氮掺杂二氧化钛负载钒磷氧催化氧化NO的实验研究

以VPO为活性组分,N掺杂TiO 2为载体,采用浸渍法制备了VPO/TiN催化剂,基于单因素实验研究了其对NO的选择性催化氧化(SCO)性能以及抗硫抗水性能。研究表明:当P/V为1/5、N/Ti为1、活性组分负载量为10%、焙烧温度为350℃时,催化剂的SCO活性最好,NO氧化率达到61%;光致发光光谱(PL)表征显示N掺杂TiO 2在催化剂表面形成的氧空位可增强催化剂对O 2的吸附;VPO/TiN催化剂抗硫抗水性能较强,反应后的催化剂表面未发现硫酸根的特征峰,水蒸气主要通过与NO竞争吸附占据活性位点来抑制催化剂的SCO活性。     

MgO低温催化臭氧降解氨氮的机制研究

研究了低温条件下单独臭氧及MgO催化臭氧化降解水中氨氮的效率和特征,并对其反应机制分别进行了探讨.结果表明,pH是影响臭氧和催化臭氧化除氨的重要因素,不仅影响溶液中NH_3与NH~+_4的比例和臭氧氧化氨氮的速率,还影响氧化产物种类,从而影响脱氮效果.10℃时,单独臭氧对水中氨氮的氧化降解效率随pH的升高而增大,pH≤9时整体降解效率不高,pH=9时仅为16.39%,而pH=10时达到41.77%.臭氧和·OH共同参与降解氨氮的过程.单独臭氧氧化氨氮生成氮气的选择性具有pH依赖性,并与Cl~-密切相关.pH低(≤9)时,氨氮多以NH~+_4形态存在,O_3与Cl~-反应生成ClO~-_x(x=1、3),再氧化NH~+_4,从而生成气态产物N_2或N_2O.MgO在低温条件下具有很强的催化臭氧化降解氨氮的能力且温度升高有利于反应的进行,0、10、20℃时,MgO催化臭氧化氨氮的效率分别为77.53%、80.17%、91.26%.此过程中,·OH参与反应的程度低,一部分氨氮降解依靠ClO~-_x氧化NH~+_4,而氨氮降解的主要途径为O_3对NH_3的直接氧化.     

表面活性剂增强修复地下水中PCE的砂箱实验及模拟

在石英砂充填的二维砂箱中开展表面活性剂（Tween 80）冲洗四氯乙烯（PCE）的修复实验,基于图像分析技术监测不同污染源区结构条件下NAPL相的去除过程.由于实验条件限制,实验中缺乏溶解相浓度数据.为此进一步基于UTCHEM数值模拟方法来理解NAPL相和溶解态之间的质量传输过程,并探讨表面活性剂浓度、注入速率等因素对修复效率的影响.综合砂箱实验和数值模拟结果表明：介质均质和非均质条件下会形成不同类型DNAPL污染源区结构,表现为离散状PCE与池状PCE体积比（GTP）差异.由于离散状污染物与表面活性剂的接触面积更大,更易被优先去除;初始GTP值越高,污染物的修复速率和修复效率也越高.增大表面活性剂浓度或提高表面活性剂的注入速率,虽然能提高DNAPL的修复速率,但会明显降低表面活性剂的修复效率,实验过程中修复效率降幅可达93%.线性驱动溶解模型可以有效地模拟表面活性剂修复DNAPLs过程,基于数值模拟方法选择合适的表面活性剂配比可有效的节省实际污染场址修复经费和时间成本.     

钴（Ⅱ）－过氧化氢－苯基荧光酮体系催化光度法测定痕量钴的研究

本文研究了钴（Ⅱ）催化过氧化氢氧化苯基荧光酮的褪色反应，测定了反应级数和表观活化能，建立了测定痕量地的新方法。２５℃时本法检出限为２９×１０－１３ｇ／ｍｌ，线性范围为０．０４～２ｎｇ／１０ｍｌ，催化反应表观活化能为５６．１５ＫＪ／ｍｏｌ。该方法己用于维生素Ｂ１２、人发和茶叶中痕量钴的测定．结果满意，相对标准偏差为２．４～３．４％。     

纳米TiO2/CNTs复合材料的制备及其光学性质

TiO2在碳纳米管上的复合材料可以增加材料的光催化性能,已成为新的研究热点.本文采用低温液相法成功地合成了TiO2/CNTs复合材料,并用TEM、XRD和UV-vis对材料进行了表征,结果表明,TiO2很好地分散在CNTs上,具有显著的催化效果,有很好的应用前景.     

