Aerosol size distribution and mass concentration measurements in various cities of Pakistan

During March and April 2010 aerosol inventories from four large cities in Pakistan were assessed in terms of particle size distributions (N), mass (M) concentrations, and particulate matter (PM) concentrations. These M and PM concentrations were obtained for Karachi, Lahore, Rawalpindi, and Peshawar from N concentrations using a native algorithm based on the Grimm model 1.109 dust monitor. The results have confirmed high N, M and PM concentrations in all four cities. They also revealed major contributions to the aerosol concentrations from the re-suspension of road dust, from sea salt aerosols, and from vehicular and industrial emissions. During the study period the 24 hour average PM(10) concentrations for three sites in Karachi were found to be 461 μg m(-3), 270 μg m(-3), and 88 μg m(-3), while the average values for Lahore, Rawalpindi and Peshawar were 198 μg m(-3), 448 μg m(-3), and 540 μg m(-3), respectively. The corresponding 24 hour average PM(2.5) concentrations were 185 μg m(-3), 151 μg m(-3), and 60 μg m(-3) for the three sites in Karachi, and 91 μg m(-3), 140 μg m(-3), and 160 μg m(-3) for Lahore, Rawalpindi and Peshawar, respectively. The low PM(2.5)/PM(10) ratios revealed a high proportion of coarser particles, which are likely to have originated from (a) traffic, (b) other combustion sources, and (c) the re-suspension of road dust. Our calculated 24 hour averaged PM(10) and PM(2.5) concentrations at all sampling points were between 2 and 10 times higher than the maximum PM concentrations recommended by the WHO guidelines. The aerosol samples collected were analyzed for crustal elements (Al, Fe, Si, Mg, Ca) and trace elements (B, Ba, Cr, Cu, K, Na, Mn, Ni, P, Pb, S, Sr, Cd, Ti, Zn and Zr). The averaged concentrations for crustal elements ranged from 1.02 ± 0.76 μg m(-3) for Si at the Sea View location in Karachi to 74.96 ± 7.39 μg m(-3) for Ca in Rawalpindi, and averaged concentrations for trace elements varied from 7.0 ± 0.75 ng m(-3) for B from the SUPARCO location in Karachi to 17.84 ± 0.30 μg m(-3) for Na at the M. A. Jinnah Road location, also in Karachi.     

Simultaneous monitoring of SARS-CoV-2, bacteria,and fungi in indoor air of hospital: a study on Hajar Hospital in Shahrekord,Iran

The novel SARS-CoV-2 outbreak was declared as pandemic by the World Health Organization (WHO) on March 11, 2020. Understanding the airborne route of SARS-CoV-2 transmission is essential for infection prevention and control. In this study, a total of 107 indoor air samples (45 SARS-CoV-2, 62 bacteria, and fungi) were collected from different wards of the Hajar Hospital in Shahrekord, Iran. Simultaneously, bacterial and fungal samples were also collected from the ambient air of hospital yard. Overall, 6 positive air samples were detected in the infectious 1 and infectious 2 wards, intensive care unit (ICU), computed tomography (CT) scan, respiratory patients’ clinic, and personal protective equipment (PPE) room. Also, airborne bacteria and fungi were simultaneously detected in the various wards of the hospital with concentrations ranging from 14 to 106 CFU m^?3 and 18 to 141 CFU m^?3, respectively. The highest mean concentrations of bacteria and fungi were observed in respiratory patients’ clinics and ICU wards, respectively. Significant correlation (p < 0.05) was found between airborne bacterial concentration and the presence of SARS-CoV-2, while no significant correlation was found between fungi concentration and the virus presence. This study provided an additional evidence about the presence of SARS-CoV-2 in the indoor air of a hospital that admitted COVID-19 patients. Moreover, it was revealed that the monitoring of microbial quality of indoor air in such hospitals is very important, especially during the COVID-19 pandemic, for controlling the nosocomial infections.

     

A Comparison of Modified and Unmodified Cellulose Nanofiber Reinforced Polylactic Acid (PLA) Prepared by Twin Screw Extrusion

The goal of this work was to evaluate the effect of chemical modification of cellulose nanofibers (CNF) on the properties of polylactic acid (PLA) nanocomposites. Acetylated nanofibers (ACNF), with degree of substitution 1.07, were isolated from acetylated kenaf fibers by mechanical treatments. Acetylated nanofibers showed more hydrophobic properties compared to non-acetylated ones. The results showed that both crystallinity and thermal stability of acetylated nanofibers were lower than non-acetylated ones. The nanocomposites were prepared by premixing two PLA master batches, one with a high concentration of ACNF and the second with CNF. These were diluted to final concentrations (5?wt%) during the extrusion. The morphology studies of PLA and its nanocomposites showed nanofiber aggregates in both materials. The results showed that the tensile and dynamic mechanical properties were enhanced for both acetylated and non-acetylated nanocomposites compared to the neat PLA matrix while no significant improvement was observed for the acetylated nanocomposites compared to non-acetylated ones. However, the storage modulus increased slightly for acetylated nanocomposites compared to non-acetylated ones.     

