Biodiesel production from vegetable oil and waste animal fats in a pilot plant

In this study, corn oil as vegetable oil, chicken fat and fleshing oil as animal fats were used to produce methyl ester in a biodiesel pilot plant. The FFA level of the corn oil was below 1% while those of animal fats were too high to produce biodiesel via base catalyst. Therefore, it was needed to perform pretreatment reaction for the animal fats. For this aim, sulfuric acid was used as catalyst and methanol was used as alcohol in the pretreatment reactions. After reducing the FFA level of the animal fats to less than 1%, the transesterification reaction was completed with alkaline catalyst. Due to low FFA content of corn oil, it was directly subjected to transesterification. Potassium hydroxide was used as catalyst and methanol was used as alcohol for transesterification reactions. The fuel properties of methyl esters produced in the biodiesel pilot plant were characterized and compared to EN 14214 and ASTM D6751 biodiesel standards. According to the results, ester yield values of animal fat methyl esters were slightly lower than that of the corn oil methyl ester (COME). The production cost of COME was higher than those of animal fat methyl esters due to being high cost biodiesel feedstock. The fuel properties of produced methyl esters were close to each other. Especially, the sulfur content and cold flow properties of the COME were lower than those of animal fat methyl esters. The measured fuel properties of all produced methyl esters met ASTM D6751 (S500) biodiesel fuel standards.     

A new approach for calculating the relative risk level of pesticides

The following paper describes a new, easier to use approach to the calculation of relative risk levels of alternative pesticides. An insect, a plant disease, and a weed were selected for describing the application procedure of a new ranking method that is based on the intrinsic properties of pesticides rather than on the processes that occur both on land and in water after they are applied to soil. The approach is based on the Toxicity-Human health-Persistency (THP) Hazard Rating System, and a consumption factor is added to the method in order to calculate the environmental risk of pesticides. The available substitute pesticides are ranked in terms of their relative risk levels from lowest to highest in order of magnitude difference. Such a ranking method may be used as a practical quantitative tool to generate significant findings aiding in the selection of the most environmentally friendly substitute against a certain pest, especially in developing countries that still face the misuse and/or unconscious use of pesticides.     

Henry's law constant, octanol-air partition coefficient and supercooled liquid vapor pressure of carbazole as a function of temperature: application to gas/particle partitioning in the atmosphere

The Henry's law constant for carbazole was experimentally determined between 5 and 35 degrees C using a gas-stripping technique. The following equation was obtained for dimensionless Henry's law constant (H') versus temperature (T, K): ln H' = -3982(T,K)(-1) + 1.01. Temperature-dependent octanol-air partition coefficients (KOA) and supercooled liquid vapor pressures (PL,Pa) of carbazole were also determined using the GC retention time method. The temperature dependence of KOA and PL were explained by the following: log KOA = 4076/(T,K) - 5.65, log PL(Pa) = -3948(T,K)(- 1) + 11.48.The gas and particle-phase carbazole concentrations measured previously in Chicago, IL in 1995 was used for gas/particle partitioning modeling. Octanol based absorptive partitioning model consistently underpredicted the gas/particle partition coefficients (Kp) for all sampling periods. However, overall there was a good agreement between the measured Kp and soot-based model predictions.     

Concentration Evolution of Gas Species within a Collapsing Bubble in a Liquid Medium

In this study numerical methods are used to investigate the relationship between chemical concentration of gas species within a cavitating bubble, equilibrium radius of the gas bubble and pressure variations in the ambient liquid. For this purpose, governing equations are developed to describe the dynamic equilibrium of a bubble in a flowing fluid and mass transfer between gas and liquid phases, where it was assumed that gases undergo isothermal compression, obey the ideal gas law, Henry law. It is further assumed that the concentration of each phase within the bubble is uniform. The resulting nonlinear equations are solved using implicit Trapezoidal method with Newton iteration. Four gas species are modeled under various initial and ambient pressure variation conditions. These conditions maybe considered to represent typical cavitation events. The numerical results obtained are presented in terms of dimensionless numbers. These results indicate that chemical damage maybe an important component of cavitation surface damage, since high concentration profiles may develop within a collapsing bubble. Proposed formulation and numerical solutions are simple and cost effective to implement. The results presented in this study maybe used to benchmark experimental investigations or other more complex solutions, which are outside the scope of this study.     

