Environmental audits: Proposed terminology

This paper presents a review of the fast developing subject of environmental auditing with the authors proposing a series of definitions. Of particular concern is a move towards the development of an accepted vocabulary for environmental impact assessment, even though the international dimension of the subject makes this a difficult task. Use of the word audit has become an accepted part of EIA vocabulary, however there are several types of audits being undertaken today. Presently, there are no commonly accepted definitions, consequently this paper will attempts to address this issue. Definitions for seven types of environmental audits are suggested, derived from the experience of the authors and from a review of the current literature. It is hoped that by the presentation of these definitions that such terms will be advocated for future EIA work, and thereby reducing confusion that otherwise may occur. The paper concludes with a brief review of the status of auditing.     

Problems of correlation of global and local monitoring of air pollution

1. The Air Polluttion Monitoring System has got a significant development of late, which is in direct relation with a considerable extention and improvement of the observation network in cities and industrial areas, with creation of a new network for assessing regional and global background of the atmosphere pollution, as well as with the wide involvement of meteorologists to monitoring organization.
2. While developing a new global monitoring system, it is necessary to take into account its relationship with the local monitoring within the region of air pollution sources, i.e. at the \lsimpact\rs level. The need in such an account is dictated first of all by the physics of pollutant spreading that states: changes in air pollution over large territories must be in a certain agreement with greater changes in the vicinity of emission sources. Methods applied in the global and local monitoring have also a number of common peculiarities. White organizing regional network for observations of the background pollution of the atmosphere twin stations (one of the pair of stations located outside the city boundaries in a small community, and the other, in the nearest city with the population of 200–400 thousand inhabitants) were established in the U.S.S.R. and in a number of socialist countries in Europe.
3. Implementation of the twin-station principles in the U.S.S.R. has contributed to data interpretation and representativity assessment as well as to correction of the station location. Observation results from the Soviet background stations and those abroad have been compared by now according to a number of indices.
4. The correlation of monitoring systems of various scales tells positively both on mutual improvement and completion of observational methods. The methods of obtaining integral characteristics of air pollution were used for the global monitoring, in particular spectral actinometric observations and chemical analysis of the precipitation composition. Now they find still wider employment. Thus methods of spectral actinometric measurements and data processing were used to estimate the degree of aerosol pollution of a number of industrial centres. The theory of solar radiation spreading and aerosol contents determination in urban atmosphere has also been developed. It is a generalization of an earlier developed theory, used to estimate global atmosphere pollution basing on actinometric data. The organization of precipitation collection and analysis on a network of stations around Leningrad and in Donbass area enables us to compare the admixture content in precipitations falling in industrial and agricultural areas.
5. A considerable increase of possibilities to measure microconcentrations of sulphur dioxide, nitrogen oxides and of a number of other pollutants is connected with the use of solid solvents for sampling. Their use will allow to avoid establishment of special laboratories at background stations and only send samples by post for their analysis in centralized laboratories.

They will also allow to considerably increase precision and accuracy of measurements. The international comparisons of methods of air pollution measurements on the background level allow to judge about the effiency of these methods.     

Transportation and fate of cationic surfactant in river water

The degradation, sorption, transportation and material balance of cationic surfactants discharged from domestic waste into river water was studied. Ion-pair solid-phase extraction behavior showed that the sorption of cationic surfactants as an ion-pair with anionic surfactant onto river sediment was so strong that little cationic surfactant was found in the bulk water. Cationic surfactant was found in river sediment at more than 500 times higher concentration than that in the bulk water. The degradation of the cationic surfactant was very slow in river water and much slower in the sediment. A material balance of cationic surfactant was estimated for a river running through Toyama City by measuring the flow rate and the concentration of cationic surfactant in the water at several points. It was found that more than 30% of cationic surfactant introduced to the river was lost during the river running through ca. 3 km in 3 h. This reduction probably comes from a quick transfer of the cationic surfactant from river water to sediment and water weed by means of adsorption or precipitation with suspending solids.     

Survey of the occurrence of residues of methyl tertiary butyl ether (MTBE) in Dutch drinking water sources and drinking water

An indicative survey has been carried out in The Netherlands investigating the presence of methyl tertiary butyl ether (MTBE) in drinking water and the corresponding sources. In total, 71 different sites used for the preparation of drinking water in The Netherlands were sampled in two successive seasons in 2001 involving the analysis of 156 samples. (ground water (n = 88), surface water (n = 17), bank filtrate water (n = 6) and drinking water (n = 45)). To combine high sample throughput with high selectivity and sensitivity, off-line purge and trap for sampling and gas chromatography mass spectrometry equipped with an automated thermal desorption sampler (TDS-GC-MS) was selected as the preferred analytical methodology. The developed procedure enabled the analysis of at least 40 samples per day and provided a limit of quantification of 2 ng l(-1). In the first period 63 samples of raw water were analyzed. Concentrations ranged between < 10 ng l(-1) and 420 ng l(-1) with a median concentration below 10 ng l(-1). The second period was focused at the re-sampling of positive locations (MTBE > 10 ng l(-1)) and a few additional drinking water utilities of which both the raw and drinking water of the utilities were analyzed. The median concentration of MTBE in the selected set of drinking water samples was 20 ng l(-1) (n = 45). At one location MTBE was found at a level of 2900 ng l(-1) caused by point source contamination of the ground water (11 900 ng l(-1)). Special attention has been paid to the quality of the results by analyzing all samples in duplicate and the analysis of control samples during each series of analyses.     

