Heat dissipation characteristic in the intake grille and radiator of a fuel cell vehicle

ABSTRACT

In this study, a three-dimension (3D) computational model was proposed to investigate the flow and heat transfer characteristics of the intake grilles of two different fuel cell vehicles. The models of the intake grilles were constructed according to the actual sizes of two vehicles, namely, Roewe 950 and Toyota Mirai, considering the heat dissipation unit to simplify the heat transfer model of the vehicle. The results showed that relative to Roewe 950, Mirai intake air flow rate was approximately 10% higher, the heat transfer capacity was approximately 7% higher, and the intake grille area was larger. The coolant outlet temperature of Mirai was lower than that of Roewe 950, which was beneficial for the long term and stable operation of a fuel cell. This comparative study provided guidance for the intake grille and radiator design of fuel cell vehicles. The only difference between fuel cell vehicles on the market and conventional vehicles was that in the former, the internal combustion engine was replaced with a fuel cell stack, which had insufficient heat transfer capacity because of the reducing temperature difference. Increasing the intake grille area and the heat exchange capacity of the radiator were the key issues for the development of fuel cell vehicles. In this study, an optimal window opening angle of the radiator fin of 23° provided a maximal heat transfer coefficient.     

内饰材料发射率对密封舱室热防护效率的影响

目的探究密封舱室热防护效率与其内饰材料表面发射率的关系,分析内饰材料发射率对其表面温度、舱室内温度的影响规律。方法采用自行设计的小型密封舱室和加热测量装置,对内饰材料表面及舱室内温度进行测量。结果当内饰材料发射率为0.09时,内饰表面温度为141.2℃,舱室内平均温度仅为90.8℃;内饰材料发射率为0.91时,内饰表面温度为124.4℃,舱室内平均温度为109.1℃。结论试样表面温度随材料发射率的提高而降低,舱室内部空气平均温度随材料发射率的提高而升高;试样表面温度与舱室空气平均温度的温度差随材料发射率的提高而减小;同时,相同试样表面温度与舱室平均温度的温度差随加热温度的提高而增加。     

低温等离子体协同催化降解废气污染物的研究进展

阐述了低温等离子体协同催化工艺流程与反应机理,探讨了反应温度、废气进口组分、废气中水蒸气含量、气体流速、气溶胶等因素对降解效果的影响。分析认为:一段式低温等离子体协同催化可改变低温等离子体特征及催化剂催化特性,但尚未解决尾气臭氧逃逸、副产物产生及放电稳定性等问题;两段式低温等离子体协同催化可提高污染物分子降解效率并减少尾气臭氧逃逸,但未能有效利用等离子体的能量,气体中的水蒸气、粉尘及反应过程中产生的气溶胶均能影响后置催化剂的催化性能;两段式低温等离子体协同催化已具备工程应用条件,还需配套高效预处理单元以降低废气中水蒸气、粉尘等对催化剂的影响。     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

汕头港水域温排水热扩散的三维数值模拟

本文建立了汕头港水域温排水扩散的三维数学模型，并采用特征差分方法求其解，对该法在三维情况下的稳定作了推导，给出了判断公式，上述模型被应用于汕头热电厂废热水排放的环境影响评价中，实例计算表明，该模型算法程序简单，计算结果合理。     

Synergistic effect of F and triggered oxygen vacancies over F-TiO2 on enhancing NO ozonation

Oxidation-absorption technology is a key step for NO_x removal from low-temperature gas. Under the condition of low O₃ concentration (O₃/NO molar ratio = 0.6), F-TiO₂ (F-TiO₂), which is cheap and environmentally friendly, has been prepared as ozonation catalysts for NO oxidation. Catalytic activity tests performed at 120°C showed that the NO oxidation efficiency of F-TiO₂ samples was higher than that of TiO₂ (about 43.7%), and the NO oxidation efficiency of F-TiO₂-0.15 was the highest, which was 65.3%. Combined with physicochemical characteristics of catalysts and the analysis of active species, it was found that there was a synergistic effect between F sites and oxygen vacancies on F-TiO₂, which could accelerate the transformation of monomolecular O₃ into multi-molecule singlet oxygen (¹O₂), thus promoting the selective oxidation of NO to NO₂. The oxidation reaction of NO on F-TiO₂-0.15 follows the Eley-Rideal mechanism, that is, gaseous NO reacts with adsorbed O₃ and finally form NO₂.     

