涪陵页岩气田钻井岩屑资源化利用实践

总结了涪陵页岩气田开发初期钻井岩屑采用固化填埋方式处置存在占地面积大且易产生二次污染隐患等问题,因地制宜地探索钻井岩屑的资源化利用。分析了水基岩屑随钻预处理和油基岩屑热脱附技术,结合钻井岩屑的理化性质,开展了水基岩屑脱水后干渣制路基材料、制砖及水泥窑协同处置,油基岩屑灰渣制混凝土、制砖及水泥窑协同处置的探索和实践,基于环境安全、技术稳定可靠、消纳量大的原则,最终形成了涪陵页岩气田钻井岩屑资源化方案:水基岩屑"随钻预处理、水泥窑协同处置",油基岩屑"热脱附、水泥窑协同处置",实现了钻井岩屑的资源化综合利用。     

高含CO2天然气运输管道缓蚀剂的筛选

大多数天然气藏CO2含量为10%~98%,CO2在不同的温度、压力条件下腐蚀极其严重。文章主要针对高含CO2天然气运输管道腐蚀的问题,开展缓蚀剂的筛选,重点开展CO2腐蚀规律研究与实验,评价环境温度、CO2分压、流动速度对腐蚀规律的影响,明确缓蚀剂的影响因素,结合管材的材质,优选评价不同类型的缓蚀剂,缓蚀效率分别为90.53%和92.64%,在管道凝液介质的气相及液相中都有较高的缓蚀效率。通过设计现场加药工艺及制度,监测评价缓蚀剂缓释效果和腐蚀情况,可防止管道运输过程中CO2腐蚀的侵害,长输管线内腐蚀控制良好。     

石油化工企业含苯胺消防污水处理技术研究

针对石油化工企业含苯胺的消防污水,利用基于过氧化氢和氯化铁为氧化剂的深度氧化技术,通过氧化、絮凝、过滤和吸附对消防污水进行处理。实验确定氧化剂的投加量为理论投加量,氧化时间1.0h,消防污水pH值为6.86时,絮凝剂最佳使用浓度约为2%,消防污水中苯胺和COD去除率达到99.5%以上,达到了消防污水处理效果。     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.     

Mitigating Impact of Devils Lake Flooding on the Sheyenne River Sulfate Concentration

Devils Lake is a terminal lake located in northeast North Dakota. Because of its glacial origin and accumulated salts from evaporation, the lake has a high concentration of sulfate compared to the surrounding water bodies. From 1993 to 2011, Devils Lake water levels rose by ~10 m, which flooded surrounding communities and increased the chance of an overspill to the Sheyenne River. To control the flooding, the State of North Dakota constructed two outlets to pump the lake water to the river. However, the pumped water has raised concerns about of water quality degradation and potential flooding risk of the Sheyenne River. To investigate these perceived impacts, a Soil and Water Assessment Tool (SWAT) model was developed for the Sheyenne River and it was linked to a coupled SWAT and CE‐QUAL‐W2 model that was developed for Devils Lake in a previous study. While the current outlet schedule has attempted to maintain the total river discharge within the confines of a two‐year flood (36 m³/s), our simulation from 2012 to 2018 revealed that the diversion increased the Sheyenne River sulfate concentration from an average of 125 to >750 mg/L. Furthermore, a conceptual optimization model was developed with a goal of better preserving the water quality of the Sheyenne River while effectively mitigating the flooding of Devils Lake. The optimal solution provides a “win–win” outlet management that maintains the efficiency of the outlets while reducing the Sheyenne River sulfate concentration to ≤600 mg/L.     

EDTA滴定法测定高锰水体总硬度的干扰和消除

测定水质总硬度最常用的是EDTA 滴定法,该法易受到多种因素的影响,而锰是重要影响因素之一。分析了锰对EDTA滴定法的影响,对比了两种掩蔽剂对不同浓度锰的掩蔽效果和对检测结果的影响。对实验结果进行了总结分析,为EDTA滴定法测定高锰水体总硬度过程中不同掩蔽剂的选择提供一定的依据。     

城市黑臭水体的产生原因及治理对策

在我国经济发展势头如此迅猛的背景下,城市污染问题日益严重。城市黑臭水体对城市生态环境造成严重影响,如果不能及时进行治理,则会对原有水生态循环系统造成破坏,影响城市居民正常生活。本文首先对城市黑臭水体产生原因进行分析,然后提出有效的治理对策。     

不同给水管材对管壁附着生物膜铅、镉的解吸动力学研究

给水管壁生物膜会吸附水中的重金属元素积累在管壁生物膜中,在受到扰动时释放回到水体,危害饮用水水质安全。试验以上海管网末梢水为实验对象,研究了PVC、铸铁和紫铜等三种管材上生物膜对铅、镉的解吸特性。结果表明,PVC、铸铁和紫铜附着生物膜对铅的解吸容量qe分别为:5.92211μmol·m^-2、128.3051μmol·m^-2和21.1808,解吸速率常数k分别为:0.001060 m^2·μmol^-1·min^-1、0.000041 m^2·μmol^-1·min^-1和0.000503 m^2·μmol^-1·min^-1,对于镉元素三种材质的解吸容量qe分别为:14.71519μmol·m^-2、18.50481μmol·m^-2和2.25225μmol·m^-2;解吸速率常数k分别为:0.000102 m^2·μmol^-1·min^-1、0.001070 m^2·μmol^-1·min^-1和0.000103 m^2·μmol^-1·min^-1。     

高温炭化法处理工业废盐工程方案研究

针对工业废盐成分复杂、精制难度高的现状,本文提出了一种工业废盐的资源化工程方案,技术经济分析表明,该工程化方案在技术上、经济上能够实现满足投资、运营要求,具备较好的推广前景。