西部复杂性地貌地区消防规划评估与建设研究 ——以凉山州区域为例

城市消防规划作为城市消防安全体系建设的重要依据,是助力城市现代化进程、推动城市综合安全智慧网络形成的重要基石。通过对凉山州各地貌地区消防现状存在问题的分析,结合凉山州的实际情况及全州建设发展多种形式综合性消防应急救援队伍的需要,提出了能满足全州消防安全需求且能够有效指导城市消防建设的相应对策。     

页岩气加砂压裂高压管汇失效爆裂风险 控制措施研究与实践

随着页岩气平台井工厂化压裂施工启动,在大排量、高压力、长时间施工条件下,高压管汇失效爆裂大幅增加。为减少高压管汇在压裂过程中失效爆裂风险,运用故障假设、因果分析法从人的因素、物的因素、技术工艺、生产管理、工作环境5个方面分析事故的原因,提出了提升采购产品质量、修订完善高压管汇使用技术规范和管理制度、实施专业化管理、应用大数据管理高压管汇、优化现场地面高压管汇流程分配布局设计与联接工艺等高压管汇失效爆裂风险预防控制措施和失效后应急安全防护措施,建立了生命周期全过程、专业化的高压管汇失效爆裂防控与应急防护体系,实现风险可防受控。为页岩气压裂作业的安全提供了参考。     

利用白云石石灰去除与回收污泥厌氧消化液中氮和磷

以白云石石灰为实验材料去除与回收污泥厌氧消化液中的氮磷,通过小试实验研究不同投药固液比S/L、初始pH值、反应温度、搅拌速度及反应时间对去除与回收氮磷效果的影响。实验结果表明,在最佳投药固液比S/L为300mg/L,最佳初始pH值范围为8.5~9.5,反应温度为25.0℃,搅拌速度为150 r/min,反应时间为24 h条件下,氨氮(NH+4-N)和磷(PO3-4-P)的去除率分别为37.26%和89.60%。利用X射线衍射仪(XRD)、扫描电镜(SEM)对沉淀产物进行了表征,通过分析可知沉淀产物中含有磷酸铵镁(MAP),可实现废水中氮磷经济有效的回收。     

Hazardous substances in indoor dust emitted from waste TV recycling facility

Various hazardous substances contained in waste TV sets might be released into environment via dust during recycling activities. Two brominated flame retardants (BFRs), polybrominated diphenyl ethers (PBDEs), and tetrabromobisphenol A (TBBPA), and five kinds of heavy metals (Cu, Pb, Cd, Cr, and Ni) were detected in indoor dust collected from two workshops (TV dismantling workshop and subsequent recycling workshop). PBDEs concentrations in dust from waste wires recycling line (722,000 ng/g) were the highest among the studied sites, followed by those in manual dismantling–sorting line (117,000 ng/g), whereas TBBPA concentrations were the highest in manual dismantling–sorting line (557 ng/g) and printed circuit board (PCB) recycling line (428 ng/g). For heavy metals, Cu and Pb were the most enriched metals in all dust samples. The highest concentration of Pb (22,900 mg/kg) was found in TV dismantling workshop-floor dust. Meanwhile, Cu was the predominant metal in dust from the PCB recycling line, especially in dust collected from electrostatic separation area (42,700 mg/kg). Occupational exposure assessment results showed that workers were the most exposed to BDE-209 among the four PBDE congeners (BDE-47, BDE-99, BDE-153, and BDE-209) in both workshops. The hazard quotient (HQ) indicated that noncancerous effects were unlikely for both BFRs and heavy metals (HQ?<?1), and carcinogenic risks for Cd, Cr, and Ni (risk?<?10^?6) on workers in two workshops were relatively low.     

船舶塑料垃圾热解特性及动力学分析

利用热重分析(TGA)研究船舶塑料垃圾在不同升温速率和不同气氛下的热解特性,并得到了热解动力学参数。结果表明,船舶塑料垃圾的热解过程主要有3个阶段,比一般塑料热解复杂;随着升温速率增大,最大热解速率和最大热解速率温度等热解特性参数也增大,反应变得更剧烈;N2/CO2比为4∶1时,热解反应进行得最完全,固体残留率最少。动力学分析表明,采用3个连续一级反应模型能很好地拟合实验数据;不同的升温速率和气氛比对反应各阶段活化能均有不同程度的影响。     