有机物分子结构与光催化氧化反应活性的关系

从正辛醇－水分配系数与Ｈａｍｍｅｔｔ常数，光催化氧化过程中的光解作用，表面活性剂的微环境效应及取代基的诱导效应等方面，探讨了有机物分子结构与其光催化氧化反应性之间的关系。     

粉煤灰综合利用—制无烟型煤

粉煤灰,又称“烟道灰”,是从燃烧装置的烟道气中收集而得到的细灰.目前,国内外对粉煤灰的综合利用极为重视,但大部分都着眼于建材、建筑和农业等方面,而本发明是将粉煤灰作为型煤的掺合料配制型煤,即将粉煤灰与烟煤、褐煤和泥炭混配,再加入适量的添加剂,混匀后经压力成型制成各种形状的无烟燃料.实践证明,只要灰质、煤质和掺比相匹配,可压制成合格的掺灰型煤,达到“煤掺灰,灰代煤、效益高”的效果.该掺灰型煤,具有反应活性高,燃烧效果好,基本无烟等特点,投资少,见效快,效益高,节约能源等.经试烧证明,燃烧排烟中的各种污染物可消减50%以上,节约煤炭约30%以上,并且,每吨掺灰型煤(按售价每吨100元计算)可增收15—20元.     

Influence of new town development on the urban heat island - The case of the Bundang area

Five new towns have been developed around the Seoul metropolitan area since 1996. However, these new towns generate lots of traffic and related problems in the areas including those new towns and Seoul as a result of increases in population and a lack of ecological-self-sufficiency. Currently, construction of another new town is under deliberation, and what should be a major consider is the notion that the new town be located within a wide, green zone. Many studies have revealed that green space can play an important role in improving urban eco-meteorological capability and air quality. In order to analyze the urban heat island which will be created by the new urban development, and to investigate the local thermal environment and its negative effects caused by a change of land use type and urbanization, Landsat TM images were used for extraction of urban surface temperature according to changes of land use over the last 15 years. These data are analyzed together with digital land use and topographic information. As a study result, it was found the urban heat island of the study area from 198.5 to 1999 rapidly developed which showed a difference of mean temperature above 2.0. Before the Bundang new town construction the temperature of the residential area was the same as a forest, but during the new town construction in 1991 analysis revealed the creation of an urban heat island. The temperature of a forest whose size is over 50% of the investigation area was lowest, and thus the presence of a forest is believed to have a direct cooling effect on the urban environment and its surroundings. The mean temperature of the residential and commercial areas in the study was found to be 4.5 higher than the forest, and therefore this part of land use is believed to be the main factor causing the temperature increase of the urban heat island.     

Decomplexation of Cu-1-hydroxyethylidene-1,1-diphosphonic acid by a three-dimensional electrolysis system with activated biochar as particle electrodes

The feasibility of decomplexation removal of typical contaminants in electroplating wastewater, complexed Cu(II) with 1-hydroxyethylidene-1,1-diphosphonic acid (Cu-HEDP), was first performed by a three-dimensional electric reactor with activated biochar as particle electrodes. For the case of 50 mg/L Cu-HEDP, Cu(II) removal (90.7%) and PO initial pH 7, acid-treated almond shell biochar (AASB) addition 20 g/L, and reaction time 180 min, with second-order rate constants of 1.10 × 10⁻³ and 1.94 × 10⁻⁵ min⁻¹respectively. The growing chelating effect between Cu(II) and HEDP and the comprehensive actions of adsorptive accumulation, direct and indirect oxidation given by particle electrodes accounted for the enhanced removal of Cu-HEDP, even though the mineralization of HEDP was mainly dependent on anode oxidation. The performance attenuation of AASB particle electrodes was ascribed to the excessive consumption of oxygen-containing functionalities during the reaction, especially acidic carboxylic groups and quinones on particle electrodes, which decreased from 446.74 to 291.48 µmol/g, and 377.55 to 247.71 µmol/g, respectively. Based on the determination of adsorption behavior and indirect electrochemical oxidation mediated by in situ electrogenerated H₂O₂ and reactive oxygen species (e.g., •OH), a possible removal mechanism of Cu-HEDP by three-dimensional electrolysis was further proposed.