Water quality test based on dielectrophoretic measurements of fresh water algae Selenastrum capricornutum

A method is described whereby dielectrophoresis of algal cells is used to perform rapid water quality analysis, specifically detecting the presence of CuSO4. The dielectric collection spectrum of the fresh water alga Selenastrum capricornutum was determined for a range of concentrations of CuSO4 from 25 mg L(-1) to 0.25 mg L(-1) for exposure times of 15 min and 18 h. In all cases increasing the concentration of CuSO4 reduced cell collection, but a step reduction was observed in collection between 2 mg L(-1) and 5 mg L(-1). This method has potential for forming a rapid, low-cost test for water quality with broad specificity and significantly reduced analysis time compared to current methods.     

Sequential extractions of selenium soils from Stewart Lake: total selenium and speciation measurements with ICP-MS detection

Different techniques have been employed in order to evaluate the most efficient procedure for the extraction of selenium from soil as required for speciation. Selenium contaminated sediments from Stewart Lake Wetland, California were used. A strong acid mineralization of the samples gives quantitative total selenium, which is then used to estimate recoveries for the milder extraction methods. The different extraction methodologies involve the sequential use of water, buffer (phosphate, pH 7) and either acid solution (e.g. HNO3 or HCl) or basic solutions (e.g. ammonium acetate, NaOH or TMAH). Pyrophosphate extraction was also evaluated and showed that selenium was not associated with humic acids. The extractants were subsequently analyzed by size exclusion chromatography (SEC) with UV (254 and 400 nm) and on-line ICP-MS detection; anion exchange chromatography, and ion-pair reversed phase chromatography with ICP-MS detection. For sequential extractions the extraction efficiencies showed that the basic extractions were more efficient than the acidic. The difference between the acidic and the basic extraction efficiency is carried to the sulfite extraction, suggesting that whatever is not extracted by the acid is subsequently extracted by the sulfite. The species identified with the different chromatographies were selenate, selenite, elemental selenium and some organic selenium.     

Integration of modeling,monitoring and laboratory observation to determine reasons for air quality violations

An attempt was made to explain ambient air quality violations in the vicinity of industrial plants. Micrometeorology, diffusion calculaations, ambient readings, and plant engineering data are all taken into consideration to ascertain whether the plant is or is not the principal offender.Scrutiny of hi-vol filters using scanning electron microscopy for particle size analysis and particle chemical make-up as an assessment technique is also described.Case histories using the above analytical techniques are discussed.Presented at the 16th National Conference on Energy and the Environment, May 23, 1979     

The occurrence of acid precipitation on the west coast of the United States

Compilation of published and unpublished data shows acid precipitation to be more widespread in the Pacific coastal states than is generally recognized. Although information is scattered and discontinuous, precipitation is definitely acidic in the Los Angeles Basin and north-central california, and in the Puget Sound region in Washington. Acid rain occurrences have been observed in western and eastern Oregon, but data are inadequate for regional generalization. New stations currently being established in Washington and Oregon, largely in resposnse to the recently renewed activity of Mount St. Helens, will greatly facilitate assessment of precipitation acidity in the Northwest.     

Characterizing soils for hazardous waste site assessments

This paper provides a review and justification of the minimum data needed to characterize soils for hazardous waste site assessments and to comply with the Comprehensive Environmental Response, Compensation and Liability Act (CERCLA). Scientists and managers within the regulatory agency and the liable party need to know what are the important soil characteristics needed to make decisions about risk assessment, what areas need remediation and what remediation options are available. If all parties involved in characterizing a hazardous waste site can agree on the required soils data set prior to starting a site investigation, data can be collected in a more efficient and less costly manner. Having the proper data will aid in reaching decisions on how to address concerns at, and close-out, hazardous waste sites.This paper was prepared to address two specific concerns related to soil characterization for CERCLA remedial response. The first concern is the applicability of traditional soil classification methods to CERCLA soil characterization. The second is the identification of soil characterization data type required for CERCLA risk assessment and analysis of remedial alternatives. These concerns are related, in that the Data Quality Objective (DQO) process addresses both. The DQO process was developed in part to assist CERCLA decision-makers in identifying the data types, data quality, and data quantity required to support decisions that must be made during the remedial investigation/feasibility study (RI/FS) process. Data Quality Objectives for Remedial Response Activities: Development Process (US EPA, 1987a) is a guidebook on developing DQOs. This process as it relates to CERCLA soil characterization is discussed in the Data Quality Objective Section of this paper.     

Criteria for the evaluation of alternative environmental monitoring variables: Theory and an application using winter flounder (Pleuronectes americanus) and Dover sole (Microstomus pacificus)

The design of environmental monitoring programs is frequently hampered by a lack of objective, quantitative criteria for evaluating alternative monitoring variables. In this paper we describe two such criteria, which we call samples required — the number of samples required to detect a given change in value — and information imparted — the amount of environmental information revealed by the monitoring variable. We then use these criteria to evaluate fin erosion in winter flounder (Pleuronectes americanus) and Dover sole (Microstomus pacificus) as marine environmental monitoring variables. Two methods for determining the samples required use contaminated and reference areas to estimate the sample statistics of a hypothetical impacted population. The first method is based on the overall difference in the proportions of diseased fish in the reference and hypothetical populations. The second treats the proportion of diseased fish in individual trawls as the variate and determines the samples required based on the mean and variance of the reference and contaminated populations. We use both methods to predict the number of trawls needed to detect an increase of 200% in fin erosion in the reference population. The first method had greater statistical power but assumes spatially homogeneous populations. The second method accounts for environmental patchiness. For Dover sole it predicted 1661 trawls would be needed to detect the 200% increase. An estuarine winter flounder population would require 74 trawls, and an oceanic winter flounder population would require 142.5 trawls. It appears that fin erosion in winter flounder may be a useful indicator of environmental contamination, but several stipulations apply. Migration may inflate the number of diseased fish observed in the reference population, and a more detailed etiology of the disease is required, including an understanding of what contaminants are responsible for manifestation of the disease.