偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附

以腈纶纤维为原料络合Fe3+制得偕胺肟合铁(Ⅲ)纤维,用其处理α-萘酚溶液,研究了偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附工艺条件和吸附动力学参数。实验结果表明,偕胺肟合铁(Ⅲ)纤维对α-萘酚的最佳吸附工艺条件为pH=3.0、吸附温度313.15K和吸附时间45min。在最佳工艺条件下,偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附在所研究的α-萘酚浓度范围内符合Freundlich等温吸附方程。未达到饱和吸附前,偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附符合一级反应动力学特征。     

Positive matrix factorization as source apportionment of soil lead and cadmium around a battery plant (Changxing County,China)

Chemical compositions of soil samples are multivariate in nature and provide datasets suitable for the application of multivariate factor analytical techniques. One of the analytical techniques, the positive matrix factorization (PMF), uses a weighted least square by fitting the data matrix to determine the weights of the sources based on the error estimates of each data point. In this research, PMF was employed to apportion the sources of heavy metals in 104 soil samples taken within a 1-km radius of a lead battery plant contaminated site in Changxing County, Zhejiang Province, China. The site is heavily contaminated with high concentrations of lead (Pb) and cadmium (Cd). PMF successfully partitioned the variances into sources related to soil background, agronomic practices, and the lead battery plants combined with a geostatistical approach. It was estimated that the lead battery plants and the agronomic practices contributed 55.37 and 29.28 %, respectively, for soil Pb of the total source. Soil Cd mainly came from the lead battery plants (65.92 %), followed by the agronomic practices (21.65 %), and soil parent materials (12.43 %). This research indicates that PMF combined with geostatistics is a useful tool for source identification and apportionment.     

Influence of soil and hydrocarbon properties on the solvent extraction of high-concentration weathered petroleum from contaminated soils

Petroleum ether was used to extract petroleum hydrocarbons from soils collected from six oil fields with different history of exploratory and contamination. It was capable of fast removing 76–94 % of the total petroleum hydrocarbons including 25 alkanes (C₁₁–C₃₅) and 16 US EPA priority polycyclic aromatic hydrocarbons from soils at room temperature. The partial least squares analysis indicated that the solvent extraction efficiencies were positively correlated with soil organic matter, cation exchange capacity, moisture, pH, and sand content of soils, while negative effects were observed in the properties reflecting the molecular size (e.g., molecular weight and number of carbon atoms) and hydrophobicity (e.g., water solubility, octanol–water partition coefficient, soil organic carbon partition coefficient) of hydrocarbons. The high concentration of weathered crude oil at the order of 10⁵ mg kg^?1 in this study was demonstrated adverse for solvent extraction by providing an obvious nonaqueous phase liquid phase for hydrocarbon sinking and increasing the sequestration of soluble hydrocarbons in the insoluble oil fractions during weathering. A full picture of the mass distribution and transport mechanism of petroleum contaminants in soils will ultimately require a variety of studies to gain insights into the dynamic interactions between environmental indicator hydrocarbons and their host oil matrix.     

有机改性成都粘土预处理垃圾渗滤液

以成都粘土为原料,十六烷基三甲基溴化铵(HDTMA)为改性剂制备有机改性土,并将其应用于垃圾渗滤液的预处理。采用单因素静态吸附实验,以粘土对垃圾渗滤液COD和氨氮的去除率作为考查指标,初步探究有机改性土预处理垃圾渗滤液的适宜条件;并对有机改性粘土及原土进行性能表征,初步分析其吸附机理。研究结果表明,有机土的处理效果明显优于原土,处理效果上比原土提高了1.6~2.3倍;有机土预处理垃圾渗滤液适宜条件为:投加量120 g/L、搅拌速度200 r/min、搅拌时间50 min、pH=7、静置时间为6 h。     

镍基催化剂对污泥微波热解制生物气效能的影响

为实现污水污泥减量化、无害化及资源化的目标,在微波热解污水污泥基础上,进行了镍基催化剂对制取生物气效能影响的研究。采用元素分析对污泥元素进行检测,气/质联用分析(GC-MS)和气相色谱(GC)对热解生物气的组成和含量进行测定。实验结果表明,镍基催化剂的添加对微波热解污水污泥制取生物气有较大促进作用。5%添加量与800℃热解终温条件下具有最佳催化效果:生物气中H2、CO产量最大,H2产量由29 g/kg增加到35.8 g/kg,提升23.4%,CO产量由302.7 g/kg增加到383.3 g/kg,提升26.6%;同时催化剂还能提高热能利用效率,降低热解终温,即5%添加量在700℃热解终温时可达到空白800℃时的产气效果;镍基催化剂主要在500~600℃时发挥催化作用,加快了H2和CO的释放。微波热解污泥制取的生物气具有产量大、富含H2与CO等优点,可推动污水污泥的资源化进程。     

