Heat dissipation characteristic in the intake grille and radiator of a fuel cell vehicle

ABSTRACT

In this study, a three-dimension (3D) computational model was proposed to investigate the flow and heat transfer characteristics of the intake grilles of two different fuel cell vehicles. The models of the intake grilles were constructed according to the actual sizes of two vehicles, namely, Roewe 950 and Toyota Mirai, considering the heat dissipation unit to simplify the heat transfer model of the vehicle. The results showed that relative to Roewe 950, Mirai intake air flow rate was approximately 10% higher, the heat transfer capacity was approximately 7% higher, and the intake grille area was larger. The coolant outlet temperature of Mirai was lower than that of Roewe 950, which was beneficial for the long term and stable operation of a fuel cell. This comparative study provided guidance for the intake grille and radiator design of fuel cell vehicles. The only difference between fuel cell vehicles on the market and conventional vehicles was that in the former, the internal combustion engine was replaced with a fuel cell stack, which had insufficient heat transfer capacity because of the reducing temperature difference. Increasing the intake grille area and the heat exchange capacity of the radiator were the key issues for the development of fuel cell vehicles. In this study, an optimal window opening angle of the radiator fin of 23° provided a maximal heat transfer coefficient.     

水稻秸秆生物炭中铜和镉的形态分布及释放特性

由于目前缺乏对生物质原料来源的管控办法,极有可能用产自受污染农田土壤的秸秆制备出具有高重金属含量的生物炭,因此,研究生物炭中重金属的形态分布及其释放特性对于防控生物炭应用产生的环境风险具有重要意义.基于此,分别采集江西省贵溪铜冶炼厂周边九牛岗污染区和中国科学院鹰潭红壤生态实验站清洁区种植的水稻秸秆制备生物炭（分别记为“九牛岗生物炭”和“红壤站生物炭”）,分析两种生物炭中Cu、Cd的含量及其化学形态分布,考察不同固液比及pH对生物炭中Cu、Cd浸出的影响.结果表明:九牛岗生物炭中Cu、Cd的总量（以w计）分别为119.99、3.83 mg/kg,显著高于红壤站生物炭（19.50、0.96 mg/kg）.尽管九牛岗生物炭中w（酸溶态Cu）、w（酸溶态Cd）显著高于红壤站生物炭,但在形态分布上,九牛岗生物炭中Cu、Cd主要为相对稳定态（可氧化态和残渣态）,二者占比分别为80.3%、76.7%,高于红壤站生物炭（二者占比分别为53.2%、48.0%）.高固液比和低pH可有效增加两种生物炭中Cu、Cd的浸出毒性,其中,九牛岗生物炭在固液比为1:20和1:60时,浸出液中ρ（Cu）、ρ（Cd）均超过GB/T 14848—2017《地下水质量标准》中Ⅱ类标准限值.动力学及累积释放试验表明,两种生物炭中的部分Cu、Cd可在短时间内迅速释放而后逐渐平稳并有上升趋势,且九牛岗生物炭中Cu、Cd释放量显著高于红壤站生物炭.研究显示,来自污染区水稻秸秆生物炭中的Cu、Cd活性显著高于清洁区生物炭,具有更高的环境风险.      

内饰材料发射率对密封舱室热防护效率的影响

目的探究密封舱室热防护效率与其内饰材料表面发射率的关系,分析内饰材料发射率对其表面温度、舱室内温度的影响规律。方法采用自行设计的小型密封舱室和加热测量装置,对内饰材料表面及舱室内温度进行测量。结果当内饰材料发射率为0.09时,内饰表面温度为141.2℃,舱室内平均温度仅为90.8℃;内饰材料发射率为0.91时,内饰表面温度为124.4℃,舱室内平均温度为109.1℃。结论试样表面温度随材料发射率的提高而降低,舱室内部空气平均温度随材料发射率的提高而升高;试样表面温度与舱室空气平均温度的温度差随材料发射率的提高而减小;同时,相同试样表面温度与舱室平均温度的温度差随加热温度的提高而增加。     

