利用下水管网系统净化城市污水的中试研究

采用充纯氧及固定化细胞技术在２７５．５ｍ市政下水管网系统中进行了日处理１５００ｍ＾３污水的中试。对单纯充氧、充氧加固定化细胞二种工艺及不同 氧量刊物了比较研究。结果表明,在加固定化细胞条件下,充纯氧（Ｖ（Ｏ２）：Ｖ（Ｈ２Ｏ）＝０．０７８：１）可使流过此段管道的污水的污染物去除６５％以上,基本达到国家污水综合排放二级标准。     

Identifying and modeling key trade-offs between hydrogen fuel cell and electric vehicles

Through a sensitivity analysis, the trade-off between vehicle range and CO₂ emissions is investigated as a function of electric emissions coefficient. Various powertrains were analysed for use in a small crossover sport utility vehicle. Gasoline, gasoline electric hybrid, diesel, fuel cell and battery electric vehicles (BEVs) were considered. Using various upstream fuel pathways and a model for vehicle performance, emissions and energy use were estimated. The hydrogen fuel cell vehicle was found preferable to BEVs under conditions of high CO₂ emissions per kW-hr and a high vehicle range requirement. The BEV was preferable for all other conditions.     

微生物-光-电化学耦合技术降解污染物和回收能源的研究进展

微生物电化学技术能同时实现污染物去除和能量回收,但存在污染物去除种类有限及产能效率低的局限,近几年将可再生的太阳能引入微生物电化学技术的微生物-光-电化学耦合技术应运而生。本文简要介绍了微生物-光-电化学耦合技术的发展背景和研究现状,对该技术现有的耦合形式进行分类,并对各种形式的耦合机理进行详细的阐释,最后对其未来的发展进行了展望。     

连续流双室微生物燃料电池处理工业废水

以实际中药废水作为阳极基质、实际含镉废水作为阴极电解液,构建了连续流双室微生物燃料电池(MFC),考察了其产电性能及对两种废水的处理效果。78 d的运行数据表明:系统可实现最大输出电压417mV、最大体积功率密度11.8 W/m3,最大体积功率密度运行条件下的库伦效率为18.5%;在阳极进水有机物浓度变化较大的情况下,实现了阳极对中药废水中有机物的有效去除,平均COD去除率为81.5%;阴极对含镉废水中Cd2+的去除率为79.4%～84.8%。这表明MFC同步处理中药废水及重金属废水具有一定的可行性。     

A real-time simulating non-isothermal mathematical model for the passive feed direct methanol fuel cell

In order to understand the complex transport phenomena in a passive direct methanol fuel cell (DMFC), a theoretical model is essential. The analytical model provides a computationally efficient framework with a clear physical meaning. For this, a non-isothermal, analytical model for the passive DMFC has been developed in this study. The model considers the coupled heat and mass transport along with electrochemical reactions. The model is successfully validated with the experimental data. The model accurately describes the various species transport phenomena including methanol crossover and water crossover, heat transport phenomena, and efficiencies related to the passive DMFC. It suggests that the maximum real efficiency can be achieved by running the cell at low methanol feed concentration and moderate current density. The model also accurately predicts the effect of various operating and geometrical parameters on the cell performance such as methanol feed concentration, surrounding temperature, and polymer electrolyte membrane thickness. The model predictions are in accordance with the findings of the other researchers. The model is rapidly implementable and can be used in real-time simulation and control of the passive DMFC. This comprehensive model can be used for diagnostic purpose as well.     

隔膜压滤机滤室最优空腔厚度

利用UG软件对隔膜压滤机滤室内流体进行三维建模,导入Gambit中进行网格划分及边界条件的设定,结合Fluent选用RNG k-ε湍流模型,采用多孔介质模型模拟隔膜压滤机滤室内固-液两相流分离,得到不同空腔厚度下滤室内流体的体积分数轮廓图、压强云图,得出滤饼含水率与空腔厚度大小的关系。实验结果表明,模拟和实验结果具有较好的一致性。在压滤机滤室空腔厚度为12 mm时,滤饼含水率为48%,每天污泥处理量为102 t,隔膜压滤机工作效率最高。     

MFC强化同步短程硝化反硝化工艺的启动

微生物燃料电池(MFC)可在阴极实现反硝化、短程反硝化和同步硝化反硝化并产生电能,但在MFC阴极实现同步短程硝化反硝化的研究尚未见到报道。为了探讨MFC阴极同步短程硝化反硝化工艺的性能,将双室曝气阴极MFC与A/O脱氮工艺结合处理人工模拟低碳氮比废水。通过静置运行15 d使得MFC阴极室亚硝态氮得以积累,氨氧化菌得以富集。随即改为连续运行后第21天成功启动同步短程硝化反硝化MFC;阴极出水氨氮浓度为0.3 mg/L,亚硝态氮浓度为15.9 mg/L,硝态氮浓度为0.6 mg/L,亚硝化率达到95%以上,阴极电极自养反硝化去除率达到50%以上,COD去除率达到85%以上。结果表明,将MFC与同步短程硝化反硝化工艺结合,通过阴极室中氧气得电子获得高p H,可以强化同步短程硝化反硝化工艺,完成生物脱氮的同时回收电能,并具有减少外加碱度的优势。     

不同好氧预处理方式对餐厨垃圾产甲烷的影响

为了研究不同好氧预处理方式对餐厨垃圾厌氧消化产甲烷的影响,通过建立3个模拟厌氧生物反应器,研究了传统厌氧生物反应器C1、上层好氧预处理-厌氧生物反应器C2和底部好氧预处理-厌氧生物反应器C3 3种不同操作条件下的产甲烷过程.结果表明,挥发性有机酸的累积使C1始终处于产甲烷滞后阶段;而C2、C3的好氧预处理通过加快易水解酸化组分和过量挥发性有机酸的好氧降解,有效缓解了酸性抑制,产甲烷滞后时间明显缩短至10 d内.第32天C2停止上层曝气后,在27 d内甲烷浓度达到了50％以上,同时,产甲烷速率迅速上升,并在第81天可达到峰值773 mL/(kg·d).C3在第11天停止底部曝气后,虽然经过22 d的时间甲烷浓度即上升至50％,但之后产甲烷速率经历回落阶段后再次逐渐上升,在实验结束时仅达到517 mL/(kg·d).上层曝气的好氧预处理方式所需曝气时间相对较长,但其产甲烷启动快,与底部曝气相比,其后期的甲烷化过程更稳定并可达到较高的产甲烷速率.     

电袋复合除尘器设计若干问题的探讨

介绍了电袋复合除尘器设计过程中烟气量的核实方法、电区与袋区分级效率的确定原则、电区与袋区主要技术参数的确定方法、滤料选取、气流分布要求等内容,对电袋复合除尘器的选择与设计具有一定的参考作用。     

生物滴滤器去除挥发性有机物的影响因素

生物滴滤器用于处理挥发性有机物,有机物的去除效率受到许多因素的影响。总结和讨论了填料、营养液、进气等诸多因素对生物滴滤器性能的影响。这些讨论结果有助于在生物滴滤器实际应用中选择合适的设计和操作条件,从而达到更佳的处理效果。