Rapid fetal karyotype from cystic hygroma and pleural effusions

Fluid from pleural effusion (n=2) and cystic hygroma (n=7) was obtained from eight fetuses, between 13 and 32 weeks of pregnancy at the time when a conventional prenatal diagnosis procedure was carried out. As these fluids contain lymphocytes, they were processed like peripheral blood. A karyotype was obtained in 4 days in both cases of pleural effusion and in four out of seven samples of cystic hygroma. An abnormal karyotype was detected in three of the four samples of cystic hygroma: two trisomies 21 and a monosomy X. Different parameters were evaluated in order to predict the feasibility of obtaining a cytogenetic diagnosis. Our data showed that if the amount of fluid obtained was ⩾4 ml and the initial lymphocyte count (ILC) was >0.2 × 10⁶ cells/ml, a cytogenetic diagnosis was possible from an initial concentration of cultured lymphocytes )ICCL) of >0.06 × 10⁶ cells/ml.     

室内氡污染的控制方法

介绍了消除氡源、控制氡源、通风和空气净化等现有房屋室内氡污染的防治方法,以及控制未来房屋内氡污染的方法。     

重庆城区大气颗粒物的元素、离子及物相组成研究

采用X－射线能谱（EDX），傅立叶红外光谱（FT－IR），X－射线衍射（XRI）对重庆市区大气颗粒污染物的元素组成，离子，物相组成进行顾研究，EDX检出了S，Cl,K,Ca,Ti,Cr,Mn,Fe,Cu,Se,Sr,Zr,Rb,Ga,Hg,Zn,Ni元素，FT－IR光谱发现主要存在SO4^2-,NH4^ 和NO3^-,XRD结果表明存在CaSO4.2H2O,α-SiO2,(NH4)2Ca(SO4)2.2H2O,(NH4)2SO4等4个主要物相以及Fe3O4,CaCO3等物相，初步讨论了重庆大气颗粒物的污染来源及其时间，空间分布。     

4—氯苯甲酸钠的光催化氧化降解及其影响因素

本试验采用P－25TiO2，光催化剂，对4－氯苯甲酸钠的光催化氧化降解及污染物初始浓度，催化剂投加量和入射光强等因素的影响进行了研究，研究发现污染物初始降解速率与其初始浓度的关系遵循Langmuir-Hinshelwood模式，其中半饱和浓度常数Ks不仅是催化剂和污染物种类的函数，而且也是入射光强的函数，催化剂投加量存在一限值，当低于此限值时，污染物降解速率由于催化剂浓度的不足受到影响而下降，当高于此限值时，污染物降解速率受催化剂投加量的影响变小，在本试验4－CBA－Na浓度为0.15-0.6mmol／L时该催化剂限值浓度大约为0.4g/L，在入射光强为1-7mW/cm^2和催化剂浓度为0.4g／L下，污染物降解速率与光强成0.67次幂关系，经估算其量子效率为6．3％。     

丹东市区段鸭绿江水体中铅、镉的含量

利用生物指示物（鳙鱼）对丹东地区鸭绿江水体中的铅、镉污染进行监测，采具鳙鱼-碳化酸溶-电热原子光谱法对丹东鸭绿江流域鳙鱼体内的铅、镉的含量进行了相关检测，在相同的实验条件下对该地区的水体中的铅、镉的含量进行对比，并对该地区的铅、镉污染进行了相关的评价，通过一年的监测未见超标。铅、镉含量分别为6．53±0．07（ng/g）、4．60±0．03（ng/g）；回收率分别为98.9％、103.5％；RSD分别为5．3％、4．1％。     

一种富稀土型三效催化剂的性能考察

对一种富烯土型三效催化剂的性能进行了考察，结果表明：该催化剂具有较好的三效活性和较好的启燃温度特性，具有较宛的空速适应范围，在空速为84000h^-1时，CO,NOx的转化率仍在90％以上，HC转化率仍在70％以上，该催化剂具有较好的耐老化性能，经实验室快速老化实验，即相当于实车行驶8万km,CO劣化系数，1.09,HC劣化系1．05，NOx劣化系数1．06，该催化剂经桑塔纳轿车整车28工况测试，其交化效果与该车配置的美国Engelherd公司的催化剂相当。     

常用氧化剂性能研究

用四种常用的氧化剂:高锰酸钾、漂白粉、NaClO和H2O2/Fe2+对大港油田港深11井酸化废水进行了处理。考察了氧化剂的投加量、氧化时间和pH值对酸化废水色度和COD去除率的影响。实验结果表明,在最佳条件下,H2O2/Fe2+对酸化废水的色度和COD的去除率最高;用高锰酸钾处理废水,其COD去除率较高,但脱色效果差;而漂白粉和NaClO的脱色率较高,但其氧化能力有限。建议油田用氧化法处理废水时应采用H2O2/Fe2+催化氧化体系。     

MODELING THE BUILDUP AND WASHOFF OF POLLUTANTS ON URBAN WATERSHEDS1

ABSTRACT: A model for urban stormwater quality was developed in this study. The basis for the model is the process by which pollutants build up on the watershed surface. For the wet climate of the study site, it was assumed that there exists an interval of time over which the pollutant buildup equals the pollutant washoff (no accumulation of pollutant). The buildup model was represented by a linear function of the antecedent dry time. The buildup function was then linked with a pollutant washoff model represented by a power function of the storm runoff volume. Various time intervals for no net accumulation were tested to calibrate the model. The model was calibrated to observed data for two small urban basins in Baton Rouge, Louisiana, and model results were used to analyze the behavior of phosphorus concentrations in storm runoff from these basins over a long period of time.     

Thermal and mechanical properties of poly(lactic Acid) and poly(ethylene/butylene Succinate) blends

In this study, blends of poly (lactic acid) (PLA) with poly(ethylene/butylene succinate) (Bionolle) have been investigated for their thermal and mechanical properties as a function of the concentration of Bionolle. Differential scanning calorimetry (DSC), dynamic mechanical analysis (DMA), and tensile tests were used to characterize the blends. From the results of the DMA and DSC, it was found that this blend system was not miscible within the compositions studied. DSC results showed that adding Bionolle aids in crystallization of PLA. It was observed that increasing the Bionolle concentration led to a slight increase in the strain-at-break of the blends but a decrease in the Young’s modulus and ultimate tensile strength. Biaxially oriented films showed an increase in tensile strength, modulus, and strain-at-break.