Effects of fly ash addition on physical properties of porous clay-fly ash composites via polymeric replica technique

The porous composites of clay and fly ash have the potential to be used in many fields, such as catalyst support and gas adsorbents. In this study, various ratios of fly ash (1–2) with different percentage of suspension (50–70 wt%) were applied to produce porous clay-fly ash composites via polymeric replica technique. Fabrication process starts by mixing clay and fly ash in distilled water to form slurry. The process is followed by fully immersing polymer sponge in slurry. The excess slurry is then removed through squeezing. Finally, the sponge coated with slurry is sintered at 500 and 1250 °C for 1 h. It is found that the compressive strength of porous composites improves significantly (0.178–1.28 MPa) when the amount of clay-fly ash suspension mixture (50–70 wt%) increases. The compressive strength of porous composites is mainly attributed to the mullite, quartz and amorphous phase formations. These results are supported by X-ray diffraction analysis. On the other hand, increase in the amount of suspension reduces the apparent density (from 2.44 to 2.32 g/cm³) and porosity (from 97 to 85 %). The reduction in apparent density is believed to be caused by the presence of high fly ash content in porous composites. The melted fly ash cenospheres have closed the internal pores and increased density of samples. Higher suspension level not only reduces porosity, but also increases close pores of the porous composites. The results are justified through the observation from the structures of porous clay-fly ash composites.     

Thermotolerant coliform loadings to coastal areas of Santa Catarina (Brazil) evidence the effect of growing urbanisation and insufficient provision of sewerage infrastructure

Thermotolerant coliform (TC) loadings were quantified for 49 catchments draining into the North and South Bays of Santa Catarina (SC, southeastern Brazil), an area known for its tourism and aquaculture. TC loadings were calculated based on flow measurements taken in 26 rivers. TC concentrations ere quantified based on surface water samples collected at 49 catchment outlets in 2012 and 2013. Median TC loads ranged from 3.7 × 10³ to 6.8 × 10⁸ MPN s^?1. TC loadings in the catchments increased in proportion to increases in resident human population, population density and percentage of urbanised area. Catchments with more than 60% of area covered by wastewater collection and treatment systems had higher TC loads per person than catchments with less than 25%. Based on the study catchments, these results indicate that current sewerage infrastructure is ineffective in reducing contamination of faecal origin to surface waters. These findings have important implications for the management of microbiological health hazards in bathing, recreational and shellfish aquaculture waters in the North and South Bays of Santa Catarina Island.     

Diversity of crude oil-degrading bacteria and alkane hydroxylase (<Emphasis Type="Italic">alkB</Emphasis>) genes from the Qinghai-Tibet Plateau

The aim of this study was to survey the response of the microbial community to crude oil and the diversity of alkane hydroxylase (alkB) genes in soil samples from the Qinghai-Tibet Plateau (QTP). The enrichment cultures and clone libraries were used. Finally, 53 isolates and 94 alkB sequences were obtained from 10 pristine soil samples after enrichment at 10 °C with crude oil as sole carbon source. The isolates fell into the phyla Proteobacteria, Actinobacteria, and Bacteroidetes, with the dominance of Pseudomonas and Acinetobacter. The composition of degraders was different from polar habitats where Acinetobacter sp. is not a predominant responder of alkane degradative microbial communities. Phylogenetic analysis showed that the alkB genes from isolates and enrichment communities formed eight clusters and mainly related with alkB genes of Pseudomonas, Rhodococcus, and Acinetobacter. The alkB gene diversity in the QTP was lower than marine environments and polar soil samples. In particular, a total of 10 isolates exhibiting vigorous growth with crude oil could detect no crude oil degradation-related gene sequences, such as alkB, P450, almA, ndoB, and xylE genes. The Shannon-Wiener index of the alkB clone libraries from the QTP ranged from 1.00 to 2.24 which is similar with polar pristine soil samples but lower than that of contaminated soils. These results indicated that the Pseudomonas, Acinetobacter, and Rhodococcus genera are the candidate for in situ bioremediation, and the environment of QTP may be still relatively uncontaminated by crude oil.     

Trace elements in muscle of three fish species from Todos os Santos Bay,Bahia State,Brazil

In this study, an analysis was performed on the concentrations of the trace elements Al, As, Ba, Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, V, and Zn in muscle of two carnivorous and one planktivorous fish species collected at Todos os Santos Bay (BTS). The accumulation order of the trace elements in Lutjanus analis was Al >Zn >Fe >Cr >Ba >Ni. In Cetengraulis edentulus, the order was Al >Fe >Zn >Cr >Ni >Mn >As. In the species Diapterus rhombeus, the order was Al >Fe >Zn >Cr >Ni >Mn >Cd. To determine the risk related to the consumption of fish, toxicity guidelines were used as standard references. It was observed that the species C. edentulus contained concentrations of As exceeding WHO limits, but these concentrations were acceptable according to the Agência Nacional de Vigilância Sanitária (ANVISA) guidelines. Cd levels were found only in D. rhombeus and in low concentrations according to the determinations of WHO and ANVISA. Pb levels were not detected in any of the three fish species. The analyzed elements did not differ statistically according to the species and feeding habits. The results point to possible risks of human contamination by As related to the consumption of the fish species C. edentulus from the BTS.     

