Comparative study of extraction methods for the determination of PAHs from contaminated soils and sediments

The following four methods were compared on the extraction efficiency of 16 EPA (US Environmental Protection Agency) polycyclic aromatic hydrocarbons (PAHs): German method of the Verband Deutscher Landwirtschaftlicher Untersuchungs und Forschungsanstalten (VDLUFA), two methods of the International Organization for Standardization using shaking (ISO A) and Soxhlet extraction (ISO B) and an ultrasonic method. Recovery rates of 16 PAHs were determined in two soils. Extraction efficiency was evaluated in five soils and three sediments. Effect of drying soils and sediments on extraction efficiency was tested using the VDLUFA and the ultrasonic methods. Our study shows that the number of aromatic rings, rather than extraction procedures, significantly influenced recovery rates of individual PAHs. No significant differences in extraction efficiency of the four methods were observed for less polluted samples. For highly polluted soils, extraction efficiency decreased in the following order: VDLUFA method > ISO A > ultrasonic method > ISO B. Influence of soil moisture on extraction efficiency depended to some extent on both solvent used and content of PAHs in samples. A mixture of dichloromethane/acetone (5:1) is recommended for PAH extraction from moist samples when the ultrasonic method is used.     

纳米级铁粉脱氯降解四氯化碳

四氯化碳的生产和使用，给人类带来了较大危害。为此，采用纳米铁粉这一新方法对其进行脱氯处理。试验以纳米级铁粉对四氯化碳的脱氯率为考察指标，选用L25（5^6）正交试验方案，考察了降解介质的初始pH值、纳米铁粉的质量、降解温度、摇床转速和脱氯时间5个影响因素。结果表明，pH值这一因素有极显著影响；在得出的纳米铁粉对四氯化碳脱氯的最佳工艺条件下，获得了99．5％的脱氯率，为有机氯化物脱氯开辟了一条新途径。     

Biodegradation of phthalate esters by two bacteria strains

In this study two aerobic phthalic acid ester (PAE) degrading bacteria strains, DK4 and O18, were isolated from river sediment and petrochemical sludge, respectively. The two strains were found to rapidly degrade PAE with shorter alkyl-chains such diethyl phthalate (DEP), dipropyl phthalate (DPrP), di-n-butyl phthalate (DBP), benzylbutyl phthalate (BBP) and diphenyl phthalate (DPP) are very easily biodegraded, while PAE with longer alkyl-chains such as dicyclohexyl phthalate (DCP) and dihexyl phthalate (DHP) and di-(2-ethylhexyl) phthalate (DEHP) are poorly degraded. The degradation rates of the eight PAEs were higher for strain DK4 than for strain O18. In the simultaneous presence of strains DK4 and O18, the degradation rates of the eight PAEs examined were enhanced. When the eight PAEs were present simultaneously, degradation rates were also enhanced. We also found that PAE degradation was delayed by the addition of nonylphenol or selected polycyclic aromatic hydrocarbons (PAHs) at a concentration of 1 microg/g in the sediment. The bacteria strains isolated, DK4 and O18, were identified as Sphigomonas sp. and Corynebacterium sp., respectively.     

Photocatalytic oxidation of triclosan

In the spring of 2003, there was an outbreak of the severe respiratory syndrome (SARS) in Hong Kong. Health concerns have thus triggered an increased and predominant use of various types of household cleansing agents such as triclosan (5-chloro-2-(2,4-dichlorophenoxy)phenol). However, it has been reported recently that triclosan could be photochemically converted to toxic 2,8-dichlorodibenzo-p-dioxin (2,8-Cl(2)DD) in the environment. It is therefore necessary to develop environmentally friendly methods for the treatment of triclosan. To this end, photocatalytic degradation of triclosan in aqueous solution was conducted using TiO(2) (Degussa P25) under irradiation of UV light (lambda < 365 nm). It was found that triclosan could be degraded by this approach. Hydrogen peroxide was added to enhance the degradation process, and the optimal initial hydrogen peroxide concentration for triclosan degradation was 0.005% (w/v). Product identification indicated that triclosan oxidation occurred at its phenol moiety and yielded quinone and hydroquinone intermediates. The formation of a dichlorophenol intermediate in triclosan degradation suggested bond-breaking of the ether linkage occurred during the process. Moreover, no chlorinated dibenzo-p-dioxin congener was detected. These findings confirm that the photocatalytic degradation of triclosan is an environmentally friendly process.     