The asiatic clam, Corbicula fluminea: An indicator of trace metal pollution in the Shatt al-Arab River, Iraq

The potential of Corbicula fluminea (Müller) as an indicator for trace metal pollution was investigated. Laboratory experiments show that Corbicula has the capability to accumulate and eliminate trace metals in relation to their concentrations in ambient water. However, an effect of individual size was observed. Seasonal variations in the concentrations of Cd, Co, Cu, Fe, Mn, Ni, Pb, V and Zn in Corbicula, water and particulate matter from the upper section of the Shatt al-Arab River were studied. Sediment samples were also analysed. Metal concentrations were determined by means of flameless AAS. It was found that Corbicula is a suitable bio-indicator for monitoring of trace metal pollution. Metal concentrations in Corbicula tissues correlated better with their corresponding concentrations in particulate matter than with the dissolved form. Temporal variations in metal concentrations were attributed to several factors, including fluctuations in metal inputs, and in geochemical and hydrological characteristics of the water. The obtained levels of trace metals were comparable to those reported for control sites, with the exception of Cd, Cu and Zn whose concentrations were higher in both Corbicula and particulate matter.     

Heavy metal mobility and potential availability in animal manure: using a sequential extraction procedure

In this study, dairy cow manure, goat manure, and chicken manure were collected from three farms and analyzed to find out the concentration of Cd, Co, Cr, Cu, Mn, Ni, Pb, and Zn. The concentration and potential of mobility and availability of heavy metals were studied in the animal manure samples. BCR Sequential extraction procedure was used to determine the binding forms of the metals. In this study, pseudo total concentrations of Mn and Zn were found out to be predominant in all the types of animal manure samples. According to the results, it was traced that Cr, Cu, and Ni were observed to be at the second highest level while Cd, Co, and Pb were seen at the lowest level in all the manure samples. When extractable amounts of heavy metals are taken into consideration, it is seen that the amount of the mobile fractions of heavy metals except for Cr and Ni are higher in comparison with that of immobile fraction in all the animal manure samples. It was also viewed that Mn, Cd, and Zn are more available in dairy cow manure and chicken manure whereas Cd, Co, and Mn are more available in goat manure.     

High boron removal by functionalized magnesium ferrite nanopowders

Hydroxyl-enriched materials are promising boron adsorbents. However, the use of these materials is hampered by issues of separation, recovery, and selectivity, notably due to the presence of interfering ions. Therefore, we synthesized here a cheap magnetic nanopowder, which was further functionalized with polyvinyl alcohol and glycidol to produce boron-selective adsorbents. We studied their selectivity and removal efficiency using batch and fixed-bed systems. Sorption was studied at both concentrated and trace amounts of boron. Results show that nanopowders have 5.3–6.5 nm pore sizes and 145–203 m²/g surface areas, using Brunauer–Emmett–Teller analysis. Polyvinyl alcohol-functionalized particles removed 93 % of boron at 5 mg/L at pH 7 in 30 min, whereas only 68 % of boron was removed by glycidol-functionalized particles. However, at higher boron concentration, of 50 mg/L, glycidol-functionalized particles showed higher adsorption affinity of 68.9 mg/g. We conclude that internal hydroxyl groups of polyvinyl alcohol-functionalized particles are less accessible at higher boron concentration. This is the first report on magnesium ferrites for boron recovery. The spent adsorbents were separated easily from the aqueous media by an external magnet and repeatedly used. Overall, our findings demonstrated that the hydroxyl-enriched magnetic nanopowders are a better alternative to the existing boron adsorbents regarding magnetic separation, reusability, and selectivity.     

1,3,5-triazine-triethylenetetramine polymer: an efficient adsorbent for removal of Cr(VI) ions from aqueous solution

The synthesis of 1,3,5-triazine-triethylenetetramine (TATETA), its characterization by infrared spectroscopy and elemental analysis, and its application for removal of Cr(VI) ions from aqueous solution is reported. The effects of pH, contact time, initial concentration of Cr(VI), sorbent dose, and temperature on adsorption were investigated and optimized by batch adsorption experiments. Adsorption was highest at acidic conditions with an equilibration time of 25 min. The adsorption followed a Langmuir model, with an adsorption capacity of 303 mg g^?1, was second order in its kinetics, and exothermic and thus spontaneous.