Carbonyl emissions from heavy-duty diesel vehicle exhaust in China and the contribution to ozone formation potential

Fifteen heavy-duty diesel vehicles were tested on chassis dynamometer by using typical heavy duty driving cycle and fuel economy cycle. The air from the exhaust was sampled by 2,4- dinitrophenyhydrazine cartridge and 23 carbonyl compounds were analyzed by high performance liquid chromatography. The average emission factor of carbonyls was 97.2 mg/km, higher than that of light-duty diesel vehicles and gasoline-powered vehicles. Formaldehyde, acetaldehyde, acetone and propionaidehyde were the species with the highest emission factors. Main influencing factors for carbonyl emissions were vehicle type, average speed and regulated emission standard, and the impact of vehicle loading was not evident in this study. National emission of carbonyls from diesel vehicles exhaust was calculated for China, 2011, based on both vehicle miles traveled and fuel consumption. Carbonyl emission of diesel vehicle was estimated to be 45.8 Gg, and was comparable to gasolinepowered vehicles （58.4 Gg）. The emissions of formaldehyde, acetaldehyde and acetone were 12.6, 6.9, 3.8 Gg, respectively. The ozone formation potential of carbonyls from diesel vehicles exhaust was 537 mg O3/km, higher than 497 mg O3/km of none-methane hydrocarbons emitted from diesel vehicles.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.     

Ionic composition of submicron particles (PM1.0) during the long-lasting haze period in January 2013 in Wuhan, central China

In January 2013, a long-lasting severe haze episode occurred in Northern and Central China; at its maximum, it covered a land area of approximately 1.4 million km². In Wuhan, the largest city in Central China, this event was the most severe haze episode in the 21st century. Aerosol samples of submicron particles (PM_1.0) were collected during the long-lasting haze episode at an urban site and a suburban site in Wuhan to investigate the ion characteristics of PM_1.0 in this area. The mass concentrations of PM_1.0 and its water-soluble inorganic ions (WSIIs) were almost at the same levels at two sites, which indicates that PM_1.0 pollution occurs on a regional scale in Wuhan. WSIIs (Na⁺, NH₄⁺, K⁺, Mg²⁺, Ca²⁺, Cl^-, NO₃^- and SO₄^2-) were the dominant chemical species and constituted up to 48.4% and 47.4% of PM_1.0 at WD and TH, respectively. The concentrations of PM_1.0 and WSIIs on haze days were approximately two times higher than on normal days. The ion balance calculations indicate that the particles were more acidic on haze days than on normal days. The results of the back trajectory analysis imply that the high concentrations of PM_1.0 and its water-soluble inorganic ions may be caused by stagnant weather conditions in Wuhan.     

Two-step accelerated mineral carbonation and decomposition analysis for the reduction of CO2 emission in the eco-industrial parks

Carbon dioxide（CO2） emissions are a leading contributor to the negative effects of global warming. Globally, research has focused on effective means of reducing and mitigating CO2 emissions. In this study, we examined the efficacy of eco-industrial parks（EIPs） and accelerated mineral carbonation techniques in reducing CO2 emissions in South Korea.First, we used Logarithmic Mean Divisia Index（LMDI） analysis to determine the trends in carbon production and mitigation at the existing EIPs. We found that, although CO2 was generated as byproducts and wastes of production at these EIPs, improved energy intensity effects occurred at all EIPs, and we strongly believe that EIPs are a strong alternative to traditional industrial complexes for reducing net carbon emissions. We also examined the optimal conditions for using accelerated mineral carbonation to dispose of hazardous fly ash produced through the incineration of municipal solid wastes at these EIPs. We determined that this technique most efficiently sequestered CO2 when micro-bubbling, low flow rate inlet gas, and ammonia additives were employed.     

Pd/activated carbon sorbents for mid-temperature capture of mercury from coal-derived fuel gas

Higher concentrations of Hg can be emitted from coal pyrolysis or gasification than from coal combustion, especially elemental Hg. Highly efficient Hg removal technology from coal-derived fuel gas is thus of great importance. Based on the very excellent Hg removal ability of Pd and the high adsorption abilities of activated carbon（AC） for H2 S and Hg, a series of Pd/AC sorbents was prepared by using pore volume impregnation, and their performance in capturing Hg and H2 S from coal-derived fuel gas was investigated using a laboratory-scale fixed-bed reactor. The effects of loading amount, reaction temperature and reaction atmosphere on Hg removal from coal-derived fuel gas were studied. The sorbents were characterized by N2 adsorption, X-ray diffraction（XRD） and X-ray photoelectron spectroscopy（XPS）. The results indicated that the efficiency of Hg removal increased with the increasing of Pd loading amount, but the effective utilization rate of the active component Pd decreased significantly at the same time. High temperature had a negative influence on the Hg removal. The efficiency of Hg removal in the N2-H2S-H2-CO-Hg atmosphere（simulated coal gas） was higher than that in N2-H2S-Hg and N2-Hg atmospheres, which showed that H2 and CO, with their reducing capacity, could benefit promote the removal of Hg. The XPS results suggested that there were two different ways of capturing Hg over sorbents in N2-H2S-Hg and N2-Hg atmospheres.     

