Investigation of the positive artifact formation during sampling semi-volatile aerosol using wet denuders

Wet denuders are used in several steam-based semi-continuous aerosol monitors to avoid gaseous absorption artifacts and pre-humidify the air stream, while simultaneously allowing measurements of water-soluble gaseous species. Unlike dry denuders, wet denuders saturate the sample air stream with water vapor, which can lead to re-partitioning of water-soluble volatile species to the aerosol phase, thereby causing a positive artifact in aerosol measurements. This paper investigates the magnitude of the positive artifact formation occurring in wet denuders using modeling techniques. Gaseous nitric acid was used as an example of volatile water-soluble gas in both flat and annular wet denuders. We have also verified the occurrence of the positive artifact in a flat wet denuder through a laboratory experiment. The model results indicate that the magnitude of the artifact is rather limited under typical conditions being less than 2.5% of ambient nitric acid concentration for the flat denuder and less than 0.6% for the annular denuder. The magnitude of the artifact increases with condensational sink of the aerosol (i.e. with the mean aerosol size and number concentration) and aerosol water solubility. While the artifact is relatively small in the absolute sense, it could be substantial for aerosol nitrate measurements, especially in ammonia limited conditions, when the concentration of the nitric acid is high and the concentration of nitrate is low. Therefore, we recommend that the artifact is assessed regularly by replacing the wet denuder with a dry denuder.     

ABR反应器的两种快速启动方法对比

ABR反应器的启动是ABR反应器能否高效稳定运行的关键,其影响因素很多。为了更好地实现ABR反应器的启动,提出了通过2种不同启动方法的对比,即1^#反应器采用好氧预挂膜的方法,2^#反应器采用低负荷启动法,得出的结论为,好氧预挂膜启动法的启动时间短,COD去除率高,出水pH稳定,颗粒状污泥生长情况较好,是一种可推广的启动方法。     

生活垃圾加载介质层填埋法对初期渗滤液污染抑制效果研究

以传统卫生填埋柱R2为对照,通过往生物反应器填埋柱R1内加载可渗透反应介质层1和2进行模拟试验,主要探讨了填埋柱R1垃圾渗滤液COD、总氮、氨氮及总磷的变化趋势,探索一种新型的加载介质层垃圾填埋处理方法。试验结果表明,填埋20周后, R1柱COD浓度基本维持在40 000～45 000 mg/L间,约为R2柱的20%～30%;第24周,R1柱总氮和氨氮分别为206.5 mg/L和167.3 mg/L,在16～24周内,R1总氮和氨氮分别约为R2的14.5%～17.5%和36.2%～43.6%;18周时,R1柱总磷达最大值1.704 mg/L,至第24周降为0.673 mg/L, 整个实验过程R1柱总磷约为R2的0.15%～0.56%。     

好氧硝化颗粒污泥膜生物反应器性能和膜污染研究

实验研究了好氧硝化颗粒污泥膜生物反应器AGMBR的处理性能,并将其与活性污泥膜生物反应器ASMBR进行对比,考察了颗粒污泥在减缓膜污染中所起的作用.好氧硝化颗粒污泥膜生物反应器AGMBR连续稳定运行102 d,系统具有良好的去除有机物和同时硝化反硝化能力,在进水COD和NH+4-N浓度分别为500和200 mg/L时,COD、NH+4-N和TN的去除率分别稳定在86%、94%和45%以上.颗粒污泥有效减缓了膜污染,延长了膜清洗的周期,AGMBR中的膜污染以膜孔堵塞为主,占总阻力的64.81%;滤饼层的阻力为2.1×1012m-1,远小于ASMBR中的16.07×10m-1;膜清洗周期是相同条件下ASMBR的2.43倍以上;而且AGMBR内不断有新颗粒生成,维持了AGMBR系统性能和运行的稳定.     

