化学工业固体废物毒性鉴别分析

该文介绍了对硫酸烧渣和磷石膏两种固体废物进行急性毒性和浸出毒性鉴别试验的过程与结果 ,并对磷石膏由危险废物转变为非危险废物的原因进行了探讨 ,为硫酸烧渣和磷石膏的处置和利用提供了依据     

Antimony leaching release from brake pads: Effect of pH,temperature and organic acids

Metals from automotive brake pads pollute water, soils and the ambient air. The environmental effect on water of antimony (Sb) contained in brake pads has been largely untested. The content of Sb in one abandoned brake pad reached up to 1.62 × 10⁴ mg/kg. Effects of initial pH, temperature and four organic acids (acetic acid, oxalic acid, citric acid and humic acid) on Sb release from brake pads were studied using batch reactors. Approximately 30% (97 mg/L) of the total Sb contained in the brake pads was released in alkaline aqueous solution and at higher temperature after 30 days of leaching. The organic acids tested restrained Sb release, especially acetic acid and oxalic acid. The pH-dependent concentration change of Sb in aqueous solution was best fitted by a logarithmic function. In addition, Sb contained in topsoil from land where brake pads were discarded (average 9 × 10³ mg/kg) was 3000 times that in uncontaminated soils (2.7 ± 1 mg/kg) in the same areas. Because potentially high amounts of Sb may be released from brake pads, it is important that producers and environmental authorities take precautions.     

Real time alteration of a nuclear waste glass and remobilization of lanthanide into an interphase

The development of predictive models for the long term evolution of nuclear waste glass requires the complete knowledge of the glass dissolution at the laboratory scale. A new approach was developed to determine the initial reaction during the first steps of experience, a new concept was developed, based on the combination of dynamic leaching test and the characterization of the altered materials. With this experimental set-up it is possible to follow in real time the glass alteration process at a fine temporal scale. The results put in evidence a singular behaviour of the lanthanide, shown by a concentration peak of La, Nd and Ce after 2 h and a quick decrease of their concentration measured on line in the solution during the leaching test. This fact is directly linked to the development of an interphase (altered layer which differs from the initial solid by its texture, structure and chemical composition) at the interface of the glass surface and the leaching solution. This work is an attempt to integrate the formation of the alteration products (here the interphase) during leaching into the dissolution mechanisms of a nuclear waste glass. A model is proposed and discussed.     

Leaching of mecoprop and dichlorprop in calcareous soil. Effect of the exogen organic matter addition in this process

Abstract

Leaching studies of mecorprop (R,S)‐2‐(4‐chloro‐2‐methylphenoxy)propanoic acid, and dichlorprop, (R,S)‐2‐(4‐chloro‐2,4‐dichlorophenoxy) propanoic acid, under saturated conditions were conducted in unamended and amended soil columns. The purpose of the study was to investigate the leaching of these herbicides in three type of soils and the exogen organic matter effect on this process. The leaching patterns could be related to variation in the soil texture and diffusion processes of the herbicides into micropores within the walls of conducting pore. The leaching rate in the amended soil columns decreased with the addition of organic matter. The breakthrough curves (BTC) of these herbicides in the leachates of the amended soil columns were wider and more diffused than the BTC obtained for the corresponding unamended soil. The theoretical BTC overestimated the pore volume required for the displacement of these pesticides from the soil column. This may be due to the differences in the adsorption process between the bacth and soil columns methods     

The use of a sequential leaching procedure for assessing the heavy metal leachability in lime waste from the lime kiln at a caustizicing process of a pulp mill

A five-stage sequential leaching procedure was used to fractionate 13 heavy metals (Cd, Cu, Pb, Cr, Zn, Fe, Mn, Al, Ni, Co, As, V, Ba) and sulphur (S) in lime waste from the lime kiln at the causticizing plant of Stora Enso Oyj Veitsiluoto Pulp Mills at Kemi, Northern Finland, into the following fractions: (1) water-soluble fraction (H₂O), (2) exchangeable fraction (CH₃COOH), (3) easily reduced fraction (HONH₃Cl), (4) oxidizable fraction (H₂O₂ + CH₃COONH₄), and (5) residual fraction (HF + HNO₃ + HCl). Although metals were leachable in all fractions, the highest concentrations for most of the metals were observed in the residual fraction (stage 5). It was also notable that the total heavy metal concentrations in lime waste did not exceed the maximal allowable heavy metal concentrations for soil conditioner agents set by the ministry of the Agricultural and Forestry in Finland. The heavy metals concentrations in lime waste were also lower than the maximal allowable heavy metals concentrations of the European Union Directive 86/278/EEC on the protection of environment, and in particular of the soil, when sewage sludge is used in agriculture. The Ca concentration (420 g kg⁻¹; d.w.) was about 262 times higher than the typical value of 1.6 g kg⁻¹ (d.w.) in arable land in Central Finland. However, the concentration Mg (0.2 g kg⁻¹; d.w.) in lime waste was equal to the Mg concentration in arable land in the Central Finland. The lime waste has strongly alkaline pH (12.8) and a neutralizing value (i.e. liming effect) of 47.9% expressed as Ca equivalents (d.w.). This indicates lime waste to be a potential soil conditioner and improvement as well as a pH buffer.     

