水杨酸法检测水质氨氮的改进方法

该氨氮检测方法是对水杨酸分光光度法的改进,通过将50 g/L的水杨酸改为150 g/L的水杨酸钠,将有效氯为3. 5 g/L的次氯酸钠溶液改为5 g/L的二氯异氰尿酸钠溶液,增加了检测试剂的稳定性和贮存时间,同时将氨氮测定上限从1 mg/L提高至2. 5 mg/L,并将显色时间从60 min优化为30 min,使得此方法更为便捷。该方法的氨氮标准曲线线性关系良好,相关系数为0. 999 6,准确性和精密度高,加标回收率良好,适用于不同类型水质中氨氮的检测。     

An experimental apparatus for testing biodiesels based on a CFR engine—setup and validation with different methyl ester blends

A cooperative fuel research (CFR) engine was modified and instrumented in order to control operating conditions and to measure engine parameters and in-cylinder pressure diagrams. Aiming at the comparison of different alternative fuels, an experimental procedure was defined, including cetane number (CN) evaluation and the definition of engine operating quantities in different working points, for fixed levels of compression ratio (CR) and injection advance. An investigation was made considering several blends of methyl-esters of rapeseed oil (RME) and of a mix of vegetable oils (VOME) with conventional diesel oil. The defined experimental procedure was applied to assess CN, engine brake thermal efficiency (bte) and exhaust emissions. Results show that the biodiesel content has a positive influence on soot emissions, with strong reduction, while thermal efficiency and NO_X emissions are negatively affected, which can be justified taking into account fuel properties and changes in combustion process. As observed outcomes are generally in line with those presented in literature, the facility proved to be a suitable tool for basic investigations on alternative fuels to be used in specific applications.     

Environmental pollution,hydropower and nuclear energy generation before and after catastrophe: Bathtub-Weibull curve and MS-VECM methods

In this paper, the life span of hydro and nuclear energy generations and the relationship between hydro and nuclear energy generations, environmental pollution, and economic growth were investigated for Japan covering the period of 1960–2018 by employing the Bathtub-Weibull curve and Markov switching-vector error correcting (MSVEC) method, respectively. According to the Bathtub-Weibull curve analysis, a rising failure rate for nuclear energy was found, indicating that the life of nuclear energy has expired, but a decreasing failure rate for hydroelectric energy has been detected. Then two different MSVEC models were used. The MSVEC method, unlike traditional approaches, determines the relationship between variables under different regimes. The results of MSVEC methods indicate three important points. First, regime-dependent asymmetry and regime changes are crucial for policy recommendations. Second, the shocks to hydropower and nuclear energy generations cause temporary deviations from the long-run growth path in both regimes. Lastly, the increase in hydropower generation leads to a decrease in environmental pollution and an increase in GDP, and an increase in nuclear power generation increases pollution and growth in both regimes.     

Comparative study on effect of blending,thermal barrier coating (LHR) and injector nozzle geometry on biodiesel-fuelled engines

Increased petroleum prices, increased threat to the environment from exhaust emissions and global warming have generated intense international interest in developing renewable and alternative non-petroleum fuels for internal combustion engines. Evolving suitable technology for addressing energy crisis creates a continued investigation into the search for sustainable and clean-burning renewable fuels. This work investigates suitability of different non-edible-derived biodiesels such as cotton seed oil methyl ester (COME), Honne oil methyl ester (HnOME) and Rubber seed oil methyl ester (RuOME) to four stroke, single cylinder compression ignition (CI) engine. Engine tests were conducted to study the effect of fuel blending, thermal barrier coating (TBC) or Low Heat Rejection (LHR) and injector nozzle geometry on the performance, combustion and emission characteristics of COME, HnOME and RuOME in the modified CI engine. Blends of biodiesels with diesel were varied from 20 to 80% in steps of 20%. Two thermal barrier coatings of partially stabilized zirconium (PSZ) and aluminium oxide (Al₂O₃) were provided on the engine to make it fully adiabatic. Nozzle injectors of 3, 4 and 5 holes, with size of orifice varied from 0.2 to 0.3 mm size were selected for the study. It was concluded that B20 biodiesel blend, PSZ-coated engine and four hole nozzle injector of 0.2 mm size resulted in overall better engine performance with increased brake thermal efficiency (BTE) and reduced HC, CO, smoke emissions for the fuel combinations tested. Combustion analysis to study the effect of biodiesel blends, LHR coatings, injector nozzle geometry on the performance of the biodiesel-fuelled engine has been presented to give more insight into the behaviour of operation.     

