in the Yangtze River Delta region of China

Carbonyl compounds are important intermediates in atmospheric photochemistry, but their primary sources are still not understood well. In this work, carbonyls, hydrocarbons, and alkyl nitrates were continuously measured during November 2011 at a rural site in the Yangtze River Delta region of China. Mixing ratios of carbonyls and hydrocarbons showed large fluctuations during the entire measurement. The average level for total measured volatile organic compounds during the pollution episode from 25th to 27th November, 2011 was 91.6 ppb, about 7 times the value for the clean period of 7th-8th, November, 2011. To preliminarily identify toluene sources at this site, the emission ratio of toluene to benzene (T/B) during the pollution episode was determined based on photochemical ages derived from the relationship of alkyl nitrates to their parent alkanes. The calculated T/B was 5.8 ppb/ppb, significantly higher than the values of 0.2-1.7 ppb/ppb for vehicular exhaust and other combustion sources, indicating the dominant influence of industrial emissions on ambient toluene. The contributions of industrial sources to ambient carbonyls were then calculated using a multiple linear regression fit model that used toluene and alkyl nitrates as respective tracers for industrial emission and secondary production. During the pollution episode, 18.5%, 69.0%, and 52.9% of measured formaldehyde, acetaldehyde, and acetone were considered to be attributable to industrial emissions. The emission ratios relative to toluene for formaldehyde, acetaldehyde, and acetone were determined to be 0.10, 0.20 and 0.40 ppb/ppb, respectively. More research on industrial carbonyl emission characteristics is needed to understand carbonyl sources better.     

粒子图像测速技术在往复隔板絮凝池中的应用

由于往复隔板絮凝池廊道狭窄、絮凝池拐弯水流结构复杂,致使整个流场的量测十分困难。采用了粒子图像测速技术,对其流场进行了量测与相关分析,提高了分析结果的准确性和可靠性。     

基于"3S"和GSM技术的近海溢油监测应用系统研究

介绍了Visual Basic6．0将“3S”和GSM有机集成中的关键技术以及系统实现的溢油面积、溢油量的计算,接收定位,溢油定位连续动态显示,信息查询,联机之间、控制中心与应急单位互相预警等功能。该系统不但为溢油应急提供指导,同时也为溢油事故的仲裁和索赔提供科学依据。     

回收法氧化镁湿法烟气脱硫机理和工艺基础研究

以氧化镁浆液作为吸收液,对空气与SO₂混合气的鼓泡吸收做了全过程的实验观察.测试分析表明,在高效而稳定的脱硫过程中,吸收液的酸化是由HSO₃^-所致;酸化趋势与SO₂水解规律相一致,由初期高pH值下SO₃^2-为主的缓变到低pH值下HSO₃^-为主的剧变;吸收液温度对脱硫率的影响不敏感;MgSO₃相对高的溶解度和易氧化性及MgSO₄良好的水溶性保持了MgO脱硫的高效率(>98%)和高利用率.燃煤烟气脱硫工业试验确认了MgSO₄经吸收液循环可提浓至实验温度(40～50℃)下的饱和浓度而不产生有害影响,脱硫率因脱硫活性物质的富集反而提高,从而显示出回收工艺的技术经济可行性.     

水蒸气电晕放电下的烟气脱硫效果

采用多针-板式电极,在70 m³/h烟气流量范围内,研究了水蒸气浓度、烟气流量、电场强度等因素对不饱和水蒸气正直流电晕放电烟气脱硫率的影响以及水蒸气电晕放电对脉冲放电烟气脱硫率的提高.研究结果表明,实验范围内,按照NH₃∶SO₂摩尔比为2∶1添加NH3的条件下,增加水蒸气流量、增强电场强度、减少烟气流量,烟气脱硫率能提高10%,达到60%左右.同时,水蒸气电晕放电能使脉冲放电的烟气脱硫率提高5%左右,达到90%以上.     

