实验室含铅、镉废水的处理方法探究

文章报道了利用一种新型的环境矿物材料-羟基磷灰石处理实验室高浓度铅、镉污水的方法,该方法与《环境水质监测质量保证手册》中的消石灰处理法相比具有去除速度快、经济有效、无二次污染、安全环保等显著优点。本文还采用消石灰处理法对一次处理后的废水的上清液进行二次处理,这样能使实验室含高浓度的铅、镉废水,在处理后达到地表水三级质量标准。     

K_2Cr_2O_7法和紫外分光光度法测定污水COD的对比研究

分别利用重铬酸钾法、重铬酸钾紫外分光光度法和紫外分光光度法测定污水的COD极差分别为2.43mg/L、1.19 mg/L和4.72 mg/L,RE%分别为0.84%、0.53%和1.36%,重铬酸钾紫外分光光度法和紫外分光光度法的线性范围分别在0~280 mg/L和0~400 mg/L.结果表明:重铬酸钾紫外分光光度法测定的准确度和精密度最高,简化了用标准溶液进行标定的步骤,缩短了实验时间;紫外分光光度法测定的结果准确度和精密度相对差一些,但是快速、操作简单、节省试剂,为广大环境工作者提供借鉴参考的实例。     

Aging and compressibility of municipal solid wastes

The expansion of a municipal solid waste (MSW) landfill requires the ability to predict settlement behavior of the existing landfill. The practice of using a single compressibility value when performing a settlement analysis may lead to inaccurate predictions. This paper gives consideration to changes in the mechanical compressibility of MSW as a function of the fill age of MSW as well as the embedding depth of MSW. Borehole samples representative of various fill ages were obtained from five boreholes drilled to the bottom of the Qizhishan landfill in Suzhou, China. Thirty-one borehole samples were used to perform confined compression tests. Waste composition and volume-mass properties (i.e., unit weight, void ratio, and water content) were measured on all the samples. The test results showed that the compressible components of the MSW (i.e., organics, plastics, paper, wood and textiles) decreased with an increase in the fill age. The in situ void ratio of the MSW was shown to decrease with depth into the landfill. The compression index, Cc, was observed to decrease from 1.0 to 0.3 with depth into the landfill. Settlement analyses were performed on the existing landfill, demonstrating that the variation of MSW compressibility with fill age or depth should be taken into account in the settlement prediction.     

湘江株洲段丰水期镉污染负荷总量测算及分配

以2010年8月湘江干流株洲段代表性断面水质与底泥监测资料以及其他资料为基础,采用WASP7模型模拟该江段丰水期镉浓度,并进行镉污染负荷测算与分配。研究结果表明,WASP7模型较好地重现了镉浓度的变化规律,8月份该河段上游镉入流量2 446.33 kg,下游出流量3 076.44 kg,区间增量630.12 kg,其中点源负荷量241.67 kg,占38.4%,面源负荷量304.49 kg,占48.3%,内源负荷量为83.96 kg,占13.3%。     

废弃中药渣催化热解制取生物油的研究

利用热重分析仪(TGA)对植物类中药渣的热解特性进行了研究,用Coats-Redfern积分法计算了其热解动力学参数,得出中药渣热解反应符合一级反应动力学方程,其活化能较低,为36.0kJ/mol。考察了热解温度对气体、液体、固体产物的影响,在723K时,液体产物生物油产率最高,为39%。以介孔分子筛SBA-15以及分别负载Al、Sn、Ni、Cu和Mg的SBA-15作为催化剂,研究催化热解对气体、液体、固体产率及生物油组分的影响。研究表明,Al-SBA-15的催化效果较好,液体产率最高,为36%;采用元素分析仪和热值测定仪,得到用Al-SBA-15作为催化剂时生物油的氧质量分数最低,低位热值最高。用GC/MS对生物油组分的分析结果表明,添加Al-SBA-15后,热解产物中脂肪族和芳香族化合物增加,而含氧化合物减少。     

