Spatial distribution and ecological risk assessment of sediment metals in a highly industrialized coastal zone southwestern Taiwan

Spatial variations of Cr, Cu, Hg, Ni, Pb, and Zn in the surface sediments from 34 stations of the Kaohsiung coastal zone southwestern Taiwan were studied to address the current pollution status, sediment quality, and potential ecological risk. The study revealed that the concentrations of sediment metals in Kaohsiung Harbor were alarmingly high compared to the other region of Kaohsiung coast. The concentrations of Cr, Cu, Hg, Ni, Pb, and Zn in the harbor sediments were as high as 351, 247, 1.93, 61.8, 60.9, and 940 mg kg⁻¹, respectively. The current situation of metal pollution was assessed by different pollution indices and results showed moderate to severe enrichment of Cu, Hg, and Zn in the harbor sediments. According to the degree of contamination, pollution load index, and contamination severity index, the sediments from the inner Kaohsiung Harbor show high degree and high severity of metal contamination, while the rest of Kaohsiung coastal areas show uncontaminated or low-level pollution. Results of mean ERM quotient and potential ecological risk index also indicated that the harbor sediments posed a 49% probability of biological toxicity and very high ecological risk. The toxic units indicated that the negative biological effects of the six metals in the harbor sediments were Zn > Cu > Cr > Ni > Hg > Pb. In contrast to Kaohsiung Harbor as a trap where considerable amount of anthropogenic metal loadings accumulated in sediments, low metal concentrations were observed in most Kaohsiung coastal sediments. It probably resulted from the limited fine-grained sediment deposition. In the wave-dominated Kaohsiung coastal zone, fine-grained sediments associated with polluted metals tend to be easily resuspended and transported offshore via waves and wave-induced currents. The results of this study can provide valuable information for river and coastal zone management.

     

The associations of air pollution exposure during pregnancy with fetal growth and anthropometric measurements at birth: a systematic review and meta-analysis

Environmental Science and Pollution Research - Fetal growth has been demonstrated to be an important predictor of perinatal and postnatal health. Although the effects of maternal exposure to air...     

对苯二甲酸降解菌固定化生物流化床处理精对苯二甲酸废水

采用微生物筛选、纯化技术,获得了降解对苯二甲酸（TA）的YPC—TA1,YPC—TA2,YPC-TA3,YPC—TA44株菌株。将筛选出的TA降解菌固定化,处理初始TA质量浓度为2650mg／L的模拟废水,降解36h后TA去除率达100％。用TA降解芮在生物流化床反应器中处理PTA废水,最佳容积负荷为6.7kg／（m^3·d）。生物流化床反应器可在容积负荷为6．0～6．5kg／（m^3·d）的较佳条件下长周期稳定运行,COD去除率保持在91％左右,TA去除率保持在94％左右。低pH废水冲击和高容积负荷废水冲击时COD,TA去除率均明显下降,恢复正常讲水后3～4d,COD,TA去除率均恢复正常。     

盐效萃取法从电子产品清洗废液中回收异丙醇

用盐效萃取法从电子产品清洗废液中回收片丙醇,考察了碳酸钾水溶液与该清洗废液的质量比对脱水率的影响,测定了异丙醇-水-碳酸钾体系存40℃时的液液相平衡数据,用Pitzer理论和NRTL方程对液液相平衡数据进行了理论计算。结果表明：当质量分数为60．00％的碳酸钾水溶液与该废液的质晕比为2．00时,脱水率高达90．00％;将有机相进行精馏可得到质量分数为99．50％的异丙醇;计算值与实测值接近,水相和有机相的绝对平均偏差分别为0．62％和0．46％。     

活性污泥的固定化及其性能研究

用改进聚乙烯醇-硼酸法将活性污泥制成固定化颗粒,考察了改进聚乙烯醇-硼酸法的最佳条件及固定化颗粒的性能。实验结果表明：改进聚乙烯醇-硼酸法的最佳条件为聚乙烯醇质量分数6．5％、包泥比（包埋剂与活性污泥质量比）1．2：1、二氧化硅质量分数1．5％、活性炭质量分数0．3％、海藻酸钠质量分数0．6％;用最佳条件下制得的固定化颗粒处理模拟化工废水,连续运行15d后的COD去除率达90％以上,且固定化颗粒耐冲击负荷和pH变化能力强;固定化颗粒对模拟化工废水的COD去除速率随进水COD的变化曲线类似于米氏方程所描述的反应初速度随底物浓度的变化规律。     

