Rock phosphate solubilizing and cellulolytic actinomycete isolates of earthworm casts

Four microbial isolates, OP2, OP3, OP6, and OP7, of earthworm casts ofPontoscolex corethrurus were found to be acid tolerant actinomycetes and efficient rock phosphate (RP) solubilizers that could grow fast on NH₄Cl-enriched or N-free carboxymethyl cellulose or glucose as sole carbon source. CMC (carboxymethyl cellulose) induced production of extracellular cellulase enzyme and the production of reducing sugar in all the isolates. RP solubilizing power was observed to be inversely related to glucose consumption. The most efficient RP solubilizer was found to consume the least glucose. Growth was faster on cellulose than on glucose media. N-free CMC induced greater glucose production than NH₄Cl-enriched CMC medium. Both CMC and glucose media were acidified by all the isolates, however, RP solubilizing power decreased with acidification. Solubilization power was greatest with isolate OP7, which also produced the greatest amount of reducing sugar per gram CMC. Both RP solubilizing power and the cellulolytic efficiency varied among isolates. A minimum of 631 μg P/0.1 g RP and a maximum of 951.4 μg P/0.1 g RP was recorded.     

UV/H2O2 oxidation of tri(2-chloroethyl) phosphate: Intermediate products, degradation pathway and toxicity evaluation

Tri(2-chloroethyl) phosphate (TCEP) with the initial concentration of 5 mg/L was degraded by UV/H₂O₂ oxidation process. The removal rate of TCEP in the UV/H₂O₂ system was 89.1% with the production of Cl^? and PO₄^3? of 0.23 and 0.64 mg/L. The removal rate of total organic carbon of the reaction was 48.8% and the pH reached 3.3 after the reaction. The oxidative degradation process of TCEP in the UV/H₂O₂ system obeyed the first order kinetic reaction with the apparent rate constant of 0.0025 min^?1 (R²=0.9788). The intermediate products were isolated and identified by gas chromatography-mass spectrometer. The addition reaction of HO? and H₂O and the oxidation reaction with H₂O₂ were found during the degradation pathway of 5 mg/L TCEP in the UV/H₂O₂ system. For the first time, environment risk was estimated via the “ecological structure activity relationships” program and acute and chronic toxicity changes of intermediate products were pointed out. The luminescence inhibition rate of photobacterium was used to evaluate the acute toxicity of intermediate products. The results showed that the toxicity of the intermediate products increased with the increase of reaction time, which may be due to the production of chlorine compounds. Some measures should be introduced to the UV/H₂O₂ system to remove the highly toxic Cl-containing compounds, such as a nanofiltration or reverse osmosis unit.     

海水中阴极极化对X80钢应力腐蚀及氢脆敏感性的影响

目的研究不同p H值海水中阴极极化对X80管线钢应力腐蚀及氢脆的抑制作用。方法采用慢应变速率拉伸试验、电化学测试、微观组织观察等分析方法。结果 X80钢在天然海水中的析氢电位约为-940m V(vs.SCE,下同),海水p H为3.5时析氢电位发生正移。其应力腐蚀敏感性与极化电位有很大关系,随着极化电位负移,X80钢的氢脆敏感性增加。天然海水中当极化电位负于-950 m V时,断口出现准解理断裂特征形貌。在-1050 m V极化电位下,钢材进入氢脆断裂区发生脆性断裂。海水p H为3.5时,-900 m V钢材有发生氢脆的危险。结论与天然海水相比,X80钢在p H为3.5的酸性海水中具有较高的应力腐蚀敏感性,两种海水介质中X80钢的应力腐蚀敏感性均随极化电位负移而增加。     

氨基酸法现场快速测定废水中的磷酸盐

通过磷酸盐与钼酸盐、氨基酸反应使样品呈淡蓝色,讨论了在事故现场快速测定水中磷的方法。试验表明方法灵敏,操作简单快速。检测范围0～15mg/L。     

Y5复合产絮菌及其产絮物絮凝特性试验研究

从含大量微生物菌群的土壤中筛选出了具有产絮效果的Y5菌液。比较不同培养条件下Y5菌液的絮凝率得出 :菌液絮凝性能是其中 3种复合菌株共同作用的结果 ;培养基初始pH值在 5 .0～ 9.0的范围内时 ,Y5菌液的生长量及其上清液的絮凝率都较高。     

