不同营养水平下悬浮细菌数量对生物粘泥性质的影响

循环水系统中的微生物有悬浮态和附着态,悬浮细菌的存在对附着态生物粘泥的生长及特性有明显影响。通过向模拟循环冷却水系统中投加不同数量初始悬浮细菌,考察在营养水平不同的情况下,悬浮细菌数量对生物粘泥化学组成和脱氢酶活性的影响。结果表明,营养水平不同,初始悬浮细菌数量对生物粘泥的化学组成和脱氢酶活性的影响程度不同;在不同营养水平下,应分别控制初始悬浮细菌数量。贫营养下,初始悬浮细菌数量应控制在6×105个/mL左右;中营养下,初始悬浮细菌数量应控制在1×105～2.6×105个/mL之间;富营养下,初始悬浮细菌数量应控制在0.11×105～2.6×105个/mL之间最不利于生物粘泥的生长。     

Anaerobic Biodegradation of Blends Based on Polyvinyl Alcohol

The presented work deals with blends composed of polyvinyl alcohol (PVA) and biopolymers (protein hydrolysate, starch, lignin). PVA does not belong to biologically inert plastics but its degradation rate (particularly under anaerobic conditions) is low. A potential solution to the issue problem lies in preparation of blends with readily degradable substrates. We studied degradation of blow-molded films made of commercial PVA and mentioned biopolymers in an aqueous anaerobic environment employing inoculation with digested activated sludge from the municipal wastewater treatment plant. Films prepared in the first experimental series were to be used for comparing biodegradation of blends modified with native or plasticized starch; in this case effect of plasticization was not proved. The degree of PVA degradation after modification with native or plasticized starch increases in a striking and practically same manner already at a starch level as low as approximately 5 wt.%. Films of the second experimental series were prepared as additionally modified with protein hydrolysate and lignin. Only lignin-modified samples exhibited a somewhat lower degree of biodegradation but regarding the measure of lignin present in blend this circumstance is not essential. Level of biodegradation with all discussed films differed only slightly—within range of experimental error.     

活性污泥的固定化及其性能研究

用改进聚乙烯醇-硼酸法将活性污泥制成固定化颗粒，考察了改进聚乙烯醇-硼酸法的最佳条件及固定化颗粒的性能。实验结果表明：改进聚乙烯醇-硼酸法的最佳条件为聚乙烯醇质量分数6．5％、包泥比（包埋剂与活性污泥质量比）1．2：1、二氧化硅质量分数1．5％、活性炭质量分数0．3％、海藻酸钠质量分数0．6％；用最佳条件下制得的固定化颗粒处理模拟化工废水，连续运行15d后的COD去除率达90％以上，且固定化颗粒耐冲击负荷和pH变化能力强；固定化颗粒对模拟化工废水的COD去除速率随进水COD的变化曲线类似于米氏方程所描述的反应初速度随底物浓度的变化规律。     

酒精在常见可燃地面材料燃烧痕迹特征规律研究

易燃液体燃烧痕迹识别对助燃剂放火火灾调查至关重要。选用丙纶地毯和PVC地板革作为纤维和塑料地板的代表,以工业酒精作为易挥发助燃剂的代表,研究酒精用量、灭火方式等对燃烧痕迹形成及痕迹稳定性的影响。通过与未加载酒精的痕迹对比,发现丙纶地毯因热稳定性较差,燃烧后往往能形成烧坑或烧洞,其燃烧轮廓以典型的灰化形式存在,加载酒精的部位熔融严重,与地面紧紧粘连在一起;PVC地板革因为表面光滑,酒精在其表面不断流淌,燃烧后会留下清晰的轮廓,类似于细线状的印痕,而地板革本身基本不会燃烧。燃烧熄灭的方式也会对其炭化程度、燃烧图痕、残余形状产生影响。     

4种农药对土壤脱氢酶活性的影响

通过天王星、功夫、久效磷、氧化乐果4种农药对土壤脱氢酶活性的抑制性进行试验，确认了实验条件的影响因素，同时分析了不同农药用量、不同土样用量及不同培养时间对脱氢酶活性的影响。试验结果表明，4种农药在不同情况下对脱氢酶活性均有不同程度的抑制作用，表明了在本地区特有的农业环境条件下，农用化学物质可能会影响和破坏农业生态环境。     

