Removal of arsenic(III,V) by a granular Mn-oxide-doped Al oxide adsorbent: surface characterization and performance

In order to remove arsenic (As) from contaminated water, granular Mn-oxide-doped Al oxide (GMAO) was fabricated using the compression method with the addition of organic binder. The analysis results of XRD, SEM, and BET indicated that GMAO was microporous with a large specific surface area of 54.26 m^2/g, and it was formed through the aggregation of massive Al/Mn oxide nanoparticles with an amorphous pattern. EDX, mapping, FTIR, and XPS results showed the uniform distribution of Al/Mn elements and numerous hydroxyl groups on the adsorbent surface. Compression tests indicated a satisfactory mechanical strength of GMAO. Batch adsorption results showed that As(V) adsorption achieved equilibrium faster than As(III), whereas the maximum adsorption capacity of As(III) estimated from the Langmuir isotherm at 25 °C (48.52 mg/g) was greater than that of As(V) (37.94 mg/g). The As removal efficiency could be maintained in a wide pH range of 3~8. The presence of phosphate posed a significant adverse effect on As adsorption due to the competition mechanisms. In contrast, Ca²⁺ and Mg²⁺ could favor As adsorption via cation-bridge involvement. A regeneration method was developed by using sodium hydroxide solution for As elution from saturated adsorbents, which permitted GMAO to keep over 75% of its As adsorption capacity even after five adsorption–regeneration cycles. Column experiments showed that the breakthrough volumes for the treatment of As(III)-spiked and As(V)-spiked water (As concentration = 100 μg/L) were 2224 and 1952, respectively. Overall, GMAO is a potential adsorbent for effectively removing As from As-contaminated groundwater in filter application.

     

Measured carbon monoxide concentrations from stock and reduced-emission prototype portable generators operated in an attached garage

There is concern about the hazard of acute residential CO exposures from portable gasoline-powered generators, which can result in death or serious adverse health effects in exposed individuals. To address this hazard, the U.S. Consumer Product Safety Commission has developed low CO emission prototype generators by adapting off-the-shelf emission control technologies onto commercially available generators. A series of tests was conducted to characterize the indoor CO concentrations resulting from portable generators operating in the attached garage of a research house under seven different test house/garage configurations. The tested generators include both unmodified and modified low CO emission prototypes. It was found that CO concentrations varied widely, with peak house CO concentrations ranging from under 10 ppm to over 10,000 ppm. The highest concentrations in the house resulted from operation of the unmodified generator in the garage with the garage bay door closed and the house access door open. The lowest concentrations resulted from operation of a modified low CO emission prototype in the garage with the garage bay door open and the house access door closed. These tests documented reductions of up to 98% in CO concentrations due to emissions from two low CO emission portable generators compared to a stock generator.

Implications: Improper portable generator use has caused 800 U.S. deaths in the past 14 years. Generators operated in attached garages can cause CO to quickly reach deadly levels. Two low-emission prototypes generators were tested and had CO emissions reduced by up to 98%. Low-emission generators can reduce the risk of consumer poisonings and deaths.     

Carbon dioxide emissions from cities in China based on high resolution emission gridded data

Based on the China high resolution emission gridded data (1 km spatial resolution), this article is aimed to create a Chinese city carbon dioxide (CO₂) emission data set using consolidated data sources as well as normalized and standardized data processing methods. Standard methods were used to calculate city CO₂ emissions, including scope 1 and scope 2. Cities with higher CO₂ emissions are mostly in north, northeast, and eastern coastal areas. Cities with lower CO₂ emissions are in the western region. Cites with higher CO₂ emissions are clustered in the Jing-Jin-Ji Region (such as Beijing, Tianjin, and Tangshan), and the Yangtze River Delta region (such as Shanghai and Suzhou). The city per capita CO₂ emission is larger in the north than the south. There are obvious aggregations of cities with high per capita CO₂ emission in the north. Four cities among the top 10 per capita emissions (Erdos, Wuhai, Shizuishan, and Yinchuan) cluster in the main coal production areas of northern China. This indicates the significant impact of coal resources endowment on city industry and CO₂ emissions. The majority (77%) of cities have annual CO₂ emissions below 50 million tons. The mean annual emission, among all cities, is 37 million tons. Emissions from service-based cities, which include the smallest number of cities, are the highest. Industrial cities are the largest category and the emission distribution from these cities is close to the normal distribution. Emissions and degree of dispersion, in the other cities (excluding industrial cities and service-based cities), are in the lowest level. Per capita CO₂ emissions in these cities are generally below 20 t/person (89%) with a mean value of 11 t/person. The distribution interval of per capita CO₂ emission within industrial cities is the largest among the three city categories. This indicates greater differences among per capita CO₂ emissions of industrial cities. The distribution interval of per capita CO₂ emission of other cities is the lowest, indicating smaller differences of per capita CO₂ emissions among this city category. Three policy suggestions are proposed: first, city CO₂ emission inventory data in China should be increased, especially for prefecture level cities. Second, city responsibility for emission reduction, and partitioning the national goal should be established, using a bottom-up approach based on specific CO₂ emission levels and potential for emission reductions in each city. Third, comparative and benchmarking research on city CO₂ emissions should be conducted, and a Top Runner system of city CO₂ emission reduction should be established.     

