Urinary levels of phthalate metabolites and associations with demographic characteristics in Korean adults

The objective of this study is to assess human exposure to phthalates and its associations with demographic characteristics of the subjects in the Korean National Human Biomonitoring Survey. The subjects aged between 18 and 69 were selected through nationwide stratified sampling. A total of 1874 urine samples were collected and stored at ?20 °C until measurement for ten selected metabolites of phthalates (MnBP, MiBP, MBzP, MCHP, MnOP, MEHP, MEOHP, MEHHP, MiNP, and MiDP) using high-performance liquid chromatography-tandem mass spectrometry (LC-MS/MS). The difference in the level of urinary phthalate metabolites by the characteristics of the subjects was tested for statistical significance using SAS Surveyreg procedure. The coefficients and standard errors from multiple linear regressions were exponentiated to estimate the adjusted proportional change (APC) and 95% CIs compared with a referent level. The proportion of data above LOQ was less than 20% for MCHP, MnOP, MiNP, and MiDP. Geometric means of creatinine-adjusted concentrations (unit: μg/g creatinine) of six other phthalate metabolites among Korean adults were 41.7 (95% CI 39.6–43.9) for MnBP, 17.1 (95% CI 16.1–18.1) for MiBP, 15.7 (95% CI 14.4–17.1) for MBzP, 8.65 (95% CI 8.10–9.22) for MEHP, 17.5 (95% CI 16.8–18.3) for MEOHP, and 38.1 (95% CI 36.2–40.2) for MEHHP. Urinary level of phthalates tended to be higher among subjects with older age, females, and those with vigorous daily physical activity and tended to be lower among drinkers and those with higher income. Our results suggest that the level of phthalate exposure is significant among Korean adults and thus warrants further studies to identify major source and route of exposure to phthalates.     

Chemical characteristics of fine particulate matters measured during severe winter haze events in Ulaanbaatar,Mongolia

In order to investigate the chemical characteristics of atmospheric aerosol measured during a severe winter haze event, 12-hr PM_2.5 (particulate matter with an aerodynamic diameter ≤2.5 μm) samples were collected at an urban site in Ulaanbaatar, Mongolia, from January 9 to February 17, 2008. On average, 12-hr PM_2.5 mass concentration was 105.1 ± 34.9 μg/m³. Low PM_2.5 mass concentrations were measured when low pressure developed over central Mongolia. The 12-hr average organic mass by carbon (OMC) varied from 6.4 to 132.3 μg/m³, with a mean of 54.9 ± 25.4 μg/m³, whereas elemental carbon (EC) concentration ranged from 0.1 to 3.6 μgC/m³, with a mean of 1.5 ± 0.8 μgC/m³. Ammonium sulfate was found to be the most abundant water-soluble ionic component in Ulaanbaatar during the sampling period, with an average concentration of 11.3 ± 5.0 μg/m³. In order to characterize the effect of air mass pathway on fine particulate matter characteristics, 5-day back-trajectory analysis was conducted, using the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model. The haze level was classified into three categories, based on the 5-day air mass back trajectories, as Stagnant (ST), Continental (CT), and Low Pressure (LP) cases. PM_2.5 mass concentration during the Stagnant condition was approximately 2.5 times higher than that during the Low Pressure condition, mainly due to increased pollutant concentration of OMC and secondary ammonium sulfate.

Implications: Mongolia is experiencing rapid rates of urbanization similar to other Asian countries, resulting in air pollution problems by the growing number of automobiles and industrialization. Ulaanbaatar, capital of Mongolia, is inherently vulnerable to air pollution because of its emission sources, topography, and meteorological characteristics. Very limited measurements on chemical characteristics of particulate matter have been carried out in Ulaanbaatar, Mongolia.     

Overflow risk analysis for designing a nonpoint sources control detention

This paper presents a design method by which the overflow risk related to a detention for managing nonpoint pollutant sources in urban areas can be evaluated. The overall overflow risk of a nonpoint pollutant sources control detention can be estimated by inherent overflow risk and operational overflow risk. For the purpose of calculating overflow risk, the 3-parameter mixed exponential distribution is applied to describe the probability distribution of rainfall event depth. As a rainfall-runoff calculation procedure required for deriving a rainfall capture curve, the U.S. Natural Resources Conservation Service runoff curve number method is applied to consider the nonlinearity of the rainfall-runoff relation. Finally, the detention overflow risk is assessed with respect to the detention design capacity and drainage time. The proposed overflow risk assessment is expected to provide a baseline to determine quantitative parameters in designing a nonpoint sources control detention.     

Optimization of Carbon Dioxide and Valeric Acid Utilization for Polyhydroxyalkanoates Synthesis by Cupriavidus necator

The utilization of captured CO₂ as a part of the CO₂ capture and storage system to produce biopolymers could address current environmental issues such as global warming and depletion of resources. In this study, the effect of feeding strategies of CO₂ and valeric acid on cell growth and synthesis of poly(3-hydroxybutyrate-co-3-hydroxyvalerate) [P(3HB-co-3HV)] in Cupriavidus necator was investigated to determine the optimal conditions for microbial growth and biopolymer accumulation. Among the studied CO₂ concentrations (1–20 %), microbial growth and poly(3-hydroxybutyrate) accumulation were optimal at 1 % CO₂ using a gas mixture at H₂:O₂:N₂ = 7:1:91 % (v/v). When valeric acid was fed together with 1 % CO₂, (R)-3-hydroxyvalerate synthesis increased with increasing valeric acid concentration up to 0.1 %, but (R)-3-hydroxybutyrate synthesis was inhibited at >0.05 % valeric acid. Sequential addition of valeric acid (0.05 % at Day 0 followed by 0.025 % at Day 2) showed an increase in 3HV fraction without inhibitory effects on 3HB synthesis during 4 d accumulation period. The resulting P(3HB-co-3HV) with 17–32 mol  % of 3HV is likely to be biocompatible. The optimal concentrations and feeding strategies of CO₂ and valeric acid determined in this study for microbial P(3HB-co-3HV) synthesis can be used to produce biocompatible P(3HB-co-3HV).     