Toxicological effects of N,N,N′,N′-tetramethylethylenediamine on electric eel (Electrophorus electricus) acetylcholinesterase and human serum butyrylcholinesterase

This study examined the adverse effects of N,N,N′,N′-tetramethylethylenediamine (TEMED) on electric eel (Electrophorus electricus) acetylcholinesterase (AChE) and human serum butyrylcholinesterase (BChE). Data show that TEMED inhibited AChE in electric eel as well as human serum BChE. Kinetic studies indicated that the inhibition produced by TEMED in both sources was of mixed type, i.e. K_m increased and V _max decreased in a concentration-dependent manner. K_I (constant of ChE–substrate–TEMED complex into ChE–substrate complex and TEMED) was estimated to be 0.674 mM for electric eel and 0.024 mM for human serum BChE. The γK_m (dissociation constant of ChE–substrate–TEMED complex into ChE–TEMED complex and substrate) was 0.083 and 0.2 mM for electric eel AChE and human serum BChE, respectively. The IC₅₀ for electric eel and for human serum ChE was 1.57 and 0.043 mM, respectively. The present results suggest that TEMED produced adverse effects on electric eel and human serum via inhibition of ChE.     

The livelihoods gap: responding to the economic dynamics of vulnerability in Somalia

A 'livelihoods gap' has become evident in international aid delivery to Somalia. Existing aid interventions do not address the economic dynamics of vulnerability resulting from Somalia's long history of predatory development and asset stripping. To prevent poor households' regular return to sub-subsistence income levels after a brief period of plenty, this paper argues that aid agencies should reorient and expand existing interventions to assist poor households to capitalise on temporary improvements in environmental and security conditions. As a corollary to emergency relief and efforts to construct state institutions, it is necessary to devise country-wide interventions that will rebuild household asset bases by protecting savings during times of stress and ensuring that markets benefit poor producers.     

An empirical bayes safety evaluation of tram/streetcar signal and lane priority measures in Melbourne

Objective: Streetcars/tram systems are growing worldwide, and many are given priority to increase speed and reliability performance in mixed traffic conditions. Research related to the road safety impact of tram priority is limited. This study explores the road safety impacts of tram priority measures including lane and intersection/signal priority measures.

Method: A before–after crash study was conducted using the empirical Bayes (EB) method to provide more accurate crash impact estimates by accounting for wider crash trends and regression to the mean effects. Before–after crash data for 29 intersections with tram signal priority and 23 arterials with tram lane priority in Melbourne, Australia, were analyzed to evaluate the road safety impact of tram priority.

Results: The EB before–after analysis results indicated a statistically significant adjusted crash reduction rate of 16.4% after implementation of tram priority measures. Signal priority measures were found to reduce crashes by 13.9% and lane priority by 19.4%. A disaggregate level simple before–after analysis indicated reductions in total and serious crashes as well as vehicle-, pedestrian-, and motorcycle-involved crashes. In addition, reductions in on-path crashes, pedestrian-involved crashes, and collisions among vehicles moving in the same and opposite directions and all other specific crash types were found after tram priority implementation.

Conclusions: Results suggest that streetcar/tram priority measures result in safety benefits for all road users, including vehicles, pedestrians, and cyclists. Policy implications and areas for future research are discussed.     

Fluoride Concentration in Drinking Water of Karachi City (Pakistan)

The ground and municipal water supply samples of Karachi city were analyzed for their fluoride contents. The fluoride contents in water samples collected from the subsurface and river sources were found below the WHO recommended value for the general health of the people. However, in some industrial areas the groundwater sample showed higher level of fluoride concentration. Continuous monitoring of water resources and cautious fluoridation is suggested to maintain proper status of fluoride concentration in the drinking water.     

Effect of Lignocellulosic Type on Long-Term Hygroscopic Behavior of Natural Filler/HDPE Composites

Natural filler/high density polyethylene (HDPE) injection-molded composites of flour from different lignocellulosic sources were prepared, and their long-term water absorption and thickness swelling were studied. Filler samples from wheat straw, hybrid Euro-American poplar, and loblolly pine were mixed with the matrix at 35 wt% lignocellulosics content and either zero or 2% maleic anhydride grafted polyethylene (MAPE) as compatibilizer. Results indicated water absorption of all the composites followed the kinetics of a Fickian diffusion process. The water diffusion coefficient of the composites was clearly dependent upon the lignocellulosic type. The wheat straw composites showed the highest and the pine composites exhibited the lowest water absorption coefficients. The highest thickness swelling took place in the wheat straw composites, followed by the poplar and pine composites, respectively. Adding MAPE to the composites decreased the water diffusion coefficient and thickness swelling by improving the adhesion between natural filler and the HDPE.     

Determination of the effect of operating cost uncertainty on mining project evaluation

Mining projects are complex businesses that demand constant risk assessment. This is because several kinds of uncertainties influence the value of a mine project, typically. These uncertainties may be classified as exploration uncertainties, economic uncertainties and engineering uncertainties. The evaluation of a mine project under these uncertainties is a complicated job, which may lead to making a wrong decision by managers and stockholders. Therefore, at first, the engineers must recognize the mining uncertainties before carrying out the project evaluation. The economic uncertainties are the most important factors, which may affect the project evaluation. Among the mentioned uncertainties, the operating cost uncertainty is an important and effective factor, which is ignored to a certain extent.