大气污染排放窗口机制研究

以2种典型的污染排放源(点污染源和线污染源)为基础,提出排污窗口的概念,通过参数转换分解源强对污染扩散进行研究。首先在高斯污染扩散模型的基础上,对非持续性污染源强建模,然后以某烟囱的周期性排污分析,检验排污窗口设置的合理性。对于单双号限行的窗口性质的污染排放研究中,首先对交通流建立线污染扩散模型,然后融合元胞自动机(9元胞互影响)模拟区域多角度污染的扩散平衡,最后对"单双号限行"下北京市不同区域空气质量指标进行分析与仿真。分析结果表明,合理的排污窗口能够减轻污染程度及对人们日常生活的影响。     

水杨酸钠-次氯酸钠法海水氨氮快速检测方法研究

对水杨酸钠-次氯酸钠法测量海水氨氮化学分析条件进行了研究。通过正交实验对水杨酸钠-次氯酸钠法试剂配比进行优化,并确定了最佳试剂配比。同时,用水杨酸钠-次氯酸钠法和靛酚蓝法测量24个海水水样,测量结果无显著差异。在反应温度为35℃,反应时间为10 min时,用改进后的方法分别测量60、120μg/L的氨氮标准溶液,相对标准偏差分别为4.0%、2.8%,回收率分别为99.8%、100.8%。该方法试剂无毒、环保,操作简单、快速,可满足营养盐自动分析仪现场快速测量的要求,提高仪器的环境友好性。     

阿什河水系枯水期氮污染特征与同位素源解析

在阿什河水系设置20个采样点,采用水质监测技术和稳定氮同位素示踪技术,研究了枯水期阿什河氮污染特征和硝酸盐氮污染来源。结果表明:(1)阿什河枯水期大部分采样点氨氮浓度较低,大部分区域达到或优于《地表水环境质量标准》(GB3838—2002)中Ⅲ类。上游河段硝酸盐氮浓度较低,中游河段较高,到下游河段略有降低。总氮浓度较高,最高达19.4mg/L。(2)阿什河水系采样点15 N的丰度(δ15 N)主要处于0.11%~0.21%、0.42%~0.78%、0.83%~0.88%和1.09%~1.26%。稳定15 N同位素示踪解析阿什河硝酸盐氮污染来源表明,阿什河上游污染源主要为大气沉降、土壤有机氮和人工化肥;中游主要受畜禽养殖污水和生活污水污染;下游主要受城镇生活污水和工业废水影响。     

Fuel efficiency improvement of a dual-fuel engine fuelled with Honge oil methyl ester (HOME)–bioethanol and producer gas