湿法净化黑烟中添加剂对炭黑沉降性能的影响

湿法净化黑烟中炭黑颗粒物的关键在于降低吸收液的表面张力并以高性能絮凝剂使其从溶液中絮凝、沉降以利于分离。选用十六烷基三甲基溴化胺(CTAB)为主要表面活性剂,使之与十二烷基苯磺酸钠(SDBS)和月桂醇聚氧乙烯(9)醚(AEO-9)进行复配实验,研究了复配液的表面张力,再向最低表面张力的复配表面活性剂溶液中投加絮凝剂聚合氯化铝(PAC)和聚丙烯酰胺(PAM),探讨絮凝剂的添加对黑烟颗粒沉降和絮凝的影响.实验结果表明:同时添加表面活性剂CTAB,SDBS和PAC,并使之浓度分别为0.5 mmol/L,0.4 mmol/L和200 mg/L时,炭黑颗粒的沉降效果最好,沉降率高达94%,且絮凝体较大,沉降时间仅为2 min。     

污水污泥裂解及其性能的研究

以碘吸附值为裂解残渣吸附性能的指标，通过单因素实验和正交实验，确定了制备裂解残渣的最佳工艺条件，并对残渣的表面元素组成、孔结构组成、晶相组成和吸附性能等性质进行了表征。结果显示：以浓度均为5 mol/L的ZnCl₂和H₂SO₄作活化剂、复配比2∶1、活化温度600℃、活化时间1 h、固液比1∶2.5，制得的裂解残渣酸洗后碘值平均值可达892.8 mg/g；用制备的裂解残渣对苯酚废水进行处理，室温下振荡5 min，苯酚去除率即可达到87.9%，且符合Langmuir吸附等温线方程和Freundlich吸附等温线方程。     

突变灰盖鬼伞过氧化物酶降解刚果红的响应面法优化分析简

酶法降解偶氮染料刚果红是一个复杂的过程，受温度、pH、酶量、刚果红浓度和双氧水浓度显著影响。为研究各因素及因素间交互作用对刚果红降解影响，提高刚果红的降解率，分别使用单因素法和响应面分析法对刚果红降解条件进行了优化。单因素实验结果显示灰盖鬼伞过氧化物酶降解刚果红的最适条件为：pH 5.0、32℃、酶量4.98 U、双氧水0.1 mmol/L、刚果红20 mg/L，此时刚果红最高降解率为34.84%。然后选双氧水浓度、刚果红浓度和灰盖鬼伞过氧化物酶量作为3个因素，通过中心组合设计实验，用响应面法对刚果红降解进行优化分析，最后得到一个拟合度良好的二次多项方程模型（R²=0.9900）。方差分析结果显示，刚果红浓度和酶量是影响最显著的因素，双氧水与酶以及染料与酶之间的交互作用极显著。响应面分析优化后的反应体系为：双氧水浓度0.15 mmol/L，刚果红浓度为27.21 mg/L，酶为2.0 7 U，在此条件下，刚果红降解率达58.13%。     

超声破解污泥上清液对A~2O工艺脱氮除磷和微生物群落结构的影响

为了提高传统污水处理工艺的脱氮除磷效率、实现污泥资源化,本实验通过超声破解污泥获取碳源,采用耗氧呼吸速率分析上清液作为碳源的可行性,并将上清液回用于生活污水,考察其对A2O工艺长期运行的脱氮除磷效果和微生物群落结构的影响。结果表明,上清液中可降解有机物达到76.2%,具有作为内碳源的潜能;上清液和生活污水按1∶15投入A2O反应器后,氮、磷的去除率分别从63.2%和53.4%提高到了82.1%和94.7%;上清液明显改变了微生物群落结构,使除磷菌Actinobacteia和反硝化聚磷菌Sphingobacterium富集。     

Cost-Effectiveness of Payments for Ecosystem Services with Dual Goals of Environment and Poverty Alleviation

The goal of this article is to understand strategies by which both the environmental and poverty alleviation objectives of PES programs can be achieved cost effectively. To meet this goal, we first create a conceptual framework to understand the implications of alternative targeting when policy makers have both environmental and poverty alleviation goals. We then use the Grain for Green program in China, the largest PES program in the developing world, as a case study. We also use a data set from a survey that we designed and implemented to evaluate the program. Using the data set we first evaluate what factors determined selection of program areas for the Grain for Green program. We then demonstrate the heterogeneity of parcels and households and examine the correlations across households and their parcels in terms of their potential environmental benefits, opportunity costs of participating, and the asset levels of households as an indicator of poverty. Finally, we compare five alternative targeting criteria and simulate their performance in terms of cost effectiveness in meeting both the environmental and poverty alleviation goals when given a fixed budget. Based on our simulations, we find that there is a substantial gain in the cost effectiveness of the program by targeting parcels based on the “gold standard,” i.e., targeting parcels with low opportunity cost and high environmental benefit managed by poorer households.