炭纤维载体固定床厌氧发酵启动运行效果实验

以开发高效率、抗冲击性能强的高浓度有机废水沼气发酵技术为目的,用传统的 UASB反应器作为对照,研究了以炭纤维为生物膜载体的固定床厌氧反应器的启动运行效果。反应器进口废水 COD 为 5 000 mg/L, 水力停留时间 (HRT) 由213 h 逐步缩短为35 h,进水有机容积负荷(OLR)由0.56 kg COD/ (m³·d)提到3.45 kg COD/(m³·d)。结果表明,固定床反应器厌氧发酵的效率比对照高,出水 pH 值也比对照稳定;运行到第 50 d 时,固定床厌氧反应器和对照的 COD去除率分别由第 7 d 的36.56%和33.58%上升到87.9%和62.6%;固定床厌氧反应器的容积比产气率最高为1.16 m³/(m³·d),累计产气量为415.59 L,而对照的容积比产气率最高值仅为0.31 m³ /(m³·d),累计产气量为 71.66 L,前者最高容积比产气率和累计产气量分别是后者的3.74倍和5.78倍。固定床厌氧反应器的启动速度、COD 去除率和产甲烷效率显著地高于对照反应器。     

河流泥沙对石油的吸附、解吸规律及影响因素的研究

通过静态（搅拌）实验,研究了河流泥沙对石油乳化油的吸附、解吸和极限残留量变化的基本规律。泥沙对石油乳化油的吸附规律符合Langmuir-Freundlich等温式,吸附与解吸过程不可逆,在清水中不能完全解吸出来。吸附量与油浓度、沙浓度、沙粒径及溶液中的电解质（盐）浓度等因素有关。根据实验资料建立了吸附等温式、解吸方程、极限残留方程、以及吸附量和极限残留量随泥沙粒径的变化关系式。最后对溶液盐度对吸附的影响作了初步探讨。     

氧化塘水质预测研究进展

本文讨论了氧化塘的净化污水机理和水质变化特点。提出了用于进行氧化塘水质预测的二维水质模型。探讨了氧化塘水质预测研究的发展趋势。     

深入学习邓小平理论做好新形势下安全生产工作

１　深入学习邓小平理论,努力维护林业改革与发展的安全环境和林区社会稳定　　深入学习邓小平理论是当前重大而紧迫的任务。当前,林业各项改革正稳步推进,但改革不可能一帆风顺,已经出现了这样那样的问题,也还会出现其它的问题。要解决这些问题,就要求我们深入学习邓小平理论,坚持解放思想、实事求是的思想路线,从改革、发展、稳定的大局出发,做好各项工作。１．１　讲学习,用理论指导实践　　“讲学习、讲政治、讲正气”是今年全党、全国的一项重要工作,是进一步深刻领会邓小平理论的重要举措。“讲学习”冠以“三讲”之首,说…     

Conversion of waste plastics into value-added carbon materials

Plastic pollution is a major environmental issue worldwide, calling for advanced methods to recycle waste plastics in the context of the circular economy. Here we review methods and strategies to convert waste plastics into value-added carbon materials, with focus on sources, properties, pretreatment of waste plastics, and on preparation of carbon materials. Pretreatment techniques include mechanical crushing, plastic stabilization and electrospinning. Carbon materials such as carbon nanotubes, graphene, carbon nanosheets, carbon spheres and porous carbon are prepared by oxygen-limited carbonization, catalytic carbonization, the template-based method, and pressure carbonization. We emphasize the conversion of polyethene terephthalate, polyethylene, polypropylene, polystyrene, halogenated plastics, polyurethane and mixed plastics.

     

微生物絮凝剂的研究与应用进展

微生物絮凝剂是具有广阔应用前景的一种天然高分子絮凝剂，因而引起科学界的高度重视．自７０年代以来，美国和日本等十多个国家已对其进行了详细的研究．本文综述了微生物絮凝剂的研究与应用进展，包括合成絮凝剂的微生物种类、微生物絮凝剂的化学本质、遗传基础和微观结构、微生物絮凝剂的絮凝机理和絮凝能力及其影响因素，微生物絮凝剂的合成条件和提取方法等方面．文中还给出了微生物絮凝剂在污染治理等领域实际应用的若干事例．