盾构隧道的开挖模拟及地震反应数值分析

由于盾构隧道掘进的特殊施工工艺,使开挖模拟的数值计算存在着诸多难以量化的因素。采用应力释放法模拟盾构隧道的开挖,在衬砌和土体之间设置等代层单元模拟盾构施工的影响,求得竣工期的应力场和位移场。在静力计算基础上运用动力有限元时程分析法,采用粘性人工边界条件,分析了隧道衬砌在地震过程中的最大响应。其结果和规律可为一般的盾构隧道地震反应分析提供借鉴。     

公路隧道火灾事故调研与对策分析

通过调研国内外近60年来,有代表性的33起公路隧道火灾事故,对公路隧道火灾事故起因、特点及危害进行了详细分析,结合国外公路隧道火灾安全措施以及防火安全评估经验,提出几点降低公路隧道火灾事故风险,减少事故危害的对策与建议。以期为公路隧道规划、设计以及建设运营等工作提供有益的参考。     

隧道火灾拱顶附近烟气最高温度的研究

为了研究顶部开口的城市隧道在采用自然通风模式下的火灾特性,在已建成的隧道中设计并实施了全尺寸火灾试验,得到了隧道火灾自然通风模式下的拱顶附近烟气最高温度纵向变化数据。通过实验数据与理论预测结果对比的方法验证了H.Kurioka等人建立的隧道火羽流模型及其计算公式的可靠性,为市政公路隧道建设提供了科学依据,为隧道火灾的研究及其消防工作提供理论指导和有益借鉴。     

集中排烟公路隧道入口段火灾下诱导风速研究

为研究集中排烟模式下公路隧道入口段发生火灾时的合理诱导风速,以某公路隧道为背景,运用火灾动力学模拟软件FDS对隧道人口段火灾时不同坡度、不同诱导风速的16组火灾工况进行模拟研究,通过对各工况下隧道内的温度场分布及烟气控制效果模拟结果的分析,得到了各工况下的合理诱导风速,研究结果可为公路隧道集中排烟系统关键设计参数提供参考.     

隧道排污量估算与治污效果预测

通过隧道排污量和排污效果的简单分析，指出了其排污治理过程中应注意的有关事项，如进 行人口控制，改善居民的生活方式，提高环境保护意识和治理技术等，所述分析方法可供其它类似 工程参考。     

Physical Modeling of Emissions from Naturally Ventilated Underground Parking Garages

The dispersion of pollutants from naturally ventilated underground parking garages has been studied in a boundary layer wind tunnel. Two idealized model setups have been analysed, one was simulating pollutant dispersion around an isolated rectangular building and one was representing dispersion in a finite array of idealized building blocks. Flow and dispersion close to modelled ground level emission sources was measured. The results illustrate the complexity of the flow around buildings and provide insight in pollutant transport from ground level sources located directly on building surfaces. As a result, areas critical with respect to high pollutant concentrations could be visualized. Particularly, the results show high concentration gradients on the surface of the buildings equipped with modelled emission sources. Inside the boundary layers on the building walls, a significant amount of pollutants is transported to upwind locations on the surface of the building. The paper documents the potential of physical modelling to be used for the simulation and measurement of dispersion close to emission sources and within complex building arrangements.     

Experimental Study of the Criteria of Flow Laminarization in Two-Dimensional Dense Gas Plumes

Laminarization of flow in a two-dimensional dense gas plume was experimentally investigated in this study. The plume was created by releasing CO₂ through a ground-level line source into a simulated turbulent boundary layer over an aerodynamically rough surface in a meteorological wind tunnel. The bulk Richardson number (Ri_*), based on negative plume buoyancy, plume thickness, and friction velocity, was varied over a wide range so that the effects of stable stratification on plume laminarization could be observed. A variety of ambient wind speeds as well as three different sizes of roughness arrays were used so that possible effects of roughness Reynolds number (Re_*) on plume laminarization could also be identified. Both flow visualization methods and quantitative measurements of velocity and intermittency of turbulence were used to provide quantitative assessments of plume laminarization.Flow visualization provided an overall picture of how the plume was affected by the negative buoyancy. With increasing Ri_*, both the plume depth and the vertical mixing were significantly suppressed, while upstream propagation of the plume from the source was enhanced. The most important feature of the flow revealed by visualization was the laminarization of flow in the lower part of the plume, which appeared to be closely related to both Ri_* and Re_*.Measurements within the simulated dense gas plumes revealed the influence of the stable stratification on mean velocity and turbulence intensity profiles. Both the mean velocity and turbulence intensity were significantly reduced near the surface; and these reductions systematically depended on Ri_*. The roughness Reynolds number also had considerable influence on the mean flow and turbulence structure of the dense gas plumes.An intermittency analysis technique was developed and applied to the digitized instantaneous velocity signals. It not only confirmed the general flow picture within the dense plume indicated by the flow visualization, but also clearly demonstrated the changes of flow regime with variations in Ri_* and Re_*. Most importantly, based on this intermittency analysis, simple criteria for characterizing different flow regimes are formulated; these may be useful in predicting when plume laminarization might occur.     

复杂环境下浅埋大跨地铁渡线隧道施工地层沉降控制方法研究

以北京地铁4号线白石桥至学院南路区间渡线隧道作为工程背景,阐述在复杂环境下浅埋大跨隧道施工的地层沉降控制方法。该隧道具有"隧道跨度大(最大跨度22.1 m),埋深浅,断面类型多、结构复杂"等特点,隧道上方有雨水管等市政管线,地层沉降控制难度极大。首先介绍了渡线隧道总体施工顺序安排、超前加固方案和各断面施工方法,并利用FLAC3D三维数值模拟程序,对最大断面开挖支护过程进行了模拟计算,研究了地表沉降规律和塑性区分布情况,用于指导施工。在施工期间对地表沉降进行监测,其结果表明:渡线隧道施工方法是合理的,地表沉降在控制范围内,确保了隧道周边环境的安全。     

隧道路段逆反射轮廓标设置技术研究

隧道是高速公路事故多发路段,为了提高隧道路段行车安全性,需为驾驶员提供与一般路段相近的视觉环境,以有效减少由隧道行车环境变化引起的驾驶员判断和操作失误,逆反射技术在提高隧道路段驾驶员视觉舒适性方面具有潜力.为了确定隧道路段轮廓标设计方案,利用Smart-Eye Pro 5.7型眼动仪,对隧道路段逆反射轮廓标设置技术进行试验,获得了不同逆反射轮廓标组合方案的驾驶员视觉数据.结果表明,小型车和大型车驾驶员对逆反射轮廓标设置高度的视觉差异性明显,设置高度约为0.4 m的逆反射轮廓标对小型车驾驶员的视觉环境改善效果最佳,相应地,大型车约为1.0m.从控制隧道内明暗变化的闪频出发,轮廓标间距以15 m左右为宜.为满足驾驶员视觉舒适性要求,应将驾驶员瞳孔直径变化率控制在0.396 ～ 1.302mm/s,据此确定小型车适用的轮廓标反光膜为超强级,大型车为工程级.研究成果在G65高速公路木冲隧道的应用使驾驶员瞳孔直径变化率控制在1.302 mm/s以内,并使同期事故减少了51.8％.