尿素/KMnO4湿法烟气脱硫脱氮的试验研究

采用尿素和KMnO₄配制成的吸收液,在填有金属鲍尔环的柱式喷淋吸收反应器中,对模拟烟气进行湿法烟气同时脱硫脱氮研究.结果表明:采用尿素和KMn0₄配制成的吸收液可以高效地脱除模拟烟气中的SO₂和NO_x,脱硫脱氮率平均分别达到99.6%和62.5%;反应吸收液中主要含有因吸收NOx和SO₂而生成的NO₃-,NO₂-,NH₄+和SO₄2-等离子;NO₃-,NO₂-和NH₄+的生成曲线及尿素的消耗曲线均为线性,其速率常数分别为0.009 1,0.0074,0.091 6和0.950 8 mmol/(L·min).吸收反应为零级反应.      

准好氧填埋工艺氧气浓度对甲烷与二氧化碳浓度的影响研究

构建了准好氧填埋模拟装置,在其产气相对稳定期间,测定填埋装置内不同点位的ψ(O₂),ψ(CH₄)和ψ(CO₂),并用数学模型对ψ(O₂)与ψ(CH₄)和ψ(CO₂)之间的关系进行拟合.结果表明:随着ψ(O₂)的增加,上层ψ(CH₄)呈对数规律下降,而ψ(CO₂)呈线性规律下降;中层ψ(CH₄)和ψ(CO₂)均呈指数规律下降;下层ψ(CH₄)呈指数规律下降,而ψ(CO₂)先保持在34%左右波动,当ψ(O₂)大于1.8%后呈指数规律下降.上层主要为好氧带,ψ(CH₄)低于ψ(CO₂);中层主要为兼氧带,当ψ(O₂)小于5.8%时ψ(CH₄)高于ψ(CO₂),而当ψ(O₂)大于5.8%时ψ(CH₄)低于ψ(CO₂);下层主要为厌氧带,当ψ(O₂)小于2.8%时ψ(CH₄)高于ψ(CO₂),而当ψ(O₂)大于2.8%时ψ(CH₄)低于ψ(CO₂).      

有机气溶胶的来源与形成研究现状

介绍了有机气溶胶来源与形成的研究现状,从有机气溶胶的化学组成特征、一次有机气溶胶的来源和二次有机气溶胶的形成机制论述其研究进展.一次有机气溶胶主要来源于烹调油烟、机动车排放、生物质燃烧、工业或民用燃油锅炉释放出的有机物,还有道路扬尘、沥青、刹车尘、轮胎屑、室外香烟烟雾、以及高等植物蜡、细菌活动和草本植物等.大气中的半挥发性有机物可通过物理和化学吸附形成二次有机气溶胶,一些挥发性有机物可通过气相化学反应转化为低挥发性的物质并形成二次有机气溶胶,其主要前体物是芳香族化合物,如苯、甲苯、二甲苯,以及烯烃、烷烃、环烷烃、萜烯和生物排放的非饱和氧化物.     

What are the disease burden and its sensitivity analysis of workers exposing to Staphylococcus aureus bioaerosol during warm and cold periods in a wastewater treatment plant?

Environmental Science and Pollution Research - Biological treatment in wastewater treatment plants releases high amounts of pathogenic bioaerosols. Quantitative microbial risk assessment is a...     

复合沸石动态膜系统的脱氨效能及其对沸石的同步回收

为同步实现吸附脱氨和微尺寸沸石回收,将沸石与动态膜技术耦合联用,构建了一种复合沸石-动态膜系统,并考察其脱氨和沸石回收效果。在初始氨氮质量浓度为10 mg·L⁻¹条件下,投加10 g·L⁻¹沸石可有效实现氨氮的去除,去除率为67%。吸附动力学和等温模型分析结果表明,该过程符合准二级动力学模型,Langmuir吸附等温模型拟合得到的最大氨氮吸附量为4.12 mg·g ⁻¹。按照1:1的质量比投加沸石与硅藻土,在投加量均为1 g·L⁻¹,流量为40 mL·min⁻¹,支撑膜孔径38 μm下可快速形成动态膜,出水浊度稳定在1 NTU以下,氨氮去除率可达到56%,在脱氨的同时能够实现沸石的有效回收。该研究结果可为复合沸石动态膜系统同步吸附脱氨和吸附材料回收提供参考。