海州湾表层沉积物磷的吸附容量及潜在释放风险

利用磷吸附指数（PSI）、磷吸附饱和度（DPS）和磷释放风险指数（ERI）研究了2016年10月和2017年5月海州湾表层沉积物的磷吸附容量及潜在释放风险.结果显示,2016年秋季PSI变化范围为99.58~199.39[mgP/（100g）]/[μmol/L],DPS变化范围为23.118%~34.289%;2017年夏季PSI变化范围是130.29~198.57[mgP/（100g）]/[μmol/L],DPS变化范围为25.545%~42.135%,两次调查中PSI和DPS均表现出相反的平面分布趋势.PSI和Al_ox、Fe_ox呈显著正相关,说明Fe_ox和Al_ox是影响海州湾表层沉积物吸附磷的主要因素,且Fe_ox占主导作用;DPS与Al_ox和Fe_ox分别表现出了显著负相关性和极显著负相关性,说明Al_ox和Fe_ox含量的增大会降低表层沉积物的磷吸附饱和度.2016年10月磷释放风险指数（ERI）的变化范围为11.59%~34.18%,2017年5月磷释放风险指数（ERI）的变化范围为12.86%~32.34%,从2次调查结果整体来看,海州湾表层沉积物的磷释放风险为中度风险.     

一种硫离子响应杀菌材料的制备及应用研究

目的制备硫离子响应杀菌材料,研究它在不同浓度铜离子条件下的封装效果,以及在不同浓度硫离子条件下的释放行为。方法选择埃洛石纳米管为载体并用透射电镜进行表征、采用真空负载的方式,将甲硝唑和苯骈三氮唑(BTA)分步填充到埃洛石纳米管内部,使用紫外分光光度法测试不同浓度铜离子对纳米管中甲硝唑的封堵效果,以及材料在不同浓度硫离子条件下的释放情况。结果实验中通过调整铜离子浓度发现,铜离子浓度越大对甲硝唑的封堵效果越好,当铜离子浓度达到160 mmol/L时,对甲硝唑的封堵效果最好。杀菌材料在外界硫离子达到0.1mmol/L后,甲硝唑的释放浓度迅速提高,进一步提高硫离子浓度,释放情况改变不明显。结论铜离子浓度达到160 mmol/L时,材料的封装效果是最好的。材料能够对硫离子实现响应释放,且对应的临界浓度为0.1 mmol/L。     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

汕头港水域温排水热扩散的三维数值模拟

本文建立了汕头港水域温排水扩散的三维数学模型，并采用特征差分方法求其解，对该法在三维情况下的稳定作了推导，给出了判断公式，上述模型被应用于汕头热电厂废热水排放的环境影响评价中，实例计算表明，该模型算法程序简单，计算结果合理。     

Release of bioactive active iodine in kelp

The release process and influencing factors of bioactive iodine of kelp are systemically studied by leaching experiment. The results showed that the bioactive iodine of kelp can be released rapidly and the principal form of iodine in lixivium is I^- . There is a dynamic process between the release and absorption of iodine. With the increase of leaching water, the gross amounts of released iodine rise.There also exists a transforming process among I^- , IO3^- and organic iodine in lixivium.     

Influence of new town development on the urban heat island - The case of the Bundang area

Five new towns have been developed around the Seoul metropolitan area since 1996. However, these new towns generate lots of traffic and related problems in the areas including those new towns and Seoul as a result of increases in population and a lack of ecological-self-sufficiency. Currently, construction of another new town is under deliberation, and what should be a major consider is the notion that the new town be located within a wide, green zone. Many studies have revealed that green space can play an important role in improving urban eco-meteorological capability and air quality. In order to analyze the urban heat island which will be created by the new urban development, and to investigate the local thermal environment and its negative effects caused by a change of land use type and urbanization, Landsat TM images were used for extraction of urban surface temperature according to changes of land use over the last 15 years. These data are analyzed together with digital land use and topographic information. As a study result, it was found the urban heat island of the study area from 198.5 to 1999 rapidly developed which showed a difference of mean temperature above 2.0. Before the Bundang new town construction the temperature of the residential area was the same as a forest, but during the new town construction in 1991 analysis revealed the creation of an urban heat island. The temperature of a forest whose size is over 50% of the investigation area was lowest, and thus the presence of a forest is believed to have a direct cooling effect on the urban environment and its surroundings. The mean temperature of the residential and commercial areas in the study was found to be 4.5 higher than the forest, and therefore this part of land use is believed to be the main factor causing the temperature increase of the urban heat island.     

高硫原油加工过程硫回收水平分析

分析了金陵分公司最近三年来加工高硫原油带入的硫在全厂炼油过程的分布情况。随着原油加工量及含硫量的快速增长，硫回收能力凸现不足，表明目前正在加速建设的加氢精制和硫磺回收装置是十分必要的，这将进一步提高综合硫回收水平。从长远来看，还需采用扩大加氢工艺能力，在提升产品质量的同时达到减少硫向环境排放的目的。