连续流双室微生物燃料电池处理工业废水

以实际中药废水作为阳极基质、实际含镉废水作为阴极电解液,构建了连续流双室微生物燃料电池(MFC),考察了其产电性能及对两种废水的处理效果。78 d的运行数据表明:系统可实现最大输出电压417mV、最大体积功率密度11.8 W/m3,最大体积功率密度运行条件下的库伦效率为18.5%;在阳极进水有机物浓度变化较大的情况下,实现了阳极对中药废水中有机物的有效去除,平均COD去除率为81.5%;阴极对含镉废水中Cd2+的去除率为79.4%～84.8%。这表明MFC同步处理中药废水及重金属废水具有一定的可行性。     

磷矿浆催化氧化湿法脱硝研究

采用液相催化氧化NO_x的方法,通过磷矿浆中过渡金属离子的催化作用,达到净化电厂烟气中NO的目的。考察了烟气含氧量、吸收温度、磷矿浆固液比及气体流量对磷矿浆湿法脱硝的影响。结果表明,试验最佳条件为NO进口质量浓度670 mg/m~3、磷矿浆吸收温度25℃、固液比500 g/L、流量0.3 L/min、含氧量20%;优化条件下的磷矿浆脱除效率最高可达88.9%。随着磷矿浆湿法催化氧化脱硝反应的进行,p H值不断下降,导致磷矿浆逐渐失效,需补入新鲜矿浆,维持吸收液的p H值以保证良好脱硝率。     

工业烟气氨法-络合法同时脱硫脱硝

在脱硫脱硝喷淋装置上采用氨法-络合法处理工业烟气。考察了吸收液pH、Fe(Ⅱ)EDTA浓度、初始烟气浓度、液气比对烟气同时脱硫脱硝效果的影响。实验结果表明:吸收液的酸碱度通过影响Fe(Ⅱ)与EDTA的络合形式进而影响NO去除率;SO_2去除率主要受吸收液pH和初始SO_2质量浓度的影响;当吸收液pH大于8、吸收液Fe(Ⅱ)EDTA浓度大于0.100 mol/L、初始SO_2质量浓度小于1 500 mg/m3、初始NO质量浓度为1 200 mg/m3时,SO_2去除率均在95%以上,NO去除率为54%;当液气比由1 L/m3增大至4 L/m3时,有效脱硫时间和有效脱硝时间分别增长了7 min和4 min。     

TiO2载体对Mn-Ce/TiO2催化剂脱硝活性的影响

以TiO₂为载体,选取过渡金属元素Mn为活性组分,稀土金属元素Ce为活性助剂,采用分步共混法制备了Mn-Ce/TiO₂催化剂（活性组分负载量16%）,系统研究了TiO₂载体的晶型和晶粒尺寸对催化剂脱硝活性的影响。实验结果表明：分别以锐钛矿型和金红石型TiO₂为载体制备的催化剂,其低温脱硝活性相差不大,活性组分均以无定型态高度分散于载体中,以金红石型TiO₂为载体制备的催化剂中部分TiO₂转变为锐钛矿型;以不同晶粒尺寸TiO₂载体制备的催化剂的低温脱硝活性相差较大,比表面积较大、晶粒尺寸较小的TiO₂载体制备的催化剂,其脱硝活性低于晶粒尺寸较大的TiO₂载体制备的催化剂。     

Preparation of biochar catalyst with saccharide and lignocellulose residues of corncob degradation for corncob hydrolysis into furfural

This paper presented a novel process for production of furfural by hydrothermal degradation of corncob over biochar catalyst, in which it was prepared with the recycling degradation solution and lignocellulosic solid residues. The biochar catalyst was papered by lignocellulose residues and concentrated saccharide solution, and then impregnated in 0.5 mol/L sulphuric acid at room temperature for 24 h assisted by the ultrasonic vibration. In the system of recycling, 8.8 % lignocellulose residues and 100 % concentrated saccharide solution from corncob hydrolysis have been recycled. Hydrolysis of corncob was carried out at 180 °C for duration of 170 min over the biochar catalyst. The experimental results have shown that the furfural yield of up to 37.75 % and overall corncob conversion rate of 62.00 % could be achieved under optimum operating conditions for the catalysts preparation and the corncob hydrolysis. It is believed that the acid density of 4.27 mmol/g of biochar catalyst makes the SO₃H groups cleave β-1,4 glycosidic linkages effectively and hydrolyze the cellulose and hemicellulose to water-soluble sugars, as well as to facilitate dehydration of xylose to give the product of furfural.     

