Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

A study on the interactions among several plant secondary compounds and aphids

The research, focused on the specific interactions among seven plant secondary compounds and aphids, was carried out and the preliminary results showed: (1) "T-typed tube method" was regarded as the best method compared with others designed to observe the interactions. (2) Cabbage aphid was able to be attracted by laurolene while it was not susceptible to α-pinene, β-pinene and diamylene. (3) Gossypol, a major secondary substance in cotton, was able to be implicated as feeding attractant to cotton aphid. (4) Rutin might be implicated repellent to cotton aphid.     

含酚废水治理方法的研究

根据含酚废水的性质，用ClO2氧化除酚，ZL—1和聚丙烯酰胺(PAM)混凝沉降除悬浮物的方法处理该废水。实验结果表明，经处理后废水中的主要污染物酚、焦油和悬浮物等去除率都很高，该水可以满足循环使用的要求。     

矿区复合生态系统中土壤演替和植被演替的相互影响

在讨论矿区复合生态系统涵义的基础上，以平朔安太堡露天煤矿为例，探讨了大型露天矿区复合生态系统演替与原生态系统演替的不同，即露天矿区复合生态系统演替极大地受着社会--经济--自然三方面的控制，在演替过程中土壤演替与植被演替相互影响、相互协调，共同作用了矿区复合生态系统。同时，还阐述了进行矿区生态重建的两大关键措施：生态环境建设和群落建设。     

复配絮凝剂的筛选及其在炼油污泥中的应用

通过试验筛选出对炼油污泥处理效果好的复配絮凝剂。试验和现场应用结果表明：使用有机高分子絮凝剂(PAM)分别和无机高分子絮凝剂(PAC)复配处理炼油污泥比单独使用任何一种絮凝剂的处理效果更好，复配絮凝剂具有适应性广、投加量少、浮渣少等优点，处理后的污水可以达到排放标准。     

混凝研究中的界面过程化学:IPF-颗粒物-水溶液的相互作用

仅以IPF 颗粒物 水溶液的相互作用为例 ,对混凝研究中二界面过程化学领域的进展加以介绍 .研究结果表明 ,经过预制的聚合铝在混凝过程中表现出较好的形态稳定性 ,而传统混凝剂则强烈地受溶液化学过程 ,尤其是溶液pH值的影响 .混凝剂水解聚合形态倾向于在颗粒物表面吸附沉积 ,而直接引发混凝作用 .单体形态则通过转化为聚合、沉淀形态起混凝作用     

建立土壤硫释放过程的人工神经网络模型

以温度、土壤含水率、胱氨酸添加量和土壤pH值作为土壤释放挥发性含硫化合物的主要影响因素,采用正交实验方法分析这些因素与土壤硫释速率的关系,利用BP神经网络算法对实验结果建模,并用模型对不同影响因素下的土壤硫释放情况进行预测。结果表明,网络模型对学习过的样本有较高预测精度,预测结果相对误差在2％以下,对未学生过的样本,误差为10％左右,表明人工神经网络方法建立的模型适用于土壤硫释放预测。     

Microbial flocculant and its application in environmental protection

１ＩｎｔｒｏｄｕｃｔｉｏｎＡｌｏｔｏｆｖａｒｉｅｄｆｌｏｃｃｕｌａｎｔｓｈａｖｅｂｅｅｎｕｓｅｄｉｎｗａｓｔｅｗａｔｅｒｔｒｅａｔｍｅｎｔ，ｄｒｅｄｇｉｎｇｄｏｗｎｓｔｒｅａｍｐｒｏｃｅｓｓｉｎｇａｎｄｓｏｍｅｉｎｄｕｓｔｒｉａｌｆｉｅｌｄｉｎｃｌ...     

城市固体废物填埋场防护层天然材料研究

提出用石灰和粉煤灰对常用的粘土 +蒙脱土的衬里进行改性。对石灰配比为 0 %、0 4 %、1%、2 %、6 %、10 %的6种复合衬里、“三明治”结构的复合衬里 ,以及粉煤灰比例为 15 % ,2 5 % ,35 % ,5 0 %的 4种复合衬里 ,从渗透系数、衰减能力的角度进行了系列测试 ,得出了石灰配比为 10 %的复合土Ⅰ衬里和“三明治”结构复合土衬里性能良好、成本低、值得推广     

Preparation of PFS coagulant by sectionalized reactor

The oxidation rate of ferrous sulfate is investigated for the preparation of polyferric sulfate(PFS)coagulant.In is proved that this reaction is zero order with respect to Fe^2 ,first order with respect to NO2(g),and first order with respect to the interface area between gas phase and liquid phase.According to this mechanism,sectionalized reactor(SR) is used in place of traditional reactor(TR),and the liquid of reaction mixture is recycled by pump.As a result,not only the flow path of reaction liquid is prolonged,but also gas-liquid contact area enlarged,and the reaction distinctly accelerated,compared with traditional reactor.The effects of parameters including temperature,acidity and others on the reaction rate are also discussed.