Influence of Technological Process on Biodegradation of PVA/Waxy Starch Blends in an Aerobic and Anaerobic Environment

Improving biodegradability of PVA/starch blends is a reality already documented by a number of works. Admittedly, mechanical properties of products (for example, tensile strength) are somewhat worse, but suitable composition optimizing or chemical modifying of starch may eliminate the problem to a large degree. This work is an attempt to find another potential effect influencing biodegradability, that of technological procedure for producing films from these blends on an extruder. The procedure with a so-called pre-extrusion step (two-stage) and dry-blend (single-stage) produced blends of slightest differences in achieved biodegradability (virtually within limits of experimental error) in aerobic (76 vs. 79%) as well as anaerobic breakdown (48 vs. 52%). Conversely, morphological analysis exhibited superior homogeneity of films prepared by the two-stage process; their tensile strength was also higher.     

Auto-adaptive Air Distribution and Structure Optimization of Ejector Burner for Biomass Alcohol Fuels

A plenty of studies on the utilization of biomass alcohol fuels have been conducted, but combustion efficiency and stability of this fuels still need to be improved. Based on biomass alcohol fuels (bio-methanol and bio-ethanol), this paper studied auto-adaptive air distribution characteristics and optimum structure parameters of an ejector burner by numerical simulation method. Also, an experiment was conducted to verify the numerical results. The results show that the mole air entrainment ratio (MAER) keeps almost constant when the ejector fuel nozzle exit locates at the segment between the ejector throat and the suction chamber entrance, but a bigger ratio α would lead to a higher MAER till the α is bigger than 8.5 for bio-methanol and 11.5 for bio-ethanol. The bio-ethanol fuel is more beneficial for air carrying role because of its big molecular weight. Operation pressure (P_w) has a little impact on MAER of the two fuels, but the rise of back pressure (P_b) would lead to rapid decrease of MAER for the two fuels. For the optimum structure burners, the MAER can be maintained at the value of theoretical complete combustion. Its changing rate is less than 2.3% for bio-methanol and 2.5% for bio-ethanol when the burner load changes from 30% to 120%, which is highly consistent with the experimental results. The optimum burner can distribute air supply automatically with the changing of burner load.     

一株高效降解废水有机质耐冷菌的筛选、鉴定及特性研究

利用生物法进行污水处理已被国内外广泛使用,但由于温度影响微生物的生长和繁殖,使其成为生物污水处理效率的限制因子.本研究从污水处理厂活性污泥中分离出5株在低温4℃条件下生长良好的菌株,其中菌株DW1在4℃条件下,96 h时可将初始COD为800 mg·L-1的生活污水有机物去除率高达67.7%.结合菌落形态特征、生理生化特性以及16S r DNA序列分析,将菌株DW1初步鉴定为假单胞菌(Pseudomonas sp.).菌株DW1对COD负荷较高的污水处理效果较好;接种量为3%(体积分数)、p H为7.0时,菌株对污水COD去除率和DHA活性较高.在4℃和25℃条件下,菌株DW1均在96 h对污水COD去除率和DHA活性最高,分别为71.2%、11.35μg·m L·h-1(以TF计)和78.8%、15.11μg·m L-1·h-1(以TF计).     

顶空气相色谱法测定工业废水中乙醇和异丙醇研究

建立了测定工业废水中乙醇和异丙醇的顶空毛细管气相色谱法.采用顶空进样技术,分析过程不使用有机试剂,避免了对分析人员和环境的危害.乙醇和异丙醇在3.00～ 20.0mg/L浓度范围内呈良好线性关系,水样测定结果重现性较好,相对标准偏差范围均小于2％,乙醇加标回收率为93.6％～104.0％,异丙醇加标回收率为94.0％～ 102.0％.本方法操作简单快速,灵敏度高,能满足工业废水中乙醇和异丙醇的监测.     

退浆废水中聚乙烯醇的分析检测研究

建立了紫外可见分光光度法检测退浆废水中聚乙烯醇(PVA)含量的方法。以硼酸为介质,碘化钾—碘溶液为显色剂,检测波长为680 nm,测定退浆废水中PVA含量的线性方程为Y=0.018 8X+0.003 2,相关系数R2=0.999 3,平均加标回收率为97.6%;方法精密度(RSD=1.5%)、重现性(RSD=1.8%)均较好。该方法操作简单、准确度高、测定快速,适用于测定退浆废水中PVA的含量。