PCBs污染土壤的CaO诱导低温热处理脱氯研究

研究了低温热处理脱氯技术对废弃电容器封存点附近污染土壤中多氯联苯脱氯的效果,考察反应温度、反应时间及CaO添加比例对PCBs去除率、脱氯率的影响以及反应前后土壤中污染物的组分变化。实验土样中PCBs浓度为107.7 mg/g,属于罕见高浓度PCBs污染土壤。当反应温度为400℃、停留时间4h、CaO添加比例为10%,PCBs的去除率为87.7%,脱氯率为85.3%。土壤样品中五氯联苯和四氯联苯反应后含量降低或未检出,部分反应后样品检出一氯联苯和联苯,说明在CaO诱导PCBs低温热处理脱氯反应中存在逐步脱氯/加氢反应途径。     

我国林业碳汇市场供需研究——以广东长隆碳汇造林项目为例

广东长隆碳汇造林项目作为我国首个获得国家发展和改革委员会签发的林业温室气体自愿减排(CCER)项目,对于我国林业碳汇参与应对气候变化具有重要的示范意义。本文对广东长隆碳汇造林项目进行了成本收益分析,发现林业碳汇交易价格被远远低估,从而使该项目不具备经济上的可复制性。为探究交易价格被低估的原因,本文考察了林业碳汇市场的供需关系,发现目前碳交易市场对林业碳汇CCER需求不足仅是表象,供需错配才是实质。首先,从需求侧来看,广东省碳排放配额设置过于宽松,缺乏林业碳汇CCER的接纳能力;其次,就供给侧而言,CCER的交易成本很高,且项目申报要求业主为企业法人,这严重限制了林业碳汇CCER的有效供给。鉴于以上问题,本文提出应同时从林业碳汇CCER的需求侧和供给侧着手改革。就需求侧而言,收紧广东省碳排放配额总量,并将林业碳汇CCER交易由补充机制改为配额管理。就供给侧而言,可以结合广东省推进林业碳普惠制度,将项目申报主体和交易主体放宽到独立法人和个人,广泛吸收民间资本、培育大型林业企业开展碳汇造林项目;降低碳汇项目进入门槛,根据省情制定方法学,简化签批手续。     

湖北省土地利用减碳增效系统仿真及结构优化研究

土地利用变化是引起碳排放的重要原因之一,土地经济效益是利用土地的目标之一,如何通过优化土地利用结构实现土地利用减碳增效是值得研究的重要问题。基于系统结构与功能相互作用的视角,梳理复杂系统内变量间的反馈关系,运用系统动力学(SD)进行建模,将约束条件纳入到多目标规划(MOP)中,实现MOP与SD模型整合,进行系统仿真并得出优化后2020年湖北省土地利用结构。结果显示,利用SD-MOP模型能够实现减碳增效目标下土地利用结构优化,与2008年真实值相比,耕地、林地、牧草地及建设用地分别增加了0.33×10~4、30.17×10~4、0.08×10~4和16.37×10~4 hm~2,其他农用地及未利用地分别减少7.23×10~4、33.15×10~4 hm~2;与无约束SD单模型仿真相比,土地利用碳排放量减少了58×10~4 t,经济效益年增长率维持在3.58%,优化方案具有可行性。SD-MOP模型优化的土地利用结构符合区域可持续发展要求,兼顾了土地利用碳减排和经济效益增长的双重目标,能为区域土地资源优化配置提供参考。     

Recycling of WEEE plastics: a review

Electric and electronic equipment (EEE) is swiftly growing in volume, level of sophistication, and diversity. Also, it evolves briskly, moved by innovation and technical change, and draws on numerous and at times rare resources. Waste EEE (WEEE) has evolved into an important societal problem. Recycling and treating WEEE implies occupational as well as environmental hazards that are still incompletely documented. Still, second hand EEE has been exported and treated in Africa, China, and India in a precarious informal context. In developed countries, EEE recycling has been sustained by a wide range of initiatives and motives, such as sustainability, creating jobs, and the value of precious or rare metals. Current EU Directives require a steep reduction of WEEE plastics (WEEP) going to landfill. Mechanical, thermal, and feedstock recycling of WEEP are analysed and some options confronted. Plastics recycling should be weighed against the eventual risks related to their hazardous ingredients, mainly legacy brominated fire retardants and heavy metals. Another paper is related to a somewhat similar problem, yet involving a different mix of plastics: recycling plastics from automotive shredder residue.