废水中2,6-二硝基酚厌氧毒性和降解动力学研究

在中温(35℃±1℃)厌氧条件下,以葡萄糖为共基质,采用间歇实验方法,研究了2,6-二硝基酚(2,6-DNP)的厌氧产甲烷毒性和厌氧降解动力学.厌氧毒性试验(ATA)以累计产甲烷量和相对活性(RA)为指标,评价了不同浓度2,6-DNP对产甲烷菌的抑制程度;结果表明,2,6-DNP浓度＜20 mg/L时,对产甲烷菌没有抑制作用,浓度为40 mg/L时产生轻度抑制,浓度为80～120 mg/L时产生重度抑制;24 h 2,6-DNP的75%、50%、25%相对抑制浓度分别为30、70和＞120 mg/L.2,6-DNP降解动力学可用Haldane方程来描述,利用非线性拟合求得动力学参数Ks、Rm、Ki分别为179.7 mg/L、4.84 mg/g VSS·h、206.5 mg/L,方差R2=0.94,拟合效果很好.     

催化超临界水氧化处理1,5-萘二磺酸

采用Mn2O3/γ-AL2O3和V2O5/γ-Al2O/为催化剂,在一连续流固定床反应器中进行了超临界水氧化1,5-萘二磺酸实验.实验结果表明,在380～440℃,24 MPa条件下,Mn2O3/γ-Al2O3和V2O5/y-Al2O3催化剂对1,5-萘二磺酸的氧化降解具有显著的促进作用,TOC去除率达到90%以上;催化剂的催化效果随反应温度的升高而增强,随pH值的降低而增强,随停留时间的延长先增强后趋于平缓.     

吸附模式对有机物光催化降解的影响2.H-酸在TiO2表面的光催化降解途径

水溶液中H-酸通过磺酸基团吸附在TiO2表面,UV照射TiO2所产生的自由基首先进攻吸附在TiO2表面的磺酸基团,从而进一步导致萘环开环.pH 2.5条件下,虽然饱和吸附量较大,但由于H-酸仅通过一个磺酸基团吸附在TiO2表面,过程中产生的硫酸根速率较慢,最终的光降解速率也较慢.pH 5.0条件下,虽然饱和吸附量较小,但由于吸附在TiO2表面的两个磺酸基团同时受到来自TiO2表面自由基的进攻,过程中产生的硫酸根速率较快,最终的光降解速率也较快.吸附模式的差异是导致H-酸在不同pH值条件下光催化降解途径和速率差异的关键因素.     

偏电压对Ti/TiO2光电催化氧化富里酸的影响

采用光电催化反应器对水中天然有机物富里酸(FA)进行降解试验,考察了外加阳极偏电压对光电催化反应器降解富里酸的影响.结果表明,当外加电压为1.2V时,具有最佳的UV254和有机碳TOC去除率,当反应时间为2h时,富里酸的UV254和总有机碳TOC的去除率分别为77.4%和45.4%.另外,在反应初期(前1h内)富里酸光电催化反应动力学常数主要受外加偏电压的影响.     

水中本底成分对催化臭氧化分解微量硝基苯的影响

考察了水中本底成分对催化臭氧化分解水中微量硝基苯的影响规律.对比试验结果表明,单独臭氧氧化、臭氧/蜂窝陶瓷催化氧化和臭氧/改性蜂窝陶瓷催化氧化工艺在自来水中比蒸馏水中对硝基苯的去除率分别增加了4.90%、2.47%和5.12%.单独臭氧氧化对硝基苯的分解效率随着镁离子浓度的升高(0～8 mg.L^-1)而增加了6.25%,在相同实验条件下,臭氧/蜂窝陶瓷催化氧化和臭氧/改性蜂窝陶瓷催化氧化对硝基苯的降解效率随着镁离子浓度的升高却降低了11.41%和17.64%;单独臭氧氧化、臭氧/蜂窝陶瓷催化氧化和臭氧/改性蜂窝陶瓷催化氧化在氯离子浓度增加(0～40 mg.L^-1)的情况下对硝基苯的去除率分别下降了4.42%、9.38%和12.24%;低浓度的腐殖酸促进了硝基苯的降解,高浓度的腐殖酸抑制了硝基苯的降解.实验还研究了臭氧投加量和硝基苯初始浓度对硝基苯降解效率的影响.     

氯化消毒过程对抗生素的降解行为及其毒性效应的影响研究进展

抗生素的大量使用导致其通过各种途径进入到污水处理厂、地表水甚至饮用水源水中.在污水处理厂二级出水排放之前以及自来水的生产和供应过程中,都必须进行氯化消毒处理以杀灭病原微生物.在此过程中,抗生素一方面可能被氯化降解,另一方面也可能转化成毒性更高的降解产物.因此,了解抗生素在氯化消毒过程中的降解行为对于明确其生态和健康风险...     

