Very high concentrations of DDE and toxaphene residues in crocodiles from the Ord River, Western Australia: an investigation into possible endocrine disruption

Organochlorine pesticide concentrations, particularly those of the DDT family and of toxaphene, were measured by gas chromatography in samples of liver and body fat taken from Australian freshwater crocodiles Crocodylus johnstoni at three locations along the Ord River in Western Australia. The three sampling sites were the irrigation area, downstream of the irrigation area, and well upstream of the irrigation area; the last site serving as the control. DDT and toxaphene were applied in large and known quantities to cotton grown in the Ord Irrigation Area from 1964 to 1974. Thus the residues in the crocodile tissues are representative of the situation almost thirty years after the use of DDT and toxaphene ceased in the area. Very high concentrations of p,p'-DDE and toxaphene were found in the lipid-rich tissues that were examined. Livers and body fat from estuarine crocodiles Crocodylus porosus from the downstream site were also analysed. As p,p'-DDE and toxaphene are both known to be disruptive of endocrine systems, a range of blood parameters, including estradiol and testesterone concentrations, were also measured for all the animals studied. The ovaries and testes of the freshwater crocodiles were also examined histologically. There were no obvious effects on blood chemistry or gonad histology of the large burden of pesticides and their metabolites carried by exposed animals, although the limited number of samples and the variability of the breeding state of the animals examined may have masked possible effects. The isolation of the area, the accurately known applications of DDT and toxaphene, and the simplicity of the drainage system make the lower Ord River a unique natural laboratory for studying the long term breakdown and effects of pesticides applied in a tropical environment.     

Variations of anthropogenic CO2 in urban area deduced by radiocarbon concentration in modern tree rings

Radiocarbon concentration in the atmosphere is significantly lower in areas where man-made emissions of carbon dioxide occur. This phenomenon is known as Suess effect, and is caused by the contamination of clean air with non-radioactive carbon from fossil fuel combustion. The effect is more strongly observed in industrial and densely populated urban areas. Measurements of carbon isotope concentrations in a study area can be compared to those from areas of clear air in order to estimate the amount of carbon dioxide emission from fossil fuel combustion by using a simple mathematical model. This can be calculated using the simple mathematical model. The result of the mathematical model followed in this study suggests that the use of annual rings of trees to obtain the secular variations of 14C concentration of atmospheric CO2 can be useful and efficient for environmental monitoring and modeling of the carbon distribution in local scale.     

Influence of aggregated particles on biodegradation activities for dimethylarsinic acid (DMA) in Lake Kahokugata

Aquatic arsenic cycles mainly depend on microbial activities that change the arsenic chemical forms and influence human health and organism activities. The microbial aggregates degrading organic matter are significantly related to the turnover between inorganic arsenic and organoarsenic compounds. We investigated the effects of microbial aggregates on organoarsenic mineralization in Lake Kahokugata using lake water samples spiked with dimethylarsinic acid (DMA). The lake water samples converted 1 μmol L⁻¹ of DMA to inorganic arsenic for 28 d only under anaerobic and dark conditions in the presence of microbial activities. During the DMA mineralization process, organic aggregates >5.0 μm with bacterial colonization increased the densities. When the organic aggregates >5.0 μm were eliminated from the lake water samples using filters, the degradation activities were reduced. DMA in the lake water would be mineralized by the microbial aggregates under anaerobic and dark conditions. Moreover, DMA amendment enhanced the degradation activities in the lake water samples, which mineralized 50 μmol L⁻¹ of DMA. The DMA-amended aggregates >5.0 μm completely degraded 1 μmol L⁻¹ of DMA with a shorter incubation time of 7 d. The supplement of KNO₃ and NaHCO₃ to lake water samples also shortened the DMA-degradation period. Presumably, the bacterial aggregates involved in the chemical heterotrophic process would contribute to the DMA-biodegradation process in Lake Kahokugata, which is induced by the DMA amendment.     

