注入式低温等离子体技术用于卷烟厂异味处理的效果研究

将注入式低温等离子体技术应用于烟厂制丝排潮和制丝除尘排放气体异味处理中,研究了注入式低温等离子体发生器参数对臭味浓度、非甲烷总烃和可检出典型有机物去除率的影响规律。结果表明:注入式低温等离子体发生器工作电压越高,注入处理烟道的氧化活性物种浓度越高,注入量越大,臭味浓度、非甲烷总烃和可检出典型有机物去除率也越高。选取合理的工作电压,臭味浓度去除率可达90%以上,非甲烷总烃去除率分别达到了83.8%(制丝排潮)和78.1%(制丝除尘)。     

高压脉冲放电等离子体处理活性红X-3B染料废水

采用高压脉冲放电等离子体技术对活性红X-3B染料废水进行处理,考察了废水电导率、脉冲电压、脉冲频率、针板间距以及曝气量对处理效果的影响。实验结果表明,当废水电导率为200μS/cm、脉冲电压为34kV、脉冲频率为60Hz、针板间距为15mm、曝气量为12L/h、处理时间为60m in时,活性红X-3B染料废水脱色率能达到98.6%。     

等离子体催化降解甲苯途径的原位红外研究

考察了在常温常压条件下,等离子体分别协同SiO₂、Al₂O₃、NiO/Al₂O₃降解甲苯的性能,并从材料的介电常数、对甲苯的吸附性及臭氧分解能力等角度分析了不同活性表现的原因,同时,采用原位红外技术研究了甲苯降解过程中催化剂表面吸附物种的变化.结果表明,当甲苯浓度为100 ppm,气体流量为100 mL·min^-1时,一定范围内,甲苯降解率随着能量密度、介电常数、吸附性及臭氧分解能力的提高而提高.甲苯在催化剂表面的吸附对其降解途径有十分重要的影响:在放电区域中加入SiO₂,甲苯仍然在气相中完成降解;而存在Al₂O₃ 及NiO/Al₂O₃时,甲苯氧化成苯甲酸的过程主要发生在催化剂表面,是甲苯催化降解的关键步骤,苯甲酸在活性位点的积累将降低催化剂的反应活性.     

Preparation of MgO/B2O3 coatings by plasma spraying on SUS304 surface and effects of heat-resistant

This study mainly deals with the preparation of MgO/B₂O₃ coatings by plasma spraying on the SUS304 surface and the effects of heatresistant. The power materials of low thermal conductivity were selected to control the heat divergent performance of high temperature parts. The reticular micro-structure between the cover thermal layer and the substrate was prepared by using the plasma spraying method. The powder mixture of MgO and B₂O₃ were selected as spraying materials and the SUS304 was used as the substrate material. The MgO/B₂O₃ coating was prepared on the surface of the SUS304 to provide better cover thermal performance. The properties of the microstructures and the morphologies were studied by Optical Microscope, Scanning Electron Microscope, Electron Probe Microanalyzer, and X-ray Diffraction. The results showed that the cover thermal performance has been improved.     

具有自动清洗功能的低温等离子油烟净化装置设计与实现

为了克服现有的油烟净化器清洗困难、清洗成本高的不足,提供一种具有自动清洗功能的低温等离子油烟净化器,该具有自动清洗功能的低温等离子油烟净化器可随时清洗吸附的油烟,并且清洗容易、成本低。     

Determination of alkali-labile phosphoprotein phosphorus from fish plasma using the Tb^3＋-tiron complex as a fluorescence probe

A sensitive method based on the fluorescence quenching effect of the Tb^3＋-Tiron complex is proposed for the determination of alkali-labile phosphoprotein phosphorus （ALP） released from fish plasma. The detection limit was 5.4 ng/ml （S/N=2）, and the relative standard deviation of the quenching effect （6 replicates） was 4.6%. The results obtained by the proposed method were in good agreement with those obtained by the colorimetric assay. The advantages of the present method are its relatively simple detection procedure, the lack of toxic organic solvents, and high sensitivity.     

Evaluation of reusing alum sludge for the coagulation of industrial wastewater containing mixed anionic surfactants

A coagulation-flocculation process is typically employed to treat the industrial wastewater generated by the consumer products industry manufacturing detergents, soaps, and others. The expenditure of chemicals including coagulants and chemicals for pH adjustment is costly for treating this wastewater. The objective of this study was to evaluate the feasibility of reusing the aluminum sulfate (alum) sludge as a coagulant or as a coagulation aid so that the fresh alum dosage can be minimized or the removal e ciency can be enhanced. The experiments were conducted in a jar-test apparatus simulating the coagulation-flocculation process for simultaneous removals of organic matters, anionic surfactants, suspended solids, and turbidity. At the optimum initial pH value of 10 and the fresh alum concentration of 400 mg/L, the total suspended solids (TSS), total chemical oxygen demand (TCOD), total anionic surfactants, and turbidity removal e ciencies were 71.5%, 76.4%, 95.4%, and 98.2%, respectively. The addition of alum sludge as a coagulant alone without any fresh alum addition could significantly remove the turbidity, TCOD, and anionic surfactants. The TSS was left in the supernatants after the settling period, but would subsequently be removed by adding the fresh alum. The TSS, TCOD, and turbidity removal e ciencies were also enhanced when both the alum sludge and the fresh alum were employed. The TCOD removal e ciency over 80% has been accomplished, which has never fulfilled by using the fresh alum alone. It is concluded that the alum sludge could be reused for the treatment of industrial wastewater generated by the consumer products industry.     

低温等离子体-催化协同降解挥发性有机废气

低温等离子体-催化协同技术适合于各类挥发性有机物的治理,特别是大气量低浓度的有机废气的处理.高效催化剂的加入可 以显著提高等离子体反应中有机废气的降解效率,减少有害副产物的生成以及提高反应器的能量利用率.从反应器、催化剂以及背景气体等方面探讨了该技术实现产业化需要解决的问题,结合低温等离子体与催化剂的相互作用、等离子体...     

等离子体催化降解有机废水研究

研究了多种因素对高压脉冲介质阻挡放电低温等离子体法处理印染废水效果的影响。通过实验得出结论:随着有效处理时间和峰值外施电压的增加,废水中的有机物的去除率增加;随着水样浓度的增加,废水中有机物的去除率降低;随着催化剂(TiO)2量的增加,废水中有机物的去除率先升高后降低,最佳催化剂的加入量为0.5 g/L TiO2悬浮液0.5 mL。     

电晕放电等离子体技术处理水中四环素的研究

采用电晕放电等离子体技术降解水中的四环素,研究了在反应体系中,初始浓度、输入功率、电极间距、空气流量及初始pH对四环素去除效率的影响.同时,还对四环素在降解过程中不同时段的COD、TOC和B/C变化进行了研究,并对其降解产物进行了分析和讨论.实验结果表明:电晕放电等离子体对水中四环素具有较好的去除效果,在四环素初始浓度为200 mg·L-1、pH=2.47、初始电导率为1.50 mS·m-1、空气流量为0.06 m3·h-1、电极间距为4 mm、输入功率为45.0 W的条件下,反应20 min后,四环素的去除率可达到99.1%,COD去除率可达31.2%,TOC去除率可达80%左右,其B/C比提高为0.30,有效地改善了废水的可生化性.