Application of gaseous ozone for inactivation of Bacillus subtilis spores

The effectiveness of gaseous ozone (O3) as a disinfectant was tested on Bacillus subtilis spores, which share the same physiological characteristics as Bacillus anthracis spores that cause the anthrax disease. Spores dried on surfaces of different carrier material were exposed to O3 gas in the range of 500-5000 ppm and at relative humidity (RH) of 70-95%. Gaseous O3 was found to be very effective against the B. subtilis spores, and at O3 concentrations as low as 3 mg/L (1500 ppm), approximately 3-log inactivation was obtained within 4 hr of exposure. The inactivation curves consisted of a short lag phase followed by an exponential decrease in the number of surviving spores. Prehydration of the bacterial spores has eliminated the initial lag phase. The inactivation rate increased with increasing O3 concentration but not >3 mg/L. The inactivation rate also increased with increase in RH. Different survival curves were obtained for various surfaces used to carry spores. Inactivation rates of spores on glass, a vinyl floor tile, and office paper were nearly the same. Whereas cut pile carpet and hardwood flooring surfaces resulted in much lower inactivation rates, another type of carpet (loop pile) showed significant enhancement in the inactivation of the spores.     

Production of Fe2O3 from FeSO4·xH2O formed in galvanizing works

FeSO₄·xH₂O is generated in large amounts in galvanizing workshops. It can be reutilized by conversion to Fe₂O₃. In this study, the recovery of Fe₂O₃ from FeSO₄·xH₂O formed in the galvanizing process has been examined. The experimental work was carried out at various temperatures and times in the oxidizing medium. The reaction temperatures and times were selected as 450, 500, 550, 600, 650, 700, 800 and 900°C, and 15, 30, 45, 60, 90 and 120 minutes, respectively. In order to determine the amount of Fe₂O₃, a titrimetric method was applied. The reaction products were characterized by means of IR and XRD techniques.The extent of conversion is low at temperatures below 650°C. Almost all of the iron (II) sulfate in the original sample was converted to iron(III) oxide at 650°C (120 min), 700°C (90 min), 800°C (60 min) and 900°C (45 min).     

Phosphate uptake and release rates with different carbon sources in biological nutrient removal using a SBR

A three-step sequencing batch reactor (SBR) was used for nutrient removal from synthetic wastewater with different glucose-organic acid mixtures (1/1). Acetic, butyric, propionic and citric acids were used as organic acids along with glucose. The operation consisted of anaerobic, anoxic and oxic (An/Ax/Ox) phases with durations of 2/1/4.5h. Sludge age was kept constant for 10 days. Phosphate release and uptake rates were determined for different glucose-organic acid mixtures in the feed wastewater. Maximum phosphate uptake (8.1mgPl(-1)h(-1)) and release rates (2.23mgPl(-1)h(-1)) were obtained with the glucose-citric acid mixture. The highest (96%) percent phosphate removal at the end of the nutrient removal cycle (7.5h) was also obtained with the glucose-citric acid mixture while the glucose-acetic acid mixture resulted in comparable percent phosphate removal (95%).     

Vegetation as an Indicator of Soil Properties and Water Quality in the Akarçay Stream (Turkey)

In this study, the relationship among water quality, soil properties, and plant coverage in the region of the Akarçay stream was examined. Correlation analyses were carried out between soil samples taken from each of four plant communities in the Akarçay basin and water in the Akarçay stream. The four plant communities in the study area are as follows: Limonium lilacinum (Boiss. et Bal.) Wag., Alhagi pseudalhagi (M. Bieb.) Desv. Peganum harmala L., and Hordeum marinum Huds. subsp. marinum. B, Cl, EC, K, Mg, Na, pH, and SO₄ data from both soil and water samples were subjected to statistical analysis, and significant correlations were obtained (p < 0.05). These correlations indicated that the chemical features of the soil had a major effect on water quality. The important parameters were B, Cl, EC, K, Mg, Na, pH, and SO₄ for Limonium lilacinum communities; Ca, K, and pV for Peganum harmala; and B, Cl, Mg, pH, and pV for Alhagi pseudalhagi. There were also statistically significant relationships (p < 0.05) among the parameters examined. These findings strongly suggested that these plant communities can be used as indicators for soil chemistry and water quality.     