Laboratory investigation of Waelz slag stabilization

Electric Arc Furnace dusts are considered hazardous waste due to their high heavy metals content (zinc, lead, etc.). The Waelz process is one of the most efficient technologies, in terms of capacity and quality, able to recover nearly the 90% of zinc contained in such EAF dusts. Unfortunately, the resulting slag still has eco-compatibility problems, although its mechanical and chemical properties are suitable for civil engineering applications. Stabilization tests, by quartz addition, were performed on EAF dusts in a laboratory furnace. Temperature, treatment time and cooling rate were varied in order to define the best conditions for regulating the formation of a stable microstructure able to hinder the release of substances. Microstructural characterization was carried-out using SEM and XRD analysis. Leaching tests were performed according to EN 12457-2 standards and water analyses were performed using ICP-OES. The best chemical stability was achieved when dust powders were mixed with 20% of silica and water-cooled.     

预处理垃圾焚烧飞灰作为碱胶凝材料混合材的研究

试验分析了垃圾焚烧飞灰的主要化学成分及矿物组成,探讨了预处理垃圾焚烧飞灰作为碱胶凝材料混合材的可能性.研究表明,垃圾焚烧飞灰主要由黏土类矿物组成,飞灰直接作为混合材参与水化过程会产生明显膨胀现象,加入30%(质量分数)飞灰制成的矿渣/飞灰试块在成型1 d脱膜时膨胀率达到15.7%,标准养护28 d后无侧压抗压强度只有12.4 MPa.对飞灰进行热活化预处理,900℃条件下活化效果最佳,同样的飞灰掺量下,试块在标准养护28 d后无侧压抗压强度达到46.0 MPa,膨胀现象消失,且碱胶凝材料中重金属稳定性良好.     

柱淋洗法修复铬污染土壤的效果研究

以铬渣污染土壤为供试土壤,采用土柱淋洗法研究柠檬酸、草酸和盐酸单一淋洗以及复合淋洗对铬去除动态和修复效果的影响,并对淋洗前后土壤中铬形态进行分析,探讨修复机理。结果表明,各淋洗方案中,以10体积0.5 mol/L草酸溶液为淋洗剂时的修复效果最好,总Cr累计淋出量为2 304 mg/kg,上层、中层和下层土壤总Cr去除率分别为79.6%、78.1%和69.6%,Cr(VI)去除率为87.8%、86.2%和75%,且土壤Cr(VI)和总Cr随着土壤深度的增加而升高,有在底部积累的可能;淋洗后土壤明显酸化,p H值从10.5降至3左右;以酸作为淋洗剂能有效降低土壤可氧化态铬含量,将其转化为移动性较强的酸可提取态,这有助于达到预期修复效果。     

Leaching of arsenic from coal fly ashes 2. Arsenic pre‐leaching with sodium gluconate solution

The present study deals with the development of an efficient and reliable process for safe disposal of coal fly ash to remove arsenic that has been found to be the most easily leachable and hazardous heavy metal in coal fly ash. Pre‐leaching of fly ash prior to disposal by a natural chelating agent, sodium gluconate (SG), was proposed and studied. Several operational factors influencing arsenic leachability, such as concentration of SG solution, liquid to solid ratio, pH, length of leaching time and leaching temperature were examined. Arsenic was found to leach out substantially with SG, but almost no further release was observed from the ash pre‐leached by SG. After the pre‐leaching treatment, the desirable high buffering capacity of the ash was well sustained. SG solution was effectively regenerated by activated alumina adsorption so that it could be successfully reused for multiple leaching/adsorption cycles.     

温州临江垃圾焚烧发电厂飞灰的性质研究

研究了温州临江垃圾焚烧发电厂生活垃圾焚烧产生飞灰的物理和化学性质。飞灰为含水率低、颗粒尺寸集中在43~175μm之间的灰色粉末,主要由Si、Al、Ca、Mg、Fe、Na、K、C和S元素组成。飞灰中Pb、Cd的浸出浓度在酸性条件下都不同程度地高于我国危险废物鉴别标准的允许浓度,其中Pb的浸出浓度在pH值1.06~13.69条件下远远超标,碱性条件下浸出毒性比酸性条件下小。矿物组成主要为石英(SiO2)、赤铁矿αFe2O3、钙长石CaO.Al2O3.2SiO2、钙铝黄长石2CaO.Al2O3.SiO2、KCl、NaCl、CaCO、PbO、TiO2、ZnCO3等,溶解盐含量高达19.5%,化学反应活性较强,热稳定性较差。