电气石强化生物膜系统处理中药废水的启动及生物膜特性分析

将电气石与生物膜技术结合构建电气石强化生物膜系统处理中药废水,通过电气石调节生物膜微环境,以增强微生物代谢活性,从而提高了反应系统的处理能力。结果表明:电气石强化厌氧流化床(AFBR)反应系统经历160 d完成中药废水的启动实验,反应系统COD去除率达到87.8%,容积负荷达到5.34 kg·(m3·d)~(-1),生物膜产甲烷活性达到126.4 mL·(g·d)~(-1);电气石强化好氧流化床(FBR)反应系统统经历35 d完成启动实验后,出水COD稳定在76.5 mg·L~(-1),反应系统对应的COD去除率和容积负荷分别为90.3%和1.4 kg·(m~3·d)~(-1)。中药废水依次经AFBR和FBR处理后,出水水质满足《中药类制药工业水污染物排放标准》(GB 21906-2008)排放要求。以上结果可为实际工程项目提供理论依据和参考。     

兽药抗生素对生态环境的混合毒性研究进展

抗生素是环境中普遍存在的污染物,畜牧水产养殖是其主要来源之一.环境中可能同时存在多种抗生素残留,因此单一药物的毒性评价难以反映抗生素对生态环境的影响,应探究其混合物的毒性效应.本文在总结大量文献的基础上,介绍了兽用抗生素的残留现状,总结了兽用抗生素对生态环境的混合毒性研究进展,讨论了兽用抗生素残留对土壤生物和水生生物的...     

热处理时间对餐厨垃圾高温干式厌氧发酵的影响

餐厨垃圾中有机物大部分以大分子的形式存在,对其进行热处理,破坏大分子有机物的存在形式,将会影响其干式厌氧发酵的过程。实验对餐厨垃圾进行了热处理(100℃),处理后将其在含固率(TS)20%、接种率25%的条件下进行高温55℃厌氧发酵。实验结果表明,热处理后,餐厨垃圾的理化性质发生显著变化,累计产气量、TS和VS的去除率均增大。当热处理时间为15 min时,餐厨垃圾的SCOD值最高,为59.49 g/L,比未处理时提高了3.3倍。同样该条件下,累计产气量也最高,为2 782.8 m L,与未处理相比累积产气量提高58.30%,第二产气高峰比未处理提前3天。各发酵瓶发酵前后TS、VS去除率的变化趋势与累计产气量的变化基本一致,累计产气量越大,TS、VS的去除率越大。     

膜电解技术处理含氯及重金属的废酸

采用离子交换膜电解技术处理铜冶炼过程产生的含氯及重金属的废酸。考察了废酸处理工艺、电解温度、电解时间、电流密度和催化剂的添加等条件对处理效果的影响。实验结果表明：采用先沉淀重金属后脱氯的废酸处理工艺,氯离子和铜离子的去除效果均较好;当以钛盐为催化剂时,在电解温度为40 ℃、电解时间为2.0 h、电流密度为825 A/m²的最佳工艺条件下,处理后废酸中的氯离子质量浓度为0.22 g/L,氯离子去除率为98.59%,铜离子质量浓度为0.45 g/L,铜离子去除率为95.08%,其他重金属大部分也得到有效去除。净化后的废酸可回用至铜冶炼的生产过程中。     

火电厂脱硝的尿素制氨技术概述

选择性催化还原法（简称SCR）脱硝用还原剂氨气的制备原料主要有液氨、氨水及尿素三种。由于液氨工艺系统简单,运输、投资、运行成本较低,在目前的工程中已广泛应用,但存在的缺点是对系统的安全性要求较高。根据《危险化学品重大危险源辨识标准》（GB18218—2009）,液氨储量超过10吨视为重大危险源,因此,某些特殊地区（如北京、广州等地）要求还原剂制备系统采用安全性要求较低的尿素工艺。尿素工艺又分为热解法和水解法制氨,本文分别说明了两种工艺的技术原理、工艺流程。     

