A comprehensive review on green buildings research: bibliometric analysis during 1998–2018

Environmental Science and Pollution Research - Buildings account for nearly 2/5ths of global energy expenditure. Due to this figure, the 90s witnessed the rise of green buildings (GBs) that were...     

有意违章行为动因分析与控制对策探讨

对有意违章行为的含义进行了界定 ,并对有意违章行为产生的动因进行了详细分析 ,提出了有意违章行为的动因主要包含违章行为与遵章行为满足生理心理需要作用的差值ΔXW、违章行为会受到法规惩处的作用FW、违章行为可导致人身伤害的主观感觉的作用RW3个方面。同时对 3个方面的动因按弗鲁姆的激励理论进行了转化 ,给出了各自的含义说明。笔者按动因分析的结果 ,给出了控制有意违章行为的步骤和措施     

BiOBr分子印迹材料的制备及其降解诺氟沙星性能

为了有效处理低浓度抗生素残留废水,以水热法制备的BiOBr为载体,诺氟沙星（NOR）为模板,通过表面分子印迹法制备了BiOBr分子印迹材料（MIP）.同时,采用SEM与XRD对制备的材料进行相分析及显微结构分析,并利用XPS、FTIR、BET和UV-Vis DRS对所合成材料的微观结构进行观察.最后,以诺氟沙星（NOR）为目标污染物,对MIP在暗反应下的吸附性能及300 W Xe灯照射下的光催化性能进行测定,并探讨pH、投加量、初始浓度、是否印迹处理对NOR去除的影响.实验结果表明,在pH为中性,MIP投加量为2.5 g·L^-1的条件下,MIP对5 mg·L^-1 NOR溶液的去除率达到96.2%,且对低浓度（1 mg·L^-1）NOR溶液的去除率达到99%.综合表明,本文所制备的MIP适用于低浓度诺氟沙星废水的处理.     

Acceleration of floc-water separation and floc reduction with magnetic nanoparticles during demulsification of complex waste cutting emulsions

Waste cutting emulsions are difficult to treat efficiently owing to their complex composition and stable emulsified structure. As an important treatment method for emulsions, chemical demulsification is faced with challenges such as low flocs–water separation rates and high sludge production. Hence, in this study, Fe₃O₄ magnetic nanoparticles (MNPs) were used to enhance chemical demulsification performance for treating waste cutting emulsions under a magnetic field. The addition of MNPs significantly decreased the time required to attain sludge–water separation and sludge compression equilibrium, from 210 to 20 min. In addition, the volume percentage of sludge produced at the equilibrium state was reduced from 45% to 10%. This excellent flocculation–separation performance was stable over a pH range of 3–11. The magnetization of the flocculants and oil droplets to form a flocculant–MNP–oil droplet composite, and the magnetic transfer of the composite were two key processes that enhanced the separation of cutting emulsions. Specifically, the interactions among MNPs, flocculants, and oil droplets were important in the magnetization process, which was controlled by the structures and properties of the three components. Under the magnetic field, the magnetized flocculant–MNP–oil droplet composites were considerably accelerated and separated from water, and the sludge was simultaneously compressed. Thus, this study expands the applicability of magnetic separation techniques in the treatment of complex waste cutting emulsions.     

Regulated emission characteristics of in-use LNG and diesel semi-trailer towing vehicles under real driving conditions using PEMS

On-road driving emissions of six liquefied natural gas(LNG) and diesel semi-trailer towing vehicles(STTVs) which met China Emission Standard IV and V were tested using Portable Emission Measurement System(PEMS) in northern China.Emission characteristics of these vehicles under real driving conditions were analyzed and proved that on-road emissions of heavy-duty vehicles(HDVs) were underestimated in the past.There were large differences among LNG and diesel vehicles, which also existed between China V vehicles and China IV vehicles.Emission factors showed the highest level under real driving conditions, which probably be caused by frequent acceleration, deceleration, and start-stop.NOx emission factors ranged from 2.855 to 20.939 g/km based on distance-traveled and 6.719–90.557 g/kg based on fuel consumption during whole tests, which were much higher than previous researches on chassis dynamometer.It was inferred from tests that the fuel consumption rate of the test vehicles had a strong correlation with NOx emission, and the exhaust temperature also affected the efficiency of Selected Catalytic Reduction(SCR) aftertreatment system, thus changing the NOx emission greatly.THC emission factors of LNG vehicles were 2.012–10.636 g/km, which were much higher than that of diesel vehicles(0.029–0.185 g/km).Unburned CH_4 may be an important reason for this phenomenon.Further on-road emission tests, especially CH_4 emission test should be carried out in subsequent research.In addition, the Particulate Number(PN) emission factors of diesel vehicles were at a very high level during whole tests, and Diesel Particulate Filter(DPF)should be installed to reduce PN emission.     

