Difference in the net value of ecological services between natural and artificial forests in China

Land degradation is a global problem that seriously threatens human society. However, in China and elsewhere, ecological restoration still largely relies on a traditional approach that focuses only on ecological factors and ignores socioeconomic factors. To improve the effectiveness of ecological restoration and maximize its economic and ecological benefits, a more efficient approach is needed that provides support for policy development and land management and thereby promotes environmental conservation. We devised a framework for assessing the value of ecosystem services that remain after subtracting costs, such as the opportunity costs, costs of forest protection, and costs for the people who are affected by the program; that is, the net value of ecosystem services (NVES). To understand the difference between the value of a resource and the net value of the ecosystem service it provides, we used data on VES, timber sales, and afforestation costs from China's massive national afforestation programs to calculate the net value of forest ecosystem services in China. Accounting for the abovementioned costs revealed an NVES of ¥6.1 × 10¹² for forests in 2014, which was 35.9% less than the value calculated without accounting for costs. As a result, the NVES associated with afforestation was 55.9% less than the NVES of natural forests. In some regions, NVES was negative because of the huge costs of human-made plantations, high evapotranspiration rates (thus, high water opportunity costs), and low forest survival rates. To maximize the ecological benefits of conservation, it is necessary to account for as many costs as possible so that management decisions can be based on NVES, thereby helping managers choose projects that maximize both economic and ecological benefits.     

石家庄市春季大气颗粒物的铅污染特征

为了解石家庄市2016年春季大气颗粒物的铅污染特征及来源,利用单颗粒气溶胶质谱仪(SPAMS),分析了大气中含铅颗粒的化学成分。结果表明: 研究期间大气环境中含铅颗粒数浓度共出现11次跳跃式升高,跳跃时间段内石家庄均处于轻度污染过程。从成分分析来看,含铅颗粒分为纯铅颗粒、Pb与K(Pb-K)、OC(Pb-OC)、Cl(Pb-Cl)、混合颗粒等八大类。观测结果表明:Pb-K颗粒最多,占到含铅颗粒的84.4%；其次为纯铅颗粒,占比为13.0%。与石家庄市污染源谱库比对进行来源解析,得到Pb-K颗粒主要来自生活垃圾焚烧源, 纯铅颗粒主要来自工业源。结合石家庄市大气污染源排放清单和后向气流轨迹分析,推测含铅颗粒可能来自市区西南方向某区县的生活垃圾焚烧企业。     

The associations of air pollution exposure during pregnancy with fetal growth and anthropometric measurements at birth: a systematic review and meta-analysis

Environmental Science and Pollution Research - Fetal growth has been demonstrated to be an important predictor of perinatal and postnatal health. Although the effects of maternal exposure to air...     

气质联用法测固定污染源中三氟甲烷、四氟甲烷、六氟乙烷和六氟化硫

建立了固定污染源排气中三氟甲烷、四氟甲烷、六氟乙烷和六氟化硫的采样和气质联用分析方法,检出限分别为0.06、0.15、0.21、0.71 mg/m3,精密度在3.2%以下,相关系数大于0.999 6,并对浙江省内2家典型企业排放的温室气体进行了监测,实际样品监测结果表明,该方法能够满足废气中4种温室气体的监测要求。     

2013年苏州春季一次重污染天气的过程分析

研究了2013年3月在江苏范围内的一次重污染天气过程，重点分析苏州在此次污染过程中大气污染的变化特征。污染过程中，苏州市颗粒物浓度上升较为明显， PM10的小时质量浓度最高达548μg／m3， PM2．5质量浓度也达到197μg／m3，污染持续时间为2 d，3月8—9日当地空气质量均达到中度污染水平。根据后向轨迹模型、颗粒物离子浓度的分析，此次污染是由外来浮尘及苏州本地污染物排放所造成的区域霾污染影响所致。根据监测结果与实际污染特征，针对性地提出了对策和措施。     

城市大气中挥发性有机化合物监测技术进展

挥发性有机物(VOCs)是臭氧及二次有机颗粒物(SOA)的主要前体物。近年来,我国逐步将VOCs纳入大气污染物控制体系。准确可靠的监测技术是大气VOCs研究及控制的重要前提保障。按照采样方法、分析方法 2个方面介绍并讨论了城市大气中VOCs的现有监测方法,较为详细地介绍了几类广泛采用的离线及在线监测技术,简要讨论了目前VOCs监测中存在的一些问题,展望了今后的发展趋势。     

淮河支流污染物综合降解系数动态测算

确定河流污染物综合降解系数动态变化规律对提高水环境容量测算精度和水环境管理具有重要意义。通过现场模拟法,采用一维稳态模型测算了淮河支流洪河五沟营-塔桥乡河段COD、氨氮和总磷在枯水期、平水期和丰水期的综合降解系数,COD、氨氮和总磷降解系数在各水期的关系为枯水期平水期丰水期,提出了建议值并利用实测浓度对计算结果进行了检验,结果表明,不同水期综合降解系数吻合情况较好。     

网状季胺基阴离子吸附剂制备及吸附性能

以丝瓜络为原料,采用醚化-接枝技术制备出季胺基阴离子交换吸附剂。采用电镜扫描、傅里叶红外光谱、比表面积孔径分布测定仪和元素分析仪等仪器对其进行分析和结构表征,并考察了温度、p H和硝酸盐初始浓度等因素对NO-3去除率的影响。实验结果表明,在20℃,p H值为3~10时,NO-3的吸附率可达90%左右;在不同温度下该吸附过程用Langmuir等温线模型和Freundich等温线模型描述均可;与伪一级动力学方程相比,伪二级动力学方程能更好地描述其吸附动力学方程。     

活性炭吸附和两级Fenton氧化组合工艺处理高盐对氨基苯酚生产废水

采用活性炭吸附和两级Fenton氧化组合工艺对高盐度对氨基苯酚生产废水进行了处理实验研究。结果表明,p H值对活性炭去除有机物的影响较小。当活性炭投加量为4 g/L时,TOC去除率61%。分级加药可以有效提高Fenton氧化对有机物的去除效率。在温度为25℃、p H为3、30%H2O2投加量为3%(V/V)、Fe2+/H2O2摩尔比为0.05时,两级Fenton氧化处理后,出水TOC降至150 mg/L以下。此外,Fenton氧化后形成氢氧化铁污泥颗粒粒径为4.5μm,经过聚丙烯酰胺(PAM)絮凝之后,污泥的粒径明显增加,过滤特性改善。PAM絮凝效果依赖于溶液的p H值,当p H超过10后会失去作用,故在使用过程中需要严格控制溶液的p H值。