PbO_2复合电极预处理甲苯二胺废水

通过涂覆—热分解法与电沉积法制备了β-PbO_2/α-PbO_2/SnO_2-Sb2O3/Ti复合电极(PbO_2复合电极),采用X射线衍射(XRD)、扫描电子显微镜(SEM)、循环伏安法(CV)、线性极化法(LSV)和加速寿命试验对电极进行表征。将PbO_2复合电极用于处理甲苯二胺(TDA)废水,考察了电解质浓度、电流密度对TDA降解效果的影响。实验结果表明:α-PbO_2呈梭状,β-PbO_2呈花菜状,多层结构的PbO_2电极利于提高电极的稳定性和活性;PbO_2复合电极的析氧电位(1.9 V)明显高于TDA的氧化电位(1.28 V),其使用寿命长达486 d;在电流密度为60 m A/cm2、Na2SO4质量浓度为10 g/L、电解时间为240 min的条件下,对COD为4 791.74 mg/L、TDA质量浓度为486.4mg/L的废水进行处理,TDA去除率高达97.3%,COD去除率可达88.1%。     

Simulation of dam/levee-break hydrodynamics with a three-dimensional implicit unstructured-mesh finite element model

Dam failures usually cause huge economic and life losses , especially in urban areas where there is a high concentration of inhabitants and economic actors. In order to understand the physical mechanisms of the formation and development of dam-break flooding, lots of efforts have been put into different types of modelling techniques. However, most of existing models are 1D (one-dimensional) or 2D models based on the shallow water equations. In this paper, we present a 3D numerical modelling investigation of dam-break flow hydrodynamics in an open L-shape channel. A newly developed 3D unstructured mesh finite element model is used here. An absorption-like term is introduced to the Navier–Stokes equations in order to control the conditioning of the matrix equation in the numerical solution process and thus improve the stability. A wetting and drying algorithm is used here to allow the free surface height to be treated with a high level of implicitness and stability. The 3D model has been validated by comparing the results with the published experimental data. Good agreement has been achieved at six selected locations. This study shows that the 3D unstructured mesh model is capable of capturing the 3D hydraulic aspects and complicated local flows around structures in simulation of dam-break flows.     

Role of illumination intensity in microcystin development using Microcystis aeruginosa as the model algae

Environmental Science and Pollution Research - Microcystis aeruginosa (M. aeruginosa) is one of the most common genera of cyanobacteria in algal blooms. In the present work, the impact of the...     

强化循环厌氧反应器处理印染废水的中试启动研究

应用自主研制的强化循环厌氧反应器(SCAR)中试规模处理实际印染废水,研究反应器的启动特性。反应器接种厌氧颗粒污泥后启动运行83 d,形成连续内循环并实现了对印染废水处理的高效稳定运行。在进水COD浓度1 000~3 650 mg/L、系统容积负荷0.7~6.4 kg/(m3·d)条件下,废水COD和色度平均去除率分别达到55%和73%。反应器内较高浓度的NH+4-N保证了系统pH的稳定性,350~600 mg/L的NH+4-N浓度没有对强化循环厌氧反应器产生抑制作用,系统内也没有出现VFA(以乙酸计)积累。启动过程中,厌氧颗粒污泥的粒径增大、沉降性能变好。启动实验完成时,反应器内微生物的脱氢酶活性(以TF计)和辅酶F420浓度分别为3.4973 mg/(g·h)和0.1872μmol/g。     

DO浓度对间歇曝气单级自养脱氮系统N2O排放的影响

以单级自养脱氮系统为研究对象,采用有效容积为15 L的SBBR反应器,系统进水NH+4-N浓度约为360 mg/L,控制温度为(30±2)℃,采用间歇曝气方式运行,曝气段DO浓度从2.4~2.6 mg/L逐渐下降到0.9~1.1 mg/L,研究了单级自养脱氮系统的脱氮性能与N2O排放情况。结果表明,反应器曝气段DO浓度从2.4~2.6 mg/L下降到0.9~1.1mg/L,系统TN去除率均达到80%,但在相同运行时间内的TN去除率依次降低,NH+4-N平均反应速率从0.19 mg/(L·min)降低至0.05 mg/(L·min),NO-3-N累计产生量稳定于14.9~16.5 mg/L,NO-2-N浓度在反应器内未产生明显的积累。随着曝气段DO浓度的下降,最大N2O释放速率逐渐降低,N2O累计释放量从73.8 mg下降到61.0 mg,N2O转化率介于2.4%~2.9%。