Remediation of toxic metal contaminated soil by washing with biodegradable aminopolycarboxylate chelants

Ex situ soil washing with synthetic extractants such as, aminopolycarboxylate chelants (APCs) is a viable treatment alternative for metal-contaminated site remediation. EDTA and its homologs are widely used among the APCs in the ex situ soil washing processes. These APCs are merely biodegradable and highly persistent in the aquatic environments leading to the post-use toxic effects. Therefore, an increasing interest is focused on the development and use of the eco-friendly APCs having better biodegradability and less environmental toxicity. The paper deals with the results from the lab-scale washing treatments of a real sample of metal-contaminated soil for the removal of the ecotoxic metal ions (Cd, Cu, Ni, Pb, and Zn) using five biodegradable APCs, namely [S,S]-ethylenediaminedisuccinic acid, imminodisuccinic acid, methylglycinediacetic acid, DL-2-(2-carboxymethyl) nitrilotriacetic acid (GLDA), and 3-hydroxy-2,2′-iminodisuccinic acid. The performance of those biodegradable APCs was evaluated for their interaction with the soil mineral constituents in terms of the solution pH and metal-chelant stability constants, and compared with that of EDTA. Speciation calculations were performed to identify the optimal conditions for the washing process in terms of the metal-chelant interactions as well as to understand the selectivity in the separation ability of the biodegradable chelants towards the metal ions. A linear relationship between the metal extraction capacity of the individual chelants towards each of the metal ions from the soil matrix and metal-chelant conditional stability constants for a solution pH greater than 6 was observed. Additional considerations were derived from the behavior of the major potentially interfering cations (Al, Ca, Fe, Mg, and Mn), and it was hypothesized that use of an excess of chelant may minimize the possible competition effects during the single-step washing treatments. Sequential extraction procedure was used to determine the metal distribution in the soil before and after the extractive decontamination using biodegradable APCs, and the capability of the APCs in removing the metal ions even from the theoretically immobilized fraction of the contaminated soil was observed. GLDA appeared to possess the greatest potential to decontaminate the soil through ex situ washing treatment compared to the other biodegradable chelants used in the study.     

Determination of flame-retardant hexabromocyclododecane diastereomers in textiles

To establish a concise and rapid procedure to analyze hexabromocyclododecane (HBCD) diastereomers in flame-retarded textiles, three different methods of extraction—Soxhlet, ultrasonic, and soaking extractions with toluene and dichloromethane (DCM)—were compared. During Soxhlet extraction using toluene, the percent contribution of α-HBCD to total HBCDs increased slightly and that of γ-HBCD decreased, indicating that γ-HBCD was isomerized to some extent at the boiling point of toluene (110.6 °C). For ultrasonic extraction, the temperature of the water bath can easily increase over time during the procedure, which might lead to undesirable effects. Therefore, we considered soaking extraction with DCM to be the most facile procedure to analyze HBCD diastereomers in textiles. Using the method established in this study, commercially available textiles in Japan (n = 10) were analyzed to understand the actual composition of HBCD contents and its diastereomer profiles. With the exception of one textile sample, HBCDs were detected in all the samples analyzed, with concentrations ranging from 22 000 to 43 000 mg kg⁻¹ (i.e. 2.2–4.3%). We found a higher proportion of the α-diastereomer in most textile products compared with that of commercial HBCD mixtures, indicating that γ-HBCD isomerized to α-diastereomer by heating processes to incorporate the commercial formulation into treated materials or that the α-diastereomer preferentially absorbed onto textile materials during the manufacturing of flame-retarded consumer products.     

Environmental impacts of shore-parallel breakwaters along Nagahama and Ohgata, District of Joetsu, Japan

A combination of sedimentological analysis of beach sands, field surveys and the assessment of the empirical methods for the breakwater design is used to investigate the impacts of offshore breakwaters on beach morphology along Nagahama and Ohgata. The results indicate that the nearshore sedimentation has been substantially disrupted due to the features formed behind the breakwaters stopping littoral transport, which led to sediment accretion on the updrift side of the breakwaters, and erosion on their downdrift side. Sedimentological analysis of beach sands made it possible to recognize the dominant process at the sections considered. In fact, the occurrence of strong offshore-going currents, the removal of finer mean grain size and the predominance of high-density heavy minerals led us to deduce that the two sections undergo a natural sedimentary imbalance.     