Characteristics of atmospheric particles and heavy metals in winter in Chang-Zhu-Tan city clusters, China

To understand the pollution characteristics of atmospheric particles and heavy metals in winter in Chang-Zhu-Tan city clusters, China, total suspended particulate(TSP) and PM10samples were collected in cities of Changsha, Zhuzhou and Xiangtan from December 2011 to January 2012, and heavy metals of Cd, Pb, Cr, and As were analyzed. It shows that the average TSP concentration in Changsha, Zhuzhou and Xiangtan were(183 ± 73),(201 ± 84) and(190 ± 66) μg/m3respectively, and the average PM10 were(171 ± 82),(178 ± 65) and(179 ± 55) μg/m3respectively. The lowest TSP and PM10concentrations occurred at the background Shaping site of Changsha. The average ratio of ρ(PM10)/ρ(TSP) was 91.9%, ranging from 81.3% to 98.9%. Concerning heavy metals, in TSP samples, the concentration of Cr, As, Cd and Pb were 28.8–56.5, 18.1–76.3, 3.9–26.1 and 148.0–460.9 ng/m3, respectively, while in PM10samples, were 16.4–42.1, 15.5–67.9, 3.3–22.2 and 127.9–389.3 ng/m3, respectively. The enrichment factor of Cd was the highest, followed by Pb and As, while that of Cr was the lowest.     

Evaluation of soil washing process with carboxymethyl-β-cyclodextrin and carboxymethyl chitosan for recovery of PAHs/heavy metals/fluorine from metallurgic plant site

Polycyclic aromatic hydrocarbons(PAHs)/heavy metals/fluorine(F) mixed-contaminated sites caused by abandoned metallurgic plants are receiving wide attention. To address the associated environmental problems,this study was initiated to investigate the feasibility of using carboxymethyl-β-cyclodextrin(CMCD) and carboxymethyl chitosan(CMC) solution to enhance ex situ soil washing for extracting mixed contaminants. Further,Tenax extraction method was combined with a first-three-compartment model to evaluate the environmental risk of residual PAHs in washed soil. In addition,the redistribution of heavy metals/F after decontamination was also estimated using a sequential extraction procedure. Three successive washing cycles using50 g/L CMCD and 5 g/L CMC solution were effective to remove 94.3% of total PAHs,93.2% of Pb,85.8% of Cd,93.4% of Cr,83.2% of Ni and 97.3% of F simultaneously. After the 3rd washing,the residual PAHs mainly existed as very slowly desorbing fractions,which were in the form of well-aged,well-sequestered compounds; while the remaining Pb,Cd,Cr,Ni and F mainly existed as Fe–Mn oxide and residual fractions,which were always present in stable mineral forms or bound to non-labile soil fractions. Therefore,this combined cleanup strategy proved to be effective and environmentally friendly.     

Acute and chronic toxic effects of Pb2+ on polychaete Perinereis aibuhitensis：Morphological changes and responses of the antioxidant system

Perinereis aibuhitensis was used to assess adverse biological effects caused by acute and chronic Pb2＋exposure in artificial seawater under controlled laboratory conditions. In 96-hr acute toxicity experiments,the morphological changes showed a positive time/dose-dependent tendency,and the 96-hr LC50 value of Pb2＋was 686.41 mg/L. The responses of enzymatic and non-enzymatic antioxidants in tissues including catalase（CAT）,peroxidase（POD）,superoxide dismutase（SOD）,glutathione peroxidase（GSH-PX）,malondialdehyde（MDA） and the content of total soluble protein（TSP）,were investigated on days 1,4,7 and 10 after Pb2＋exposure under chronic toxicity testing. Results showed that the activation of the antioxidant system in P. aibuhitensis depended on the Pb2＋concentration and the duration of exposure time.Specifically,POD and SOD activities were induced on the first day of the exposure and decreased to the control level on day 10 after exposure. Therefore,these two indexes could be used to indicate oxidative stress associated with P. aibuhitensis exposure to Pb2＋.     

Review of the progress in preparing nano Ti02： An important environmental engineering material

TiO2 nanomaterial is promising with its high potential and outstanding performance in photocatalytic environmental applications, such as CO2 conversion, water treatment, and air quality control. For many of these applications, the particle size, crystal structure and phase, porosity, and surface area influence the activity of TiO2 dramatically. TiO2 nanomaterials with special structures and morphologies, such as nanospheres, nanowires, nanotubes, nanorods, and nanoflowers are thus synthesized due to their desired characteristics. With an emphasis on the different morphologies of TiO2 and the influence factors in the synthesis, this review summarizes fourteen TiO2 preparation methods, such as the sol-gel method, solvothermal method, and reverse micelle method. The TiO2 formation mechanisms, the advantages and disadvantages of the preparation methods, and the photocatalytic environmental application examples are proposed as well.     

西安市2013年空气质量状况分析

本文收集西安市2013年环境监测站发布的空气质量指数（AQI）及环境空气状况与监测月报资料,对空气质量等级、AQI变化情况、主要污染物浓度变化趋势及采暖期和非采暖期浓度比较进行分析.研究结果表明：西安市2013空气质量二级以上的达标率为37.8％,年均AQI值为151,SO2、NO2、PM10和PM2.5的月监测浓度变化趋势无显著意义,采暖期平均浓度均显著高于非采暖期平均浓度,PM2.5采暖期均值是非采暖期均值的3.09倍.由此可见控制SO2、NO2、PM10和PM2.5的排放是改善西安市空气质量的重点工作.