Occurrence and source analysis of typical veterinary antibiotics in manure, soil, vegetables and groundwater from organic vegetable bases, northern China

The residue of antibiotics is becoming an intractable environmental problem in many organic vegetable bases. However, their residual levels and distribution are still obscure. This work systematically analyzed the occurrence and migration of typical veterinary antibiotics in organic vegetable bases, northern China. The results showed that there was no obvious geographical difference in antibiotic distribution between soil and manure. A simple migration model can be easy and quick to predict the accumulation of antibiotics in soil. Antibiotics were mainly taken up through water transport and passive absorption in vegetables. The distribution of antibiotics in a plant was in the sequence leaf > stem > root, and performed biological accumulation. The residues of antibiotics in all samples in winter were significantly higher than those in summer. Overall, this work can lay the foundation for understanding ecological risk of antibiotics and their potential adverse effects on human health by food chain.     

Simulating the fate and transport of TCE from groundwater to indoor air

This work provides an exploratory analysis on the relative importance of various factors controlling the fate and transport of volatile organic contaminants (in this case, TCE) from a DNAPL source zone located below the water table and into the indoor air. The analysis is conducted using the multi-phase compositional model CompFlow Bio, with the base scenario problem geometry reminiscent of a field experiment conducted by Rivett [Rivett, M.O., (1995), Soil–gas signatures from volatile chlorinated solvents: Borden field experiments. Groundwater, 33(1), 84–98.] at the Borden aquifer where groundwater was observed to transport a contaminant plume a substantial distance without vertical mass transport of the contaminant across the capillary fringe and into the vadose zone. Results for the base scenario model indicate that the structure of the permeability field was largely responsible for deflecting the groundwater plume upward towards the capillary fringe, permitting aqueous phase diffusion to transport the TCE into the vadose zone. Alternative permeability realizations, generated as part of a Monte Carlo simulation process, at times deflected the groundwater plume downwards causing the extended thickness of the saturated zone to insulate the vadose zone from exposure to the TCE by upward diffusive transport. Comparison of attenuation coefficients calculated using the CompFlow Bio and Johnson and Ettinger [Johnson, P.C. and Ettinger, R.A., (1991), Heuristic model for predicting the intrusion rate of contaminant vapors into buildings. Environmental Science and Technology, 25, 1445–1452.] heuristic model exhibited fortuitous agreement for the base scenario problem geometry, with this agreement diverging for the alternative permeability realizations as well as when parameters such as the foundation slab fracture aperture, the indoor air pressure drop, the capillary fringe thickness, and the infiltration rate were varied over typical ranges.     

Deposition rates of unattached and attached radon progeny in room with turbulent airflow and ventilation

In this paper deposition rate coefficients for unattached and attached radon progeny were estimated according to a particle deposition model for turbulent indoor airflow described by Zhao and Wu [2006. Modeling particle deposition from fully developed turbulent flow in ventilation duct. Atmos. Environ. 40, 457–466]. The parameter which characterizes turbulent indoor airflow in this model is friction velocity, u*. Indoor ventilation changes indoor airflow and friction velocity and influences deposition rate coefficients. Correlation between deposition and ventilation rate coefficients in the room was determined. It was shown that deposition rate coefficient increases with ventilation rate coefficient and that these parameters of the Jacobi room model cannot be assumed to be independent. The values of deposition rate coefficients were presented as functions of friction velocity and ventilation rate coefficient. If ventilation rate coefficient varies from 0.1 up to 1 h⁻¹, deposition rate coefficients for unattached and attached fractions were estimated to be in the range 3–110 h⁻¹ and 0.015–0.35 h⁻¹, respectively.     

新疆主要污染物减排形势分析

全国SO2和COD的排放量削减10%是国家＂十一五＂规划纲要确定的约束性指标。2006年、2007年连续两年新疆都没有完成国家下达的节能减排指标,主要污染物排放总量仍然呈上升趋势。通过分析,采取大企业大集团战略淘汰落后的工业工艺装置,落实工程减排和技术减排要求即可实现2010年全区总能耗保持在2005年的水平,实现国家对新疆增产不增污的规划定位。在此基础上如能落实管理减排和结构调整减排要求,全区污染物排放量将进一步削减。     

迎难而上 大力推进新疆污染减排工作

在深刻论述新疆地区近年来开展节能减排和总量控制工作情况的基础上，针对我区污染物总量控制工作所面临的形势和问题进行了认真总结，并结合我区今后经济发展要求，为确保完成“十一五”总量控制目标，认真做好“十二五”总量控制工作，提出了加强污染源监督管理、完善考核制度、推进大集团战略及提高环境准入条件等8个方面的对策和建议。     

