Heat dissipation characteristic in the intake grille and radiator of a fuel cell vehicle

ABSTRACT

In this study, a three-dimension (3D) computational model was proposed to investigate the flow and heat transfer characteristics of the intake grilles of two different fuel cell vehicles. The models of the intake grilles were constructed according to the actual sizes of two vehicles, namely, Roewe 950 and Toyota Mirai, considering the heat dissipation unit to simplify the heat transfer model of the vehicle. The results showed that relative to Roewe 950, Mirai intake air flow rate was approximately 10% higher, the heat transfer capacity was approximately 7% higher, and the intake grille area was larger. The coolant outlet temperature of Mirai was lower than that of Roewe 950, which was beneficial for the long term and stable operation of a fuel cell. This comparative study provided guidance for the intake grille and radiator design of fuel cell vehicles. The only difference between fuel cell vehicles on the market and conventional vehicles was that in the former, the internal combustion engine was replaced with a fuel cell stack, which had insufficient heat transfer capacity because of the reducing temperature difference. Increasing the intake grille area and the heat exchange capacity of the radiator were the key issues for the development of fuel cell vehicles. In this study, an optimal window opening angle of the radiator fin of 23° provided a maximal heat transfer coefficient.     

内饰材料发射率对密封舱室热防护效率的影响

目的探究密封舱室热防护效率与其内饰材料表面发射率的关系,分析内饰材料发射率对其表面温度、舱室内温度的影响规律。方法采用自行设计的小型密封舱室和加热测量装置,对内饰材料表面及舱室内温度进行测量。结果当内饰材料发射率为0.09时,内饰表面温度为141.2℃,舱室内平均温度仅为90.8℃;内饰材料发射率为0.91时,内饰表面温度为124.4℃,舱室内平均温度为109.1℃。结论试样表面温度随材料发射率的提高而降低,舱室内部空气平均温度随材料发射率的提高而升高;试样表面温度与舱室空气平均温度的温度差随材料发射率的提高而减小;同时,相同试样表面温度与舱室平均温度的温度差随加热温度的提高而增加。     

Sulphate, Nitrogen and Base Cation Budgets at 21 Forested Catchments in Canada, the United States and Europe

To assess the concern over declining base cation levels in forest soils caused by acid deposition, input-output budgets (1990s average) for sulphate (SO₄), inorganic nitrogen (NO₃-N; NH₄-N), calcium (Ca), magnesium (Mg) and potassium (K) were synthesised for 21 forested catchments from 17 regions in Canada, the United States and Europe. Trend analysis was conducted on monthly ion concentrations in deposition and runoff when more than 9 years of data were available (14 regions, 17 sites). Annual average SO₄ deposition during the 1990s ranged between 7.3 and 28.4 kg ha⁻¹ per year, and inorganic nitrogen (N) deposition was between 2.8 and 13.8 kg ha⁻¹ per year, of which 41–67% was nitrate (NO₃-N). Over the period of record, SO₄ concentration in deposition decreased in 13/14 (13 out of 14 total) regions and SO₄ in runoff decreased at 14/17 catchments. In contrast, NO₃-N concentrations in deposition decreased in only 1/14 regions, while NH₄-N concentration patterns varied; increasing at 3/14 regions and decreasing at 2/14 regions. Nitrate concentrations in runoff decreased at 4/17 catchments and increased at only 1 site, whereas runoff levels of NH₄-N increased at 5/17 catchments. Decreasing trends in deposition were also recorded for Ca, Mg, and K at many of the catchments and on an equivalent basis, accounted for up to 131% (median 22%) of the decrease in acid anion deposition. Base cation concentrations in streams generally declined over time, with significant decreases in Ca, Mg and K occurring at 8, 9 and 7 of 17 sites respectively, which accounted for up to 133% (median 48%) of the decrease in acid anion concentration. Sulphate export exceeded input at 18/21 catchments, likely due to dry deposition and/or internal sources. The majority of N in deposition (31–100%; median 94%) was retained in the catchments, although there was a tendency for greater NO₃-N leaching at sites receiving higher (<7 kg ha^-1 per year) bulk inorganic N deposition. Mass balance calculations show that export of Ca and Mg in runoff exceeds input at all 21 catchments, but K export only exceeds input at 16/21 sites. Estimates of base cation weathering were available for 18 sites. When included in the mass balance calculation, Ca, Mg and K exports exceeded inputs at 14, 10 and 2 sites respectively. Annual Ca and Mg losses represent appreciable proportions of the current exchangeable soil Ca and Mg pools, although losses at some of the sites likely occur from weathering reactions beneath the rooting zone and there is considerable uncertainty associated with mineral weathering estimates. Critical loads for sulphur (S) and N, using a critical base cation to aluminium ratio of 10 in soil solution, are currently exceeded at 7 of the 18 sites with base cation weathering estimates. Despite reductions in SO₄ and H⁺ deposition, mass balance estimates indicate that acid deposition continues to acidify soils in many regions with losses of Ca and Mg of primary concern. The U.S. Government's right to retain a non-exclusive, royalty free licence in and to any copyright is acknowledged. The Canadian Crown reserves the right to retain a non-exclusive, royalty free licence in and to any copyright.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

