Effect of pressure and atmosphere during hydrothermal treatment on the properties of sewage sludge-derived solid fuel

Journal of Material Cycles and Waste Management - Efforts to improve the performance of hydrothermal treatment (HT) in producing high-quality solid fuel from sewage sludge were carried out by...     

氢氟酸的污染与防治

综述氢氟酸烷基化装置，运行过程中氢氟酸的危害，污染源的分析，防治措施及取得效果．     

三峡库区中低产土壤重金属含量及其与小麦吸收的关系

三峡库区中低产土壤的Hg,As,Cr,Pb,Cu五个重金属含量（除渝北区外），均在国家土壤环境质量标准内，属自然背景值一级标准。Cd和Zn高于全国土壤中的平均含量和背景值含量，属二级标准。土壤的重金属含量与土壤母质类型，pH值，阳离子交换量，有机质，无定形铁和物理性粘粒有关，同时存在一定的地域分布。重庆近郊的土壤所有重金属含量相对较高。土壤重金属的可给态或有效性含量极低，锌和铜不是过量，而是不足。小麦籽粒中As,Cr,Pb,Zn,Cu含量低于国家食品对重金属限量标准和小麦籽粒背景值标准，Hg,Cd含量高于国家规定标准。籽粒中的Cu,Zn含量是小麦茎叶中的2.0-2.2倍，而茎叶中的Hg,Pb,As,Cr,Cd含量明显高于籽粒。     

中国农村贫困地区可持续发展的制度分析

中目农村贫困地区可持续发展受多重制度因素的影响。本文通过对农村贫困地区可持续发展的制度分析。提出制度创新一对农村贫困地区做出一系列新的制度安排是农村贫困地区可持续发展的保障。     

长江经济带突发水污染风险分区研究

长江经济带突发水污染事件频发,对区域人群健康和生态安全造成严峻挑战.环境风险分区是环境风险管理的基础和有效工具.本研究以2015年为基准年,基于环境统计数据、DEM数据、水质监测断面数据和基础地理数据,综合考虑了水系流向、水系级别及水质等因素,以1 km×1 km的网格为基本单元,对长江经济带开展突发水污染风险分区.结果表明:①高风险区面积为3348.9 km~2,占评估区总面积的0.16%;较高风险区面积为26030.7 km~2,占比1.27%;中风险区面积为97971.1 km~2,占比4.79%;低风险区面积为1916838.7 km~2,占比93.77%;②从沿长江干流两岸分布来看,高风险区面积沿长江上游至下游呈逐渐增加趋势,主要集中分布在重庆市中部、湖北省东部、安徽省东部、江苏省中西部、浙江省北部、上海市西部等地;③从沿长江主要支流两岸分布来看,高风险区主要分布在嘉陵江南段、乌江南段、汉水东段、湘江北段、赣江北段等.研究结果可为长江经济带生态环境管理提供科学依据.     

基于LOADEST和数字滤波的水源地基流氮素输出定量方法应用实例

地表直接径流和基流均是流域非点源氮/磷养分输出的重要水文途径.科学认识和定量模拟基流氮/磷养分输出对于准确解析水源地水体非点源污染来源至关重要.基于Load Estimator模型和数字滤波算法,建立了定量水源地基流氮素输出的方法体系.以浙江省珊溪水源地的玉泉溪流域为例,利用玉泉溪2010-01—2013-12期间逐月总氮(TN)水质监测数据和逐日流量数据,展示了该方法的计算过程.结果表明,本文建立的水源地基流氮素输出定量方法结果合理,模拟精度高,决定系数和纳什系数分别为0.83和0.80;玉泉溪流域2010—2013年TN负荷量为141.21～274.68 t·a~(-1),平均208.63 t·a~(-1),年基流TN负荷量为84.39～168.68 t·a~(-1),平均127.69 t·a~(-1);基流对玉泉溪年均TN负荷量贡献率高达60%以上,流域基流养分输出对地表水体的污染应引起足够重视.     