Mineral content of drinking water in lowland papua

This study presents concentration of nine minerals (Na, K, Mg, Ca, Cl, Mn, Zn, Cd, Pb) in 31 drinking water samples collected in the Papua New Guinea lowland, where coastal villagers draw water from artificial wells blended with sea water, riverside villagers utilize brackish river water, and inland villagers fetch creek or swamp water whose chemical composition is close to rain water. During the dry season, the coastal well water contains 500 mgL⁻¹ of sodium and 50–90 μgL⁻¹ of lead. The inland creek or swamp water contains very small amount of minerals; on the average, for instance, 0.64 mgL⁻¹ of magnesium, 0.84 mgL⁻¹ of calcium, and 4.78 mgL⁻¹ of water hardness (as CaCO₃). From some epidemiological evidence in industrialized countries, these mineral concentrations are judged to be indicative of high risk of cardiovascular disorders.     

Presence of macrolide-lincosamide-streptogramin B and tetracycline antimicrobials in swine waste treatment processes and amended soil.

Little is known about the fate of antimicrobials during common agricultural waste handling procedures. To better define the potential scope of this problem, concentrations of antimicrobials throughout the waste treatment process were estimated based on known antimicrobial usage, and the resulting predictions of high antimicrobial concentrations indicated the need for further investigation. Samples from building pits, a solids settling basin, a holding pond, and soil amended with waste treatment byproducts were therefore analyzed for traditional chemical parameters and macrolide, lincosamide, and tetracycline antimicrobials. Substantial improvements in water quality were observed during the treatment process. While the macrolide tylosin was not detected, chlortetracycline, oxytetracycline, and lincomycin were found at high concentrations throughout the waste treatment process. Oxytetracycline and lincomycin were also detected in soil from a field amended with waste treatment byproducts.     

Biodegradation of synthetic surfactants by river microorganisms

Ｂｉｏｄｅｇｒａｄａｔｉｏｎｏｆｓｙｎｔｈｅｔｉｃｓｕｒｆａｃｔａｎｔｓｂｙｒｉｖｅｒｍｉｃｒｏｏｒｇａｎｉｓｍｓ￥ＨｉｄｅａｋｉＭａｋｉ；ＫｅｎｒｏｕＴｏｋｕｈｉｒｏ；ＹａｓｕｈｉｒｏＦｕｊｉｗａｒａ；ＭｉｃｈｉｈｉｋｏＩｋｅ；ＫｅｎｊｉＦｕｒｕｋ...     

Efficacy of handrails in preventing stairway falls: a new experimental approach

In previous studies of stairway handrails, data were derived from static experiments which characterized the influence of the handrail design on ability to generate stabilizing force. This paper describes a novel and safe experimental approach developed to study the biomechanical efficacy of handrail use under dynamic conditions, wherein support-surface motion is used to perturb the balance of the subject who stands on a small (three step), heavily padded mock staircase. A primary objective of this initial study was to determine the influence of factors such as perturbation magnitude, stance leg (left or right), proximity to the handrail, initial hand position (on or off the rail), and ability to complete a step while grabbing the rail. The study was also intended to address a more basic issue: is it even possible to grab a handrail with sufficient speed and accuracy to prevent a fall after losing balance on a stairway? Testing of four healthy young adults demonstrated that sizeable stabilizing handrail force can be generated very quickly (up to 60% of body weight in less than 1 second) in response to loss of balance. Furthermore, these grabbing responses were clearly of functional significance, resulting in a marked reduction in the incidence of ‘falls’ (i.e. landing on the padded surface) compared to trials where the handrail was absent. The most consistent aspect of the force generation was the tendency to exert a forward axial force along the rail. An unexpected finding was that this force often appears to be exerted through a pulling, rather than pushing, action, because of the posterior location of the grip relative to the body. Although most of the force components tended to increase with perturbation magnitude, the lateral forces appeared to be most dependent on whether a step was taken. Stance leg had few effects, but variation in proximity to the rail was found to influence the angle at which the hand approached the rail. Gripping the rail prior to perturbation led to a greater tendency to pull upwards. Implications of these findings for safer handrail design are discussed.