The associations of air pollution exposure during pregnancy with fetal growth and anthropometric measurements at birth: a systematic review and meta-analysis

Environmental Science and Pollution Research - Fetal growth has been demonstrated to be an important predictor of perinatal and postnatal health. Although the effects of maternal exposure to air...     

Preparation of biochar catalyst with saccharide and lignocellulose residues of corncob degradation for corncob hydrolysis into furfural

This paper presented a novel process for production of furfural by hydrothermal degradation of corncob over biochar catalyst, in which it was prepared with the recycling degradation solution and lignocellulosic solid residues. The biochar catalyst was papered by lignocellulose residues and concentrated saccharide solution, and then impregnated in 0.5 mol/L sulphuric acid at room temperature for 24 h assisted by the ultrasonic vibration. In the system of recycling, 8.8 % lignocellulose residues and 100 % concentrated saccharide solution from corncob hydrolysis have been recycled. Hydrolysis of corncob was carried out at 180 °C for duration of 170 min over the biochar catalyst. The experimental results have shown that the furfural yield of up to 37.75 % and overall corncob conversion rate of 62.00 % could be achieved under optimum operating conditions for the catalysts preparation and the corncob hydrolysis. It is believed that the acid density of 4.27 mmol/g of biochar catalyst makes the SO₃H groups cleave β-1,4 glycosidic linkages effectively and hydrolyze the cellulose and hemicellulose to water-soluble sugars, as well as to facilitate dehydration of xylose to give the product of furfural.     

Formation of persistent chlorinated aromatic compounds in simulated and real fly ash from iron ore sintering

Effects of carbon concentration and Cu additive in simulated fly ash (SFA) and real fly ash (RFA) on the formation of polychlorinated dibenzofurans (PCDFs), polychlorinated dibenzo-p-dioxins (PCDDs), chlorobenzenes, and polychlorinated biphenyls which were all regarded as persistent chlorinated aromatics in iron ore sintering were investigated. In the annealing process of SFA with various carbon contents, the yield of chlorinated aromatics and the I-TEQ obtained their maximum at 10 wt% carbon content. Active carbon in SFA acted as the carbon source as well as an adsorbent which led to higher production of PCDD/F in solid phase at 10 wt% carbon content. The increase of carbon content will be beneficial on the formation of 2,3,7,8-Chloro-substituted PCDF compared with 2,3,7,8-Chloro-substituted PCDD. In addition, the CuCl₂·2H₂O was a much more powerful catalyst in the formation of chlorinated aromatic compounds compared with elementary Cu, since it served as both a catalyst and a chlorine donor. However, the RFA behaved similarly with SFA with elementary Cu in the formation of chlorinated aromatic compounds. The effect of carbon content and copper additives on formation of 2,3,7,8-chloro-substituted congeners displayed similar characteristics with the tetra- to octa-PCDD/F isomers and even the total PCDD/Fs.     

Measurement of the vertical profile of atmospheric SO2 during the heating period in Beijing on days of high air pollution

This paper reports altitude-resolved concentrations of sulfur dioxide (SO₂) and particulate matter up to 10 microns in diameter (PM₁₀) in the planetary boundary layer of major urban centers during extreme pollution episodes. The concentration of SO₂ was observed continuously from November 24, 2004, to December 4, 2004, in Beijing during the heating period. Fluorescence SO₂ analyzers were used to measure the atmospheric SO₂ concentrations. Four SO₂ analyzers were placed at 4 different levels (8 m, 47 m, 120 m, and 280 m) of the 325-m high meteorological observation tower of the Institute of Atmospheric Physics (IAP), Chinese Academy of Sciences. A maximal SO₂ concentration of 172.3 ppb was measured during this pollution episode, and SO₂ concentration increased with altitude and reached its maximal value at ～50 m. The study also analyzed the meteorological situation before, during, and after the pollution episode.     

磁强化臭氧氧化生化处理二级出水的试验研究

在外加磁场作用下,采用臭氧氧化对青岛某污水处理厂生化处理二级出水进行了处理.考察了臭氧投加量、反应时间、磁场强度对处理效果的影响.经过多次试验得到的最佳运行参数为:臭氧投加量3.5 mg/L;反应时间10 min;磁场强度3 000Gs.外加磁场提高了臭氧氧化的效率,缩短了反应时间.     

