乙醇汽油与普通汽油非常规污染物排放特性对比研究

在一台满足国Ⅴ排放标准的双喷射(气口喷射+缸内直喷)汽油机上开展了燃用E10乙醇汽油(乙醇体积比为10%)对发动机非常规排放特性影响的试验研究.使用傅里叶变换红外分析仪(FTIR)测量了饱和烃、不饱和烃、芳香烃及醇、醛等非常规污染物排放量,对比分析了双喷射模式时各工况下E0和E10两种燃料的非常规排放水平.结果表明,双喷射模式下,加入乙醇有效降低了乙烯、1,3-丁二烯、苯和甲苯的排放量,但会导致乙醛排放升高.双喷射模式下,随着负荷增加,两种燃料下的1,3-丁二烯和甲苯排放呈现先升高后降低的趋势,乙烯、甲醛和苯排放则先降低后升高.乙醇能抑制1,3-丁二烯、乙烯生成,抑制效果为PFI模式优于双喷射模式,GDI模式抑制量最低.PFI和GDI模式下E10的甲醛排放均显著升高,但双喷射模式有效抑制了甲醛排放的增加.     

Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

成都市施工扬尘排放特征研究

采用DustTRAK TM气溶胶（粉尘）监测仪对成都市112个不同类别的房建、市政工地施工扬尘进行测试,研究了不同类别施工扬尘的排放特征,分析了下风向扬尘浓度的变化趋势,并采用CALPUFF对成都市新都区某建筑工地的排放进行了模拟.结果表明：（1）成都市施工扬尘排放浓度约为0.13~2.91mg/m³,其中房建类施工平均浓度约为0.94mg/m³,高于市政施工;大型工地扬尘平均浓度约为0.61mg/m³,低于中型和小型工地;土方施工阶段平均浓度约为1.21mg/m³,远高于地基建设、主体建设、装饰阶段.（2）成都市施工扬尘呈现出高低浓度交替的周期性变化,其中房建工程土方施工阶段的高低浓度差值可达到0.6mg/m³以上.（3）施工扬尘在场界外下风向5~15m范围内会出现浓度增加的趋势,随后逐渐下降,在50m附近逐渐趋于稳定,稳定浓度介于0.1~0.2mg/m³.（4）CALPUFF模型能较好地从宏观角度来模拟成都地区施工扬尘的扩散趋势,但难以捕捉施工扬尘在下风向近距离的扩散特征.     

Potential of secondary aerosol formation from Chinese gasoline engine exhaust

Light-duty gasoline vehicles have drawn public attention in China due to their significant primary emissions of particulate matter and volatile organic compounds(VOCs). However,little information on secondary aerosol formation from exhaust for Chinese vehicles and fuel conditions is available. In this study, chamber experiments were conducted to quantify the potential of secondary aerosol formation from the exhaust of a port fuel injection gasoline engine. The engine and fuel used are common in the Chinese market, and the fuel satisfies the China V gasoline fuel standard. Substantial secondary aerosol formation was observed during a 4–5 hr simulation, which was estimated to represent more than 10 days of equivalent atmospheric photo-oxidation in Beijing. As a consequence, the extreme case secondary organic aerosol(SOA) production was 426 ± 85 mg/kg-fuel, with high levels of precursors and OH exposure. The low hygroscopicity of the aerosols formed inside the chamber suggests that SOA was the dominant chemical composition. Fourteen percent of SOA measured in the chamber experiments could be explained through the oxidation of speciated single-ring aromatics. Unspeciated precursors, such as intermediate-volatility organic compounds and semi-volatile organic compounds, might be significant for SOA formation from gasoline VOCs. We concluded that reductions of emissions of aerosol precursor gases from vehicles are essential to mediate pollution in China.     

柴油机尾气中PAH_s的分析

本文概述了柴油机尾气中ＰＡＨｓ的分析方法，着重论述了采样及预处理方法，特别对预处理方法进行了深入的探讨。另外，通过对柴油机两种不同工况下产生的尾气进行分析后发现，柴油机转速越高，其排放尾气中ＰＡＨｓ的含量就越低。     

流动注射法测定水中总碳酸盐

将流动注射应用于水中总碳酸盐的分析,并研究了各种实验条件对于结果的影响。实验证明,这种方法基本不存在干扰,在采样量为0.05ml时,检出限(3σ)为80mg/L;峰高的检测范围100~1000mg/L;峰宽的检测范围1000~5000mg/L,能够很好地应用于火力发电厂中生水、锅炉水的总碳酸盐测定。     

高压密封消解-流动注射同时测定海水中总氮和总磷

建立了高压密封消解-流动注射同时测定海水中总氮和总磷的方法,方法采用特制聚四氟乙烯密封消解罐,经高压消解锅消解后,用流动注射分析仪同时测定海水中的总氮和总磷。结果显示,总氮和总磷在0~3.20 mg/L范围内线性良好,总氮相关系数(r)=0.9997,检出限为0.012 mg/L,相对标准偏差为0.65%~2.59%,加标回收率为97.8%~102%;总磷相关系数(r)=0.9999,检出限为0.006 mg/L,相对标准偏差为0.50%~6.67%,加标回收率为98.8%~101%。该方法可同时测定海水中总氮和总磷,方法准确度和精密度良好,满足分析要求,适用于大批量海水样品中总氮和总磷的快速准确定量。     

Multipoint source method in air pollution modelling of cold start emission

The paper presents a new method of air pollution modelling on a micro scale. For estimation of concentration of car exhaust pollutants, each car is treated as an instantaneous moving emission source. This approach enables us to model time and spatial changes of emission, especially during cold and cool start of an engine. These stages of engine work are a source of significant pollution concentration in urban areas. In this work, two models are proposed: one for the estimation of emission after cold start of the engine and another for the prediction of pollutant concentration. The first model (defined for individual exhaust gas pollutants) enables us to calculate the emission as a function of time after the cold or cool start, ambient temperature and average speed of motion. This model uses the HBEFA database. The second mathematical model is developed in order to calculate the pollutant dispersion and concentrations. The finite volume method is applied to discretise the set of partial differential equations describing wind flow and pollutant dispersion in the domain considered. Models presented in this paper can be called short-term models on a small spatial scale. The results of numerical simulation of pollutant emission and dispersion are also presented.     

内蒙古发展循环经济的方向与政策初探

本文从内蒙古资源、经济与环境问题现状出发，分析了发展循环经济的必要性、紧迫性和可行性，提出了我区建立循环经济的发展战略应考虑的基本原则，发展方向和法律、政策方面的建议。     

流动注射在线氢化物发生—原子荧光光谱法测定环境水样中痕量无机汞和有机汞

提出了一种流动注射在线氢化物发生—原子荧光光谱法测定水样中痕量无机汞和有机汞的分析方法。以溴化剂作为有机汞的消解剂 ,在有、无溴化剂的存在下 ,采用流动注射在线氢化物发生—原子荧光光谱法分别测定总汞和无机汞 ,差减法求出有机汞的含量。方法操作简便快速 ,灵敏度高 ,干扰少 ,经加标回收实验验证 ,回收率达 95 %～ 10 5 %。