Determinants of workers’ attitude toward low-carbon technology adoption: empirical evidence from Chinese firms

As the main contribution of China’s carbon emissions, low-carbon production in industrial firms becomes an inevitable choice, and industrial firm employees’ attitudes on low-carbon new technology directly influence the results of low-carbon production. Based on the Unified Theory of Acceptance and Use of Technology model, structural equation modeling was used to analyze the main factors influencing firm staff to accept low-carbon new technology. The study reveals that the employee’s social impact, performance expectation, effort expectations and convenient conditions, and employee characteristics are all main factors affecting their acceptance attitudes on low-carbon new technology. And social influence has the largest effect on employees’ acceptance attitudes toward low-carbon new technology. Accordingly, relevant policy recommendations are put forward for the future research direction.     

湖南省四水流域水沙周期特征及其影响因素分析

采用复小波变换和M K非参数检验的方法分析了湖南省四水流域主要控制站1951~2011年径流量与输沙量周期规律和突变特征。结果表明：(1)湖南四水径流量存在多个波动增加和波动减少的波动变化现象,但无显著变化趋势;而输沙量虽然有一定的波动,但总体上呈波动减少变化态势,而且下降趋势较显著;(2)湘潭站、桃江站和桃源站径流量和输沙量存在20~25 a的第一主周期,而石门站径流量和输沙量的第一主周期不具有一致性,径流量主周期为2 a,输沙量主周期为13 a,但其径流量和输沙量第二、三主周期变化规律相吻合,均为3~5 a的周期;(3)大量的水利工程建设是导致输沙量减少的主要原因,径流量的变化与降水的变化规律较为一致     

Toxicity of sediment cores from Yangtze River estuary to zebrafish (<Emphasis Type="Italic">Danio rerio</Emphasis>) embryos

Toxicity evaluation is an important segment in sediment quality monitoring in order to protect aquatic organisms and human health. The purpose of this study is to assess the toxicity of sediments from three sediment cores in Yangtze River Estuary, China, using the zebrafish (Danio rerio) embryo tests. Fertilized zebrafish eggs were exposed to both whole sediments and sediment organic extracts prepared from collected sediments, in order to provide a comprehensive and realistic insight into the bioavailable toxicity potential of the sediments. As end points, development parameters (mortality, hatching rate, and abnormality) in the developing embryos were recorded during the 96-h exposure. The results showed that some samples increased mortality, inhibited the hatching of embryos, and induced morphological abnormalities. The embryonic toxicities presented serrated changes and irregular distribution with depth, which may be related to hydrodynamic effect and unstable environmental input. However, lethal and sub-lethal effects were more significant at the sub-surface sediments (10～40 cm), which indicated that the pollution is more serious in recent decades.     

Emission Impacts of Electric Vehicles

Alternative vehicular fuels are proposed as a strategy to reduce urban air pollution. In this paper, we analyze the emission Impacts of electric vehicles In California for two target years, 1995 and 2010. We consider a range of assumptions regarding electricity consumption of electric vehicles, emission control technologies for power plants, and the mix of primary energy sources for electricity generation. We find that, relative to continued use of gasoline-powered vehicles, the use of electric vehicles would dramatically and unequivocally reduce carbon monoxide and hydrocarbons. Under most conditions, nitrogen oxide emissions would decrease moderately. Sulfur oxide and particulate emissions would Increase or slightly decrease. Because other areas of the United States tend to use more coal in electricity generation and have less stringent emission controls on power plants, electric vehicles may have less emission reduction benefits outside California.     

Bio-immobilization of Cu and Zn in recirculated bioreactor landfill

Purpose  

To protect the environmental quality of soil, groundwater, and surface water near the landfill site, it is necessary to make an accurate assessment of the heavy metal mobility. This study aims to present the bio-immobilization behavior of heavy metals in landfill and provide some reference suggestion for the manipulation of heavy metal pollution control after closure.     

三苯类废气处理进展

综述了近年来三苯类废气处理所采用的方法,如吸收法、吸附法、催化氧化法、生物法、光催化法和低温等离子体法等,对各种方法的处理机理、处理效果以及优缺点进行了概括和分析,并指出联用技术将是未来的发展方向.     

制药废水有机污染物特性分析与处理

分析了某制药企业废水生物处理站进出水中有机污染物的相对分子质量分布和气相色谱—质谱图谱,提出了根据废水水质特性有针对性地确定制药废水处理工艺的新思路.实验结果表明:进出水中的有机污染物主要是相对分子质量小于1 000的物质,且主要来源于车间5排放的COD比重大、水量小的工段废水;采用旋转蒸馏预处理法处理车间5废水,可使...