矿物材料吸附去除污水中磷的试验研究

采用粉煤灰、高岭土、泥渣(取电厂澄清池排泥作脱水干燥处理)作为吸附剂深度处理污水中的磷,对比分析了3种吸附剂的吸附速度、吸附性能及除磷效果。结果表明:粉煤灰和高岭土用时20 min完成对磷的有效吸附,沉降泥渣用时5 min即可实现同等吸附效果;沉降泥渣对污水中磷的吸附能力较好,投加量为0.2 g/L的泥渣对磷的去除率可达98.1%,而投加量为0.2 g/L粉煤灰或高岭土对磷的去除率仅达到77.2%。     

提升汇流环湿热环境适应性方法研究

目的提高汇流环在湿热环境下的适应能力。方法实物解剖,观察汇流环绝缘材料损坏情况、碳粉堆积情况,在不同温度、湿度下测试绝缘材料绝缘度、抗电强度,碳粉堆积和导电情况,比对不同绝缘材料性能,并找出最适合的绝缘材料,比对滚动汇流环、碳刷组件、刷丝组件,找到解决碳粉堆积的方法。结果汇流环受湿热影响会从接缝处和电缆连接处进入湿气,温度、湿度的上升会使得原绝缘材料性能下降,长时间使用汇流环,碳粉会在汇流环内堆积并受到湿热的影响而导电,局部密封汇流环可以减少湿气进入。PPO材料性能优异,可以替换原绝缘材料从而减少湿热的影响,使用刷丝组件替代碳刷可以避免碳粉的产生。结论综合运用局部密封、绝缘材料改进、碳刷组件改进三种措施,可以有效提高汇流环在湿热环境下的适应能力。     

自动电位滴定法测定水中氯离子

以银电极为响应电极，用硝酸银溶液滴定水中氯离子，等当点时，产生电位突跃，以此确定终点电位，在仪器上锁定的此终点电位值，从而完成样品的自动分析。     

过氧化聚吡咯/聚乙烯吡咯烷酮修饰碳糊电极测定废水中苯酚

建立了过氧化聚吡咯(OPPy)和聚乙烯吡咯烷酮(PVP)修饰碳糊电极测定废水中苯酚的方法.优化了试验条件,苯酚的氧化峰电流在1.0×10-5 mol/L～1.0×10-3 mol/L之间线性关系良好,检出限为1.0×10-6 mol/L.该电极制作简单,选择性好,测定灵敏度高,精密度与准确度均符合要求.     

BOD5测定方法的研究

通过对比实验，对BOD5的测定方法进行研究，探索用氧电极法测定BOD5的可能性和可行性，对其不足之处提出相应的解决措施，使之能更适用于科研、监测教学等方面的需要。     

Carbon Dioxide Balance of Wood Substitution: Comparing Concrete- and Wood-Framed Buildings

In this study a method is suggested to compare the net carbon dioxide (CO₂) emission from the construction of concrete- and wood-framed buildings. The method is then applied to two buildings in Sweden and Finland constructed with wood frames, compared with functionally equivalent buildings constructed with concrete frames. Carbon accounting includes: emissions due to fossil fuel use in the production of building materials; the replacement of fossil fuels by biomass residues from logging, wood processing, construction and demolition; carbon stock changes in forests and buildings; and cement process reactions. The results show that wood-framed construction requires less energy, and emits less CO₂ to the atmosphere, than concrete-framed construction. The lifecycle emission difference between the wood- and concrete-framed buildings ranges from 30 to 130 kg C per m² of floor area. Hence, a net reduction of CO₂ emission can be obtained by increasing the proportion of wood-based building materials, relative to concrete materials. The benefits would be greatest if the biomass residues resulting from the production of the wood building materials were fully used in energy supply systems. The carbon mitigation efficiency, expressed in terms of biomass used per unit of reduced carbon emission, is considerably better if the wood is used to replace concrete building material than if the wood is used directly as biofuel.     

电极旋转放电条件下O3合成效率的理论研究

根据低温等离子体理论和电磁场理论，在实验的基础上研究了电极旋转条件下低温等离子体的产生机制和臭氧的合成机制，分析了放电过程中二次放电重叠对臭氧合成的影响，建立了旋转放电与二次放电的理论模型，并根据这一理论模型导出电极旋转条件下的臭氧合成效率与二次放电重叠概率以及电极旋转速度间的理论关系．这一理论结果表明：二次放电重叠使得臭氧合成效率降低，而电极以适当地速度旋转则可以有效地避免二次放电的重叠，从而提高臭氧的合成效率．理论值和实验结果能够较好地吻合．     

银硫离子选择电极测定工业废水中的硫化物

本法用Ag/S离子选择电极测定废水中的硫化物,测定浓度范围0.1～1000.0mg/l,方法精密度为4.3％,回收率为P2.5％,检出限为0.1mg/l。大多数离子不干扰测定,该法简便快速,适用于例行监测。     

Decomplexation of Cu-1-hydroxyethylidene-1,1-diphosphonic acid by a three-dimensional electrolysis system with activated biochar as particle electrodes

The feasibility of decomplexation removal of typical contaminants in electroplating wastewater, complexed Cu(II) with 1-hydroxyethylidene-1,1-diphosphonic acid (Cu-HEDP), was first performed by a three-dimensional electric reactor with activated biochar as particle electrodes. For the case of 50 mg/L Cu-HEDP, Cu(II) removal (90.7%) and PO initial pH 7, acid-treated almond shell biochar (AASB) addition 20 g/L, and reaction time 180 min, with second-order rate constants of 1.10 × 10⁻³ and 1.94 × 10⁻⁵ min⁻¹respectively. The growing chelating effect between Cu(II) and HEDP and the comprehensive actions of adsorptive accumulation, direct and indirect oxidation given by particle electrodes accounted for the enhanced removal of Cu-HEDP, even though the mineralization of HEDP was mainly dependent on anode oxidation. The performance attenuation of AASB particle electrodes was ascribed to the excessive consumption of oxygen-containing functionalities during the reaction, especially acidic carboxylic groups and quinones on particle electrodes, which decreased from 446.74 to 291.48 µmol/g, and 377.55 to 247.71 µmol/g, respectively. Based on the determination of adsorption behavior and indirect electrochemical oxidation mediated by in situ electrogenerated H₂O₂ and reactive oxygen species (e.g., •OH), a possible removal mechanism of Cu-HEDP by three-dimensional electrolysis was further proposed.     

基于行业全产业链评估一份外卖订单的环境影响

构建"生产-运输-使用-废弃处置"的外卖全产业链，通过大样本企业调研与外卖平台大数据分析，计算8个样本城市不同材质与规格的外卖餐盒、餐具、包装袋的市场使用比例，挖掘骑手配送的海量数据，收集城市垃圾处理处置情况，系统评估外卖全过程的环境影响.结果表明，外卖包装物全产业链中生产环节（45%）与废弃处置环节（50%）为环境影响的主要来源，严重程度依次为固废排放、水污染、资源能源消耗和大气污染.所在城市及选用包装物材质的不同，外卖行业造成的环境影响会有显著区别，全产业链上的各环节需相互配合，多主体共同承担环境责任，采取差别化的减缓应对措施.