Gasification characteristics of biomass for tar removal by secondary oxidant injection

Gasification experiments for sawdust were conducted using a fixed bed reactor at 900 °C by varying the secondary oxidant injection ratio to determine the optimal conditions for tar removal along with the enhancement of gasification efficiency. Secondary oxidant was injected as an oxidant at the top zone of the gasifier in varying ratios of 10–30% of the total amount of oxidant. This method was based on the primary method of tar removal and gasification efficiency improvement by thermal cracking of tar. Various gasification performance parameters were evaluated and tar content was estimated by measuring the fluctuation of weight of the activated carbon filter. The results showed that the concentration of tar in the producer gas decreased by injecting the secondary oxidant, even though syngas yield decreased. The recycling potential of the char produced in the gasification experiments was also assessed with the purpose of utilizing char as an adsorbent by determining its surface area and pore volume. The results demonstrated that the char produced from the gasification experiment had similar quality to that of the activated carbon used in this experiment.     

Catalytic upgrading pyrolysis of pine sawdust for bio-oil with metal oxides

The catalytic upgrading pyrolysis of pine sawdust was performed at 500 °C with various metal oxides to improve the quality of the bio-oil. The aim of this study was to investigate the potential of the metal oxides instead of traditional zeolites for catalytic upgrading pyrolysis with the analysis of Gas Chromatograph/Mass Spectrometer. In this study, the used catalysts were Calcium-oxide, Magnesium oxide, Titanium dioxide, and Zeolite (Si/Al?=?80). The influence of catalysts on products yields and compositions were investigated. Most metal oxides can enhance the bio-gas with the bio-oil yields decreased. The metal oxides led to a decrease of Acids, Aldehydes, Ketones and an increase of Furfural, Cresols, Catechols in Furans and Phenolics. Among the catalysts, the MgO catalysts was the most effective to convert the high molecular into lights ones (6.65% Cresols) with yield of 20.48% for Furfural. The deoxygenation reaction in bio-oil was suggested to convert oxygenated compounds into the low molecular weight of the materials (6.39% Guaiacols). Thus, the used metal oxides can improve the quality of bio-oil by decreasing undesirable compounds as well as increasing the desirable compounds with low oxygen contents via deoxygenation reaction.     

Absorption characteristics of potassium carbonate-based solutions with rate promoters and corrosion inhibitors

In this research, absorbents for CO₂ capture were prepared by blending 30 wt% potassium carbonate, 3 wt% of a rate promoter, and 1 wt% of a corrosion inhibitor. Pipecolic acid, sarcosine, and diethanolamine were chosen as rate promoter candidates. Based on a rate promoter screening test for CO₂ loading capacity and absorption rate, pipecolic acid and sarcosine were selected to be used as rate promoters. 1,2,3-benzotriazole and ammonium thiocyanate were chosen as corrosion inhibitors, and they were mixed with a 30 wt% potassium carbonate-based absorbent mixture containing one of the rate promoters. The absorption rates for four absorbent solutions (30 wt% potassium carbonate?+?3 wt% pipecolic acid?+?1 wt% 1,2,3-benzotriazole, 30 wt% potassium carbonate?+?3 wt% pipecolic acid?+?1 wt% ammonium thiocyanate, 30 wt% potassium carbonate?+?3 wt% sarcosine?+?1 wt% 1,2,3-benzotriazole, and 30 wt% potassium carbonate?+?3 wt% sarcosine?+?1 wt% ammonium thiocyanate) were measured, tabulated, and graphically displayed. These types of absorbents can be used for capturing CO₂ under high temperature and pressure conditions, such as those found in coal-fired power plants.     

Stable isotope on the evaluation of water quality in the presence of WWTPs in rivers

Environmental Science and Pollution Research - We investigated the distribution of nitrogen compounds in Han River as well as two tributaries of Tancheon and Jungrangcheon. Particularly, we...     

Characterization of heat shock protein 40 and 90 in Chironomus riparius larvae: effects of di(2-ethylhexyl) phthalate exposure on gene expressions and mouthpart deformities

Di(2-ethylhexyl) phthalate (DEHP) is a widely distributed phthalate that organisms are frequently exposed to due to its wide range of commercial and manufacturing uses as a plasticizer. Indeed, DEHP is often found in freshwater systems that receive domestic waste water discharges. Therefore, we evaluated the effects of DEHP on the mRNA levels of heat shock protein (HSP) 40 and 90 in chironomids. In addition, we evaluated the effects of exposure to DEHP on the induction of morphological deformities in chironomids. To accomplish this, partial sequences of HSP 40 and 90 from Chironomus riparius larvae were amplified and sequenced. The inferred amino acid sequences were then aligned with those of other insect HSP 40 and 90 genes. The results of this alignment revealed that there was a high degree of similarity among the homologues. In addition, the HSP 40 and 90 mRNA expressions were significantly upregulated in response to short and long-term exposure to DEHP at concentrations of 1, 10, and 30 microgL(-1). Furthermore, the occurrence of mouthpart deformities was significantly higher in chironomids that were treated with DEHP (12-20%) than in controls (3-5%). Taken together, these results indicate that HSP 40 and 90 play important roles in the physiological changes related to metabolism and cell protection that occur in C. riparius larvae that have been exposed to DEHP.