Spatial distribution and concentration of sulfur in relation to vegetation cover and soil properties on a reclaimed sulfur mine site (Southern Poland)

This work aims to assess the spatial distribution and concentration of sulfur in the topsoil layer and to determine the relationships between sulfur concentration, soil pH, soil electrical conductivity, and plant cover at the reforested site of the former sulfur mine (Southern Poland). Soil samples were collected from 0 to 20 cm (topsoil) from a total of 86 sampling points in a regular square grid with sides of 150 m. Plant cover was assayed in circular plots with an area of 100 m², divided into a woody plant layer and herbaceous plant layer. Soil properties such as particle size distribution, pH in KCl and H₂O, soil electrical conductivity (EC), soil organic carbon (SOC), total nitrogen (N_T), and total sulfur (S_T) were determined. The degree of soil contamination with sulfur was assessed based on the guidelines of the Institute of Soil Science and Plant Cultivation (IUNG), Poland. The results indicate that remediation and application of lime were not fully effective in spatial variation, because 33 points with sulfur contamination above 500 mg kg^?1 were observed. These spots occurred irregularly in the topsoil horizons. This high sulfur concentration in the soil did not result in severe acidification (below 4.5) in all cases, most likely due to neutralization from the application of high doses of flotation lime. High vegetative cover occurred at some points with high soil sulfur concentrations, with two points having S concentration above 40,000 mg kg^?1 and tree cover about 60%. Numerous points with high soil EC above 1500 μS cm^?1 as well as limited vegetation and high soil sulfur concentrations, however, indicate that the reclamation to forest is still not completely successful.     

Assessment of urban sustainability efficiency based on general data envelopment analysis: a case study of two cities in western and eastern China

Sustainable urban development focuses on enhancing urban well-being, while also balancing the demands of urban social and economic development, natural resource consumption, and environmental pollution. This work used general data envelopment analysis to assess the urban sustainability efficiency (USE) and sustainability potential (SP) in Lanzhou and Xiamen, two cities that are characteristic of urban areas in western and eastern China. The assessment indicator system included important natural and urban welfare factors as input and output indices, respectively. The results showed that overall urban sustainability efficiency increased in Lanzhou and Xiamen from 1985 to 2010, but that the sustainability of natural resources clearly decreased. The urban sustainability efficiency of Xiamen was higher than that of Lanzhou, and the sustainability potential of Xiamen was lower than that of Lanzhou; this indicates that Xiamen performed better in terms of urban sustainable development. The urban sustainability efficiency in Xiamen has increased with increasing urban population, and the rate and scale of economic development have been higher than in Lanzhou. The assessment and analysis performed in this study show that cities with different natural resources and development characteristics have different forms, patterns, and trajectories of sustainable development.     

The methylic versus the ethylic route: considerations about the sustainability of Brazilian biodiesel production

Brazil is considered one of the world’s leading producers of biofuels given the predominance of ethanol fuel in its energy matrix. However, despite the prominence of Brazil in ethanol production, the vast majority of biodiesel production plants in Brazil use methanol instead of ethanol as the alcohol for transesterification reaction, as is generally the case in the rest of the world. The aim of this paper is therefore to examine the transesterification process in the Brazilian biodiesel production in terms of sustainability. In this regard, it was necessary to evaluate the way in which the industrial process is currently carried out, the role of government incentives or subsidies for the use of ethanol to produce biodiesel, and the investments of companies in technology development for the same purpose. This study presents indications that the development of the biodiesel market in Brazil is still oriented toward a production model which is inconsistent with the environmental and social aspects of sustainability.     

The Role of Wind in Modeling of Oil Pollution Transport and Diffusion in the Persian Gulf

The Persian Gulf ecosystem is facing a variety of stresses as a result of being located within the richest oil province in the world, which hosts more than 67 % of the world oil reserve. In this paper, the distribution of oil pollution on the surface layer of the Persian Gulf is predicted for the different months after the release, based on the Coupled Hydrodynamical Ecological model for Regional Shelf seas (COHERENS). An Eulerian model for the Persian Gulf is set up using the Cartesian coordinate in the horizontal direction, and the sigma coordinate in the vertical direction. Based on this model, our analysis and simulation results indicate that the winds lead to diffusion of the contaminant concentration in the direction of the Arabian coast from the initial position of the spill. The results of this study can be used to provide appropriate solutions for preventing oil from spreading further in the region.     

Solar energy for electricity and fuels

Solar energy conversion into electricity by photovoltaic modules is now a mature technology. We discuss the need for materials and device developments using conventional silicon and other materials, pointing to the need to use scalable materials and to reduce the energy payback time. Storage of solar energy can be achieved using the energy of light to produce a fuel. We discuss how this can be achieved in a direct process mimicking the photosynthetic processes, using synthetic organic, inorganic, or hybrid materials for light collection and catalysis. We also briefly discuss challenges and needs for large-scale implementation of direct solar fuel technologies.     

Soil C and N models that integrate microbial diversity

Industrial agriculture is yearly responsible for the loss of 55–100 Pg of historical soil carbon and 9.9 Tg of reactive nitrogen worldwide. Therefore, management practices should be adapted to preserve ecological processes and reduce inputs and environmental impacts. In particular, the management of soil organic matter (SOM) is a key factor influencing C and N cycles. Soil microorganisms play a central role in SOM dynamics. For instance, microbial diversity may explain up to 77 % of carbon mineralisation activities. However, soil microbial diversity is actually rarely taken into account in models of C and N dynamics. Here, we review the influence of microbial diversity on C and N dynamics, and the integration of microbial diversity in soil C and N models. We found that a gain of microbial richness and evenness enhances soil C and N dynamics on the average, though the improvement of C and N dynamics depends on the composition of microbial community. We reviewed 50 models integrating soil microbial diversity. More than 90 % of models integrate microbial diversity with discrete compartments representing conceptual functional groups (64 %) or identified taxonomic groups interacting in a food web (28 %). Half of the models have not been tested against an empirical dataset while the other half mainly consider fixed parameters. This is due to the difficulty to link taxonomic and functional diversity.