Monitoring of diazinon concentrations and loadings,and identification of geographic origins consequent to stormwater runoff from orchards in the Sacramento River watershed,U.S.A

Diazinon contamination of California's rivers has resulted in placing several rivers on the federal Clean Water Act § 303d list of impaired waterways. Impaired water body listing requiresthe development of Total Maximum Daily Loads (TMDL). Previous studies identified stormwater related diazinon pulses in California rivers. This study was conducted to monitor diazinonconcentrations in the Sacramento River watershed after rainfallevents, to ascertain whether pulses could be identified and, ifconcentrations of concern were observed, to estimate loadings anddetermine geographic origins of the insecticide. TMDL developmentrequires knowledge of contaminant sources, loadings, and geographic origins. Flow and diazinon concentrations peaked in the Sacramento River at Sacramento after the three largest stormsduring January and February 1994. Diazinon concentrations peakedconsequent to each of three storms. Diazinon concentrationsmeasured in the Sacramento River at Sacramento exceeded theCalifornia Department of Fish and Game acute and chroniccriteria for protection of aquatic life during January andFebruary for nine and nineteen days, respectively. Multipleexceedances were observed throughout the watershed. Diazinon loading and geographic origin differed with each of the three storms. The design of this study provides a useful template for others attempting to identify loadings and sources of contaminants in surface waters and to rectify aquatic ecosystemcontamination from various land use practices.     

汕头港水域温排水热扩散的三维数值模拟

本文建立了汕头港水域温排水扩散的三维数学模型，并采用特征差分方法求其解，对该法在三维情况下的稳定作了推导，给出了判断公式，上述模型被应用于汕头热电厂废热水排放的环境影响评价中，实例计算表明，该模型算法程序简单，计算结果合理。     

确定不同保证率下的中国酸沉降临界负荷

在进行中国酸沉降临界负荷区划时 ,通常以 1°× 1°(经纬度 )的网格为单位进行计算 ,难以反映网格内不同生态系统对酸沉降敏感性的差异 .为了便于决策者根据临界负荷确定酸沉降控制对策 ,也为了使 1°× 1°的结果更具代表性和实用性 ,本研究确定了 0 1°× 0 1°网格为单位计算的中国酸沉降临界负荷 ,并在此基础上通过引入保证率的概念 ,得到了一系列与一定的经济技术水平相适应的、允许有一定损失的 1°× 1°的中国酸沉降临界负荷图 .利用累积分布函数 ,本研究还确定了不同保证率下的中国酸沉降超临界负荷分布和各省、市、自治区的酸沉降临界负荷 .     

Influence of new town development on the urban heat island - The case of the Bundang area

Five new towns have been developed around the Seoul metropolitan area since 1996. However, these new towns generate lots of traffic and related problems in the areas including those new towns and Seoul as a result of increases in population and a lack of ecological-self-sufficiency. Currently, construction of another new town is under deliberation, and what should be a major consider is the notion that the new town be located within a wide, green zone. Many studies have revealed that green space can play an important role in improving urban eco-meteorological capability and air quality. In order to analyze the urban heat island which will be created by the new urban development, and to investigate the local thermal environment and its negative effects caused by a change of land use type and urbanization, Landsat TM images were used for extraction of urban surface temperature according to changes of land use over the last 15 years. These data are analyzed together with digital land use and topographic information. As a study result, it was found the urban heat island of the study area from 198.5 to 1999 rapidly developed which showed a difference of mean temperature above 2.0. Before the Bundang new town construction the temperature of the residential area was the same as a forest, but during the new town construction in 1991 analysis revealed the creation of an urban heat island. The temperature of a forest whose size is over 50% of the investigation area was lowest, and thus the presence of a forest is believed to have a direct cooling effect on the urban environment and its surroundings. The mean temperature of the residential and commercial areas in the study was found to be 4.5 higher than the forest, and therefore this part of land use is believed to be the main factor causing the temperature increase of the urban heat island.     

钢绞线逐根张拉下锚墩基床沉陷所致锚索预应力损失问题

在预应力锚索锚墩下部地基岩土的基床系数较低情况下,采用钢绞线逐根张拉来施加预应力会导致较大的预应力损失以及各钢绞线较显著的预应力不均。基于锚墩基床岩土体的弹性压缩模型,理论探讨了钢绞线逐根对称循环张拉下的锚索预应力损失,及钢绞线的预应力均匀性问题。分析表明,基床系数越低,逐根张拉下的锚索预应力损失越大,且其所含各钢绞线预应力的均匀性越差;而同样荷载和基床系数下,锚索所含钢绞线根数越多, 逐根张拉后的预应力损失和不均匀性也越大。但采用分级循环张拉、正序张拉及调整、锚墩下部一定扩散角填石等工序及措施有助于减轻预应力损失和解决不均匀性问题。     

用预先热处理的材料加工长杆高强度双头螺柱

用预先热处理的材料生产长杆高强度双头螺柱新工艺 ,消除了长杆的热处理变形 ,降低了机械性能的不稳定性 ,提高了产品质量及螺纹联接的可靠性。