Preparation of rare-earth metal complex oxide catalysts for catalytic wet air oxidation

Catalytic wet air oxidation (CWAO) is one of the most promising technologies for pollution abatement. Developing catalysts with high activity and stability is crucial for the application of the CWAO process. The Mn/Ce complex oxide catalysts for CWAO of high concentration phenol-containing wastewater were prepared by coprecipitation. The catalyst preparation conditions were optimized by using an orthogonal layout method and single-factor experimental analysis. The Mn/Ce serial catalysts were characterized by Brunauer-Emmett-Teller (BET) analysis and the metal cation leaching was measured by inductively coupled plasma torch-atomic emission spectrometry (ICP-AES). The results show that the catalysts have high catalytic activities even at a low temperature (80°C) and low oxygen partial pressure (0.5 MPa) in a batch reactor. The metallic ion leaching is comparatively low (Mn<6.577 mg/L and Ce<0.6910 mg/L, respectively) in the CWAO process. The phenol, COD_Cr, and TOC removal efficiencies in the solution exceed 98.5% using the optimal catalyst (named CSP). The new catalyst would have a promising application in CWAO treatment of high concentration organic wastewater. Translated from Techniques and Equipment for Environmental Pollution Control, 2005, 6(2): 40–44 [译自: 环境污染治理技术与设备]     

LPWCO method for the treatment of high concentrated organic wastewater

Based on wet air oxidation (WAO) and Fenton reagent, thispaper raises a new low pressure wet catalytic oxidation(LPWCO)which requires low pressure for the treatment of highlyconcentrated and refractory organic wastewater. Compared withgeneral wet air oxidation, the pressure of the treatment(0.1-0.6MPa) is only one of tens to percentage of latter(3.5-10MPa). Inaddition, its temperature is no more than 180℃.Compared withFenton reagent, while H2O2/COD(weight ratio) less than 1.2, theremoval of COD in the treatment is over twenty percents more thanFenton's even the value of COD is more than 14000mg/L. In thispaper, we study the effect factor of COD removal and the mechanismof this treatment. The existence of synergistic effect (catalytic oxidation and carbonization) for COD removal in H2SO4-Fenton reagent system under the condition of applied pressure and heating (0.1-0.6MPa, 104-165℃) was verified. The best condition of this disposal are as follows:H2O2/COD(weight ratio)=0.2-1.0, Fe2+ 0.6×10-3 mol, H2SO4 0.5mol, COD>1×104mg/L, the operating pressure is 0.1-0.6MPa and temperature is 104-165℃. This method suit to dispose the high-concentrated refractory wastewater, especially to the wastewater containing H2SO produced in the manufacture of pesticide, dyestuff and petrochemical works.     

车用催化转化器及其对发动机性能影响的研究

本文论述了影响催化转化器性能的主要因素有催化剂，催化剂的中毒失效，催化转化器的结构和排气系统的影响，温度、发动机工作状况等；强调催化转化器的结构与发动机及排气系统匹配的重要性。     

V2O5-WO3/TiO2脱硝催化剂的制备及其性能

对选择性催化还原脱硝用催化剂V2O5-WO3/TiO2的制备工艺进行了实验研究.采用溶胶-凝胶法制得TiO2凝胶,对凝胶进行不同条件下的干燥和煅烧处理,然后通过浸渍法在TiO2上依次负载WO3和V2O5,最终得到V2O5-WO3/TiO2催化剂.结果表明,TiO2凝胶的处理温度对催化剂结构和脱除NO的性能有一定的影响,TiO2凝胶干燥温度为105 ℃时制得的催化剂活性较高,在实验条件下NO脱除率最高可达98.3%.     

磁场对酪氨酸酶活性及其催化降解酚类有机物影响的研究

研究了恒磁场对酪氨酸酶(TYR)活性及其催化降解酚类有机物的影响.结果显示,不同磁场强度(10～350 mT)处理下TYR酶活性均有提高,最佳磁场强度150mT下酶活力提高了27.1%.不同磁化时间下TYR酶活都有上升,但磁化60min后酶活上升幅度有所下降.酶经磁场处理后对温度、pH值稳定性增强,在温度为20～35 ℃、pH为5.0～10.0时均能保持较高活性,最佳温度为25℃,最佳pH为7.0;磁化后TYR酶的Michaelis常数Km为3.83 mmol·L-1,未磁化的Michaelis常数Km为2.65 mmol·L-1.磁场作用可促进TYR对酚类有机物邻苯二酚、苯酚、2,4-二氯酚的转化,反应速度依次递减,磁化处理对邻苯二酚反应的促进作用尤其明显;磁化处理后的酶对不同浓度苯酚和2,4-二氯酚的去除率均明显高于未磁化处理的酶,且随着酶用量增加,酚去除率提高.荧光发射光谱分析表明,磁化酪氨酸酶的荧光强度增强,构像发生了变化.