Effects of fly ash addition on physical properties of porous clay-fly ash composites via polymeric replica technique

The porous composites of clay and fly ash have the potential to be used in many fields, such as catalyst support and gas adsorbents. In this study, various ratios of fly ash (1–2) with different percentage of suspension (50–70 wt%) were applied to produce porous clay-fly ash composites via polymeric replica technique. Fabrication process starts by mixing clay and fly ash in distilled water to form slurry. The process is followed by fully immersing polymer sponge in slurry. The excess slurry is then removed through squeezing. Finally, the sponge coated with slurry is sintered at 500 and 1250 °C for 1 h. It is found that the compressive strength of porous composites improves significantly (0.178–1.28 MPa) when the amount of clay-fly ash suspension mixture (50–70 wt%) increases. The compressive strength of porous composites is mainly attributed to the mullite, quartz and amorphous phase formations. These results are supported by X-ray diffraction analysis. On the other hand, increase in the amount of suspension reduces the apparent density (from 2.44 to 2.32 g/cm³) and porosity (from 97 to 85 %). The reduction in apparent density is believed to be caused by the presence of high fly ash content in porous composites. The melted fly ash cenospheres have closed the internal pores and increased density of samples. Higher suspension level not only reduces porosity, but also increases close pores of the porous composites. The results are justified through the observation from the structures of porous clay-fly ash composites.     

The progress of interdisciplinarity in invasion science

Interdisciplinarity is needed to gain knowledge of the ecology of invasive species and invaded ecosystems, and of the human dimensions of biological invasions. We combine a quantitative literature review with a qualitative historical narrative to document the progress of interdisciplinarity in invasion science since 1950. Our review shows that 92.4% of interdisciplinary publications (out of 9192) focus on ecological questions, 4.4% on social ones, and 3.2% on social–ecological ones. The emergence of invasion science out of ecology might explain why interdisciplinarity has remained mostly within the natural sciences. Nevertheless, invasion science is attracting social–ecological collaborations to understand ecological challenges, and to develop novel approaches to address new ideas, concepts, and invasion-related questions between scholars and stakeholders. We discuss ways to reframe invasion science as a field centred on interlinked social–ecological dynamics to bring science, governance and society together in a common effort to deal with invasions.     

Design of water quality monitoring networks with two information scenarios in tropical Andean basins

Design and redesign of water quality monitoring networks were evaluated for two similarly sized watersheds in the tropical Andes via optimization techniques using geographic information system technology (GIS) and a matter-element analysis of 5-day biological oxygen demand (BOD₅) and total suspended solids (TSS). This resulted in a flexible, objectively based design for a 1128-km² watershed without prior water quality data (La Miel River), and a network redesign of a 1052-km² watershed with historical water quality monitoring (Chinchiná River). Monitoring design for the undocumented basin incorporated mathematical expressions for physical, anthropological, and historical factors—and was based on clear objectives for diagnosis and intervention of water pollution. Network redesign identified network redundancy, which resulted in a 64% reduction in the number of water quality monitoring stations along the channel, and a 78% reduction of stations throughout the basin. Most tropical drainage basins throughout the world have little to no prior water quality data. But even in well-studied drainage basins like the Chinchiná River, which is among the most thoroughly studied basins in Colombia, redesign of historical and existing monitoring networks will become a standard tool to advance the restoration of polluted surface waters, not only in Colombia, but also throughout the world.     

Biological treatment of wastewater in aeration tanks: Theoretical bases for process calculations

This article describes the method, based on the kinetics of enzyme reaction, for calculating treatment rates for wastewater effluents of varied concentrations in mixing aeration tanks and continuous flow aeration tanks. Using this method would make it possible to optimize the parameters of the biological treatment of wastewater. In addition, the authors illustrate that partitioning of the aeration space of the mixing aeration tank in a separate KU‐200 compact installation, which is intended for wastewater treatment from small sources, would make it possible to increase its efficiency by a factor of 1.8.     

Evaluation in situ of genotoxicity and stress in South American common toad <Emphasis Type="Italic">Rhinella arenarum</Emphasis> in environments related to fluorite mine

Little attention has been paid to the impact of wastewater generated by mining activities on fluoride. In this study, we evaluated the hematology responses of common South American toad Rhinella arenarum inhabiting natural and artificial environments associated with a fluorite mine from central Argentina. We analyzed three sampling stations associated with the fluorite mine: (I) Los Cerros Negros stream (CN), which runs on granitic rock with a high fluorite content; (II) Los Vallecitos stream (LV), which runs on metamorphic rock with low fluorite content; and (III) artificial decantation ponds (DP) containing sediments produced by fluorite flotation process. We calculated frequencies of micronuclei, erythrocyte nuclear abnormalities, mitosis, and immature erythrocytes. In addition, we performed a differential leukocyte count and determined neutrophils/lymphocyte ratio as a stress response estimator. We found high micronucleus (MN) and erythrocyte nuclear abnormality (ENA) frequencies in DP and CN but low frequencies in LV. The neutrophil/lymphocyte ratio was different among sites, with a significant increase in individuals from DP. Values registered in DP could be caused by exposure to mixture of compounds registered in dams that hold wastewater, while high values registered in CN stream might be due to natural concentrations of fluoride. Our results suggest that blood is an effective and non-destructive sensitive indicator for monitoring genotoxic agents in freshwater ecosystems.     