用生物滴滤床处理H2S和挥发性有机物混合废气

用生物滴滤床（BTF）处理某化工厂污水站的H2S和挥发性有机物（VOCs）混合废气,当废气中H2S质量浓度为120～400mg／m^3、VOCs质量浓度为115～340mg／m^时,运行稳定后H2S和VOCs的去除率为95％和85％。考察了影响BTF运行的循环水水质情况,试验结果表明：加入Na2CO3可使循环水pH控制在3～6;循环水中含盐量、Cl^-质量浓度和SO4^2-质量浓度分别为2200～3300,600～800,1200～1400mg／L,均未达到抑制微生物的水平。     

从6-APA和7-ADCA生产废液中回收苯乙酸

采用溶剂萃取、水法提取等方法从6-氨基青霉烷酸和7-氨基-3-去乙酰氧基头孢烷酸生产废液（简称废液）中回收苯乙酸（PAA）,考察了各种因素对回收效果的影响。实验结果表明：以甲苯为萃取剂,在萃取温度30℃、萃取时间15m in、500mL废液中萃取剂加入量130mL的最佳条件下,萃取率为96.5%;在提取温度为65℃左右、结晶温度低于10℃的条件下,PAA收率大于89%,纯度大于99%;所得PAA产品质量好,可用于青霉素G等医药产品的生产。     

厌氧-好氧生物反应器填埋工艺特性研究

基于生物反应器填埋技术,研究1种填埋场地循环操作的厌氧-好氧生物反应器填埋工艺,设计了该工艺模拟装置并研究了其运行工艺特性.厌氧阶段主要通过渗滤液回灌控制反应器工艺条件,主要试验结果为,pH值,R1在 6周后可上升至6.7～7.8,R2在17周内一直低于6.8;渗滤液COD浓度,R1在13周时下降至10?617 mg/L,R2在5周后上升至60?000 mg/L后长期趋于稳定;填埋气累计产量,R1在8周达到44%,R2几乎不产气.衡量稳定化可以分别采用渗滤液pH、COD浓度及BOD₅/COD的减少率、填埋气的累计产率等指标来判断,并据此转换为好氧填埋运行.好氧阶段主要是通过强制通风来减少恶臭和水分,主要试验结果为,通风19d氨气浓度降为1.16 mg/m³,通风23d后恶臭浓度降为19;通风14d后含水率降为26%.完成此阶段的工艺指标值可依据矿化垃圾开采的最终用途确定.对主要试验数据进行了数值模拟.厌氧-好氧填埋过程的微生物演替经RISA分析,有4个优势菌群,一些兼性菌群在厌氧-好氧阶段起着重要的承前启后作用.     

非点源污染河流的水环境容量估算和分配

通过河流相应集水区内氮磷的各污染源分析(包括农地、畜禽养殖和生活排污等),利用输出系数模型估算各非点源的氮磷投(排)放量和入河量;采用河段氮磷输入-输出平衡关系分析方法,估算河流对氮磷的每月自净量.以此为基础,参照水功能区划所要求的水质目标,提出了水质未超标河段相应集水区的氮磷剩余水环境容量按月估算模型,和水质超标河段相应集水区内氮磷投放削减量的按月估算模型,及其在各污染源之间的分配方案.结果表明,长乐江的总氮和总磷自净量分别达到775.9 t·a^-1和30.9 t·a^-1,自净率分别为28.8%和51.2%.河流对氮磷的自净量不仅受水文生态条件的影响而表现出较大的季节性变化,而且随着污染负荷量本身的增加而提高.按照水功能区划中Ⅲ类水的水质要求,长乐江总氮含量全年超标;各非点源的总氮投(排)放量均须不同程度的削减,削减总量应达到1 581.0　t;氮源削减量分配结果表明,化肥是应削减的最大氮源,要求在河流相应集水区内的化肥氮投放削减量为1 047.4 t·a^-1;而与各种氮源的投排放现状相比,要求削减比例最高的是畜禽养殖的氮排放量,达32.4%.长乐江流域尚有一定的总磷剩余水环境容量(2 335.7 t·a^-1).根据目标水质要求,平水期是各污染源总氮投放需要削减的量最大的时期,丰水期则是总磷剩余水环境容量最小的时期.     

β射线衰减法和重量法测定环境空气中PM10的对比研究

用β射线衰减法和重量法同步测定了2005年乐清市环境空气中PM10日均浓度,实验覆盖了乐清市的各种气象条件和PM10的浓度变化范围,具有一定的代表性.实验结果表明:在同一监测条件下,两种方法的测定结果具有一致性和可比性,β射线衰减法测得的PM10比重量法高,年均值偏高23%;两种方法测得的PM10高度相关,相关系数为0.994,能用回归直线来描述两者之间的关系.