On-road motor vehicle emissions and fuel consumption in urban driving conditions

This paper reports on the analysis of on-road vehicle speed, emission, and fuel consumption data collected by four instrumented vehicles. Time-, distance-, and fuel-based average fuel consumption, as well as CO, HC, NOx, and soot emission factors, were derived. The influences of instantaneous vehicle speed on emissions and fuel consumption were studied. It was found that the fuel-based emission factors varied much less than the time- and distance-based emission factors as instantaneous speed changed. The trends are similar to the results obtained from laboratory tests. The low driving speed contributed to a significant portion of the total emissions over a trip. Furthermore, the on-road data were analyzed using the modal approach. The four standard driving modes are acceleration, cruising, deceleration, and idling. It was found that the transient driving modes (i.e., acceleration and deceleration) were more polluting than the steady-speed driving modes (i.e., cruising and idling) in terms of g/km and g/sec. These results indicated that the on-road emission measurement is feasible in deriving vehicle emissions and fuel consumption factors in urban driving conditions.     

餐饮业外排烹调油烟气的危害及净化方法研究进展

我国快速发展的餐饮业外排的油烟气污染日趋严重,其毒性研究结果表明其中所含的污染物对人体健康有较大危害;油烟气形态及组成的特殊性使其净化处理较困难,国内外研究者针对这一问题相继作出了不少研究,取得了一定程度的进展.但对中国而言,仍然缺乏实用高效的油烟气净化技术.     

Removal of nitrogen and phosphate from wastewater by addition of bittern

Removal of nitrogen and phosphate through crystallization of struvite (MgNH(4)PO(4).6H(2)O) has gained increasing interest. Since wastewaters tend to be low in magnesium relative to ammonia and phosphates, addition of this mineral is usually required to effect the struvite crystallization process. The present study evaluated the feasibility of using bittern, a byproduct of salt manufacture, as a low-cost source of magnesium ions. High reaction rates were observed; the extent of nitrogen and phosphorus removals did not change beyond 10 min. Phosphorus removals from pure solutions with bittern added were equivalent to those obtained with MgCl(2) or seawater. Nitrogen removals with bittern were somewhat lower than with the alternate Mg(2+) sources, however. Application of bittern to biologically treated wastewater from a swine farm achieved high phosphate removal, but ammonia removals were limited by imbalance in the nitrogen:phosphorus ratio.     

A combined radical and non-radical oxidation processes for efficient degradation of Acid Orange 7 in the homogeneous Cu(II)/PMS system: important role of chloride

Environmental Science and Pollution Research - Trace copper ion (Cu(II)) in water and wastewater can trigger peroxymonosulfate (PMS) activation to oxidize organic compounds, but it only works under...     

Kinetic modeling of microbially-driven redox chemistry of radionuclides in subsurface environments: coupling transport, microbial metabolism and geochemistry

Microbial reactions play an important role in regulating pore water chemistry as well as secondary mineral distribution in many subsurface systems and, therefore, may directly impact radionuclide migration in those systems. This paper presents a general modeling approach to couple microbial metabolism, redox chemistry, and radionuclide transport in a subsurface environment. To account for the likely achievement of quasi-steady state biomass accumulations in subsurface environments, a modification to the traditional microbial growth kinetic equation is proposed. The conditions for using biogeochemical models with or without an explicit representation of biomass growth are clarified. Based on the general approach proposed in this paper, the couplings of uranium reactions with biogeochemical processes are incorporated into computer code BIORXNTRN Version 2.0. The code is then used to simulate a subsurface contaminant migration scenario, in which a water flow containing both uranium and a complexing organic ligand is recharged into an oxic carbonate aquifer. The model simulation shows that Mn and Fe oxyhydroxides may vary significantly along a flow path. The simulation also shows that uranium(VI) can be reduced and therefore immobilized in the anoxic zone created by microbial degradation.