Effect of fipronil on biogas production performance during anaerobic digestion of chicken manure and corn straw

Fipronil is a broad-spectrum insecticide that has a good control effect on pests of commercial poultry. Although many studies have reported the environmental fate of fipronil, the influence of residual fipronil in poultry waste on biogas production has not been further explored yet. In this article, an experimental comparative study on anaerobic digestion (AD) of chicken manure (CM) and corn straw (CS) with different fipronil concentrations (FCs) was carried at 8% of total solid (TS) and mid-temperature (35?±?1)°C. The results showed that fipronil had a significant effect on biogas production during AD of CM and CS. When the FC is at a low level (≤10?mg·kg^?1), the biogas production rate is increased and the digestion period was shortened, while higher FC (≥ 20?mg·kg^?1) showed an inhibitory effect. During the monitoring of enzyme activity, low FC showed no significant effect on cellulase and saccharase, but the urease activity increased in the early stage. High FC showed inhibition of activity of cellulase and urease, but the saccharase activity was significantly inhibited until FC reached 40?mg·kg^?1. This study also confirms that the environment in anaerobic digester is favorable for the degradation of fipronil, and its half-life is about 15.83?days.     

Ozone facilitated degradation of caffeine using Ce-TiO2 catalyst

The ozone initiated oxidation of 1,3,7-trimethylxanthine (caffeine), commonly found in wastewaters as model compound is reported using cerium (Ce)/titanium dioxide (TiO₂) as catalyst. The effect of pH and loading of ceria on titania were investigated. Effect of reaction conditions on degradation of caffeine based on their pseudo first-order rate constants were compared. The combination of catalyst Ce-TiO₂ and ozone aeration significantly enhanced the degradation of caffeine compared to uncatalysed ozonation. The oxidation of caffeine ensued via the free radical mechanism, through enhanced ozone decomposition into OH radicals. Ce/TiO₂(0.5?wt%) showed good activity in degradation of caffeine at pH 6, in both natural stream and river water samples showing about 60% total organic carbon removal in 2?h ozonation period. Using liquid chromatography-mass spectroscopy, degradation products were analysed. A reaction intermediate and one final product were positively identified. Nano-catalysts with different loadings of Ce on TiO₂ synthesized by sol-gel route were characterized by scanning electron microscope, transmission electron microscopy, BET and powder X-ray diffraction spectrum techniques. The results showed that the material retained a highly ordered mesoporous structure and possessed large surface area.     

Evaluation of photolysis and hydrolysis of pyraclostrobin in aqueous solutions and its degradation products in paddy water

This study evaluated the hydrolysis and photolysis kinetics of pyraclostrobin in an aqueous solution using ultra-high-performance liquid chromatography–photodiode array detection and identified the resulting metabolites of pyraclostrobin by hydrolysis and photolysis in paddy water using high-resolution mass spectrometry coupled with liquid chromatography. The effect of solution pH, metal ions and surfactants on the hydrolysis of pyraclostrobin was explored. The hydrolysis half-lives of pyraclostrobin were 23.1–115.5?days and were stable in buffer solution at pH 5.0. The degradation rate of pyraclostrobin in an aqueous solution under sunlight was slower than that under UV photolysis reaction. The half-lives of pyraclostrobin in a buffer solution at pH 5.0, 7.0, 9.0 and in paddy water were less than 12?h under the two light irradiation types. The metabolites of the two processes were identified and compared to further understand the mechanisms underlying hydrolysis and photolysis of pyraclostrobin in natural water. The extracted ions obtained from paddy water were automatically annotated by Compound Discoverer software with manual confirmation of their fragments. Two metabolites were detected and identified in the pyraclostrobin hydrolysis, whereas three metabolites were detected and identified in the photolysis in paddy water.     

废旧硬质聚氨酯泡沫塑料的木质素改性及再生

采用含有二乙二醇(DEG)和乙醇胺(ETA)的双组分解交联剂降解废旧硬质聚氨酯泡沫塑料(PU硬泡),并利用降解得到的低聚物多元醇与木质素复合制备出性能增强的再生PU硬泡。通过对制备的再生PU硬泡的红外光谱、密度、吸水率、抗压强度、热稳定性、导热系数、热重曲线等进行分析测试,考察m(DEG)∶m(ETA)对再生PU硬泡性能的影响。实验结果表明:m(DEG)∶m(ETA)=1∶3时废旧PU硬泡的降解效果最好;木质素加入量为2.0%(w)时再生PU硬泡的密度低、抗压强度高、保温性能良好,达到国家标准《建筑绝热用硬质聚氨酯泡沫塑料》(GB/T 21558—2008)的品质要求。