Experimental investigation of outdoor and indoor mean concentrations and concentration fluctuations of pollutants

Tracer gas was released upwind of a two-compartment complex shaped building under unstable atmospheric conditions. The mean wind direction was normal to or at 45° to the long face of the building. The general patterns of concentration distribution on the building external walls and inside the building were analysed and the influence of natural and mechanical ventilation on indoor concentration distributions was discussed. Mean concentration levels, as well as the concentration fluctuation intensity, were higher on the windward walls of the building, although concentration levels varied along each wall. Concentration fluctuations measured inside the building were lower than those measured outside. Inside the two compartments of the building, the time series of concentrations had a similar general behaviour; however, gas concentrations took approximately 1.5 times longer to reach the mean maximum concentration value at the downwind compartment 02 while they also decreased more rapidly in the upwind compartment 01 after the source was turned off. The highest indoor concentration and concentration fluctuation values were observed at the detectors located close to the windward walls, especially when the building windows were open. Experiments with and without natural ventilation suggested that infiltration and exfiltration of contaminants is much faster when the building windows are open, resulting to higher indoor concentration levels. Furthermore, mechanical ventilation tends to homogenize concentrations and suppress concentration fluctuations, leading to lower maximum concentration values.     

Formation of PCDD/Fs from oxidation of 2-monochlorophenol over an Fe2O3/silica surface

The role of iron in surface-mediated formation of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) from 2-chlorophenol (2-MCP) was investigated over the temperature range of 200-550 °C under oxidative conditions. In order to compare and contrast with previous work on copper and ferric oxide-mediated pyrolysis of 2-MCP, identical reaction conditions were maintained (50 ppm 2-MCP, model fly-ash particles containing 5% Fe₂O₃ on silica). Observed products included dibenzo-p-dioxin (DD), 1-monochlorodibenzo-p-dioxin (1-MCDD), dibenzofuran (DF), 4,6-dichlorodibenzofuran (4,6-DCDF), 2,4- and 2,6-dichlorophenol, 2,4,6-trichlorophenol, quinone, catechol, chloro-o-quinone, chlorocatechol and polychlorinated benzenes. Yields of DD and 1-MCDD were 2 and 5 times higher than under pyolysis conditions, respectively. Although 4,6-DCDF was the major PCDD/F product formed with a yield that was 2.5× greater than under pyrolysis, the yield of non-chlorinated DF, which was the dominant PCDD/F product under pyrolysis, decreased by a factor of 3. Furthermore, the ∼2× higher yield of PCDDs under oxidative conditions resulted in a PCDD to PCDF ratio of 0.75 compared to a relatively low ratio of 0.39 previously observed under pyrolytic conditions.     

垃圾堆肥场堆肥废气环境影响评价分析

垃圾堆肥场的建设将改变目前垃圾任意堆放的局面 ,堆肥产品可用于林业使垃圾得到无害化处理 ,并变废为宝。尽管如此在垃圾堆肥过程中还将释放出有害气体和垃圾渗透液等影响环境质量。针对堆肥所产生的大气污染物进行源强确定、扩散计算 ,分析其影响范围并推算卫生防护距离。     

Environmental site assessments and audits: Building inspection requirements

Environmental site assessment criteria were originally developed by organizations that focused, almost exclusively, on surface, subsurface, and pollution source contamination. Many of the hazards associated with indoor environments and building structures were traditionally not considered when evaluating sources and entities of environmental pollution. Since a large number of building materials are potentially hazardous, careful evaluation is necessary. Until recently, little information on building inspection requirements of environmental problems has been published. Traditionally, asbestos has been the main component of concern. The ever-changing environmental standards have dramatically expanded the scope of building surveys. Indoor environmental concerns, for example, currently include formaldehyde, lead-based paint, polychlorinated biphenyls, radon, and indoor air pollution. Environmental regulations are being expanded and developed that specifically include building structures. These regulatory standards are being triggered by an increased awareness of health effects from indoor exposure, fires, spills, and other accidents that have resulted in injury, death, and financial loss. This article discusses various aspects of assessments for building structures.     

超临界水氧化法处理有机污染物

介绍了超临界水氧化法处理有机污染物的基本原理，工艺流程和应用实例及使用范围，对比分析了超临界水氧化法与焚烧法处理有机污染物的技术特点，经济实用性，指明了超临界水氧化法作为一种有效的有机污染物处理方法，在化工环保等领域将具有广阔的应用前景。