国内外饮用水余氯限值及监测方法的研究进展

新型冠状病毒肺炎疫情期间大规模使用含氯消毒剂,其残留可能对水环境及人体健康造成影响.我国饮用水水源地质量标准并未设置余氯项目及其浓度限值,且缺乏统一的余氯现场快速分析方法标准.为公共卫生事件发生期间的水质余氯监测与评价提供参考,对国内外饮用水标准余氯限值、实验室标准分析方法、现场快速分析方法等进行汇总分析,结果表明:①不同国家和地区以及WHO（World Health Organization,世界卫生组织）在饮用水标准中分别设置了出厂水中余氯限值（范围为0.1~2.0 mg/L）、管网末梢水中余氯限值（范围为0.1~1.8 mg/L）及饮用水中余氯最大允许浓度（范围为4~5 mg/L）.②比色法、容量法因其具有反应迅速且稳定、准确度及精密度较高等优点而成为国内外实验室主要标准或推荐分析方法,高效液相色谱法检出限最低,灵敏度最高,可用于余氯痕量分析.③余氯现场快速分析方法多以比色法为主,在线监测方法多为电化学方法,但缺乏统一的标准方法.研究显示,国外饮用水标准中余氯最大允许浓度为5 mg/L,WHO推荐高风险环境下的管网末梢余氯浓度最低为0.5 mg/L,建议尽快开展水质余氯现场监测方法标准化研究.      

大兴安岭5种乔木树种燃烧释放PM2.5中水溶性元素特性

采用自主设计的生物质燃烧实验装置,在不同燃烧状态（明燃、阴燃）下,对大兴安岭林区5种典型乔木树种的不同部位（枝、叶、皮）燃烧释放PM_2.5中的水溶性元素特性进行研究.结果显示,不同树种间PM_2.5的排放因子差异显著,排放范围为（2.408±0.854）~（9.227±1.172）g/kg.5种乔木树种燃烧释放PM_2.5中主要检测到Mg、Ca、K等16 种元素,其中Ca、K、Zn、Mg 4种元素的排放因子明显大于其它元素.不同树种间元素排放因子差异较大,针叶树的排放因子一般高于阔叶树.除Cd元素外,不同器官间排放的元素总量无明显差异.不同树种不同器官燃烧释放PM_2.5中水溶性元素的占比顺序较为一致,其中Ca、K、Zn和Mg 4种元素的排放因子在枝、叶、皮中均较高.此外,燃烧状态对元素排放特征影响较大,Li、Mg、Ca等7种元素的排放因子均表现为明燃显著高于阴燃.     

基于地形位置指数的赤水河流域植被时空变化研究

地形因子和植被覆盖是区域灾害评价的关键指标,也是山区型村镇建设生态安全评估的重要内容.为探析山区型村镇建设的生态约束条件,以赤水河流域为研究对象,基于1998—2018年SPOT_VGT NDVI数据,利用地形位置指数（Topographic Position Index,TPI）和坡度位置指数方法,研究了赤水河流域植被生长季NDVI时空变化及地形分异特征.结果表明:①赤水河流域内,1998—2018年植被生长季平均NDVI呈缓慢上升趋势,斜率为0.004 7;NDVI>0.60的集中连片区域主要分布在古蔺县北部、赤水市大部和习水县西北部,占赤水河流域总面积的8.42%;Sen's slope在0.009~0.015区间时,赤水河流域植被生长增强趋势最明显,主要集中分布在赤水河中上游、二道河以及下游的大同河干流地区.②TPI在-39.4~34.3区间的面积最多,为6 221.63 km2,占赤水河流域总面积的34.05%;将赤水河流域坡度类型划分为山脊、上坡、中坡、平坡、下坡、山谷6个坡度位置类型,其中,中坡面积（7 792.02 km2）最大,占流域总面积的42.64%,表明TPI数值较小且坡度大于5°的区域是赤水河流域地形主体.③赤水河流域植被在山脊的平均NDVI最高,为0.747,且山脊平均Sen's slope最高,为0.007 2;山谷平均NDVI最低,为0.709.研究显示,赤水河流域植被分布在118.5~486.9的TPI区间或分布在山脊处时整体生长较好,且生长增强趋势最明显.      

中国东南沿海大(中)型浅成中低温热液矿床—斑岩型矿床评价的地质准则、成矿模式及其找矿意义

本文总结中国东南沿海高钾钙碱性—双峰式火山岩带中已勘查大中型矿床成矿环境的共性：矿床所处区域构造的部位、成岩与成矿时代、矿床与岩浆成因类型、火山构造及其基底构造控矿性、矿床与爆发角砾岩、矿床与矿化类型叠加与共生、矿化与蚀变的分带往、矿床定位深度与剥蚀深度。作者认为这八点可作为找寻与评价大（中）型矿床的地质准则。通过火山地质与矿床地质统一的研究提出本区晚中生代以火山为中心地热体系的成矿模式。并就三个方面作类比：①与现代火山地热体系成矿作用类比；②以紫金山高硫型浅成低温热液矿床与世界同类型矿床作比较；③与环太平洋其他火山岩带同类型矿床模式作类比．通过建立本区的模式与类比获得进一步找矿中值得重视的一些思路．     

SBR法处理中药材有机废水工艺研究

应用ＳＢＲ法对中药材有机废水进行了研究。考察了ＣＯＤＣＲ、ＢＯＤ５、ＳＳ、ＮＨ３－Ｈ的处理效果，以及ＰＨ、水温、污泥负荷等条件对去除率的影响。运行结果表明，ＰＨＯ ６．０－９．０、ｔ为１５－３０℃、污沁荷０．３ｋｇＢＯＤ５／ｋｇＭＬＳＳ．ｄ，运行程序：进水０．５ｈ（限制曝气）、曝气１０ｈ、脱氮１．５ｈ，沉降０．５ｈ，排水０．５ｈ、闲置１１ｈ，周期时间２４ｈ时ＣＯＤＣＲ去除率８８％、ＢＯＤ５９４％、