城市污水处理厂污水处理系统中四环素类药物耐药菌的分布特性研究

采用微生物平板涂布法对2家城市污水处理厂污水处理各阶段的四环素类药物(四环素、金霉素、土霉素)耐药菌分布进行了测定,分析了污水处理的各阶段对四环素类药物耐药菌的去除效果。结果显示,2家污水处理厂污水处理系统中均能检出土霉素、四环素、金霉素耐药菌,数量分布均为土霉素耐药菌>四环素耐药菌>金霉素耐药菌。3种耐药菌的浓度均在加氯消毒出水中为最小(在0～103 cfu/mL),在外排污泥中最大(高于进水浓度,在105～107 cfu/mL)。四环素耐药菌数从进水的1.1×105～1.6×105 cfu/mL降为出水的0～5.5×102 cfu/mL,说明污水处理过程对四环素耐药菌有一定的去除效果,但四环素耐药菌占总菌数的百分比没有明显下降或上升,相比于进水的1.1%～3.4%,出水仍然保持在3.1%～4.3%左右,表明污水处理过程中没有选择性的富集或去除四环素耐药菌。     

微波萃取肉类样品中的多氯联苯方法研究

用丙酮和正己烷（1＋1）的混合溶剂做萃取剂,采用微波萃取的方法提取动物肉类中的9个多氯联苯（PCBs）单体,通过弗罗里硅土和氧化铝净化后,在带ECD检测器的气相色谱上测定。取样量为2g时,多氯联苯（PCBs）在GC—ECD上响应的线性范围为11～100ng／g,研究的样品加标测定范围为11—500ng／g,检出限从5．3—13．3ng／g,平均加标回收率在98．7％-118％。     

季铵化合物对环境的影响及微生物降解研究进展

季铵化合物(QACs)作为最主要的阳离子表面活性剂,被认定为一种需要深入研究的潜在有害物质.美、日、欧地区学者已经对QACs展开了广泛研究,而国内只对其分析监测方法作了一些初步探索,在环境领域对于QACs的研究还鲜有报道.综述了QACs在城市污水处理厂以及自然水体中的分布特征、环境风险、降解特性以及降解机制等方面的研究进展,并对QACs的环境影响以及生物降解的研究方向进行了探讨,对相关研究人员具有一定的参考价值.     

A case study predicting environmental impacts of urban transport planning in China

Predicting environmental impacts is essential when performing an environmental assessment on urban transport planning. System dynamics (SD) is usually used to solve complex nonlinear problems. In this study, we utilized system dynamics (SD) to evaluate the environmental impacts associated with urban transport planning in Jilin City, China with respect to the local economy, society, transport, the environment and resources. To accomplish this, we generated simulation models comprising interrelated subsystems designed to utilize changes in the economy, society, road construction, changes in the number of vehicles, the capacity of the road network capacity, nitrogen oxides emission, traffic noise, land used for road construction and fuel consumption associated with traffic to estimate dynamic trends in the environmental impacts associated with Jilin's transport planning. Two simulation scenarios were then analyzed comparatively. The results of this study indicated that implementation of Jilin transport planning would improve the current urban traffic conditions and boost the local economy and development while benefiting the environment in Jilin City. In addition, comparative analysis of the two scenarios provided additional information that can be used to aid in scientific decision-making regarding which aspects of the transport planning to implement in Jilin City. This study demonstrates that our application of the SD method, which is referred to as the Strategic Environmental Assessment (SEA), is feasible for use in urban transport planning.     

Polybrominated diphenyl ethers in house dust in Singapore

The use of polybrominated diphenyl ethers (PBDEs) as flame retardants in Singapore is not strictly regulated; therefore these compounds can be readily found in furniture, electronic devices, and building materials. This study was the first of its kind to be conducted in Singapore to measure concentrations of PBDEs in house dust. Samples were collected from 31 homes in various locations across the island-state of Singapore, and a total eight PBDEs congeners were measured. PBDEs were detected in all 31 dust samples and the number of BDE congener detected per home ranged between 3 and 8. The most abundant BDE congeners found were BDE 47, 99 and 209, with a median value of 20 ng g(-1) dust, 24 ng g(-1) dust and 1000 ng g(-1) dust, respectively. BDE 209 contributed 88% to the median of all the congeners, and BDE 47 and 99 contributed 1.8% and 3.5%, respectively. Different congener profiles were observed between this and studies conducted elsewhere, which is consistent with the use of different commercial PBDE around the world. No significant correlations between PBDE dust levels and residential characteristics (number of TVs and computers, floor area or flooring material) were observed. The daily intake of PBDEs via the inhalation pathway was estimated. House dust may be regarded as the most important exposure route of PBDEs for children.