Renewable and alternative fuels have numerous advantages compared with fossil fuels as they are renewable and biodegradable and provide food and energy security and foreign exchange savings besides addressing environmental concerns and socio-economic issues (Yaliwal et al. 2013. International Journal of Sustainable Engineering, doi:10.1080/19397038.2013.801530. Zhu et al. 2011a, Applied Thermal Engineering 31 (14–15): 2271–2278; Zhu et al. 2011b, Fuel 90: 1743-1750; Banapurmath, Tewari, and Hosmath 2008, Renewable Energy 33: 2007-2018; Banapurmath 2009, “Performance, Combustion and Emission Characteristics of a Single Cylinder Direct Injection CI Engine Operated on Dual Fuel Mode Using Honge Oil and Producer Gas.” PhD thesis, 1–195; Banapurmath et al. 2011, Waste and Biomass Valorization 2: 1–11). In this context, the main objective of the present work is to study methods of biofuel production such as Honge oil methyl ester (HOME) using a conventional transesterification process and bioethanol from the Calliandra calothyrsus shrub using a new pretreatment method known as hydrothermal explosion. Further, experimental investigations were carried out on a single-cylinder, four-stroke, direct-injection stationary diesel engine operating in a dual-fuel mode using HOME, bioethanol and producer gas combinations to determine its performance, combustion and emission characteristics. The performance of the dual-fuel engine was analyzed at optimized engine conditions. HOME-Bioethanol (BE) blends such as HOME+ 5% bioethanol (BE5), HOME+ 10% bioethanol (BE10) and HOME+ 15% bioethanol (BE15) were prepared by adding bioethanol to HOME (on volume basis) in different proportions ranging from 5 to 15% with an increment of 5%. In this present work, the effect of different BE blends on the performance of producer gas fuelled dual fuel engine was studied. Experimental investigation on dual fuel engine using BE5-Producer gas operation resulted in up to 4–9% increased brake thermal efficiency with decreased hydrocarbon (HC), carbon monoxide (CO) and marginally increased nitric oxide (NOx) emission levels compared to HOME-Producer gas, BE10-producer gas and BE15-producer gas mode of operation. However, it was observed that, the overall performance of BE-producer gas operation was found to be lower compared to diesel-producer gas operation.     

全球低碳发展评估及中国低碳发展的实现路径

低碳发展日益成为国际关注的热点问题,中国正处在快速工业化和城镇化进程当中,通过低碳发展实现经济社会转型尤为迫切。在全球大背景下正确判断中国的低碳发展水平,汲取各国有益的低碳发展经验,寻求适合中国的低碳发展路径尤为重要。从低碳发展特征指标变动出发,通过统计分析,得出全球低碳发展历史和现状水平,以及中国所处的位置。研究表明,近20年来全球碳生产力水平不断提高,近年来中国的碳生产力水平飞速提升,但是中国的碳生产力仍然远远低于全球平均水平,离先进国家的差距更大,不足法国的1/10,人均二氧化碳排放增速位居世界前列,减排压力巨大。因此,结合国内外实践经验,总结了中国低碳发展的5个实现路径,分别是调整能源结构、发展低碳产业、倡导低碳消费、建设低碳城市和加强碳汇建设。     

基于小流域尺度的目标抗生素排放量估算方法——以梅江流域为例

抗生素的大量使用和排放造成的环境污染和生态风险问题日益突出,抗生素排放量的估算是评价流域内抗生素污染程度的重要指标,但目前抗生素排放量估算方法尚不完善。本研究以梅江流域为例,建立了适合小流域尺度的典型抗生素排放量估算方法,计算了四环素类抗生素(TCs)向不同环境相的排放量并分析了其主要来源。结果表明:2016年梅江流域TCs排放量为8 558.1 kg,不同行政区抗生素排放量差异较大,其中梅江镇受人口密度及养殖密度影响,抗生素排放量最大,高达1 224.4 kg;同时流域内不同抗生素的排放量也有所不同,其大小顺序为强力霉素(DXC)土霉素(OTC)四环素(TC)金霉素(CTC);TCs受排放源、排放途径等因素影响,以进入环境水相及土壤相为主,其中进入水相中的抗生素主要来自人类及生猪粪便,进入土壤相中的抗生素主要来自生猪及三黄鸡粪便。梅江小流域抗生素具有潜在的生态风险,应加强抗生素使用管理。该研究为我国小尺度流域目标抗生素排放量的估算提供了十分有效的方法。