有机磷酸酯诱导迟发性神经毒性及其对神经毒性酯酶（NTE）活性影响的动态研究

以成年产卵来航母鸡为试验动物，研究了三甲基苯基磷酸酯（Ｔｒｉ－ｏ－ＣｒｅｓｙｌＰｈｏｓ－ｐｈａｔｅ，ＴＯＣＰ）诱导的迟发性神经毒性．试验发现，母鸡口服ＴＯＣＰ（７５０ｍｇ／ｋｇ）后，经过大约８－１０ｄ的潜伏期开始出现中毒症状，其表现为以步态失调为主要特征的运动障碍呈进行性加重，至第２１ｄ开始便发展为瘫痪，对鸡脑神经病损靶标酯酶（ＮｅｕｒｏｐａｔｈｙＴａｒｇｅｔＥｎｚｙｍｅ，ＮＴＥ）活性的测定表明，有机械诱导的迟发性神经毒性（Ｏｒｇａｎｏｐｈｏｓｐｈａｔｅ－ＩｎｄｕｃｅｄＤｅｌａｙｅｄＰｏｌｙｎｅｕｒｏｐａｔｈｙ，ＯＰＩＤＰ）与ＮＴＥ活性抑制之间的关系不平行，其毒性症状的轻重与ＮＴＥ活性被抑制的强弱也不呈正相关，很可能，在给药后２４ｈ，体内ＯＰＩＤＰ已被触发，此外，实验观察到给予ＴＯＣＰ后被试鸡的体重明显下降。     

溶解氧对水质变化和沉积物吸磷过程的影响

通过室内模拟实验,研究有光和黑暗条件下,富氧和缺氧环境对东太湖沉积物吸收磷酸盐过程的影响.研究结果表明沉积物能够吸收上覆水中高质量浓度的磷酸盐,但吸收量和吸收速度随环境条件的不同而不同;缺氧环境上覆水中的pH高于或略高于相同光照条件下的富氧环境;实验开始的前20d,富氧环境有利于沉积物吸附上覆水中的磷酸盐,并快速达到吸附平衡,缺氧环境则相反;实验开始20d后,有光缺氧组上覆水中磷酸盐质量浓度开始迅速下降,且明显低于其他实验条件;富氧环境沉积物中总磷的增加量高于缺氧环境,其含量顺序为无光富氧＞有光富氧＞有光缺氧＞无光缺氧;溶解氧对沉积物中铁结合态磷和钙结合态磷含量的影响较大,对有机磷含量的影响不大.     

变速器壳体低周疲劳优化设计

目的 分析变速器壳体驻车耐久试验的失效根本原因,对变速器壳体进行低周疲劳优化设计.方法 首先排查壳体的化学成分、铸造质量,排除材料和工艺引起失效问题的可能性,然后通过有限元方法分析驻车轴孔的最大拉应变、驻车工况壳体变形、轴孔接触区域.根据局部应变分布特征,提出驻车轴修形的优化方案,并且根据壳体材料的低周疲劳参数,确定Coffin-Manson模型,并根据该模型预测壳体驻车轴孔优化前后的疲劳寿命.结果 驻车轴孔的最大拉应变高达0.95％,确定应变过大是导致壳体失效的根本原因.驻车轴度修形的优化方案将最大拉应变降低到0.40％,塑性应变占比由42％降低到5％,疲劳寿命的预测值由原来的175次提高到7980次,满足试验循环次数1000次的要求,最终优化物理样机通过了驻车耐久试验验证.结论 使用的Coffin-Manson模型参数能准确地预测变速器壳体的低周疲劳寿命,驻车轴小角度修形优化方案能够有效解决局部应变过大的失效问题,具有一定的工程参考意义.     

大型车车身覆盖件冲压成形特征分析及选材研究

为满足大型车身覆盖件冲压成形要求并实现钢板与零件的对路供应 ,必须在深入解析零件成形特征的基础上 ,确定高应变部位的成形敏感材料参数。在材料力学性能测试和成形极限分析的基础上 ,对侧围外板的冲压成形特征和成形敏感参数进行了分析。结果表明 :侧围外板零件高应变部位的变形方式为胀形 深拉延变形 ,n值和r值为影响侧围外板零件成形的主要材料敏感参数     

Simultaneous sorption of aqueous phenanthrene and phosphate onto bentonites modified with AlCl3 and CTMAB

The purpose of this work is to synthesize a new type of bentonite sorbent that can simultaneously remove both organic compounds and phosphate from water. Inorganic-organic bentonites (Al-CTMAB-Bent) were synthesized by modifying bentonites with both AlCl₃ and cetyltrimethyl ammonium bromide (CTMAB). Simultaneous sorption of aqueous phenanthrene and phosphate onto Al-CTMAB-Bent was examined. Removal rates of phenanthrene and phosphate from water reached 96.3% and 90.2%, respectively, at their respective initial concentrations of 1 mg/L and 5 mg/L and the added amount of Al-CTMAB-Bent was 1.25 g/L. The residual turbidity of the Al-CTMAB-Bent suspension decreased 81.4% compared to that of organobentonite suspension after a 1 h settling time. Thus, inorganic-organic bentonite can be used to treat wastewater containing both organic pollutants and phosphate. Translated from Environmental Science, 2006, 27(1): 91–94 [译自: 环境科学]