新型TCAS吸附树脂对水中Cd2+的吸附去除研究

通过静态吸附试验,研究一种由超分子受体化合物磺化硫杂杯芳烃（TCAS）与树脂结合的产物——新型TCAS吸附树脂对重金属Cd²⁺的吸附去除性能,并初步探讨了吸附机理。试验研究结果表明,TCAS吸附树脂对Cd²⁺的饱和吸附量为14.45 mg/g。当温度为20℃,0.5 g TCAS吸附树脂对10 mL浓度为5 mg/L的Cd²⁺溶液吸附60 min时, Cd²⁺的去除率可达到99%以上。pH值是影响TCAS吸附树脂吸附效果的重要因素,在pH=5～9时,Cd²⁺的去除率随着pH值的升高而增大。在试验范围内,TCAS吸附树脂对Cd²⁺吸附符合Freundlich方程。吸附在TCAS吸附树脂上的Cd²⁺可洗脱回收,TCAS吸附树脂也可再生利用。 TCAS吸附树脂对重金属Cd²⁺的吸附机理主要归因于TCAS对Cd²⁺的络合作用。     

无银催化-分光光度法测定COD的研究

以XS-LP为催化剂,探讨了改进的无银催化HACH法测定污水中COD的系列条件实验。结果表明:在药剂A,B的投配比为1∶2,投加总量为12 g/L的条件下,其准确度、精密度与国标法有较好的可比性,分别小于10%和3%;对实际废水的测量结果与国标回流法的相关系数分别高达0.9951和0.9874,可满足一般环境检测技术规范要求。     

脂肪酰基氨基酸对矿物润滑油生物降解性的影响研究

通过生物降解试验研究了N-月桂酰基谷氨酸、N-月桂酰基甘氨酸、N-月桂酰基丙氨酸和N-油酰基甘氨酸4种脂肪酰基氨基酸对HVI 350矿物润滑油生物降解性的影响,采用高倍电子显微镜分析了生物降解过程中微生物数量和形态变化。结果表明,在矿物润滑油中添加少量脂肪酰基氨基酸后,矿物润滑油的生物降解性能明显改善,且生物降解过程中微生物数量增多、形态发生变化,这可能是脂肪酰基氨基酸增加了微生物的营养,且具有表面活性,有利于细胞的吸收,从而促进了矿物润滑油生物降解。     

DGGE、T-RFLP 、LH-PCR对两种活性污泥的微生物种群多样性分析的比较

采用基于PCR扩增的分子生态技术DGGE、T-RFLP和LH-PCR,对2种典型污水处理系统中的活性污泥（生活污泥、焦化污泥）进行微生物种群多样性分析;并以此比较3种技术的优劣,提出不同应用条件下研究方法的选择依据。根据实验结果：DGGE得到的条带较多,但误差来源也最多;T-RFLP技术较为灵敏,但需要选择适当的内切酶,严格控制酶切条件,并且文库比对误差较大;而LH-PCR操作简单,结果稳定性较高。虽然目前尚无法判断3种方法的准确性,但LH-PCR在活性污泥的微生物种群多样性分析中已显示出潜在优势。     

表面活性剂清洗处理重度石油污染土壤

为了优化表面活性剂清洗处理重度石油污染土壤的方法和具体洗脱条件参数,采集山东省东营市胜利油田污染土壤,研究了阴离子-非离子混合表面活性剂对该土壤中石油类污染物的去除效果。应用化学热洗原理,主要考查了表面活性剂配比、投加量、清洗温度及清洗助剂对去除效果的影响。实验得到的清洗处理最佳条件为：使用LAS与TX-100质量比为8∶2的组合表面活性剂,总表面活性剂浓度为3 g/L,助剂硅酸钠浓度为5 g/L,75℃条件下搅拌1 h。清洗后土壤含油量从20%下降到4.6%,去除率达到76.9%。废水回用实验表明,清洗处理的废水对土壤中石油烃类物质仍有一定的去除效果。废水回用比从30%到100%时,对土壤中石油烃的去除率都可达到55%以上。对废水进行二次回用时仍能去除18.8%的污染物。