Lithium extraction from salt lake brines with high magnesium/lithium ratio: a review

Environmental Chemistry Letters - The demand for lithium is growing rapidly with the increase in electric vehicles, batteries and electronic equipments. Lithium can be extracted from brines, yet...     

A combined radical and non-radical oxidation processes for efficient degradation of Acid Orange 7 in the homogeneous Cu(II)/PMS system: important role of chloride

Environmental Science and Pollution Research - Trace copper ion (Cu(II)) in water and wastewater can trigger peroxymonosulfate (PMS) activation to oxidize organic compounds, but it only works under...     

河口切变锋引起的滩槽泥沙交换效应

切变锋是河口湾锋系中最为常见和最易观察到的锋面类型。本文对长江口的切变锋进行现场观察和滩，槽同步水文资料分析，简述了长江口切变锋发生的部分和基本特性，提出了切变锋引起的滩，槽泥沙呈现螺旋形交换形式等论点。     

内螺纹变截面铜管拉伸工艺的研究

此文提出了内螺纹变截面铜管分段拉仲一次成形新工艺,并就工艺因素对该管拉伸成形的影响进行了试验研究,从而为合理制订成形工艺提供了依据。     

金属加工过程中应力状态的分析方法

分析简单地拉伸、压缩和扭转的情况时,应力状态能容易地被确定.但是,实际上在金属加工过程中材料是承受复杂的应力状态,在模具——工件接触面上增加有摩擦力.而且,这些应力和摩擦力一般地沿着接触面变化.准确的计算或预测载荷、力、应力和温度,不但对设计适宜的设备是重要的,而且对研究工艺期间材料的变化过程也是重要的.本文将讨论材料变形过程中所运用的主要分析方法及其优缺点.     

圆形烟道烟尘采样点位置确定之正误

采样点位置的确定是烟尘测试中的一项基础工作。在全国沿用10多年的确定圆形圆形烟道烟尘采样点位置的计算表中的数据,经验算有60％有误;原来以烟道中心为基准的计算公式虽然正确,但实用性差。为了进一步完善烟气测试理论,提高监测质量,提出以烟道内壁为基准的新计算公式。运用新、旧2种计算公式得到一致的计算结果—新计算表,进一步证实了原计算表中的错误。     

Active capping demonstration in the Anacostia river,Washington, D.C.

An active capping demonstration project in Washington, D.C., is testing the ability to place sequestering agents on contaminated sediments using conventional equipment and evaluating their subsequent effectiveness relative to conventional passive sand sediment caps. Selected active capping materials include: (1) AquaBlokTM, a clay material for permeability control; (2) apatite, a phosphate mineral for metals control; (3) coke, an organic sequestration agent; and (4) sand material for a control cap. All of the materials, except coke, were placed in 8,000‐ft test plots by a conventional clamshell method during March and April 2004. Coke was placed as a 1.25‐cm layer in a laminated mat due to concerns related to settling of the material. Postcap sampling and analysis were conducted during the first, sixth, and eighteenth months after placement. Although postcap sampling is expected to continue for at least an additional 24 months, this article summarizes the results of the demonstration project and postcap sampling efforts up to 18 months. Conventional clamshell placement was found to be effective for placing relatively thin (six‐inch) layers of active material. The viability of placing high‐value or difficult‐to‐place material in a controlled manner was successfully demonstrated with the laminated mat. Postcap monitoring indicates that all cap materials effectively isolated contaminants, but it is not yet possible to differentiate between conventional sand and active cap layer performance. Monitoring of the permeability control layer indicated effective reductions in groundwater seepage rates through the cap, but also showed the potential for gas accumulation and irregular release. All of the cap materials show deposition of new contaminated sediment onto the surface of the caps, illustrating the importance of source control in maintaining sediment quality. © 2006 Wiley Periodicals, Inc.     

基于两种再分析资料的一次四川盆地大气污染过程气象要素数值模拟研究

利用ECMWF-ERA5和NCEP-FNL再分析资料作为中尺度气象模式WRF（The Weather Research and Forecasting）初始场,对四川盆地2018年1月一次大气污染过程气象要素进行了模拟,对比分析了气温、风速、风向、相对湿度、边界层高度、温廓线的模拟效果,并结合大气超级站观测数据对模拟结果进行评估.结果表明：两种资料均能较好地模拟出气象要素的变化情况,但由于两套资料时空分辨率、采用的模式、同化方案、数据来源和质量控制方案存在一定区别,导致各要素模拟效果并不一致.与NCEP-FNL相比,ECMWF-ERA5模拟的平均相对湿度（59.23%）与观测值差异更小,且均方根误差、偏差较小,分别为9.83%和-0.83%,但NCEP-FNL模拟的平均气温（8.99℃）更接近观测值,且偏差值较小,为-0.04℃.两组模拟结果均显示盆地内部为模拟区域的低风速区,相对湿度模拟值在60%以上,气温高于西部山地地区.NCEP-FNL模拟的盆地内部气温、相对湿度、风速小于ECMWF-ERA5模拟值,但边界层高度模拟值较大.ECMWF-ERA5模拟的逆温强度相比较小,且温度露点差较小.此次污染过程PM_2.5和PM₁₀日均浓度最大值分别为190.1 μg·m^-3和261.0 μg·m^-3,相对湿度增大引发的颗粒物吸湿增长是导致PM_2.5和PM₁₀质量浓度突增的主要原因.     

成都市大气颗粒物粒径分布及其对能见度的影响

使用环境颗粒物分析仪（GRIMM180）对成都市2018年10月—2019年9月0.25~32 μm的大气颗粒物数浓度粒径分布进行观测,结合细颗粒物（PM_2.5）质量浓度以及相对湿度（RH）、能见度、降水量等气象要素数据,分析了成都市大气颗粒物粒径分布及其与能见度的关系.结果表明,观测期间成都市大气颗粒物以细粒子为主,0.25~0.5 μm的粒子数浓度占总数浓度的97.75%,数浓度谱呈单峰分布,2018年秋季、2019年夏季表面积谱呈双峰分布,2018年冬季、2019年春季表面积谱呈三峰,体积谱均为三峰分布;在不同RH区间,PM_2.5质量浓度及数浓度均与能见度呈负相关,且其中0.25~0.5 μm粒径段的细颗粒物因为对可见光波段的米散射效应而对能见度产生较大影响;在不同RH情况下,不同粒径段颗粒物数浓度对能见度的影响程度有所差别：在低RH（<70%）下,0.25~0.3 μm粒径段粒子数浓度对能见度影响最大;在中等RH（70%~80%）下,0.3~0.5 μm粒径段粒子数浓度对能见度的影响最大;而在高RH（>80%）下,0.3~0.5 μm和0.5~1 μm粒径段粒子数浓度对能见度影响相当.