Adsorptive amputation of hazardous azo dye Congo red from wastewater: a critical review

Increasing amount of dyes in an ecosystem has propelled the search of various methods for dye removal. Amongst all the methods, adsorption occupies a prominent place in dye removal. Keeping this in mind, many adsorbents used for the removal of hazardous anionic azo dye Congo red (CR) from aqueous medium were reviewed by the authors. The main objectives behind this review article are to assemble the information on scattered adsorbents and enlighten the wide range of potentially effective adsorbents for CR removal. Thus, CR sorption by various adsorbents such as activated carbon, non-conventional low-cost materials, nanomaterials, composites and nanocomposites are surveyed and critically reviewed as well as their sorption capacities are also compared. This review also explores the grey areas of the adsorption performance of various adsorbents with reference to the effects of pH, contact time, initial dye concentration and adsorbent dosage. The equilibrium adsorption isotherm, kinetic and thermodynamic data of different adsorbents used for CR removal were also analysed. It is evident from a literature survey of more than 290 published papers that nanoparticle and nanocomposite adsorbents have demonstrated outstanding adsorption capabilities for CR.

Open image in new window

Graphical abstract ?

     

Thermotolerant coliform loadings to coastal areas of Santa Catarina (Brazil) evidence the effect of growing urbanisation and insufficient provision of sewerage infrastructure

Thermotolerant coliform (TC) loadings were quantified for 49 catchments draining into the North and South Bays of Santa Catarina (SC, southeastern Brazil), an area known for its tourism and aquaculture. TC loadings were calculated based on flow measurements taken in 26 rivers. TC concentrations ere quantified based on surface water samples collected at 49 catchment outlets in 2012 and 2013. Median TC loads ranged from 3.7 × 10³ to 6.8 × 10⁸ MPN s^?1. TC loadings in the catchments increased in proportion to increases in resident human population, population density and percentage of urbanised area. Catchments with more than 60% of area covered by wastewater collection and treatment systems had higher TC loads per person than catchments with less than 25%. Based on the study catchments, these results indicate that current sewerage infrastructure is ineffective in reducing contamination of faecal origin to surface waters. These findings have important implications for the management of microbiological health hazards in bathing, recreational and shellfish aquaculture waters in the North and South Bays of Santa Catarina Island.     

Dynamic trends of heavy metal contents in plants and soil under different industrial air pollution regimes

Based on 30-year monitoring of Ni²⁺ and Cu²⁺ concentrations in the organic horizon of Albic Rustic Podzols and the foliage of six plant species, a dynamic trend in the level of heavy metal accumulation in the components of forest ecosystems of the Kola Peninsula has been revealed against the background of five- to eightfold reduction of pollutant emissions. The direction of the trend has been found to differ: the size of polluted area and pollution level increase with time, while the concentrations of heavy metals in plants decrease due to reduction in their input from the polluted air.     

Wasteload Allocation Using Wastewater Treatment and Flow Augmentation

A Wasteload allocation model, named Cost-Flow-Augmentation Model involving wastewater treatment and flow augmentation as a method of pollution abatement has been developed. The cost functions for wastewater treatment were developed as power functions of biochemical oxygen demand (BOD) removal using the regression module of the SPSS10 software. The cost function for flow augmentation was also developed using a regression between cost of dam/barrage and corresponding flow released from upstream reservoir for downstream water quality improvement. The response of wasteloads and flow augmentation on the water quality was quantified in terms of transfer coefficient calculated using the QUAL2E water quality simulation model. The performance of these models is demonstrated on the 22-km-long Delhi stretch of river Yamuna, India. Optimal solutions of the formulated models were obtained using the Web-based interactive non-differentiable interactive multiobjective bundle-based optimization system software. The optimal solutions obtained reveal that flow augmentation is not an economically feasible pollution abatement option for the Delhi stretch of river Yamuna.     

Production costs and operative margins in electric energy generation from biogas. Full-scale case studies in Italy

The purpose of this study was to observe the economic sustainability of three different biogas full scale plants, fed with different organic matrices: energy crops (EC), manure, agro-industrial (Plants B and C) and organic fraction of municipal solid waste (OFMSW) (Plant A). The plants were observed for one year and total annual biomass feeding, biomass composition and biomass cost (€ Mg^?1), initial investment cost and plant electric power production were registered. The unit costs of biogas and electric energy (€ Sm^?3_biogas, € kW h^?1_EE) were differently distributed, depending on the type of feed and plant. Plant A showed high management/maintenance cost for OFMSW treatment (0.155 € Sm^?3_biogas, 45% of total cost), Plant B suffered high cost for EC supply (0.130 € Sm^?3_biogas, 49% of total cost) and Plant C showed higher impact on the total costs because of the depreciation charge (0.146 € Sm^?3_biogas, 41% of total costs). The breakeven point for the tariff of electric energy, calculated for the different cases, resulted in the range 120–170 € MW h^?1_EE, depending on fed materials and plant scale. EC had great impact on biomass supply costs and should be reduced, in favor of organic waste and residues; plant scale still heavily influences the production costs. The EU States should drive incentives in dependence of these factors, to further develop this still promising sector.