Assessment of heavy metal concentrations in the food web of lake Beyşehir, Turkey

The accumulation of heavy metals (Cd, Pb, Hg and Cr) was measured by atomic absorption spectrophotometry in water, sediment, plankton and fish samples collected from Lake Bey?ehir, which is important bird nesting and visiting areas, and irrigation and drinking water sources. In Lake Bey?ehir, the accumulation orders of heavy metals were Cd>Pb>Cr>Hg in water, Pb>Cd>Cr>Hg in sediment, Pb>Cd>Cr>Hg in plankton, and Cd>Pb>Cr>Hg in the muscles and gills of chub, carp, tench, except for the muscle of pikeperch, in which it was Pb>Cd>Cr>Hg (P<0.05). In addition to this, accumulation orders of heavy metals in the food web was also found to be water>plankton>sediment>fish tissues, except for Cr. According to international criterias and Turkish regulations, heavy metal concentrations especially Cd and Pb in Lake Bey?ehir were markedly above the permissible levels for drinking water.     

Heavy metals in mullet, Liza abu, and catfish, Silurus triostegus, from the Atatürk Dam Lake (Euphrates), Turkey

The distribution of some heavy metals in three different organs of mullet, Liza abu, and catfish, Silurus triostegus, from Atatürk Dam Lake located on Euphrates (Turkey) was studied. Co and Mo concentrations were below limits of detection in all fish organs, whereas Ni was also below limits in organs of mullet. The metal accumulation in the liver and gill of L. abu and S. triostegus was found to be quite high in comparison with the muscle. In general, the concentrations are similar to those previously observed on other fish studied in Atatürk Dam Lake and lower than those determined in Tigris River. The analysed metals (Co, Cu, Fe, Mn, Mo, Ni and Zn) were found in fish muscle at mean concentrations under the permissible limits proposed by FAO.     

Impacts of land use conversion on soil properties and soil erodibility

Land use conversion can affect natural ecological processes such as surface runoff and erosion. Therefore, it has potential to change soil stability To investigate this process in depth, Iskalan creek catchment in the Black sea region, where excessive land use applications and erosion events have often occured, was selected as the study area. The objective was to determine the effects of land use conversion on soil properties, soil erodibility and the relationships among soil properties and some erodibility indices. Duplicate topsoil samples were taken by using steel cylinders at 100 different sampling points from three different land use types; 34 of them are in farmlands, 34 in rangelands and 32 in forestlands. Soil particle size distribution, loss of ignition, pH, electrical conductivity skeleton percentage and three erodibility indices were determined. Data were analysed by using Pearson correlation analysis (at 95% and 99% significance level), ANOVA and Tukey's test at 95 % significance level. According to study results, land use conversion affects some properties of soils significantly Loss of ignition of soils in forests was significantly higher than soils in farmlands and rangelands. Soil skeleton percentage in rangelands and farmlands were significantly different. The study results showed that there was significant difference between pH of soils in forests and farmlands (p < 0.05). Pearson correlation analysis results showed significant correlations among erodibility indices and certain soil properties such as clay and sand fraction of soils (p < 0.05 and p < 0.01). Topsoils of the study area were sensitive to erosion according to all three erodibility indices. The most sensitive soils were in farmlands.     

Mapping of bioclimatic comfort for potential planning using GIS in Aydin

People are relaxed (satisfied or well-off) in what is described as comfortable climatic conditions. In such conditions, a person’s energy balance is not disturbed because of stresses from extreme heat or cold. Bioclimatic structure has been well researched and should be a consideration in the planning process for arranging comfortable spaces. It represents the understanding that energy balance is one of the basic elements of a sustainable landscape design. The goals of this study have been to create ideal places for human thermal comfort and to advance objectives focused on the importance of sustainable and ecological landscape planning and design work, along with their accompanying economic benefits. In this study, which focuses on the climate of the Province of Aydin, the most suitable areas for bioclimatic comfort have been identified. The climate values for the Aydin Province have been taken from a total of 22 meteorological stations. Stations at altitudes ranging from 11 to 871 m were used to note the climate changes that occurred. The average temperature, relative humidity, and wind speed from each station, including data collected using Geographic Information System (GIS) software, were transferred. GIS maps were then created from the imported data, and areas of optimal comfort around the city of Aydin were determined. The results show the range that is suitable for a bioclimatic comfort zone in Aydin. The bioclimatic comfort range was determined to be roughly 17 °C for Aydin, and the city of Aydin demonstrated a comfort range between 14 and 19 °C. As a result, the city of Aydin was shown to be a suitable area for bioclimatic comfort.