MCM-41介孔分子筛的合成及其对铜离子的吸附性能简

以微硅粉为硅源,CTAB和PEG-6000为模板剂,合成MCM-41介孔分子筛。采用XRD、N₂吸附-脱附曲线、FTIR以及TEM表征了其结构、比表面积、孔径分布及晶体形貌,并且以该样品为吸附剂,对含Cu²⁺的溶液进行了静态吸附实验。结果表明,以微硅粉为硅源成功合成了具有典型六方排列孔道结构的MCM-41,其比表面积为869.5 m²/g,孔容为0.97 cm³/g,平均孔径为3.3 nm;溶液pH为5~6时,MCM-41对Cu²⁺的去除效果最好;MCM-41对Cu²⁺的最大吸附吸附容量36.3 mg/g;MCM-41对Cu²⁺的吸附性能符合Langmuir吸附方程的特征。动力学研究表明,该过程符合准二级动力学模型。     

负载型Mn-Ce/TiO2催化剂的制备及其低温脱硝活性简

以成型TiO₂作为载体,通过浸渍法制备了Mn-Ce/TiO₂低温SCR催化剂,并系统研究了制备方法、煅烧条件、活性组分担载量、Mn含量等参数对催化剂催化还原NO性能的影响。结果表明,煅烧温度的升高会促使活性组分结晶度的提高,从而引起催化活性的降低,在500℃和600℃下所得Mn-Ce/TiO₂催化剂活性组分为无定型态,表现出较高的脱硝活性。活性组分担载量的增加有利于催化活性的提高。Mn含量对Mn-Ce/TiO₂催化剂的活性有较大影响,当Mn/（Mn+Ce）摩尔比为40%和85%时,催化剂活性最高。     

煅烧的水滑石同时去除水体中砷和氟

为探讨水滑石类材料对水体中氟、砷离子的同时去除效果,采用共沉淀法合成(Mg∶Al=2∶1)纳米类水滑石(LDHs),用傅立叶转换红外光谱、电子扫描透射电镜、X射线晶体衍射等手段对合成的材料进行了表征,并研究纳米材料在不同初始浓度、pH、吸附时间、阴离子干扰条件下其同时除砷氟性能。结果表明,煅烧后的水滑石(LDOs)对砷最大吸附量为51.02 mg/g,对氟最大吸附量为36.63 mg/g。吸附动力学实验表明,煅烧水滑石对砷的吸附在前6 h内基本完成,对氟的吸附在前10 h内基本完成。砷氟共存溶液保持pH=4~10及pH=6~8时,水滑石分别对砷、氟保持良好的吸附效率。对比不同阴离子对水滑石共除砷氟效率的影响,水滑石除砷速率受到阴离子影响力大小为:HPO2-4CO2-3NO-3Cl-SO2-4;水滑石除氟速率受到阴离子影响力大小为:CO2-3HPO2-4SO2-4Cl-NO-3。材料再生循环利用4次后,对砷和氟的吸附效率均能达到90%以上。实验结果表明,所合成的水滑石是一种优秀的能共除砷氟的吸附剂。     

船舶塑料垃圾热解特性及动力学分析

利用热重分析(TGA)研究船舶塑料垃圾在不同升温速率和不同气氛下的热解特性,并得到了热解动力学参数。结果表明,船舶塑料垃圾的热解过程主要有3个阶段,比一般塑料热解复杂;随着升温速率增大,最大热解速率和最大热解速率温度等热解特性参数也增大,反应变得更剧烈;N2/CO2比为4∶1时,热解反应进行得最完全,固体残留率最少。动力学分析表明,采用3个连续一级反应模型能很好地拟合实验数据;不同的升温速率和气氛比对反应各阶段活化能均有不同程度的影响。     

一株光合细菌的分离鉴定及其产电特性

采用光照富集及厌氧划线法从污水厂二沉池活性污泥分离到一株光合细菌YC-1,结合菌落特征、细胞形态、活细胞吸收光谱及16S rRNA基因序列分析等对其进行了分类学鉴定,并研究了YC-1在不同光源照射下的产电性能。结果表明,该菌为短杆状,有鞭毛,菌落呈淡粉色,含有大量细菌叶绿素a,16S rRNA基因序列与Rhodopseudomonas palustris DX-1相似度为99%,属于假单胞菌属(Pseudomonas sp.);双室微生物燃料电池的阳极室接种YC-1,并以乙酸钠为底物,铁氰化钾作为阴极电子受体,外载为1 000Ω时,电池稳定运行时输出电压为0.58 V,且输出电压不受光源光谱影响。