高炉渣对Cd~(2+)的吸附性能

采用包头钢铁集团炼铁厂的高炉渣为吸附剂(粒径0.154 nm)对Cd2+进行吸附,运用SEM技术对吸附剂进行了表征,研究了初始Cd2+质量浓度、吸附剂加入量、吸附时间、吸附温度和废水pH对Cd2+去除率的影响,并探讨了吸附机理。表征结果显示:高炉渣吸附剂具有疏松多孔的特点,表面十分粗糙,比表面积较大。实验结果表明:当吸附温度为室温(28℃)、废水pH为7、初始Cd2+质量浓度为10 mg/L、吸附剂加入量为8 g/L、吸附时间为60 min时,Cd2+去除率达到98.55%;高炉渣对Cd2+的吸附符合拟二级动力学方程和Langmuir等温吸附模型,且吸附反应易发生。     

大肠杆菌吸附-化学还原法用废含金催化剂制备金纳米线

采用大肠杆菌吸附-化学还原法,以大肠杆菌(ECCs)为模板、十六烷基三甲基溴化铵为保护剂、抗坏血酸为还原剂,由废含金催化剂制备金纳米线(AuNWs)。采用XRD,SEM,TEM等技术对AuNWs进行表征。研究了AuNWs对罗丹明6G(R6G)和4-巯基苯甲酸(4-MBA)的拉曼散射信号的增强效果。实验结果表明:在制备过程中加入微生物ECCs,可使金回收率提高约20百分点;当溶液pH小于4时,反应2 h后,有大量呈线状的AuNWs聚集沉降,金回收率可达99%1以上。表征结果显示,AuNWs呈多晶结构,晶格间距为0.23 nm。表面增强拉曼散射分析表明,AuNWs对R6G和4-MBA具有良好的拉曼光谱增强性能。     

纳米铁氧化物吸附处理重金属废水的研究进展

概述了用于吸附重金属的主要纳米铁氧化物的种类及其吸附效果,介绍了常见的纳米铁氧化物制备方法及改性方法,讨论了影响纳米铁氧化物吸附重金属的主要因素,并对纳米铁氧化物在水环境保护领域中的研究方向提出了展望:如发展绿色、高效的纳米铁氧化物制备工艺,探讨纳米铁氧化物结构调控和表面功能化对其吸附性能的影响等。     

碱熔融—微波晶化法合成粉煤灰沸石及其对Cd2+的吸附

以粉煤灰为主要原料,采用碱熔融—微波晶化法合成粉煤灰沸石。采用XRD,SEM,TEM等技术表征了粉煤灰沸石的微观结构,并对其吸附Cd²⁺的性能进行了研究。表征结果显示,粉煤灰沸石主要由X型沸石、P型沸石和铝组成,粉煤灰沸石中有排列规则、呈蜂窝状的孔穴和孔道存在,其孔穴和孔道大小分布均匀,致密。粉煤灰沸石的比表面积为108.49 m²/g,平均孔径为3.779 nm,孔体积为0.221 mL/g。实验结果表明,在溶液pH为7、吸附时间30 min的最佳吸附条件下,Cd²⁺去除率均大于94%。粉煤灰沸石对Cd²⁺的吸附可很好地用二级动力学方程进行拟合,相关系数为0.999 99。可用Langmuir等温吸附模型描述该吸附过程,该吸附过程是单分子层吸附,主要是化学吸附,粉煤灰沸石对Cd²⁺的饱和吸附量为49.261 mg/g。     

Responses of alkaline phosphatase activity to wind-driven waves in a large, shallow lake: Implications for phosphorus availability and algal blooms

Phosphorus is a vital nutrient for algal growth, thus, a better understanding of phosphorus availability is essential to mitigate harmful algal blooms in lakes. Wind waves are a ubiquitous characteristic of lake ecosystems. However, its effects on the cycling of organic phosphorus and its usage by phytoplankton remain poorly elucidated in shallow eutrophic lakes. A mesocosm experiment was carried out to investigate the responses of alkaline phosphatase activity fractions to wind waves in large, shallow, eutrophic Lake Taihu. Results showed that wind-driven waves induced the release of alkaline phosphatase and phosphorus from the sediment, and dramatically enhanced phytoplanktonic alkaline phosphatase activity. However, compared to the calm conditions, bacterial and dissolved alkaline phosphatase activity decreased in wind-wave conditions. Consistently, the gene copies of Microcystis phoX increased but bacterial phoX decreased under wind-wave conditions. The ecological effects of these waves on phosphorus and phytoplankton likely accelerated the biogeochemical cycling of phosphorus and promoted phytoplankton production in Lake Taihu. This study provides an improved current understanding of phosphorus availability and the phosphorus strategies of plankton in shallow, eutrophic lakes.     

三维有机LDH的制备及其对有机物的普适性吸附

以表面活性剂十二烷基硫酸钠(SDS)为软模板剂,制得有机三维花状层状双金属氢氧化物(3D-SLDH).采用X射线衍射(XRD)、扫描电子显微镜(SEM)、X射线能谱仪(EDS)和N2吸附-脱附等表征手段对3D-SLDH的结构进行表征,确定最佳合成尿素浓度,并通过静态吸附实验考察了3D-SLDH对金橙Ⅱ(AO7)、罗丹明...     

