Heat dissipation characteristic in the intake grille and radiator of a fuel cell vehicle

ABSTRACT

In this study, a three-dimension (3D) computational model was proposed to investigate the flow and heat transfer characteristics of the intake grilles of two different fuel cell vehicles. The models of the intake grilles were constructed according to the actual sizes of two vehicles, namely, Roewe 950 and Toyota Mirai, considering the heat dissipation unit to simplify the heat transfer model of the vehicle. The results showed that relative to Roewe 950, Mirai intake air flow rate was approximately 10% higher, the heat transfer capacity was approximately 7% higher, and the intake grille area was larger. The coolant outlet temperature of Mirai was lower than that of Roewe 950, which was beneficial for the long term and stable operation of a fuel cell. This comparative study provided guidance for the intake grille and radiator design of fuel cell vehicles. The only difference between fuel cell vehicles on the market and conventional vehicles was that in the former, the internal combustion engine was replaced with a fuel cell stack, which had insufficient heat transfer capacity because of the reducing temperature difference. Increasing the intake grille area and the heat exchange capacity of the radiator were the key issues for the development of fuel cell vehicles. In this study, an optimal window opening angle of the radiator fin of 23° provided a maximal heat transfer coefficient.     

内饰材料发射率对密封舱室热防护效率的影响

目的探究密封舱室热防护效率与其内饰材料表面发射率的关系,分析内饰材料发射率对其表面温度、舱室内温度的影响规律。方法采用自行设计的小型密封舱室和加热测量装置,对内饰材料表面及舱室内温度进行测量。结果当内饰材料发射率为0.09时,内饰表面温度为141.2℃,舱室内平均温度仅为90.8℃;内饰材料发射率为0.91时,内饰表面温度为124.4℃,舱室内平均温度为109.1℃。结论试样表面温度随材料发射率的提高而降低,舱室内部空气平均温度随材料发射率的提高而升高;试样表面温度与舱室空气平均温度的温度差随材料发射率的提高而减小;同时,相同试样表面温度与舱室平均温度的温度差随加热温度的提高而增加。     

鄂东鸭儿湖地区大气中有机氯农药特征及土-气交换

采用聚氨酯泡沫-被动采样法（PUF-PAS）采集鸭儿湖地区大气样,研究典型污染源地区大气中有机氯农药（OCPs）组成、来源及土-气交换现状。鸭儿湖地区大气中OCPs主要组成为艾氏剂（Aldrin）、滴滴涕（DDTs）、六六六（HCHs）、六氯苯（HCB）、甲氧滴滴涕（Methoxychlor）和a-硫丹（α-Endosulfan）,约占OCPs总量的84%。较高浓度Aldrin（平均浓度为161.25 pg/m³）广泛存在应引起高度重视。HCHs（平均浓度为89.64 pg/m³）和DDTs（平均浓度为92.29 pg/m³）普遍存在且含量高,污染程度比较明显。HCHs异构体中β-HCH高于α-HCH,远远高于γ-HCH和δ-HCH,说明HCHs经过长期降解已逐渐稳定下来;来源分析推测存在工业HCHs的使用或者受大气长距离传输影响。DDTs在各点位分布明显不同于HCHs,且各点位DDTs的六种组成均存在很大差别,可能由于点位地理位置以及农药使用情况导致;来源分析推测大气中DDTs主要来自历史残留。鸭儿湖地区OCPs土气交换研究表明,HCHs主要表现为从大气向土壤中沉降;DDTs在大多数点位源于土壤中历史残留的挥发,部分点位受到大气长距离传输影响。     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

汕头港水域温排水热扩散的三维数值模拟

本文建立了汕头港水域温排水扩散的三维数学模型，并采用特征差分方法求其解，对该法在三维情况下的稳定作了推导，给出了判断公式，上述模型被应用于汕头热电厂废热水排放的环境影响评价中，实例计算表明，该模型算法程序简单，计算结果合理。     

狭窄海湾潮交换的分段模式Ⅱ.在象山港的应用

作者前文所建立的狭窄海湾潮交换的分段模式的合理性由矩形海湾数值计算结果得到验证，并被应用于象山港海湾水的更新周期估算     

狭窄海湾潮交换的分段模式Ⅰ.模式的建立

Ｋｕｏ 和 Ｎｅｉｌｓｏｎ 的分区段潮交换模式基于 Ｋｅｔｃｈｕｍ 潮冲程理论划分区段，并以各断面的回流系数来反映区段间的交换特征，是一个适合于狭长小潮湾沿程水交换近似估算的简捷有效的模式。本研究对该模式中的混合过程物理简化方式作了更为合理的修正，即引进了“内湾各相邻区段间水体混合交换同时发生”的设定。同时，基于对交换率概念的系统分析，本文还对模式中最重要的特征参数回流系数的特性及其简化确定方法作了进一步探讨     

海洋沉积物中的多氯联苯

综述了目前国内外对PCB的研究状况，并指出了PCB的来源、分布及其在沉积物和水相之间的循环受人为活动和生物活动等许多因素的影响。此外本文还概述了PCB的毒性研究近况以及测定其在沉积物中行为的方法，从而为控制环境污染提供了科学依据。     

螯合纤维的合成及其吸附重金属离子的研究

研究了含有胺肟基和胺腙基功能纤维的合成、结构表征和螯合性能。新型合纤维对多种重金属离子具有良好的吸附性能，能从被污染的水体和土壤中去除重金属离子，经洗脱后可回收金属，螯合纤维能反复使用。     

The curve of ion exchange ratio(%)-pH of the interaction between suspended particles with Cd(II) in the Yellow River

The curve of ion exchange ratio(%)-pH of the interactionbetween suspended particles with Cd(II) in the Yellow River wasstudied. The effects of lysine on this curve have been alsoinvestigated. The results showed that (1) Cadmium in Cd(OH)+ formin the suspended particles exchanges with the cations.The exchangeratio of Cd2+ is nearly at its greatest value in the range of pH(8.0-8.5) in natural aquatic system; (2) Ion exchange ratiodecreases as the concentration of Cd2+ raises from 8.9×10-6 mol/L to 2x8.9 x 10-6mol/L; (3) At the lysine concentration of 6.8x10-6 mol/L, it can promote the ion exchange ratio; (4) Adsorption of thesuspended particles to cadmium is weaker in seawater and Jin ShaRiver than in the Yellow River.