肉类加工废水生物脱氮工艺的工程应用

采用ABRSBR组合工艺开展了大量现场模拟试验及动力学理论研究,最终获得了进一步提高肉类加工废水脱氮效率的措施途径。通过对已建成、正调试、正设计3种情况下肉类加工废水脱氮工艺的研究,表明此脱氮工艺具有良好的工程应用价值。     

富拉尔基区城市垃圾产业化、无害化处理途径的思考

城市垃圾污染问题不容忽视,危害巨大,加强城市垃圾分类,如何进行资源化、产业化、无害化处理是一项利国利民的大事。     

Health risk assessment of heavy metals in Cyprinus carpio (Cyprinidae) from the upper Mekong River

The purposes of this research are to quantify the concentration of heavy metals (Zn, Cu, As, Pb, Cd, and Hg) in the water and fish tissues of common carp (Cyprinus carpio) in the upper Mekong River and to thereby elucidate the potential dietary health risks from fish consumption of local residents. Surface water and fish tissues (gill, muscle, liver, and intestine) from four representative sample areas (influence by a cascade of four dams) along the river were analyzed for heavy metal concentrations. Results revealed that the levels of heavy metals in fish were tissue-dependent. The highest Cu and As levels were found in the liver; the highest Zn and Pb levels occurred in the intestine, and the highest Hg level was found in the muscle. The total target hazard quotient (THQ) value for residents is > 1 for long-term fish consumption, and local residents are, therefore, exposed to a significant health risk. Results from the current study provide an overall understanding of the spatial and tissue distribution of heavy metals in water and fish body along the upper Mekong River under the influence of cascade dams and highlight the potential health risk of As for the local residents of long-term fish consumption.

     

The associations of air pollution exposure during pregnancy with fetal growth and anthropometric measurements at birth: a systematic review and meta-analysis

Environmental Science and Pollution Research - Fetal growth has been demonstrated to be an important predictor of perinatal and postnatal health. Although the effects of maternal exposure to air...     

流动注射分光光度法测定水中铝的含量

以桑色素作显色剂,采用流动注射分光光度法测定水中铝的含量。在桑色素质量浓度为0．8g／L、聚氧乙烯辛基苯基醚体积分数为1．0％、进样环体积为400μL、检测波长420nm的条件下,采用流动注射分光光度法对水中铝的含量进行测定,本方法的线性范围为2～300μg／L,检出限（信噪比为3）为0．124μg／L,相对标准偏差为2．9％,加标回收率为96．4％～101．8％。     

应急处理苯胺污染水源水的粉末活性炭吸附工艺的研究

以浑河水为原水,模拟突发苯胺污染,通过投加粉末活性炭(PAC)进行应急处理的试验研究.试验结果表明:PAC对苯胺的吸附在30 min内能达到80%～90%的吸附容量;PAC对苯胺的吸附等温线符合弗兰德里希(Freundlich)吸附模式,在苯胺的平衡质量浓度为0.030 mg/L时,PAC对其吸附容量约为5 mg/g;比表面积较大的木屑炭对苯胺的吸附效果比煤质炭好,但粒度以300目左右为宜;炭浆浓度越小对苯胺的吸附效果越好;溶液pH以不小于5为最好;絮凝剂最佳的投加顺序是先投加炭浆然后投加絮凝荆;对突发的浑河水苯胺污染,在取水口处投加PAC是十分有效的应急处理措施.     

射流曝气周期活性污泥法脱氮除磷研究

针对零星居民点的污水处理,开发了射流曝气周期活性污泥法工艺.它是一种连续进水、周期性间歇曝气的改良型SBR工艺,也是一种时间程序和空间程序相结合的污水处理工艺,具有良好的脱氮除磷效果.试验表明,在水力负荷4 m3/d,曝气周期为每2 h曝气15 min、静置105 min的条件下,出水COD为48.8～53.5 mg/L,去除率达79.4%～80.5%;出水TN为2.81～3.98 mg/L,去除率达82.4%～89.4%;出水NH3-N为0.36～0.78 mg/L,去除率高达96.4%～98.4%;出水TP为0.63～1.18 mg/L,去除率为67.2%～78.9%,均可达到《城镇污水处理厂污染物排放标准》(GB 18918-2002)中的一级B排放标准.     

土工离心机及振动台发展综述

土工离心机是土力学研究与岩土离心模型试验的重要设备.本文概述了土工离心机工作原理和国内外应用现状,并对离心振动台进行了介绍,最后对土工离心机的发展趋势作了展望.     

三峡库区小江回水区二氧化碳分压的时空变化特征分析

2009年9月～2010年4月在三峡库区与小江交汇的回水区的典型段面测量了该区域水体表层水和水体内部两部分水体中的有关物理化学参数,并利用这些水化学特征值通过水化学平衡模型计算出该区域水体CO2的分压。得出该区域水体中的CO2分压在一定时空范围内的变化特征。并对该区域有关水质参数与CO2的分压进行了相关性分析,得出其相关系数。指出了水体CO2分压与水体碳循环的关系。通过对三峡库区小江流域这一典型回水区域水体的CO2分压的分析研究,可望为三峡库区及其它同类型区域水体的二氧化碳分压研究提供一个分析案例,也为今后进一步从事水库温室效应的研究提供参考     

International trade,carbon leakage,and CO2 emissions of manufacturing industry

Foreign trade drives China’s growth,but as the trade scale continues to expand,the carbon emissions also increase quickly.Based on the industry panel data from 1996 to 2010,this paper calculates carbon emissions of 27manufacturing industries.According to the intensity of carbon emissions,this paper divides the manufacturing sectors into low carbon and high carbon manufacturing industry and then analyzes the carbon emission trends.Next,the paper uses the feasible generalized least square regression to verify the existence of environmental Kuznets curve（EKC）of the manufacturing industry’s carbon.In order to investigate the carbon leakage problem,the regression also includes the interaction term between trade and industrial value added.Our findings are as follows:the carbon emissions of the whole manufacturing industry and low carbon manufacturing industry accord with the EKC curve,but have a linear relationship with the high carbon manufacturing industry;trade reduces the carbon emissions of the whole manufacturing industry and low carbon manufacturing industry,but it increases those of the high carbon manufacturing industry;for the whole manufacturing industry and low carbon manufacturing industry,there is no carbon leakage,but it exists in the high carbon manufacturing industry.On the whole,pollution haven hypothesis does not hold up in China,and China does not need to limit industry foreign trade to reduce the emission of CO₂.But the manufacturing industry will still be the main engine of the economic growth,and therefore our country should make an effective low-carbon policy,introduce advanced technology,increase R&D investment into lowcarbon technologies,and upgrade and transform the original equipment to change the backward mode of production.