Improved performance of a biomaterial-based cation exchanger for the adsorption of uranium(VI) from water and nuclear industry wastewater

The amine-modified polyhydroxyethylmethacrylate (poly(HEMA))-grafted biomaterial (tamarind fruit shell, TFS) carrying carboxyl functional groups at the chain end (PGTFS-COOH) was prepared and used as an adsorbent for the removal of uranium(VI) from water and nuclear industry wastewater. FTIR spectral analysis revealed that U(VI) ions and PGTFS-COOH formed a chelate complex. The adsorption process was relatively fast, requiring only 120 min to attain equilibrium. The adsorption kinetic data were best described by the pseudo-second-order equation. The equilibrium adsorption data were correlated with the Sips isotherm model. The maximum U(VI) ions uptake with PGTFS-COOH was estimated to be 100.79 mg/g. The complete removal of 10 mg/L U(VI) from simulated nuclear industry wastewater was achieved by 3.5 g/L PGTFS-COOH. The reusability of the adsorbent was demonstrated over 4 cycles using NaCl (1.0 M) + HCl (0.5 M) solution mixture to de-extract the U(VI). The results show that the PGTFS-COOH tested is very promising for the recovery of U(VI) from water and wastewater.     

Leaching,mobility and persistence of tebufenozide in columns packed with forest litter and soil

Abstract

Leaching, downward mobility and persistence of tebufenozide was investigated under laboratory conditions in columns packed with forest litter and soil, after fortification with the analytical grade material (purity > 99.6%) and with two commercial formulations, RH‐5992 2F (aqueous flowable) and RH‐5992 ES (emulsion suspension). Two types of litter and soil were used: one type with relatively high amounts of sand and the other with high amounts of clay.

The concentrations eluted in the leachates were lower when the analytical material (dissolved in acetone) was used for fortification, than when the two formulations (diluted with water) were used. The amount leached was higher for RH‐5992 2F than for RH‐5992 ES. The type of substrate, i.e., sandy or clay type, had only marginal influence on the amounts eluted in the leachates. Downward movement of tebufenozide from the top 2‐cm layer to the untreated middle and bottom layers (3‐cm segments) was consistently lower when the analytical material was used for fortification, than when the two formulations were used. Downward movement was higher for RH‐5992 2F than for RH‐5992 ES. Persistence of tebufenozide in substrates, maintained under submerged conditions for 70 days after leaching, indicated an initial 2‐week lag period prior to the onset of degradation. Formulation‐related differences were observed in the half‐life (DT₅₀) values. When the analytical material was used for fortification, the DT₅₀ ranged from ca 54 to 59 d. However, when the formulations were used for fortification, the DT₅₀ showed a higher range, i.e., from ca 62 to 67 d for RH‐5992 2F and ca 70 to 80 d for RH‐5992 ES. Formulation ingredients appear to have caused enhanced adsorption of tebufenozide onto the substrates, thus delaying degradation.     

Aflatoxin decomposition in various soils

Abstract

The persistence of aflatoxin in the soil environment could potentially result in a number of adverse environmental consequences. To determine the persistence of aflatoxin in soil, ¹⁴C‐labeled aflatoxin B₁, was added to silt loam, sandy loam, and silty clay loam soils and the subsequent release of ¹⁴CO₂ was determined. After 120 days of incubation, 8.1% of the original aflatoxin added to the silt loam soil was released as CO₂ ? Aflatoxin decomposition in the sandy loam soil proceeded more quickly than the other two soils for the first 20 days of incubation. After this time, the decomposition rate declined and by the end of the study, 4.9% of the aflatoxin was released as CO_2. Aflatoxin decomposition proceeded most slowly in the silty clay loam soil. Only 1.4% of aflatoxin added to the soil was released as CO₂ after 120 days incubation. To determine whether aflatoxin was bound to the silty clay loam soil, aflatoxin B₁ was added to this soil and incubated for 20 days. The soil was periodically extracted and the aflatoxin species present were determined using thin layer chromatographic (TLC) procedures. After one day of incubation, the degradation products, aflatoxins B₂ and G₂, were observed. It was also found that much of the aflatoxin extracted from the soil was not mobile with the TLC solvent system used. This indicated that a conjugate may have formed and thus may be responsible for the lack of aflatoxin decomposition.     

Thermodynamics of interaction of lindane on silty loam and silty clay loam Indian soils

Abstract

Interaction of lindane with silty loam and silty clay loam soils was studied in batch tests at 23, 30 and 37° C. Sorption experiments were carried out at four concentrations and for varying time of contact upto 72 hours. This was followed by desorption studies. No desorption was observed. The sorption data was analysed using sorption equations and evaluating the thermodynamic parameters. The sorption was found to be predominantly entropic in nature and a combined effect of adsorption and chemisorption. The effect of organic matter and other chemical and mineralogical constituents of soils has also been discussed. The sorption with single application of lindane with the two soil types indicates that the insecticide is less likely to reach groundwater.