有机废物厌氧发酵生物合成己酸研究进展

厌氧发酵处理有机废物并合成高价值羧酸盐的技术日趋成熟。尤其是己酸作为产物之一,因其附加值高,易于分离,用途广泛,越来越受到关注。微生物合成己酸需要电子供体及受体。详细介绍了乙醇、乙酸分别作为电子供体、受体合成己酸的机理——逆β氧化反应,总结合成己酸底物以及影响合成的因素（温度、pH值、水力停留时间、竞争路径、氢气分压、底物比例、氮源等）。目前采用科氏梭菌以乙醇为电子供体来合成己酸的技术较成熟,探索了利用乳酸为电子供体合成己酸的代谢机理,并指出开发乳酸转化合成己酸的技术可成为未来发展方向。     

Dynamic nano-Ag colloids cytotoxicity to and accumulation by Escherichia coli: Effects of Fe3+, ionic strength and humic acid

Released Ag ions or/and Ag particles are believed to contribute to the cytotoxicity of Ag nanomaterials, and thus, the cytotoxicity and mechanism of Ag nanomaterials should be dynamic in water due to unfixed Ag particle:Ag⁺ ratios. Our recent research found that the cytotoxicity of PVP-Ag nanoparticles is attributable to Ag particles alone in 3 hr bioassays, and shifts to both Ag particles and released Ag⁺ in 48 hr bioassays. Herein, as a continued study, the cytotoxicity and accumulation of 50 and 100 nm Ag colloids in Escherichia coli were determined dynamically. The cytotoxicity and mechanisms of nano-Ag colloids are dynamic throughout exposure and are derived from both Ag ions and particles. Ag accumulation by E. coli is derived mainly from extracellular Ag particles during the initial 12 hr of exposure, and thereafter mainly from intracellular Ag ions. Fe³⁺ accelerates the oxidative dissolution of nano-Ag colloids, which results in decreasing amounts of Ag particles and particle-related toxicity. Na⁺ stabilizes nano-Ag colloids, thereby decreasing the bioavailability of Ag particles and particle-related toxicity. Humic acid (HA) binds Ag⁺ to form Ag⁺-HA, decreasing ion-related toxicity and binding to the E. coli surface, decreasing particle-related toxicity. HA in complex conditions showed a stronger relative contribution to toxicity and accumulation than Na⁺ or Fe³⁺. The results highlighted the cytotoxicity and mechanism of nano-Ag colloids are dynamic and affected by environmental factors, and therefore exposure duration and water chemistry should be seriously considered in environmental and health risk assessments.     

Ozone pollution characteristics and sensitivity analysis using an observation-based model in Nanjing, Yangtze River Delta Region of China

Ground-level ozone (O₃) has become a critical pollutant impeding air quality improvement in Yangtze River Delta region of China. In this study, we present O₃ pollution characteristics based on one-year online measurements during 2016 at an urban site in Nanjing, Jiangsu Province. Then, the sensitivity of O₃ to its precursors during 2 O₃ pollution episodes in August was analyzed using a box model based on observation (OBM). The relative incremental reactivity (RIR) of hydrocarbons was larger than other precursors, suggesting that hydrocarbons played the dominant role in O₃ formation. The RIR values for NO_X ranged from –0.41%/% to 0.19%/%. The O₃ sensitivity was also analyzed based on relationship of simulated O₃ production rates with reductions of VOC and NO_X derived from scenario analyses. Simulation results illustrate that O₃ formation was between VOCs-limited and transition regime. Xylenes and light alkenes were found to be key species in O₃ formation according to RIR values, and their sources were determined using the Positive Matrix Factorization (PMF) model. Paints and solvent use was the largest contributor to xylenes (54%), while petrochemical industry was the most important source to propene (82%). Discussions on VOCs and NO_X reduction schemes suggest that the 5% O₃ control goal can be achieved by reducing VOCs by 20%. To obtain 10% O₃ control goal, VOCs need to be reduced by 30% with VOCs/NO_X larger than 3:1.